Printable · GCSE Foundation · ages 14-16
Ratio, proportion and rates of change worksheet — GCSE Foundation
Fifteen questions across the ratio, proportion and rates of change statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Ratio, proportion and rates of change worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (c) 90 cm² — The perimeter ratio is 30 : 45, which simplifies to 2 : 3, so the larger frame is 1.5 times the perimeter of the smaller one. Areas scale with the square of this length scale factor: 1.5² = 2.25. 40 × 2.25 = 90, so the larger frame has an area of 90 cm². Giving 60 cm² uses the scale factor, 1.5, without squaring it (40 × 1.5 = 60). Giving 135 cm² cubes the scale factor, 1.5³ = 3.375, as if area scaled like a volume (40 × 3.375 = 135). Giving 2.25 cm² is the squared scale factor on its own, without multiplying by the smaller frame's area of 40 cm².
- (b) 8 — Method: the gradient of a straight line is the change in the vertical value divided by the change in the horizontal value between two points on the line. Working: from the origin (0, 0) to (5, 40) the vertical change is 40 − 0 = 40 and the horizontal change is 5 − 0 = 5, so the gradient is 40 ÷ 5 = 8, which here means a cost of £8 for each litre. Answer: 8. The distractors: 0.125 comes from dividing the horizontal change by the vertical change, 5 ÷ 40, which gives litres per pound instead of the gradient; 40 comes from reading off the vertical value of the point and calling it the gradient, ignoring the 5 litres it took to reach that cost; 35 comes from subtracting the two coordinates, 40 − 5, instead of dividing them.
- (b) 16 — Method: substitute x into each equation separately, then subtract the smaller value from the larger. Working: y = 3 × 4 = 12 and z = 7 × 4 = 28, so the difference is 28 − 12 = 16. Answer: 16. The distractors: 4 comes from subtracting the constants, 7 − 3, which is the difference between the two gradients rather than the difference between the values at x = 4; 40 comes from adding the two values, 12 + 28, instead of subtracting them; 28 is the value of z on its own, given instead of being compared with the value of y.
- (d) 1/4 — Method: work out both amounts first, then put the amount named before the word 'of' on top and the amount named after it on the bottom. Working: there are 4 × 5 = 20 apples, so the fraction is 5/20; dividing the numerator and the denominator by 5 gives 1/4. Answer: 1/4. The distractors: 4/1 comes from quoting the multiplier given in the question, which compares the apples with the pears rather than the pears with the apples; 4/5 comes from writing the 20 apples over the 25 fruits altogether, 20/25, a part-to-whole fraction; 5/9 comes from reading '4 times as many' as '4 more than', giving 5 + 4 = 9 apples and the fraction 5/9.
- (c) 1 : 25 — The radii are in the ratio 4 : 20, which simplifies to 1 : 5. Areas scale with the square of the length ratio, so the area ratio is 1² : 5² = 1 : 25. Giving 1 : 5 uses the radius ratio without squaring it. Giving 1 : 10 doubles the radius ratio instead of squaring it. Giving 25 : 1 has the areas the right way round for larger to smaller, not smaller to larger.
- (c) 20% — Method: percentage increase = (increase ÷ original) × 100. Working: the increase is 54 − 45 = 9, and 9 ÷ 45 = 0.2, so the percentage increase is 0.2 × 100 = 20. Answer: 20%. The distractors: 9% comes from writing the actual increase as a percentage; 16.7% comes from dividing by the new value 54 instead of the original 45; 120% is the multiplier 1.2 written as a change rather than the change itself.
- (d) 3200 × 0.88³ — A fall of 12% leaves 88% of the value, because 100 − 12 = 88, and 88% written as a decimal multiplier is 0.88. Decay repeats that multiplier once for each year, so over 3 years it is applied three times: 0.88 × 0.88 × 0.88, which is written 0.88³. The calculation is therefore 3200 × 0.88³. Adding the percentages to make a single fall of 36% would be wrong, because each year's fall is taken from a smaller value than the year before.
- (d) 4.7 km — Multiply the map length by the scale factor: 9.4 × 50 000 = 470 000 cm. Convert to kilometres: 470 000 cm = 4700 m = 4.7 km. Converting only to metres and calling the answer 4700 kilometres mistakes metres for kilometres. Misreading the scale as 1 : 5000 instead of 1 : 50 000, 9.4 × 5000 = 47 000 cm = 0.47 km, is ten times too small. Misplacing the decimal point in 9.4 and effectively using 94, 94 × 50 000 = 4 700 000 cm = 47 km, is ten times too big.
- (b) −1% — Method: write each change as a multiplier and multiply them. A 10% fall is × 0.9 and a 10% rise is × 1.1. Working: 0.9 × 1.1 = 0.99, so the final price is 99% of the original, which is 1% less. Answer: an overall change of −1%. The distractors: 0% comes from assuming a 10% fall and a 10% rise cancel — they do not, because the rise is 10% of a smaller amount; +1% has the size right but the sign wrong, from reading the multiplier 0.99 as 1% above 1 instead of 1% below it; −2% comes from finding the 1% fall and then counting it once for each of the two changes.
- (a) 180 g flour and 120 g butter — The ratio 3 : 2 means flour and butter must scale by the same factor. Scaling both parts by 60 gives 180 g flour and 120 g butter, since 3 × 60 = 180 and 2 × 60 = 120, which is the correct pair. Swapping the amounts gives 120 g flour and 180 g butter, which is in the ratio 2 : 3 — butter to flour, not flour to butter. Scaling the flour by 60 but the butter by only 45 gives 180 g flour and 90 g butter, using two different scale factors on the two parts of the ratio. Scaling the flour by 60 but the butter by 70 gives 180 g flour and 140 g butter, the opposite inconsistency.
- (d) 8 cm — Convert 4 m to centimetres: 4 m = 400 cm. The scale 1 : 50 means the real object is 50 times the plan, so the plan length is the real length divided by 50: 400 ÷ 50 = 8, giving 8 cm. Using the length in metres instead of centimetres, 4 ÷ 50 = 0.08, gives 0.08 cm, far too small to draw. Misplacing a digit in the division gives 80 cm, ten times too big. Multiplying instead of dividing, 400 × 50 = 20 000, gives 20 000 cm — using the scale in the wrong direction, as if going from plan to real life instead of real life to plan.
- (a) 135 km — Method: find the distance travelled on one litre, then scale up to 9 litres. Working: 90 ÷ 6 = 15 km per litre, so 15 × 9 = 135 km. Answer: 135 km. 45 km comes from working out the extra distance for the extra 3 litres (15 × 3) but forgetting to add the original 90 km. 60 km comes from using the ratio the wrong way round, 90 × 6 ÷ 9, instead of finding the rate per litre first. 99 km comes from simply adding the number of litres, 9, onto the original distance, 90, instead of scaling the whole journey.
- (a) 3/8, 41%, 0.43 — Method: convert every value to a decimal so they can be compared on the same scale, then order them. Working: 3/8 = 0.375, 41% = 0.41, and 0.43 stays as 0.43, so from smallest to largest the decimals are 0.375, 0.41, 0.43, giving the order 3/8, 41%, 0.43. Answer: 3/8, 41%, 0.43. The order 3/8, 0.43, 41% comes from comparing 0.43 and 41% as raw digits (43 versus 41) without converting 41% into the decimal 0.41 first, wrongly placing 0.43 before 41%. The order 0.43, 41%, 3/8 comes from placing the values in completely reversed order, from largest to smallest instead of smallest to largest. The order 41%, 0.43, 3/8 comes from ordering the values by their TYPE (percentage, then decimal, then fraction) rather than by their actual size.
- (b) 4:9 — 4 : 9 has no common factor other than 1, so it is already in its simplest form. 6 : 8 can be divided by 2 to give 3 : 4, so it is not simplest. 10 : 15 can be divided by 5 to give 2 : 3, so it is not simplest. 7 : 14 can be divided by 7 to give 1 : 2, so it is not simplest.
- (a) 1000m — Method: kilograms are a smaller unit than tonnes, so change tonnes into kilograms by multiplying by 1000. Working: m tonnes = m × 1000 kg = 1000m kg. So the expression is 1000m. Distractor m/1000 comes from dividing by 1000 instead of multiplying, which would make the number of kilograms smaller than the number of tonnes, the wrong way round. Distractor 1000 + m comes from adding the conversion factor instead of multiplying by it. Distractor m − 1000 comes from subtracting the conversion factor instead of multiplying by it.
Build your own mix at the worksheet builder.