Printable · GCSE Foundation · ages 14-16
Rounding, significant figures and error intervals worksheet — GCSE Foundation
Fifteen questions on "rounding, significant figures and error intervals" — DfE statement N15. Print it, or print three versions so neighbours cannot copy by letter; the key gives the letter for each version.
Answer key: Rounding, significant figures and error intervals worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (b) 4,700 — To round to the nearest 100, look at the digit in the tens column, which decides whether the hundreds column rounds up or stays the same. In 4,685 that digit is 8, and since 8 is 5 or more, the 6 in the hundreds column rounds up to 7, giving 4,700. Simply changing the last two digits to zero without checking the tens digit gives 4,600, which rounds down when it should round up. Rounding to the nearest 10 instead of the nearest 100 gives 4,690. Rounding to the nearest 1,000 instead gives 5,000, one place value too coarse.
- (c) 3.95 — The digit after the second decimal place is 7, which is 5 or more, so round the second decimal place up: 3.947 rounds to 3.95. A candidate who truncated instead of rounding, simply cutting off after 2 decimal places, wrote 3.94. A candidate who rounded to 1 decimal place instead of 2 wrote 3.9. A candidate who rounded up but mishandled the carry wrote 4.0.
- (c) Sam is correct — The leading zeros in 0.070268 are not significant, so the first three significant figures are 7, 0 and 2. The next digit along is 6, and since 6 is 5 or more, the third significant figure rounds up from 2 to 3, giving 0.0703. This means Sam's answer is correct. Writing 0.070 keeps only 2 significant figures, one short of what was asked. Writing 0.0702 ignores the digit 6 that follows and leaves the third figure unrounded. Writing 0.0704 rounds the third figure up twice, as if a later digit had also pushed it up.
- (a) 1,500 ≤ m < 2,500 — Method: a four-digit figure written to 1 significant figure has been rounded to the nearest 1,000, so the mass lies within half of 1,000, that is 500, of the figure given. Working: 2,000 − 500 = 1,500 and 2,000 + 500 = 2,500. The lower limit is included, because 1,500 kg rounds up to 2,000 kg to 1 significant figure, while 2,500 kg rounds up to 3,000 kg, so the upper limit is not. Answer: 1,500 ≤ m < 2,500. The distractors: 1,950 ≤ m < 2,050 comes from rounding to the nearest 100 instead of to 1 significant figure; 1,000 ≤ m < 3,000 goes a whole 1,000 either side instead of half of it; 1,500 < m ≤ 2,500 has the two limits the wrong way round.
- (d) 30 kg — Round 0.485 kg to 1 significant figure: 0.5 kg. Multiply by the 60 cakes: 0.5 × 60 = 30 kg. A candidate who rounded to 2 significant figures instead of 1 used 0.49 kg, giving 0.49 × 60 = 29.4 kg. A candidate who used the unrounded amount instead of the estimate worked out 0.485 × 60 = 29.1 kg. A candidate who rounded 0.485 down to 0.4 kg instead of up to 0.5 kg worked out 0.4 × 60 = 24 kg.
- (b) 6.2 ≤ x < 6.3 — Truncating simply cuts off the digits after the required decimal place instead of rounding them, so every value from 6.2 up to (but not reaching) 6.3 truncates to 6.2. This gives the error interval 6.2 ≤ x < 6.3, with no allowance made on the lower side because truncation never rounds a smaller value up into this interval. Using 6.15 ≤ x < 6.25 applies the rounding rule of going half a unit either side, which does not apply to truncation. Writing 6.1 < x ≤ 6.2 puts the interval below 6.2 instead of above it. Writing 6.2 ≤ x ≤ 6.3 wrongly includes 6.3, which truncates down to itself, not to 6.2.
- (c) 6 — Method: the first significant figure is the first non-zero digit; round using the digit after it to decide whether to round up or down. Working: the first significant figure of 6.283 is the 6; the next digit is 2, which rounds down, so 6.283 rounds to 6. 6.3 comes from rounding to 2 significant figures instead of 1. 10 comes from rounding up to the nearest 10 instead of finding 1 significant figure of the number itself. 0.6 comes from misplacing the decimal point after rounding. Answer: 6.
- (c) 0.0065 — Leading zeros are never significant, so counting from the first non-zero digit, the first two significant figures of 0.006482 are 6 and 4. Look at the next digit along, 8, to decide whether the second figure rounds up: since 8 is 5 or more, the 4 rounds up to 5, giving 0.0065. Rounding to 2 decimal places instead of 2 significant figures gives 0.01, which answers a different question. Wrongly counting one of the leading zeros as a significant figure and stopping one figure short gives 0.006. Keeping an extra digit, as in 0.00648, gives 3 significant figures rather than 2.
- (d) 25,000 — Method: to round to the nearest 1,000, look at the hundreds digit; 5 or more sends the thousands digit up, less than 5 leaves it where it is, and every digit below the thousands becomes zero. Working: 24,681 has 4 in the thousands place and 6 in the hundreds place. As 6 is 5 or more, the 4 thousands go up to 5 thousands and the hundreds, tens and units are replaced by zeros. Answer: 25,000. The distractors: 24,000 comes from cutting the last three digits off instead of rounding, which leaves the thousands digit untouched; 24,700 is 24,681 rounded to the nearest 100, a finer degree of accuracy than the question asks for; 20,000 is 24,681 rounded to the nearest 10,000, a coarser degree of accuracy.
- (a) 42.5 ≤ t < 47.5 — Rounding to the nearest 5 minutes means the actual time can be up to half of 5 minutes, 2.5 minutes, below or above 45 before it would round to a different multiple of 5. The lower bound is 45 − 2.5 = 42.5 and the upper bound is 45 + 2.5 = 47.5. A time of exactly 47.5 minutes would round up to 50, not 45, so 47.5 is excluded while 42.5 does still round to 45. Writing 42.5 ≤ t ≤ 47.5 wrongly includes 47.5. Writing 40 ≤ t < 50 uses a whole rounding unit, 5, either side instead of half of it. Writing 44.5 ≤ t < 45.5 treats the rounding unit as 1 minute instead of 5 minutes.
- (a) 0.08 — Method: decimal places are counted from the decimal point, including any zeros straight after it, so rounding to 2 decimal places is decided by the digit in the third decimal place. Working: 0.0759 has 7 in the second decimal place and 5 in the third, and 5 counts as rounding up, so the 7 goes up to 8. Answer: 0.08. The distractors: 0.07 comes from chopping the digits after the second decimal place off instead of rounding them; 0.076 is 0.0759 correct to 2 significant figures rather than 2 decimal places, because the zeros in front of the 7 are not significant figures; 0.1 is 0.0759 rounded to 1 decimal place, a coarser degree of accuracy than the question asks for.
- (a) 330 ml — Correct to the nearest 20 ml means the true volume could be up to 10 ml (half of 20) either side of 340 ml. The smallest possible volume is 340 − 10 = 330 ml. A candidate who subtracted the full 20 ml instead of half of it worked out 340 − 20 = 320 ml. A candidate who added instead of subtracted, finding the largest possible volume instead of the smallest, worked out 340 + 10 = 350 ml. A candidate who halved the interval again by mistake, using 5 ml instead of 10 ml, worked out 340 − 5 = 335 ml.
- (d) 0.024 cm — Method: significant figures are counted from the first non-zero digit; the zeros in front of it only fix the place value and are not significant. Working: in 0.02384 the first significant figure is 2 and the second is 3, so the rounding is decided by the next digit, 8. As 8 is 5 or more, the second significant figure goes up from 3 to 4, in the same place value. Answer: 0.024 cm. The distractors: 0.023 cm comes from chopping the 84 off instead of rounding it; 0.02 cm comes from counting the leading zeros as significant figures, so the 2 is taken as the second figure and the rounding stops there; 0.0238 cm is 0.02384 correct to 3 significant figures, one figure too many.
- (a) 8.15 ≤ y < 8.25 — Rounding to 1 decimal place means the error interval spans half of 0.1, so 0.05, either side of 8.2: 8.2 − 0.05 = 8.15 and 8.2 + 0.05 = 8.25. The lower bound uses ≤ because 8.15 itself rounds to 8.2, but the upper bound uses < because 8.25 would round up to 8.3. So the error interval is 8.15 ≤ y < 8.25. A candidate who used the wrong rounding band gave 8.1 ≤ y < 8.2. A candidate who used a strict inequality at both ends wrote 8.15 < y < 8.25, wrongly excluding 8.15 itself. A candidate who added the full 0.1 instead of half of it wrote 8.2 ≤ y < 8.3.
- (c) 5.7 kg — Method: to round to 1 decimal place, keep one digit after the decimal point and let the digit in the second decimal place decide whether that digit stays as it is or goes up. Working: 5.672 has 6 in the first decimal place and 7 in the second decimal place; 7 is 5 or more, so the 6 goes up to 7 and the digits beyond the first decimal place are dropped. Answer: 5.7 kg. The distractors: 5.6 kg comes from chopping the digits after the first decimal place off instead of rounding them, which is truncation rather than rounding; 6.0 kg comes from rounding to the nearest whole kilogram instead of to 1 decimal place; 5.0 kg comes from chopping everything after the decimal point off, so the mass is both truncated and given to the wrong degree of accuracy.
Build your own mix at the worksheet builder.