Printable · GCSE Foundation · ages 14-16
Ratio, proportion and rates of change worksheet — GCSE Foundation
Fifteen questions across the ratio, proportion and rates of change statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Ratio, proportion and rates of change worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (c) 1 : 25 — The radii are in the ratio 4 : 20, which simplifies to 1 : 5. Areas scale with the square of the length ratio, so the area ratio is 1² : 5² = 1 : 25. Giving 1 : 5 uses the radius ratio without squaring it. Giving 1 : 10 doubles the radius ratio instead of squaring it. Giving 25 : 1 has the areas the right way round for larger to smaller, not smaller to larger.
- (c) £478.40 — Method: apply the percentage increase, then apply the percentage decrease to the new price. Working: after the increase, the laptop costs £520 × 1.15. Multiplying this result by 0.80 gives the final price, £478.40. Answer: £478.40. £494 comes from combining the two percentages into a single net change (15% − 20% = −5%) and applying it directly, £520 × 0.95 = £494, instead of applying the two changes one after the other. £416 comes from applying only the 20% decrease to the original price, £520 × 0.80 = £416, forgetting the increase entirely. £598 comes from applying only the 15% increase and stopping there, forgetting to apply the decrease at all.
- (b) 1:200000 — '1 cm represents 2 km' means 1 cm on the map is 2 km in real life. Convert 2 km into centimetres, the same unit as the 1: 2 km = 2000 m = 200 000 cm. So the scale is 1 : 200 000. Converting only as far as metres gives 1 : 2000 — the conversion to centimetres was never finished. Losing a zero in the conversion gives 1 : 20 000, ten times too small. Writing 1 : 2 without converting units at all compares 1 cm to 2 km directly, which is not a valid ratio since the units do not match.
- (a) f = 4s — Method: in the ratio 4 : 1 the sugar is 1 part, so one part weighs s grams, and the flour is 4 of those same parts. Working: one part is s, so four parts are 4 × s, giving f = 4s; as a check, if s = 3 then the flour is 4 × 3 = 12 g, and 12 : 3 does simplify to 4 : 1. Answer: f = 4s. The distractors: f = s/4 uses the ratio the wrong way round, as though the flour were 1 part and the sugar 4; f = s + 3 comes from reading the ratio as a difference, 4 − 1 = 3, and adding that difference instead of multiplying; f = 5s uses 4 + 1 = 5, the total number of parts, as the multiplier, but 5 parts is the whole mixture and not the flour on its own.
- (c) 2:5 — Divide both numbers by their highest common factor, 4: 8 ÷ 4 = 2 and 20 ÷ 4 = 5, giving the ratio 2:5. Choosing 5:2 comes from writing the ratio the wrong way round, as cupcakes to muffins. Choosing 2:3 comes from using the difference between the two amounts (20 − 8 = 12) as the second part of the ratio instead of the number of cupcakes, then simplifying 8:12 by dividing by 4. Choosing 2:7 comes from comparing the muffins with the total number of items on the tray (8 out of 28) instead of comparing them with the cupcakes.
- (b) 3 : 5 — The highest common factor of 27 and 45 is 9. Divide both parts by 9: 27 ÷ 9 = 3 and 45 ÷ 9 = 5, giving 3 : 5. Giving 9 : 15 divides by 3, a common factor but not the highest one, so it is not yet in simplest form. Giving 5 : 3 swaps the order of the two parts. Giving 27 : 45 has not been simplified at all.
- (a) 4 — The length scale factor, cubed, gives the volume scale factor: L³ = 64, so L = the cube root of 64 = 4, since 4 × 4 × 4 = 64. 64 comes from using the volume scale factor itself as the length scale factor, without taking a root at all. 8 comes from taking the square root of 64 instead of the cube root — that would be the correct root for an area scale factor, not a volume one. 32 comes from halving the volume scale factor (64 ÷ 2), instead of cube-rooting it.
- (b) −1% — Method: write each change as a multiplier and multiply them. A 10% fall is × 0.9 and a 10% rise is × 1.1. Working: 0.9 × 1.1 = 0.99, so the final price is 99% of the original, which is 1% less. Answer: an overall change of −1%. The distractors: 0% comes from assuming a 10% fall and a 10% rise cancel — they do not, because the rise is 10% of a smaller amount; +1% has the size right but the sign wrong, from reading the multiplier 0.99 as 1% above 1 instead of 1% below it; −2% comes from finding the 1% fall and then counting it once for each of the two changes.
- (c) 250 miles — Find the distance travelled in 1 hour: 150 ÷ 3 = 50 miles. Multiply by 5 hours: 50 × 5 = 250 miles. Giving 300 miles doubles the original distance (150 × 2 = 300) using a scale factor of 2 instead of the correct 5 ÷ 3. Giving 200 miles adds only one extra hour's distance, 50, instead of the two extra hours actually needed (150 + 50 = 200, rather than 150 + 100). Giving 90 miles divides by the scale factor instead of multiplying (150 × 3 ÷ 5 = 90).
- (d) 2 3/4 — Divide 22 by 8: 8 goes into 22 twice, with a remainder of 6, so 22/8 = 2 and 6/8 left over. Since 6/8 simplifies to 3/4 (dividing both by 2), the blue beads are 2 3/4 of the red beads. 2 5/8 comes from miscalculating the remainder as 22 − 16 = 5 instead of 6. 2 3/11 comes from writing the leftover 6 over the original 22 instead of over the 8, giving 6/22, then simplifying that to 3/11. 1 3/8 comes from halving only the numerator of 22/8 to get 11/8, without halving the denominator too, giving the mixed number 1 3/8.
- (a) £2.80 — Method: find the cost of one pencil first, then use it to find the cost of 7 pencils. Working: £1.20 ÷ 3 = £0.40 for one pencil, and £0.40 × 7 = £2.80. So 7 pencils cost £2.80. Distractor £8.40 comes from multiplying £1.20 by 7 without first dividing by 3 to find the cost of one pencil. Distractor £1.20 comes from assuming the price stays the same no matter how many pencils are bought. Distractor £0.40 is the cost of one pencil, found correctly but never multiplied by 7.
- (b) 1 : 3 — Write the two lengths as a ratio: 5 : 15. Divide both parts by their highest common factor, 5, to give 1 : 3. Writing 3 : 1 swaps the order, comparing B to A instead of A to B. Leaving the ratio as 5 : 15 has not been simplified. Finding 1 : 2 comes from comparing the smaller length to the gap between the two lengths (15 − 5 = 10, then wrongly simplifying 5 : 10), not from comparing the two lengths themselves.
- (b) 1 : 2.25 — Method: to write a ratio in the form 1 : n, divide both parts by the first part. Working: 4 ÷ 4 = 1 and 9 ÷ 4 = 2.25, so 4 : 9 = 1 : 2.25. Working out 9 ÷ 4 = 2.25 correctly but then writing it as the first part gives 2.25 : 1, the two parts the wrong way round. Subtracting 9 − 4 = 5 gives 1 : 5, confusing the difference between the parts with the ratio. Multiplying 4 × 9 = 36 gives 1 : 36, confusing the product of the parts with the ratio.
- (d) 40 cm — Method: convert the real length to centimetres, then divide by the scale factor. Working: 10 m = 1000 cm. 1000 ÷ 25 = 40 cm. Wrong options: 0.4 cm comes from dividing 10 by 25 without converting metres to centimetres first; 25000 cm comes from multiplying instead of dividing (1000 × 25); 4 cm comes from converting 10 m to 100 cm (using ×10 instead of ×100) before dividing.
- (d) 1.5 — Method: the length scale factor is the square root of the area scale factor, not the area scale factor itself. Working: the area scale factor is 45 ÷ 20 = 2.25, and the square root of 2.25 is 1.5. Answer: 1.5. Nadia's answer, 2.25, is the AREA scale factor — she never took the square root to get back to the length scale factor. 4.5 comes from doubling the area scale factor instead of taking its square root. 0.67 comes from taking the square root in the wrong direction, finding the scale factor from the larger rug to the smaller rug instead of the other way round.
Build your own mix at the worksheet builder.