Printable · GCSE Foundation · ages 14-16
Statistics worksheet — GCSE Foundation
Fifteen questions across the statistics statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Statistics worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (c) No, the mode here is the lowest value of the nine — Method: an average is meant to stand for the data as a whole, so test any proposed average by asking how many values it sits near. Working: the value 4 appears three times and every other count appears once, so 4 is indeed the mode. But those three hours are the quiet ones at the start of the day, and the other six counts run from 11 up to 25; putting the nine counts in order, the middle one is the fifth, which is 13. So the mode sits at the very bottom of the data, with six of the nine hours far above it. Answer: no, because the mode here is the lowest value of the nine, so it describes the quiet opening hours rather than a typical hour. The distractors: saying the mode can only be used when no value repeats reverses the definition, since a mode exists only because a value does repeat; saying the mode is the value that occurs most often is a correct definition, but being the commonest value does not make a value typical when it lies at one end of the data; saying the mode is the best average for any list of numbers ignores the fact that mean, median and mode each describe a population well in different circumstances.
- (d) An outlier from the damaged wing, not the trend. — That bird's point lies a long way from the rising trend followed by every other bird, and its low wingspan is explained by the damaged wing rather than by its age — it is an outlier caused by an unusual factor, not part of the general relationship between age and wingspan, so it should not be used when drawing the line of best fit. Saying every point must be used ignores that an outlier caused by a separate, identifiable factor can rightly be set aside. Saying it shows no correlation ignores that the other 19 points do show a clear rising trend; one outlier does not remove that. Saying it proves the line is inaccurate confuses one unusual bird with a fault in the line itself, when the line correctly describes the trend followed by the rest of the data.
- (a) 26 — Method: a line of best fit lets one quantity be predicted from the other, so the score is substituted into the equation of the line and the resulting inequality is solved for the number of hours. Working: a score of at least 80 means 2.5x + 15 ≥ 80; taking 15 from both sides gives 2.5x ≥ 65, and dividing both sides by 2.5 gives x ≥ 26, so the least whole number of hours is 26. Checking, 2.5 × 26 + 15 = 80, which does reach the target. Answer: 26 hours — and this is only an estimate, because a line of best fit predicts a trend rather than an individual result, and a prediction made outside the range of hours the pupils actually revised for would be an extrapolation and less reliable still. The distractors: 27 comes from reaching 26 and then rounding up again, although 26 hours already gives a score of exactly 80; 32 comes from 80 ÷ 2.5, which ignores the 15 in the equation of the line; 38 comes from (80 + 15) ÷ 2.5, that is from adding the 15 instead of subtracting it when rearranging.
- (c) The frequency of that category — Method: a bar chart for categorical data has one bar for each category, and the vertical scale on which the bars are measured is a count. Working: a bar drawn twice as tall as another tells you that twice as many items of data fell into its category, so the height measures how many items of data belong to that one category, which is exactly what a frequency is. Answer: the height of each bar is the frequency of that category — a count of items of data. The distractors: the number of different categories comes from reading the vertical scale as though it counted the bars, which is shown along the horizontal axis instead; the total of all the data comes from treating one bar as though it stood for the whole data set rather than for one category; the mean of all the data comes from confusing a bar chart with a measure of average, which no single bar can show.
- (b) 120, unreliable — x = 25 is outside 1 to 12 — The line of best fit is y = 4x + 20. 4 × 25 = 100, and 100 + 20 = 120, so the estimate is y = 120. But x = 25 lies far outside the plotted range of 1 to 12 years, so this is an extrapolation, and the estimate is not reliable. Reaching 100 instead of 120 comes from 4 × 25 = 100 with the intercept of 20 left out — still correctly flagged as unreliable, but the wrong value. Calling the estimate reliable simply because it was calculated correctly, giving 120, wrongly assumes that a correct calculation is automatically trustworthy, ignoring that x = 25 lies far beyond the data actually collected. Reaching 68, from 4 × 12 = 48 and 48 + 20 = 68, substitutes x = 12, the top of the plotted range, instead of the assistant's actual x = 25, and wrongly calls that reliable because 12 lies inside the range.
- (c) A line of best fit — Method: the straight line drawn on a scatter graph is named from the job it does — it is chosen so that it follows the whole set of points as closely as possible. Working: the line passes through the middle of the points, with roughly as many points above it as below it, and it need not pass through any of the plotted points at all; the name given to the straight line chosen in that way is a line of best fit. Answer: a line of best fit. The distractors: a line of symmetry comes from confusing a trend with symmetry, which is a property of a shape rather than of a set of data; a horizontal line through the mean comes from thinking the trend is shown by an average, when a horizontal line would say that the vertical quantity does not change and so show no correlation; a line joining the first and last points comes from thinking the line must join the two extreme points, which lets two points decide a trend that all of the points should share in.
- (a) The relationship between two variables — Method: what a diagram shows is decided by what has to be known before a single mark can be plotted on it. Working: every point on a scatter graph is plotted from a pair of measurements taken from the same person or object, one read on the horizontal axis and one on the vertical axis; having two measurements for each point is what makes it possible to look for a pattern between them, and the pattern between two variables is what the graph displays. Answer: a scatter graph shows the relationship between two variables. The distractors: the frequency of each single value is what a bar chart or a vertical line chart shows, and it needs only one list of values; how a total is shared between categories is what a pie chart shows; how one quantity changes over time is what a time series line graph shows, in which one of the two axes is always time.
- (a) A straight line sloping down from left to right — Method: a line of best fit is a straight line drawn to follow the trend of the points, so its slope is decided by the direction of the relationship between the two quantities. Working: as the price rises, the satisfaction score falls, so the points start high on the left of the graph and finish low on the right; the straight line that follows them therefore slopes downwards as the graph is read from left to right, which is the line of a negative correlation. Answer: a straight line sloping down from left to right. The distractors: a line sloping up comes from reading a falling relationship as a rising one; a horizontal line comes from expecting no correlation, since a horizontal line says the satisfaction score does not change as the price changes; a curve passing through every point comes from thinking a line of best fit has to touch all of the plotted points, when it is a single straight line drawn through the middle of them.
- (d) 25% — First find the number of fruit cakes: 80 − 34 − 26 = 20. Then write this as a percentage of the total: 20 ÷ 80 × 100 = 25%. Giving 20% comes from reporting the count of fruit cakes, 20, directly as a percentage, without dividing by the total of 80 first. Giving 32.5% computes the percentage of chocolate cakes instead of fruit cakes: 26 ÷ 80 × 100 = 32.5%. Giving 42.5% computes the percentage of sponge cakes instead of fruit cakes: 34 ÷ 80 × 100 = 42.5%.
- (a) No, the size of the fire affects both of the quantities — Method: correlation says that two quantities change together; a claim that one of them produces the other is a further claim, and it needs evidence that a scatter graph on its own cannot give. Working: the graph does show strong positive correlation, so more engines did go with greater damage. But neither quantity was set by the researchers: both were decided by how large the fire was. A large blaze brings many appliances and also destroys a great deal, while a small one brings few and destroys little, so a third quantity is driving both of the recorded ones. Answer: no, because the size of the fire affects both of the quantities. The distractors: saying the correlation is negative contradicts the graph, which shows the two quantities rising together, and reaching the right verdict from a false reading of the data is not the reason the mark is for; saying that strong positive correlation shows one quantity causes the other is the assumption the question exists to test, and no strength of correlation can establish cause; saying the points lie close to the line of best fit describes how strong the correlation is, and strength and cause are different matters entirely.
- (c) The mean, because every value counts towards it, so 100 pulls it from 7 up to about 20.3. — Method: work each measure out before the extra value is added and again afterwards, then compare the size of the two changes. Working: before, the six values total 42, so the mean is 42 ÷ 6 = 7, and the middle pair 6 and 8 give a median of (6 + 8) ÷ 2 = 7; after, the seven values total 142, so the mean is 142 ÷ 7 = 20.29 to 2 decimal places, while the median is now the 4th of the seven ordered values, which is 8; the mean has moved by about 13.3 and the median by 1. Answer: the mean, because every value counts towards it, so 100 pulls it from 7 up to about 20.3 — this is why the median is often preferred when a data set contains an outlier. The distractors: the reply that the mean rises by 100 adds the extra value to the mean instead of adding it to the total; the reply that the median moves to 12 takes the largest of the original values as the new middle instead of counting to the 4th of the seven values; the reply about even and odd counts quotes a rule that does not exist, since the median moved because a very large value was added, not because the count of values changed.
- (c) No — median £505 at A vs £510 at B. — Branch A's seven wages in order are £480, £495, £500, £505, £510, £515 and £1,200, so the median, the 4th value, is £505. Branch B's in order are £480, £490, £500, £510, £520, £530 and £540, so the median is £510. Since £505 is lower than £510, the median wage is not higher at Branch A, so the claim is not fairly supported. Choosing 'Yes — mean £600.71 at A vs £510 at B' uses the mean: 480 + 495 + 500 + 505 + 510 + 515 + 1200 = 4205, and 4205 ÷ 7 = 600.71, a figure pulled upward by the £1,200 outlier that does not represent a typical wage. Choosing 'Yes — median £515 at A vs £510 at B' miscounts the middle position, taking the 6th wage, £515, instead of the correct 4th value, £505. Choosing 'Yes — highest wage £1,200 at A vs £540 at B' compares the highest wage at each branch rather than a measure of the typical, or average, wage.
- (d) 23.57 °C — Method: add all seven temperatures, divide by the number of readings and round only at the end. Working: 22 + 24 + 23 + 25 + 26 + 21 + 24 = 165, and 165 ÷ 7 = 23.5714…, which rounds to 23.57 to 2 decimal places. Answer: 23.57 °C. The distractors: 24 °C comes from writing down the mode, the only temperature recorded twice, instead of the mean; 27.5 °C comes from dividing the total by 6 instead of by the 7 days recorded; 5 °C comes from working out the range, 26 − 21, which is a measure of spread and not an average.
- (c) Neither causes the other; sunshine links both. — Both ice cream sales and sunburn cases tend to rise on hot, sunny days, so the amount of sunshine is a third factor linked to both — neither variable causes the other. Saying ice cream sales cause the sunburn assumes a causal link in one direction that the correlation alone cannot establish. Saying sunburn cases cause the ice cream sales assumes the reverse causal link, which is no more justified. Saying a strong correlation always means causation is the general error this question is testing: correlation, however strong, does not by itself prove that one variable causes the other.
- (a) 3/10 — There are 60 − 9 = 51 right-handed pupils. Of the 24 pupils who prefer Art, 6 are left-handed, so 24 − 6 = 18 are right-handed and prefer Art. The probability that a randomly chosen pupil is right-handed and prefers Art is 18/60, which simplifies to 3/10. Giving 2/5 is 24/60 simplified — the probability of preferring Art, ignoring the right-handed condition entirely. Giving 17/20 is 51/60 simplified — the probability of being right-handed, ignoring the Art condition entirely. Giving 1/10 is 6/60 simplified — the probability of being left-handed and preferring Art, the wrong hand condition.
Build your own mix at the worksheet builder.