Printable · GCSE Foundation · ages 14-16
Ratio, proportion and rates of change worksheet — GCSE Foundation
Fifteen questions across the ratio, proportion and rates of change statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Ratio, proportion and rates of change worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (b) 75 cm² — Areas of similar shapes are in the ratio of the squares of their lengths. Squaring both parts of 3 : 5 gives an area ratio of 9 : 25, so the larger area is 25/9 of the smaller one. Working with the smaller area: 27 ÷ 9 = 3, and 3 × 25 = 75. The area of the larger rectangle is 75 cm².
- (b) 1:12 — C = 12n means that for every 1 pen there are 12 pence of cost, so n : C = 1 : 12, and the highest common factor of 1 and 12 is 1, so this is already in its simplest form. Writing C : n instead of n : C gives 12 : 1, the ratio the wrong way round. Reading C = 12n as '12 more than n' instead of '12 times n', so n = 1 gives C = 13, gives 1 : 13, from adding instead of multiplying. Choosing n = 12, so C = 12 × 12 = 144, gives the correct pair of values n : C = 12 : 144, but the ratio the right way round left unsimplified — 12 and 144 share a common factor of 12, which has not been cancelled.
- (b) 1:25 — Write the ratio time : volume using the numbers in the question: 8 : 200. Divide both parts by their highest common factor, 8, to give 1 : 25. (25:1 comes from writing the ratio the wrong way round, volume : time. 8:25 comes from dividing only the volume by 8 and leaving the time unchanged. 25:8 is that same mistake written the wrong way round.)
- (d) 20 — Gradient = change in T ÷ change in t = (140 − 60) ÷ (6 − 2) = 80 ÷ 4 = 20. A student who subtracts in the wrong order gets −20. A student who divides 80 by 2 instead of 4 gets 40. A student who wrongly treats the line as passing through the origin and uses the point (2, 60) on its own gets 60 ÷ 2 = 30.
- (c) 40 cm — Method: split the total length into the number of parts shown by the ratio, then find the value of the shorter share. Working: the ratio 4:5 has 4 + 5 = 9 parts, so one part is 90 ÷ 9 = 10 cm, and the shorter piece is 4 × 10 = 40 cm. So the shorter piece is 40 cm. Distractor 50 cm is the length of the LONGER piece, not the shorter one. Distractor 45 cm comes from splitting the ribbon into two equal halves, ignoring the ratio. Distractor 10 cm is the value of one part, found correctly but never multiplied by 4.
- (a) 3/5 — The quantity being described goes on the top of the fraction and the quantity it is compared with goes on the bottom. Here the potatoes are written as a fraction of the carrots, so the mass of the potatoes is the numerator and the mass of the carrots is the denominator. Both masses are already in kilograms, so no conversion is needed. This gives 3/5, and since 3 and 5 share no common factor it is already in its simplest form.
- (d) 4/7 — Put the tomato plant's height over the sunflower's height: 80/140. Divide both numbers by their highest common factor, 20: 80÷20 = 4, 140÷20 = 7, giving 4/7. (7/4 comes from writing the heights the wrong way round. 3/7 comes from finding the difference in the heights, 140 − 80 = 60 cm, and writing it as a fraction of the sunflower's height, 60/140. 4/11 comes from comparing the tomato plant's height to the total height of both plants, 80/220.)
- (d) 4:3 — Boys = 28 − 16 = 12. Girls to boys is 16 : 12. The highest common factor of 16 and 12 is 4. Divide both parts by 4: 16 ÷ 4 = 4 and 12 ÷ 4 = 3, so the ratio is 4 : 3. Dividing by 2 instead of 4 gives 8 : 6, which still shares a common factor of 2, so it is not fully simplified. Swapping the order gives 3 : 4, boys to girls instead of girls to boys. Writing girls to the whole class, 16 : 28, simplifies to 4 : 7 — that compares girls to everyone, not girls to boys.
- (a) 0.62 miles — The gradient of the line is the change in miles divided by the change in kilometres: 31 ÷ 50 = 0.62, so 1 kilometre converts to 0.62 miles. Dividing the wrong way round, 50 ÷ 31 = 1.612..., rounds to 1.61 miles — that finds how many kilometres are in 1 mile, not the reverse. Doubling the gradient, 1.24 miles, comes from using 62 ÷ 50 instead of 31 ÷ 50. Reading off the y-coordinate of the given point without dividing by the x-coordinate gives 31.00 miles, which is the number of miles for 50 kilometres, not for 1 kilometre.
- (a) 1.5 km — Multiply the map length by the scale: 6 × 25 000 = 150 000 cm. Convert to kilometres: 150 000 cm = 1.5 km. Dividing by only 1000 instead of the full conversion when changing units gives 150 km, a hundred times too large. Misreading the scale as 1 : 2500 instead of 1 : 25 000 gives 6 × 2500 = 15 000 cm = 0.15 km, a hundred times too small. Leaving the answer as 150 000 without converting units at all, and calling it 150 000 km, mistakes centimetres for kilometres completely.
- (a) 20% — Method: a percentage is a number of parts per hundred, so divide the numerator by the denominator and multiply by 100. Working: 1 ÷ 5 = 0.2, and 0.2 × 100 = 20; the same result comes from scaling 1/5 to 20/100. Answer: 20%. The distractors: 5% comes from reading the denominator 5 straight off as the percentage; 25% comes from confusing 1/5 with 1/4, the fraction met most often in percentage work; 50% comes from a place value slip in the division, writing 1 ÷ 5 as 0.5 instead of 0.2.
- (d) 2:3 — The highest common factor of 20 and 30 is 10. Divide both parts of the ratio by 10: 20 ÷ 10 = 2 and 30 ÷ 10 = 3, so 20 : 30 = 2 : 3. Dividing by 5 instead of the highest common factor gives 4 : 6, which still shares a common factor of 2, so it is not fully simplified. Dividing only the first part by 10 and leaving the second part unchanged gives 2 : 30, which is not equivalent to the original ratio. Swapping the order of the two parts gives 3 : 2, the ratio the wrong way round.
- (d) 120 g — Mass = density × volume, so 0.8 × 150 = 120 g. Working out 150 ÷ 0.8 = 187.5 divides by the density instead of multiplying, the wrong way round for finding a mass. Working out 150 × 8 = 1200 misplaces the decimal point in the density, treating 0.8 g/cm³ as 8 g/cm³. Working out 150 − 0.8 = 149.2 simply subtracts the density from the volume, which does not give a mass. The piece of wood has a mass of 120 g.
- (b) Provider Y — £21.00 against Provider X's £23.00 — Provider X's gradient is (35 − 15) ÷ 100 = 0.2, so cost = 15 + 0.2 × 40 = 15 + 8 = £23.00. Provider Y's gradient is (45 − 5) ÷ 100 = 0.4, so cost = 5 + 0.4 × 40 = 5 + 16 = £21.00. £21.00 is less than £23.00, so Provider Y is cheaper: 'Provider Y — £21.00 against Provider X's £23.00'. Getting both costs right but naming Provider X as cheaper compares the two numbers the wrong way round — £23.00 is more than £21.00, not less. Comparing only the fixed fees, £15.00 and £5.00, ignores the cost of the 40 gigabytes actually used. Reading off the costs at 100 gigabytes, £35.00 and £45.00, directly from the graph answers a different usage from the 40 gigabytes the question asks about.
- (b) 5 litres — Method: adding water changes the total volume but adds no salt, so work out the volume of salt, then the total volume that makes that salt 20% of the mixture, then the extra water. Working: 30% of 10 litres is 0.3 × 10 = 3 litres of salt. For the same 3 litres to be 20% of the new mixture, the new total volume is 3 ÷ 0.2 = 15 litres. The water added is the extra volume, 15 − 10 = 5 litres. Answer: 5 litres. The distractors: 3 litres is the volume of salt in the solution, which is the first step and not what the question asks for; 15 litres is the total volume of the new mixture, which counts the 10 litres already in the container as water that was poured in; 2 litres comes from taking 20% of the original 10 litres, applying the new percentage to the old volume instead of to the new one.
Build your own mix at the worksheet builder.