Printable · GCSE Foundation · ages 14-16
Scatter graphs, correlation and lines of best fit worksheet — GCSE Foundation
Fifteen questions on "scatter graphs, correlation and lines of best fit" — DfE statement S6. Print it, or print three versions so neighbours cannot copy by letter; the key gives the letter for each version.
Calculator
Answer key: Scatter graphs, correlation and lines of best fit worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (b) Positive correlation — Method: the type of correlation is named from the direction the points take as the scatter graph is read from left to right. Working: the points rise from left to right, so as the arm span read on the horizontal axis increases, the height read on the vertical axis increases as well; two quantities that increase together show positive correlation. Answer: positive correlation. The distractors: negative correlation comes from naming the direction the wrong way round, since a negative correlation needs the points to fall as the graph is read from left to right; no correlation comes from treating points that are spread out rather than sitting exactly on a line as though they showed no relationship; direct proportion comes from confusing a rising trend with proportion, which would additionally need the line through the points to pass through the origin and would mean doubling one quantity doubles the other.
- (a) A straight line sloping down from left to right — Method: a line of best fit is a straight line drawn to follow the trend of the points, so its slope is decided by the direction of the relationship between the two quantities. Working: as the price rises, the satisfaction score falls, so the points start high on the left of the graph and finish low on the right; the straight line that follows them therefore slopes downwards as the graph is read from left to right, which is the line of a negative correlation. Answer: a straight line sloping down from left to right. The distractors: a line sloping up comes from reading a falling relationship as a rising one; a horizontal line comes from expecting no correlation, since a horizontal line says the satisfaction score does not change as the price changes; a curve passing through every point comes from thinking a line of best fit has to touch all of the plotted points, when it is a single straight line drawn through the middle of them.
- (a) No, the size of the fire affects both of the quantities — Method: correlation says that two quantities change together; a claim that one of them produces the other is a further claim, and it needs evidence that a scatter graph on its own cannot give. Working: the graph does show strong positive correlation, so more engines did go with greater damage. But neither quantity was set by the researchers: both were decided by how large the fire was. A large blaze brings many appliances and also destroys a great deal, while a small one brings few and destroys little, so a third quantity is driving both of the recorded ones. Answer: no, because the size of the fire affects both of the quantities. The distractors: saying the correlation is negative contradicts the graph, which shows the two quantities rising together, and reaching the right verdict from a false reading of the data is not the reason the mark is for; saying that strong positive correlation shows one quantity causes the other is the assumption the question exists to test, and no strength of correlation can establish cause; saying the points lie close to the line of best fit describes how strong the correlation is, and strength and cause are different matters entirely.
- (b) On average a plant grew 1.5 cm taller for each extra day — Method: in the equation of a line, the number multiplying x is the gradient, and a gradient states the change in y produced by an increase of 1 in x, read in the units of the two axes. Working: here x is measured in days and y in centimetres, so the gradient 1.5 carries the units centimetres per day. Testing it on the line, 5 days gives 1.5 × 5 + 4 = 11.5 cm and 6 days gives 1.5 × 6 + 4 = 13 cm, a rise of 1.5 cm for the one extra day. Answer: on average a plant grew 1.5 cm taller for each extra day of watering. The distractors: 1.5 cm as the height before any watering is the value of y when x is 0, which is the other number in the equation, 4 cm, so this swaps the gradient and the intercept; 1.5 cm as the gap between the tallest and the shortest plant reads the gradient as a range, when a range is a difference between two of the 16 plants and a gradient is a rate; 1.5 days for each extra centimetre inverts the rate, dividing days by centimetres instead of centimetres by days, and the line gives 1 cm of growth in two thirds of a day.
- (a) x = 0 gives y = −20: a negative number sold — The y-intercept is the value the line predicts when x = 0: y = 3 × 0 − 20 = −20. A kiosk cannot sell a negative number of ice creams, so this is not a sensible estimate. The 3 in the equation is the gradient, not the intercept, so an option claiming x = 0 gives y = 3 has swapped the two numbers around — substituting x = 0 makes the 3x term equal 0, leaving −20, not 3. The danger of extrapolating to very high temperatures is a real issue with this line, but it is a different issue from the y-intercept, so it does not answer this question. And whether x = 0 could occur on a trading day is beside the point: the model still makes that prediction, and it is the prediction itself, −20, that is impossible.
- (a) Minutes a candle has burned and length remaining — As a candle burns for longer, less of it remains, so these two variables move in opposite directions as one increases — that is negative correlation. A pupil's shoe size generally increases as they get older, so age and shoe size show positive correlation, not negative, since both rise together. A football team's shirt colour is not a numerical quantity linked to how many matches it wins, so shirt colour and number of wins show no correlation at all. The number of letters in a pupil's name has no real connection to their ability in maths, so that pair also shows no correlation.
- (b) At 0 guests, the model predicts 2 m of table — The y-intercept of a line of best fit y = mx + c is the value of y when x = 0. Here y = 0.5 × 0 + 2 = 2, so the line predicts a table length of 2 m when there are 0 guests. The 2 m does not grow as more guests arrive — that role belongs to the gradient, 0.5 — so an option saying each extra guest adds 2 m has swapped the two numbers around. The 2 is a length in metres, not a number of guests, so an option requiring 2 guests before set-up has misread its units. And the table length does change with x, since it is 0.5x + 2 and not a fixed value, so an option claiming the table is always 2 m ignores the 0.5x term completely.
- (b) £11.00 — 1.5 × 6 = 9, and 9 + 2 = 11, so the estimated cost is £11.00. Choosing £9.00 stops after 1.5 × 6 = 9 and forgets to add the £2. Choosing £12.00 adds the mass and the constant first and then multiplies: 6 + 2 = 8, and 8 × 1.5 = 12.00. Choosing £13.50 swaps the gradient and the intercept, using y = 2x + 1.5 instead: 2 × 6 = 12, and 12 + 1.5 = 13.50.
- (b) 120, unreliable — x = 25 is outside 1 to 12 — The line of best fit is y = 4x + 20. 4 × 25 = 100, and 100 + 20 = 120, so the estimate is y = 120. But x = 25 lies far outside the plotted range of 1 to 12 years, so this is an extrapolation, and the estimate is not reliable. Reaching 100 instead of 120 comes from 4 × 25 = 100 with the intercept of 20 left out — still correctly flagged as unreliable, but the wrong value. Calling the estimate reliable simply because it was calculated correctly, giving 120, wrongly assumes that a correct calculation is automatically trustworthy, ignoring that x = 25 lies far beyond the data actually collected. Reaching 68, from 4 × 12 = 48 and 48 + 20 = 68, substitutes x = 12, the top of the plotted range, instead of the assistant's actual x = 25, and wrongly calls that reliable because 12 lies inside the range.
- (a) The relationship between two variables — Method: what a diagram shows is decided by what has to be known before a single mark can be plotted on it. Working: every point on a scatter graph is plotted from a pair of measurements taken from the same person or object, one read on the horizontal axis and one on the vertical axis; having two measurements for each point is what makes it possible to look for a pattern between them, and the pattern between two variables is what the graph displays. Answer: a scatter graph shows the relationship between two variables. The distractors: the frequency of each single value is what a bar chart or a vertical line chart shows, and it needs only one list of values; how a total is shared between categories is what a pie chart shows; how one quantity changes over time is what a time series line graph shows, in which one of the two axes is always time.
- (d) 20 — 0.4x + 1 = 9, so 0.4x = 9 − 1 = 8, and 8 ÷ 0.4 = 20, so 20 sessions are needed. Choosing 23 divides 9 by 0.4 without first subtracting the 1: 9 ÷ 0.4 = 22.5, rounded up to 23. Choosing 25 subtracts the wrong way, adding the 1 instead of taking it away: 9 + 1 = 10, and 10 ÷ 0.4 = 25. Choosing 2 misplaces the decimal point in the gradient, dividing by 4 instead of by 0.4: 8 ÷ 4 = 2.
- (b) Interpolation — The salary is being estimated for a value of x between 1 and 15, which is inside the range of x-values that were actually plotted, so this is interpolation. Extrapolation would apply if the estimate used a value of x below 1 or above 15, outside the plotted range. Correlation describes the relationship between the two variables, not the reliability of an estimate, and causation describes one variable actually causing a change in the other, which is a different idea altogether — neither is the word being asked for here.
- (d) An outlier from the damaged wing, not the trend. — That bird's point lies a long way from the rising trend followed by every other bird, and its low wingspan is explained by the damaged wing rather than by its age — it is an outlier caused by an unusual factor, not part of the general relationship between age and wingspan, so it should not be used when drawing the line of best fit. Saying every point must be used ignores that an outlier caused by a separate, identifiable factor can rightly be set aside. Saying it shows no correlation ignores that the other 19 points do show a clear rising trend; one outlier does not remove that. Saying it proves the line is inaccurate confuses one unusual bird with a fault in the line itself, when the line correctly describes the trend followed by the rest of the data.
- (c) No, 90 cm is far outside the heights on the graph — Method: a line of best fit describes the trend only across the stretch of data it was drawn through; predicting beyond that stretch is extrapolation, and nothing in the data supports it. Working: the heights used to draw this line run from 150 cm to 180 cm, all of them Year 10 pupils, while 90 cm is 60 cm below the shortest of them and belongs to a two-year-old child, whose build follows no trend the graph has measured. Substituting anyway gives 0.9 × 90 − 85 = −4, a mass of −4 kg, which cannot exist. Answer: no, because 90 cm is far outside the heights on the graph. The distractors: saying a line of best fit cannot be used to predict at all throws away its main purpose, since a prediction made between the plotted values is perfectly sound; saying the line passes through all 20 points misdescribes a line of best fit, which is drawn to follow the trend of the points and will normally pass through few of them; saying the equation works for any value put into it treats an equation fitted to Year 10 heights as a law of nature, and the mass of −4 kg shows what that assumption produces.
- (b) Treat them as outliers and check them before deciding — Method: a point lying a long way from the pattern the rest of the data make is called an outlier, and an outlier is investigated before anything is done with it, because it may be an error in the data or it may be a genuine but unusual case. Working: 48 of the 50 points lie close to the rising line of best fit, so the trend is set by those 48; the two remaining points do not follow it, so they are identified as outliers and checked — a mistake in measuring or recording would be corrected, while a genuine reading would be kept and reported. Answer: treat them as outliers and check them before deciding what to do with them. The distractors: deleting them at once assumes that every point far from the line must be an error, which throws away real data; moving the line so that it passes through them assumes a line of best fit must touch particular points, when it is drawn to follow all 50; taking them as proof that there is no correlation lets two points overturn the pattern that the other 48 agree on.
Build your own mix at the worksheet builder.