Printable · GCSE Foundation · ages 14-16
Statistics worksheet — GCSE Foundation
Fifteen questions across the statistics statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Statistics worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (a) A straight line sloping down from left to right — Method: a line of best fit is a straight line drawn to follow the trend of the points, so its slope is decided by the direction of the relationship between the two quantities. Working: as the price rises, the satisfaction score falls, so the points start high on the left of the graph and finish low on the right; the straight line that follows them therefore slopes downwards as the graph is read from left to right, which is the line of a negative correlation. Answer: a straight line sloping down from left to right. The distractors: a line sloping up comes from reading a falling relationship as a rising one; a horizontal line comes from expecting no correlation, since a horizontal line says the satisfaction score does not change as the price changes; a curve passing through every point comes from thinking a line of best fit has to touch all of the plotted points, when it is a single straight line drawn through the middle of them.
- (a) Chloe's marks are far more spread out than Ben's — Method: a mean reports where a set of values sits, and two sets can sit in the same place while behaving quite differently, so a measure of spread has to be worked out as well. Working: Ben's marks add to 62 + 64 + 65 + 66 + 68 = 325 and 325 ÷ 5 = 65; Chloe's add to 40 + 52 + 65 + 78 + 90 = 325 and 325 ÷ 5 = 65, so the two means agree, as the question says. The ranges do not: Ben's is 68 − 62 = 6 marks, while Chloe's is 90 − 40 = 50 marks. Ben's five marks all sit within 3 marks of 65; Chloe's lowest is 25 marks below it and her highest 25 marks above it. Answer: Chloe's marks are far more spread out than Ben's, which is exactly what the mean cannot show. The distractors: saying Ben's marks are more spread out comes from subtracting in the order the values are written, 62 − 68 = −6 against 40 − 90 = −50, and then reading −6 as the larger spread; saying Chloe scored far more marks in total assumes a wider set of marks must add to more, when both totals are 325; saying the two sets vary by the same amount assumes that equal means force equal spread, when the two ranges are 6 and 50.
- (a) 26 — Method: a line of best fit lets one quantity be predicted from the other, so the score is substituted into the equation of the line and the resulting inequality is solved for the number of hours. Working: a score of at least 80 means 2.5x + 15 ≥ 80; taking 15 from both sides gives 2.5x ≥ 65, and dividing both sides by 2.5 gives x ≥ 26, so the least whole number of hours is 26. Checking, 2.5 × 26 + 15 = 80, which does reach the target. Answer: 26 hours — and this is only an estimate, because a line of best fit predicts a trend rather than an individual result, and a prediction made outside the range of hours the pupils actually revised for would be an extrapolation and less reliable still. The distractors: 27 comes from reaching 26 and then rounding up again, although 26 hours already gives a score of exactly 80; 32 comes from 80 ÷ 2.5, which ignores the 15 in the equation of the line; 38 comes from (80 + 15) ÷ 2.5, that is from adding the 15 instead of subtracting it when rearranging.
- (d) 45 — Method: convert the angle into a fraction of the full circle, 360°, then apply that fraction to the total number of shoppers. Working: the card sector is 90° out of 360°, a fraction of 90 ÷ 360 = 0.25. Applying that fraction to the 180 shoppers gives 0.25 × 180 = 45 shoppers. Giving 90 states the angle itself, not a number of shoppers — the angle first has to be converted into a fraction. Using the remaining angle, 360 − 90 = 270°, and scaling that, 270 ÷ 360 × 180 = 135, finds the number who did NOT pay by card, not the number who did. Dividing 360 by 90, 360 ÷ 90 = 4, finds how many equal 90° sectors fit in the circle, a fact about the pie chart's shape, not about the shoppers at all. Always convert the angle to a fraction of 360° first, and apply that same fraction to the total number of people.
- (a) 3/10 — There are 60 − 9 = 51 right-handed pupils. Of the 24 pupils who prefer Art, 6 are left-handed, so 24 − 6 = 18 are right-handed and prefer Art. The probability that a randomly chosen pupil is right-handed and prefers Art is 18/60, which simplifies to 3/10. Giving 2/5 is 24/60 simplified — the probability of preferring Art, ignoring the right-handed condition entirely. Giving 17/20 is 51/60 simplified — the probability of being right-handed, ignoring the Art condition entirely. Giving 1/10 is 6/60 simplified — the probability of being left-handed and preferring Art, the wrong hand condition.
- (b) £1,000 — Wages take up 150° out of 360°, so the amount spent on wages is 150 ÷ 360 × 2400 = £1,000. Choosing £600 uses the repairs angle, 90°, instead of the wages angle: 90 ÷ 360 × 2400 = 600. Choosing £3,600 treats the angle in degrees as if it were a percentage, 150 ÷ 100 × 2400 = 3600, instead of dividing by 360°. Choosing £800 uses the angle for the 'other costs' sector, 360 − 90 − 150 = 120°, instead of the wages sector: 120 ÷ 360 × 2400 = 800.
- (c) Because every pupil has an equal chance of being picked — Method: whether a sample represents its population is decided by the selection method, not by the size of the sample, so ask whether the method gives every member of the population the same chance of being chosen. Working: the names are drawn at random from a list of all 10,000 pupils, so each pupil has the same chance, 500 out of 10,000, of being drawn, and no group of pupils is more likely to appear than any other; that is what keeps bias out of the sample. Answer: because every pupil has an equal chance of being picked. The distractors: the reply about 5% treats the sampling fraction as the test of fairness, but a badly chosen 5% is still biased and a well chosen 1% is not; the reply about 500 being large enough makes size the test instead, which is the same mistake in another form, since a large sample drawn from one school would still misrepresent the city; the reply about the most willing pupils describes self-selection, which hands the choice of who is in the sample to the pupils who feel most strongly about the question.
- (b) 135 — Method: use the sample to find the PROPORTION of left-handed pupils, then apply that same proportion to the whole school population. Working: in the sample, 6 out of 40 pupils are left-handed, a proportion of 6 ÷ 40 = 0.15. Applying that proportion to the school's 900 pupils gives an estimate of 0.15 × 900 = 135 pupils. Giving 6 simply repeats the number of left-handed pupils IN THE SAMPLE, without scaling up to the whole school at all. Multiplying the population by the number of left-handed pupils in the sample without first dividing by the sample size, 900 × 6 = 5400, badly overestimates — that is more pupils than the whole school has. Dividing the population by the sample size but forgetting to multiply by the number of left-handed pupils found, 900 ÷ 40 = 22.5, finds the scale factor but stops one step short of using it. Always find the proportion in the sample first, then scale that same proportion up to the population.
- (a) Equal means; Class A is more consistent, smaller range. — Method: when two data sets share a measure of location, compare a measure of spread to say more about consistency. Working: both classes have the same mean mark, 14, so on average they performed equally well. Class A has the smaller range, 6, so its marks are more tightly grouped around 14 than Class B's marks, which vary by as much as 14. So Class A's marks were more consistent, even though neither class did better on average. Saying Class B did better because it has the bigger range confuses a wide spread with a high score — a big range describes variability, not performance. Saying Class A did better because it has the smaller range makes the same mistake in the other direction: the two classes are tied on the mean, so neither one 'did better'. Saying the classes cannot be compared because their means are equal misses the whole point of also comparing the range. Always compare both an average AND a spread before describing two data sets — either one alone tells only half the story.
- (b) Interpolation — The salary is being estimated for a value of x between 1 and 15, which is inside the range of x-values that were actually plotted, so this is interpolation. Extrapolation would apply if the estimate used a value of x below 1 or above 15, outside the plotted range. Correlation describes the relationship between the two variables, not the reliability of an estimate, and causation describes one variable actually causing a change in the other, which is a different idea altogether — neither is the word being asked for here.
- (c) The frequency of that category — Method: a bar chart for categorical data has one bar for each category, and the vertical scale on which the bars are measured is a count. Working: a bar drawn twice as tall as another tells you that twice as many items of data fell into its category, so the height measures how many items of data belong to that one category, which is exactly what a frequency is. Answer: the height of each bar is the frequency of that category — a count of items of data. The distractors: the number of different categories comes from reading the vertical scale as though it counted the bars, which is shown along the horizontal axis instead; the total of all the data comes from treating one bar as though it stood for the whole data set rather than for one category; the mean of all the data comes from confusing a bar chart with a measure of average, which no single bar can show.
- (a) A vertical line chart (discrete numerical data) — The number of pets is discrete numerical data — whole-number values such as 0, 1, 2, 3 or 4 — recorded for one variable, so a vertical line chart is the chart specified for this kind of data. A bar chart is used for categorical data, such as favourite colour, not numerical values counted like this. A pie chart shows proportions of a whole and does not show the frequency of each separate value. A scatter graph compares two different variables against each other, and only one variable, the number of pets, is recorded here.
- (d) Only internet users reach the website; others are excluded. — Method: a sample is biased when it systematically leaves out part of the population, or systematically over-represents another part. Working: anyone without internet access, or who does not visit the council's website, has NO chance of being included — the sample is drawn only from internet-using residents, which is not the whole town. Saying too many people might respond because the survey is free confuses bias with sample size — bias is about who CAN be reached, not how many respond. Saying people might lie describes a different problem, response honesty, not who was sampled in the first place. Saying online surveys cannot be anonymous is not a reason connected to bias at all. A sample is biased when part of the population has no chance of being included, whatever the reason for that.
- (c) Strong negative correlation — Method: correlation is described by two things — the direction the points take as the graph is read from left to right, and how closely the points lie to a single straight line. Working: reading the pairs in order of age, the ages rise 14, 18, 23, 27, 31, 36, 42, 49 while the scores fall 92, 88, 85, 80, 78, 74, 70, 65; the score falls at every single step, with no reversal anywhere, so the points fall from left to right and lie close to a straight line. Answer: strong negative correlation — negative for the falling direction, strong because every point follows the pattern. The distractors: strong positive correlation comes from noticing a clear pattern and calling any clear pattern positive, without checking the direction; weak negative correlation comes from reading the direction correctly but judging points that do not lie exactly on a straight line to be only loosely related, when these eight fall without a single exception; no correlation comes from reading a falling trend as though it showed no relationship at all, when a falling trend is itself a relationship.
- (d) How much the temperatures varied over the seven days — Method: the range of a set of values is the largest value take away the smallest, so it is built from two values only and it measures the gap they leave between them. Working: the largest of the seven readings is 7 °C and the smallest is 2 °C, so the range is 7 − 2 = 5 °C. That figure says the week's readings covered a band 5 °C wide; it names no particular day and no particular reading. Answer: the range describes how much the temperatures varied over the seven days. The distractors: the temperature that occurred most often is the mode, which here is 3 °C, and a mode counts repeats instead of measuring a gap; the temperature typical of the week is an average, and the range is not an average, since it throws away every value lying between the two extremes; the number of different temperatures recorded is 6, a count of how many distinct values appear, while the range is a difference between two of them.
Build your own mix at the worksheet builder.