Printable · GCSE Foundation · ages 14-16
Ratio, proportion and rates of change worksheet — GCSE Foundation
Fifteen questions across the ratio, proportion and rates of change statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Ratio, proportion and rates of change worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (d) 2:3 — The highest common factor of 20 and 30 is 10. Divide both parts of the ratio by 10: 20 ÷ 10 = 2 and 30 ÷ 10 = 3, so 20 : 30 = 2 : 3. Dividing by 5 instead of the highest common factor gives 4 : 6, which still shares a common factor of 2, so it is not fully simplified. Dividing only the first part by 10 and leaving the second part unchanged gives 2 : 30, which is not equivalent to the original ratio. Swapping the order of the two parts gives 3 : 2, the ratio the wrong way round.
- (d) Yes, because 4 × 9 = 6 × 6 — Method: two ratios are equal when their cross-products are equal, so multiply the first part of each ratio by the second part of the other. Working: 4 × 9 = 36 and 6 × 6 = 36; the two products match, so the ratios are equal, and simplifying both to 2:3 shows the same thing. Answer: yes, because 4 × 9 = 6 × 6. The distractors: the reason that the number 6 appears in both ratios reaches the right verdict from a surface match, since a figure shared by two ratios says nothing about equivalence — 4:6 and 6:5 share a 6 and are not equal; the reason built on 9 − 6 and 6 − 4 compares the differences inside each ratio, 3 against 2, which is additive thinking and ends at a verdict of no; the reason built on 4 × 6 and 6 × 9 multiplies the two parts of each ratio together instead of across the pair, giving 24 against 54 and again a verdict of no.
- (c) 150% — Percentage = (180,000 ÷ 120,000) × 100 = 150%.
- (a) 3/8, 41%, 0.43 — Method: convert every value to a decimal so they can be compared on the same scale, then order them. Working: 3/8 = 0.375, 41% = 0.41, and 0.43 stays as 0.43, so from smallest to largest the decimals are 0.375, 0.41, 0.43, giving the order 3/8, 41%, 0.43. Answer: 3/8, 41%, 0.43. The order 3/8, 0.43, 41% comes from comparing 0.43 and 41% as raw digits (43 versus 41) without converting 41% into the decimal 0.41 first, wrongly placing 0.43 before 41%. The order 0.43, 41%, 3/8 comes from placing the values in completely reversed order, from largest to smallest instead of smallest to largest. The order 41%, 0.43, 3/8 comes from ordering the values by their TYPE (percentage, then decimal, then fraction) rather than by their actual size.
- (a) 15:1 — Write the ratio distance : petrol using the numbers in the question: 90 : 6. Divide both parts by their highest common factor, 6, to give 15 : 1. (1:15 comes from writing the ratio the wrong way round, petrol : distance. 5:2 comes from dividing only the distance by 6 and leaving the 6 litres unchanged, giving 15:6, which does simplify to 5:2 — the error is the step before, because both parts of a ratio must be divided by the same number. 14:1 comes from subtracting at the first step instead of dividing, 90 − 6 = 84, and then writing 84 : 6 and dividing both parts by 6 to get 14 : 1; subtracting has no part in simplifying a ratio.)
- (b) 9 m/s — The gradient of line P is 21 ÷ 3 = 7, so P has a rate of 7 m/s. The gradient of line Q is 45 ÷ 5 = 9, so Q has a rate of 9 m/s. Because 9 is greater than 7, line Q is the steeper line, with gradient 9 m/s. Taking line P's gradient instead of Q's gives 7 m/s, the less steep line. Subtracting the two lines' coordinates directly, (45 − 21) ÷ (5 − 3) = 24 ÷ 2 = 12 m/s, mixes points from different lines rather than using one line's own two points. Adding the two gradients, 7 + 9 = 16 m/s, treats 'steeper' as a total rather than a comparison.
- (d) 1:4 — Convert 1.4 l to millilitres: 1.4 l = 1400 ml. The ratio is 350 : 1400. Divide both parts by 350: 350 ÷ 350 = 1 and 1400 ÷ 350 = 4, giving 1 : 4. Misreading 1.4 l as 14 (moving the decimal point) gives 350 : 14, which simplifies to 25 : 1 — a very different, implausible ratio. Dividing by 175 instead of 350 gives 2 : 8, which still shares a common factor of 2, so it is not fully simplified. Swapping the order gives 4 : 1, litres to millilitres the wrong way round.
- (a) 8:1 — Multiply both parts of the ratio by 4 to clear the fraction: 2 × 4 = 8 and 1/4 × 4 = 1, giving 8 : 1. Getting 1 : 8 has the two parts the wrong way round. Getting 2 : 4 comes from writing down the denominator of the fraction (4) as the second part instead of multiplying through by it. Getting 8 : 4 comes from multiplying only the first part of the ratio by 4 and leaving the second part as the fraction's denominator.
- (c) 1 : 16 — Work out each area before comparing. Square P has area 3 × 3 = 9 cm². Square Q has area 12 × 12 = 144 cm². The ratio of the areas is 9 : 144, and both parts divide by 9: 9 ÷ 9 = 1 and 144 ÷ 9 = 16, giving 1 : 16. Notice that the sides are in the ratio 1 : 4, and the areas are in the ratio of the squares of those parts, which is what always happens when a length is scaled. Stopping at 1 : 4 would compare the sides and never the areas, and cubing the parts to reach 1 : 64 is the rule for volumes rather than for areas. The order matters too: the question names square P first, so its area must be the first part of the ratio.
- (c) 2:5 — Divide both numbers by their highest common factor, 4: 8 ÷ 4 = 2 and 20 ÷ 4 = 5, giving the ratio 2:5. Choosing 5:2 comes from writing the ratio the wrong way round, as cupcakes to muffins. Choosing 2:3 comes from using the difference between the two amounts (20 − 8 = 12) as the second part of the ratio instead of the number of cupcakes, then simplifying 8:12 by dividing by 4. Choosing 2:7 comes from comparing the muffins with the total number of items on the tray (8 out of 28) instead of comparing them with the cupcakes.
- (d) 13/10 — First find the selling price: £150 + £45 = £195. Put the selling price over the cost price: 195/150. Divide both numbers by their highest common factor, 15: 195÷15 = 13, 150÷15 = 10, giving 13/10. (10/13 comes from writing the prices the wrong way round. 3/10 is just the profit written as a fraction of the cost price, 45/150, not the selling price. 13/23 comes from comparing the selling price to the combined total of the cost price and the selling price, 195/345.)
- (d) 25% — Method: percentage decrease = decrease ÷ original amount × 100. Working: the reduction is £60 − £45 = £15, and 15 ÷ 60 = 0.25, so 0.25 × 100 = 25%. Answer: 25%. The distractors: 15% comes from quoting the £15 reduction as though pounds and per cent were the same thing; 33% comes from dividing the £15 by the new price £45 instead of by the original £60, which gives 33% to the nearest per cent; 75% is the new price written as a percentage of the old one, which is what is still paid rather than what has been taken off.
- (d) 60 — Method: 75% is three quarters, so divide by 4 to find one quarter and then multiply by 3. Working: 80 ÷ 4 = 20 for one quarter, and 3 × 20 = 60. Answer: 60 milk chocolates. The distractors: 20 is one quarter of 80, which is 25% and not 75%; 55 comes from subtracting 25 from 80 rather than taking 25% of 80 away from it; 75 comes from quoting the percentage itself as a number of chocolates.
- (c) 40 cm — First find the real pitch length using Plan A's scale: 8 × 1000 = 8000 cm. Now find its length on Plan B using Plan B's scale: 8000 ÷ 200 = 40 cm. Assuming both plans use the same scale and leaving the length as 8 cm ignores that Plan B has a different scale. Using the ratio of the two scales upside down, 200 ÷ 1000 = 0.2, then 8 × 0.2 = 1.6, gives 1.6 cm — Plan B is drawn to a larger scale than Plan A, so lengths on it should be bigger, not smaller. Dividing by 2000 instead of 200 gives 4 cm, ten times too small.
- (a) 160 g — Method: use the ratio 20:100 to find the mass of the whole solution from the mass of acid, then take the acid away to leave the water. Working: 20:100 = 40:m, and 40 ÷ 20 = 2, so m = 2 × 100 = 200 g of solution; the water is 200 − 40 = 160 g. Answer: 160 g. The distractors: 200 g is the mass of the whole solution, which is the middle step and includes the acid the question asks you to leave out; 8 g comes from working out 20% of 40 g, which treats the 40 g as the whole solution rather than as the 20% inside it; 10 g comes from reading the 40 g as the 80% that is water, giving a solution of 50 g and a difference of 50 − 40.
Build your own mix at the worksheet builder.