Printable · GCSE Foundation · ages 14-16
Ratio, proportion and rates of change worksheet — GCSE Foundation
Fifteen questions across the ratio, proportion and rates of change statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Ratio, proportion and rates of change worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (d) 35 — Method: in direct proportion the ratio y : x is the same for every pair, so find the constant and substitute the new value of x. Working: k = 20 ÷ 8 = 2.5, so y = 2.5x; when x = 14, y = 2.5 × 14 = 35. Answer: 35. The distractors: 26 comes from additive thinking — x rises by 6, so 6 is added to y — which would keep the difference constant rather than the ratio; 28 comes from rounding the constant 2.5 down to 2 and working out 2 × 14, which loses the half in the constant; 5.6 comes from using the constant upside down, 8 ÷ 20 = 0.4, and working out 0.4 × 14.
- (c) 5 hours — Method: measure the job in decorator-hours, which is in the same ratio as the number of rooms, then share the decorator-hours between the decorators available. Working: 5 decorators × 6 hours = 30 decorator-hours for 3 rooms, so one room takes 30 ÷ 3 = 10 decorator-hours; 5 rooms take 5 × 10 = 50 decorator-hours; shared between 10 decorators that is 50 ÷ 10 = 5 hours. Answer: 5 hours. The distractors: 3 hours comes from halving the 6 hours because the number of decorators doubles, while forgetting that there are also more rooms to paint; 10 hours comes from scaling the 6 hours up for the rooms only, 6 × 5 ÷ 3, and leaving the workforce at 5 decorators; 6 hours comes from assuming that doubling the decorators and increasing the rooms cancel each other out, which they do not, because the rooms rise by a factor of 5/3 and the workforce by a factor of 2.
- (a) f = 4s — Method: in the ratio 4 : 1 the sugar is 1 part, so one part weighs s grams, and the flour is 4 of those same parts. Working: one part is s, so four parts are 4 × s, giving f = 4s; as a check, if s = 3 then the flour is 4 × 3 = 12 g, and 12 : 3 does simplify to 4 : 1. Answer: f = 4s. The distractors: f = s/4 uses the ratio the wrong way round, as though the flour were 1 part and the sugar 4; f = s + 3 comes from reading the ratio as a difference, 4 − 1 = 3, and adding that difference instead of multiplying; f = 5s uses 4 + 1 = 5, the total number of parts, as the multiplier, but 5 parts is the whole mixture and not the flour on its own.
- (a) 4 hours — This is inverse proportion: more pumps take less time. Multiply the original numbers to find the total pump-hours needed: 2 × 10 = 20 pump-hours. Divide by the new number of pumps: 20 ÷ 5 = 4 hours. Working out 10 × 5 ÷ 2 = 25 hours treats it as direct proportion, as if more pumps needed more time. Stopping at 20 gives the total pump-hours, not the number of hours. Working out 10 − (5 − 2) = 7 hours subtracts the extra number of pumps straight from the number of hours, treating pumps and hours as the same kind of quantity. 5 pumps take 4 hours.
- (b) 4/3 — Work out the number of bananas: 3/4 of 16 = 12. Form the fraction 16/12 (apples over bananas); both numbers share a factor of 4, so 16 ÷ 4 = 4 and 12 ÷ 4 = 3, giving 4/3. 3/4 comes from giving the fraction that was already stated in the question (bananas as a fraction of apples), instead of inverting it. 4/1 comes from reading '3/4 of the apples' as 'the apples reduced by 3/4', giving only 4 bananas, then 16/4 = 4. 4/7 comes from comparing the apples with the total number of pieces of fruit (16/28), instead of with the bananas alone.
- (b) The ratio C : m is not constant because the formula includes a fixed charge of £3 as well as the charge per mile. — For the ratio C : m to stay constant, C must be directly proportional to m, i.e. C = km with no constant term. Because of the +3 fixed charge, C is not directly proportional to m: for example m = 1 gives C = 5.5 (ratio 5.5 : 1), while m = 10 gives C = 28 (ratio 2.8 : 1) — the ratio has changed.
- (c) 5 m — The scale 1 : 100 means 1 cm on the map represents 100 cm in real life. The path is 5 cm on the map, so the real length is 5 × 100 = 500 cm. Convert to metres: 500 cm = 5 m. Dividing instead of multiplying, 5 ÷ 100 = 0.05, gives 0.05 m — the scale must be used to make the real object bigger than the map, not smaller. Leaving the answer as 500 without converting to metres and calling it 500 m mistakes centimetres for metres. Using a scale of 1 : 1000 instead of the given 1 : 100 gives 5 × 1000 = 5000 cm = 50 m, ten times too large.
- (d) 40 cm — Method: convert the real length to centimetres, then divide by the scale factor. Working: 10 m = 1000 cm. 1000 ÷ 25 = 40 cm. Wrong options: 0.4 cm comes from dividing 10 by 25 without converting metres to centimetres first; 25000 cm comes from multiplying instead of dividing (1000 × 25); 4 cm comes from converting 10 m to 100 cm (using ×10 instead of ×100) before dividing.
- (c) 48 mm — Method: extension = k × force, where k = extension ÷ force. Working: k = 12 ÷ 5 = 2.4 mm per N. At 20 N: extension = 2.4 × 20 = 48 mm. Wrong options: 32 mm comes from adding the extension and force numbers instead of scaling (12 + 20); 3 mm comes from treating the relationship as inverse proportion (12 × 5 ÷ 20); 36 mm comes from using an incorrect scale factor of 3 between the forces instead of the correct factor of 4 (20 ÷ 5).
- (b) 12 cm — Method: height:width = 3:2 means both lengths are built from parts of the same size, so write 3:2 = 18:x, find one part and multiply by the number of parts in the width. Working: the height is 3 parts and measures 18 cm, so one part is 18 ÷ 3 = 6 cm; the width is 2 parts, so 2 × 6 = 12 cm. Answer: 12 cm. The distractors: 27 cm comes from using the ratio the wrong way round, 18 ÷ 2 × 3, which makes the width longer than the height even though 2 is the smaller part; 6 cm is the value of one part, given as the width instead of being doubled; 17 cm comes from treating the ratio as a difference — 3 − 2 = 1, so 1 cm is taken off the height — but a ratio scales the lengths, it does not subtract from them.
- (d) 120 g — Mass = density × volume, so 0.8 × 150 = 120 g. Working out 150 ÷ 0.8 = 187.5 divides by the density instead of multiplying, the wrong way round for finding a mass. Working out 150 × 8 = 1200 misplaces the decimal point in the density, treating 0.8 g/cm³ as 8 g/cm³. Working out 150 − 0.8 = 149.2 simply subtracts the density from the volume, which does not give a mass. The piece of wood has a mass of 120 g.
- (a) 18/25 — First find the new number of rose bushes: 90 × 1.2 = 108 (a 20% increase multiplies by 1.2). Then write 108 over 150 and divide top and bottom by 6 to get 18/25. Choosing 3/5 comes from using the original 90 rose bushes without applying the 20% increase (90/150 = 3/5). Choosing 25/18 comes from writing the number of lavender bushes over the new number of rose bushes, the wrong way round. Choosing 3/25 comes from multiplying 90 by 0.2 instead of 1.2, finding only the increase (18) rather than the new total, then writing 18/150 = 3/25.
- (d) 7/5 — The number of unbroken crayons is 60 − 25 = 35. The comparison is with the broken crayons, so the broken crayons are the denominator: 35/25. Both parts divide by 5: 35 ÷ 5 = 7 and 25 ÷ 5 = 5. The fraction is 7/5, which is greater than 1 because there are more unbroken crayons than broken ones.
- (d) 1200 cm — Method: multiply the drawing length by the scale factor. Working: 4 × 300 = 1200 cm. Wrong options: 0.013 cm comes from dividing instead of multiplying (4 ÷ 300); 304 cm comes from adding the scale factor to the drawing length instead of multiplying; 600 cm comes from using half the scale factor (150) instead of 300.
- (a) £1,000 — Method: find the increase, then add it to the original price; the multiplier 1.25 does both steps at once. Working: 25% is one quarter, so 25% of £800 = £800 ÷ 4 = £200, and £800 + £200 = £1,000. Answer: £1,000. The distractors: £200 is the increase on its own, not the new price; £825 comes from adding £25 to £800, treating the 25% as £25; £600 comes from taking the 25% off the price instead of adding it on.
Build your own mix at the worksheet builder.