Printable · GCSE Foundation · ages 14-16
Ratio, proportion and rates of change worksheet — GCSE Foundation
Fifteen questions across the ratio, proportion and rates of change statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Ratio, proportion and rates of change worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (c) 500 — Pressure = force ÷ area = 250 ÷ 0.5 = 500 pascals. Getting 125 comes from multiplying the force by the area instead of dividing (250 × 0.5 = 125). Getting 249.5 comes from subtracting the area from the force instead of dividing. Getting 50 comes from misreading the area as 5 m² instead of 0.5 m² and dividing 250 by 5.
- (a) 15:1 — Write the ratio distance : petrol using the numbers in the question: 90 : 6. Divide both parts by their highest common factor, 6, to give 15 : 1. (1:15 comes from writing the ratio the wrong way round, petrol : distance. 5:2 comes from dividing only the distance by 6 and leaving the 6 litres unchanged, giving 15:6, which does simplify to 5:2 — the error is the step before, because both parts of a ratio must be divided by the same number. 14:1 comes from subtracting at the first step instead of dividing, 90 − 6 = 84, and then writing 84 : 6 and dividing both parts by 6 to get 14 : 1; subtracting has no part in simplifying a ratio.)
- (b) 2 : 5 — 40% as a fraction is 40/100 = 2/5, so a = (2/5)b, giving a : b = 2 : 5. Swapping the two numbers gives 5 : 2, which is the ratio b : a instead. Treating 40% as the fraction of the total (a + b) rather than of b alone gives a : (a + b) = 2 : 5, which rearranges to a : b = 2 : 3 — a different statement from the one in the question. Inverting that same mistaken ratio gives 3 : 2.
- (d) 5 — The gradient equals the amount gained divided by the time taken: 15 ÷ 3 = 5 litres per minute.
- (d) £120 — Method: add the parts of the ratio, divide the prize by the number of parts to find the value of one part, then multiply by the parts in the share asked for. Working: 2 + 3 + 4 = 9 parts, £360 ÷ 9 = £40 for one part, and the share asked for is 3 parts, so 3 × £40 = £120. Answer: £120. The distractors: £40 is the value of one part rather than of a 3-part share; £80 is the 2-part share; £160 is the 4-part share, which is what a candidate reaches by picking the largest share instead of the one the question names.
- (c) 1.2 — Add the parts of the ratio: 6 + 1 = 7. Divide the total amount by the number of parts: 8.4 ÷ 7 = 1.2 litres, which is the value of one part and also the amount of syrup, since syrup is 1 part. (7.2 litres is the amount of water, using 6 parts instead of 1. 1.4 comes from dividing 8.4 by 6 — the water's part of the ratio — instead of dividing by the total number of parts, 7. 0.84 comes from dividing 8.4 by 10 instead of by 7.)
- (a) £40.32 — Find the cost per square metre from the rate given: £14.40 ÷ 20 = £0.72 per m². Then multiply by the area to be covered: £0.72 × 56 = £40.32. Working out 14.40 × 20 ÷ 56 ≈ £5.14 uses the ratio the wrong way round, scaling down as if 56 m² needed less paint than 20 m². Stopping at £0.72 only gives the cost per square metre, not the cost for the whole wall. Working out 14.40 + (56 − 20) = £50.40 adds the extra square metres straight onto the cost in pounds, treating square metres and pounds as the same kind of quantity. Covering 56 m² costs £40.32.
- (a) 0.8 — The gradient of a line through the origin is the y-coordinate of a point divided by its x-coordinate: 20 ÷ 25 = 0.8. Choosing 1.25 comes from dividing the wrong way round, 25 ÷ 20. Choosing 20 comes from reading off the cost at the point instead of dividing it by the number of miles. Choosing 5 comes from subtracting the two coordinates (25 − 20) instead of dividing them.
- (a) 20% — Method: a percentage concentration compares the sugar with the whole solution, so add the two masses to get the mass of solution and then scale the ratio of sugar to solution to a denominator of 100. Working: the solution has a mass of 200 + 50 = 250 g; sugar:solution = 50:250, and scaling to per 100 gives 50 ÷ 250 × 100 = 20, so the ratio is 20:100. Answer: 20%. The distractors: 25% comes from comparing the sugar with the 200 g of water, 50:200, rather than with the whole solution; 80% is the percentage of the solution that is water, 200:250, which answers for the wrong part of the mixture; 0.2% comes from working out 50 ÷ 250 = 0.2 and writing that decimal down as a percentage without multiplying by 100.
- (a) 20 litres per minute — Method: the gradient is the change in the vertical value divided by the change in the horizontal value, and its units are the vertical unit for each one of the horizontal unit. Working: from (2, 50) to (6, 130) the volume changes by 130 − 50 = 80 litres and the time changes by 6 − 2 = 4 minutes, so the gradient is 80 ÷ 4 = 20, measured in litres for each minute. Answer: 20 litres per minute. The distractors: 25 litres per minute comes from using one point on its own, 50 ÷ 2, which assumes the line starts at the origin when the tank already held 50 litres at 2 minutes; 0.05 litres per minute comes from dividing the change in time by the change in volume, 4 ÷ 80, which gives the time for each litre but is then labelled as litres for each minute; 20 minutes for each litre has the right value with the units the wrong way round, and a tank that needed 20 minutes to gain a single litre would be filling far more slowly than this one.
- (d) 2 3/4 — Divide 22 by 8: 8 goes into 22 twice, with a remainder of 6, so 22/8 = 2 and 6/8 left over. Since 6/8 simplifies to 3/4 (dividing both by 2), the blue beads are 2 3/4 of the red beads. 2 5/8 comes from miscalculating the remainder as 22 − 16 = 5 instead of 6. 2 3/11 comes from writing the leftover 6 over the original 22 instead of over the 8, giving 6/22, then simplifying that to 3/11. 1 3/8 comes from halving only the numerator of 22/8 to get 11/8, without halving the denominator too, giving the mixed number 1 3/8.
- (b) 5 litres — Method: adding water changes the total volume but adds no salt, so work out the volume of salt, then the total volume that makes that salt 20% of the mixture, then the extra water. Working: 30% of 10 litres is 0.3 × 10 = 3 litres of salt. For the same 3 litres to be 20% of the new mixture, the new total volume is 3 ÷ 0.2 = 15 litres. The water added is the extra volume, 15 − 10 = 5 litres. Answer: 5 litres. The distractors: 3 litres is the volume of salt in the solution, which is the first step and not what the question asks for; 15 litres is the total volume of the new mixture, which counts the 10 litres already in the container as water that was poured in; 2 litres comes from taking 20% of the original 10 litres, applying the new percentage to the old volume instead of to the new one.
- (a) 1/9 — The ratio copper : tin is 9:1, so write tin over copper: 1/9. (9/1 comes from writing the ratio the wrong way round, copper over tin. 1/10 comes from comparing the tin to the total mass of the alloy, 1 part out of 10. 9/10 comes from comparing the copper to the total mass of the alloy, 9 parts out of 10.)
- (c) 70 cm — Method: convert the real length to centimetres, then divide by the scale factor. Working: 84 m = 8400 cm. 8400 ÷ 120 = 70 cm. Wrong options: 0.7 cm comes from dividing 84 by 120 without converting metres to centimetres; 1,008,000 cm comes from multiplying instead of dividing (8400 × 120); 7 cm comes from converting 84 m to 840 cm (using ×10 instead of ×100) before dividing.
- (d) 3200 × 0.88³ — A fall of 12% leaves 88% of the value, because 100 − 12 = 88, and 88% written as a decimal multiplier is 0.88. Decay repeats that multiplier once for each year, so over 3 years it is applied three times: 0.88 × 0.88 × 0.88, which is written 0.88³. The calculation is therefore 3200 × 0.88³. Adding the percentages to make a single fall of 36% would be wrong, because each year's fall is taken from a smaller value than the year before.
Build your own mix at the worksheet builder.