Printable · GCSE Foundation · ages 14-16
Statistics worksheet — GCSE Foundation
Fifteen questions across the statistics statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Statistics worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (a) 3/10 — There are 60 − 9 = 51 right-handed pupils. Of the 24 pupils who prefer Art, 6 are left-handed, so 24 − 6 = 18 are right-handed and prefer Art. The probability that a randomly chosen pupil is right-handed and prefers Art is 18/60, which simplifies to 3/10. Giving 2/5 is 24/60 simplified — the probability of preferring Art, ignoring the right-handed condition entirely. Giving 17/20 is 51/60 simplified — the probability of being right-handed, ignoring the Art condition entirely. Giving 1/10 is 6/60 simplified — the probability of being left-handed and preferring Art, the wrong hand condition.
- (a) Equal means; Class A is more consistent, smaller range. — Method: when two data sets share a measure of location, compare a measure of spread to say more about consistency. Working: both classes have the same mean mark, 14, so on average they performed equally well. Class A has the smaller range, 6, so its marks are more tightly grouped around 14 than Class B's marks, which vary by as much as 14. So Class A's marks were more consistent, even though neither class did better on average. Saying Class B did better because it has the bigger range confuses a wide spread with a high score — a big range describes variability, not performance. Saying Class A did better because it has the smaller range makes the same mistake in the other direction: the two classes are tied on the mean, so neither one 'did better'. Saying the classes cannot be compared because their means are equal misses the whole point of also comparing the range. Always compare both an average AND a spread before describing two data sets — either one alone tells only half the story.
- (d) How much the temperatures varied over the seven days — Method: the range of a set of values is the largest value take away the smallest, so it is built from two values only and it measures the gap they leave between them. Working: the largest of the seven readings is 7 °C and the smallest is 2 °C, so the range is 7 − 2 = 5 °C. That figure says the week's readings covered a band 5 °C wide; it names no particular day and no particular reading. Answer: the range describes how much the temperatures varied over the seven days. The distractors: the temperature that occurred most often is the mode, which here is 3 °C, and a mode counts repeats instead of measuring a gap; the temperature typical of the week is an average, and the range is not an average, since it throws away every value lying between the two extremes; the number of different temperatures recorded is 6, a count of how many distinct values appear, while the range is a difference between two of them.
- (d) Correlation is a link; causation is one causing the other — Method: the two words describe different claims — one is about a pattern in the data, the other is about what produced that pattern. Working: correlation says only that two quantities tend to change together, which is something a scatter graph can display; causation says that a change in one quantity actually brings about the change in the other, which needs evidence a scatter graph cannot supply, because a third quantity may be driving both. Answer: correlation is a link between the quantities, while causation is one quantity causing the change in another. The distractors: the statement giving causation as the link and correlation as the cause simply swaps the two words over; the statement that the words mean the same thing is the classic error of reading a correlation as proof of cause; the statement that a scatter graph shows causation but not correlation reverses what a scatter graph can do, since the pattern it displays is exactly the correlation.
- (d) 19 kg — Method: estimate the mean of grouped data by multiplying each class's midpoint by its frequency, adding the four totals, then dividing by the total frequency. Working: the midpoints are 5, 15, 25 and 35 kg. The weighted totals are 11 × 5 = 55, 5 × 15 = 75, 5 × 25 = 125 and 9 × 35 = 315, which add to 570. Dividing by the 30 dogs gives an estimate of 570 ÷ 30 = 19 kg. Giving 5 kg reads off the midpoint of the modal class, 0 < m ≤ 10, the class with the most dogs — but the class with the most dogs is not where the mean falls, and neither is a substitute for actually calculating it. Giving 20 kg averages the four midpoints, (5 + 15 + 25 + 35) ÷ 4, treating every class as equally likely and ignoring that far more dogs are in the lightest and heaviest classes than in the middle two. Giving 570 kg stops after finding the correct weighted total and forgets the final division by the 30 dogs. Always weight each midpoint by its own frequency, and always finish by dividing by the total frequency, not the number of classes.
- (c) 40 minutes — Method: for grouped data, estimate the mean using the midpoint of each class — multiply each midpoint by its frequency, add the results, then divide by the total frequency. Working: the midpoints are 10, 30, 50 and 70 minutes. 10 × 5 = 50. 30 × 10 = 300. 50 × 10 = 500. 70 × 5 = 350. Σfx = 50 + 300 + 500 + 350 = 1200. Σf = 5 + 10 + 10 + 5 = 30. Estimated mean = 1200 ÷ 30 = 40 minutes. Using the upper boundary of each class instead of the midpoint — 20 × 5 = 100, 40 × 10 = 400, 60 × 10 = 600, 80 × 5 = 400 — gives a total of 1500 and an estimate of 1500 ÷ 30 = 50 minutes, too high because a boundary is not the middle of the class. Averaging the frequencies themselves, 5, 10, 10 and 5, ignores the times altogether and gives 7.5. Stopping after Σfx = 1200 without dividing by the total frequency gives a number far too large to be a time in minutes. Always find the midpoint of each class before multiplying by the frequency, and always divide by Σf at the end.
- (d) 23.57 °C — Method: add all seven temperatures, divide by the number of readings and round only at the end. Working: 22 + 24 + 23 + 25 + 26 + 21 + 24 = 165, and 165 ÷ 7 = 23.5714…, which rounds to 23.57 to 2 decimal places. Answer: 23.57 °C. The distractors: 24 °C comes from writing down the mode, the only temperature recorded twice, instead of the mean; 27.5 °C comes from dividing the total by 6 instead of by the 7 days recorded; 5 °C comes from working out the range, 26 − 21, which is a measure of spread and not an average.
- (c) Height 170 cm, mass 65 kg — Method: a point on a scatter graph is written as a pair of coordinates in which the horizontal value is written first and the vertical value second, so each value is matched to the quantity named on its own axis. Working: in (170, 65) the value 170 is the horizontal coordinate and the horizontal axis shows height in centimetres, so the height is 170 cm; the value 65 is the vertical coordinate and the vertical axis shows mass in kilograms, so the mass is 65 kg. Answer: height 170 cm, mass 65 kg, each with the unit named on its own axis. The distractors: height 65 cm and mass 170 kg come from reading the pair the wrong way round, which would describe an impossible person; height 170 cm and mass 170 kg come from reading the horizontal coordinate for both quantities and never using the second number; height 235 cm and mass 105 kg come from combining the two coordinates, 170 + 65 and 170 − 65, instead of reading them separately.
- (b) Interpolation — The salary is being estimated for a value of x between 1 and 15, which is inside the range of x-values that were actually plotted, so this is interpolation. Extrapolation would apply if the estimate used a value of x below 1 or above 15, outside the plotted range. Correlation describes the relationship between the two variables, not the reliability of an estimate, and causation describes one variable actually causing a change in the other, which is a different idea altogether — neither is the word being asked for here.
- (b) 120, unreliable — x = 25 is outside 1 to 12 — The line of best fit is y = 4x + 20. 4 × 25 = 100, and 100 + 20 = 120, so the estimate is y = 120. But x = 25 lies far outside the plotted range of 1 to 12 years, so this is an extrapolation, and the estimate is not reliable. Reaching 100 instead of 120 comes from 4 × 25 = 100 with the intercept of 20 left out — still correctly flagged as unreliable, but the wrong value. Calling the estimate reliable simply because it was calculated correctly, giving 120, wrongly assumes that a correct calculation is automatically trustworthy, ignoring that x = 25 lies far beyond the data actually collected. Reaching 68, from 4 × 12 = 48 and 48 + 20 = 68, substitutes x = 12, the top of the plotted range, instead of the assistant's actual x = 25, and wrongly calls that reliable because 12 lies inside the range.
- (d) The mode, because colours cannot be added or ordered — Method: an average can only be used on data that supports the operation it needs. A mean needs the values to be added and divided, a median needs them to be placed in order, and a range needs one value to be taken away from another; a mode needs only counting, so it is the average available when the data are categories rather than numbers. Working: the data collected here are colours, silver, black, blue and red. The numbers 74, 52, 40 and 34 count the cars of each colour, they do not measure them, and 74 + 52 + 40 + 34 = 200 simply returns the size of the survey. No colour can be added to another, and there is no order that puts blue before red, so of the four averages only the one found by counting survives. Answer: the mode, because colours cannot be added or ordered, and the mode is silver. The distractors: the mean is said to use all 200 colours, and a mean of the four frequencies, 200 ÷ 4 = 50, is a number of cars rather than a colour, so it describes nothing about a typical car; the median is said to put the colours in order, but ordering the frequencies 34, 40, 52, 74 orders the counts, not the colours, and gives 46, again a number of cars; the range is not an average at all, and 74 − 34 = 40 measures the gap between the commonest and rarest counts, which is a measure of spread.
- (a) No, the size of the fire affects both of the quantities — Method: correlation says that two quantities change together; a claim that one of them produces the other is a further claim, and it needs evidence that a scatter graph on its own cannot give. Working: the graph does show strong positive correlation, so more engines did go with greater damage. But neither quantity was set by the researchers: both were decided by how large the fire was. A large blaze brings many appliances and also destroys a great deal, while a small one brings few and destroys little, so a third quantity is driving both of the recorded ones. Answer: no, because the size of the fire affects both of the quantities. The distractors: saying the correlation is negative contradicts the graph, which shows the two quantities rising together, and reaching the right verdict from a false reading of the data is not the reason the mark is for; saying that strong positive correlation shows one quantity causes the other is the assumption the question exists to test, and no strength of correlation can establish cause; saying the points lie close to the line of best fit describes how strong the correlation is, and strength and cause are different matters entirely.
- (c) The mean, because every value counts towards it, so 100 pulls it from 7 up to about 20.3. — Method: work each measure out before the extra value is added and again afterwards, then compare the size of the two changes. Working: before, the six values total 42, so the mean is 42 ÷ 6 = 7, and the middle pair 6 and 8 give a median of (6 + 8) ÷ 2 = 7; after, the seven values total 142, so the mean is 142 ÷ 7 = 20.29 to 2 decimal places, while the median is now the 4th of the seven ordered values, which is 8; the mean has moved by about 13.3 and the median by 1. Answer: the mean, because every value counts towards it, so 100 pulls it from 7 up to about 20.3 — this is why the median is often preferred when a data set contains an outlier. The distractors: the reply that the mean rises by 100 adds the extra value to the mean instead of adding it to the total; the reply that the median moves to 12 takes the largest of the original values as the new middle instead of counting to the 4th of the seven values; the reply about even and odd counts quotes a rule that does not exist, since the median moved because a very large value was added, not because the count of values changed.
- (d) 24 — Method: for a sample in proportion to the population, apply the same fraction that each group makes up of the whole population to the size of the sample. Working: women make up 300 out of the 500 members, a fraction of 300 ÷ 500 = 0.6. Applying that fraction to the sample of 40 gives 0.6 × 40 = 24 women. Splitting the sample evenly, 40 ÷ 2 = 20, ignores that the club has more women than men and treats the two groups as equal in size, which they are not. Misreading the sample size as 50 instead of 40, then applying the 3:2 ratio of women to men, 3 ÷ 5 × 50 = 30, uses the right ratio but the wrong sample total. Working out the number of MEN instead of women, 200 ÷ 500 × 40 = 16, answers a different question — how many men, not how many women, belong in the sample. Always apply each group's own share of the population to the sample size, and check which group the question is actually asking about.
- (b) All 2,000 members of the sports centre. — Method: in a survey, the population is the whole group the survey is trying to find out about, and the sample is the smaller group actually asked. Working: this survey wants to know what the sports centre's members think, so the population is every one of the 2,000 members — whether or not they were personally asked. Saying the population is the 100 members who were asked names the sample, not the population; the sample is drawn FROM the population, so it is smaller than it, not the same as it. Saying the population is everybody who lives in Ipswich widens the group far beyond who the survey is actually about — plenty of Ipswich residents are not members of the sports centre at all, so they are outside this survey altogether. Saying the population is the members who say they are unhappy confuses the population with a result of the survey: whether a member turns out to be happy or unhappy is something the survey finds out, not part of the definition of who is being studied. The population is always the whole group the question is about, before any sampling or any results come in.
Build your own mix at the worksheet builder.