Printable · GCSE Foundation · ages 14-16
Statistics worksheet — GCSE Foundation
Fifteen questions across the statistics statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Statistics worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (c) No — median £505 at A vs £510 at B. — Branch A's seven wages in order are £480, £495, £500, £505, £510, £515 and £1,200, so the median, the 4th value, is £505. Branch B's in order are £480, £490, £500, £510, £520, £530 and £540, so the median is £510. Since £505 is lower than £510, the median wage is not higher at Branch A, so the claim is not fairly supported. Choosing 'Yes — mean £600.71 at A vs £510 at B' uses the mean: 480 + 495 + 500 + 505 + 510 + 515 + 1200 = 4205, and 4205 ÷ 7 = 600.71, a figure pulled upward by the £1,200 outlier that does not represent a typical wage. Choosing 'Yes — median £515 at A vs £510 at B' miscounts the middle position, taking the 6th wage, £515, instead of the correct 4th value, £505. Choosing 'Yes — highest wage £1,200 at A vs £540 at B' compares the highest wage at each branch rather than a measure of the typical, or average, wage.
- (a) 1.24 — Method: for data given as a frequency table, the mean is Σfx ÷ Σf — multiply each value by its frequency, add the results, then divide by the total frequency. Working: 0 × 6 = 0. 1 × 10 = 10. 2 × 6 = 12. 3 × 3 = 9. So Σfx = 0 + 10 + 12 + 9 = 31. The total frequency is Σf = 6 + 10 + 6 + 3 = 25. Mean = 31 ÷ 25 = 1.24 siblings. Averaging the frequency column itself, (6 + 10 + 6 + 3) ÷ 4 = 6.25, mixes up the frequencies with the values they belong to. Writing down 1, the number of siblings with the highest frequency, gives the mode, not the mean. Writing down 31 stops after finding Σfx and forgets to divide by the total frequency, 25. Always divide Σfx by Σf — never stop at the top of the fraction.
- (a) Drawing 60 names at random from a list of all 1200 pupils — Method: a sample is random when every member of the population has the same chance of being chosen and nobody, including the pupils themselves, can influence who ends up in it; test each method against that. Working: drawing names from a list of all 1200 pupils gives each pupil the same chance, 60 out of 1200, whatever their year group, class or opinion, so the method is random. Answer: drawing 60 names at random from a list of all 1200 pupils. The distractors: asking the pupils who volunteer is self-selection, and the pupils with the strongest views volunteer first, so they decide the sample; asking the pupils nearest the door is convenience sampling, which reaches only those who happen to be in one place at one time; asking two Year 10 classes samples a cluster, so every pupil in the other year groups has no chance of being chosen at all.
- (d) Testing destroys bulbs, so testing all leaves none to sell. — Method: testing every item in a population instead of a sample is a census — sensible only when testing does not use up or destroy what is being tested. Working: here, testing a bulb to find its lifespan destroys it, so testing all 50,000 bulbs would leave nothing left to sell — a sample lets the company estimate the typical lifespan without destroying its whole stock. Extra electricity used in testing is not the real reason a census is avoided here — it is the destruction of the product that matters. Saying a sample is always more accurate than a full census is the wrong way round: a census, if it could be carried out, gives the exact figure for the whole population — it is testing being destructive, not a lack of accuracy, that rules it out here. There is no law against testing every item a company makes — nothing in the question suggests that. When testing destroys the item being tested, sampling is necessary, not just convenient.
- (a) A vertical line chart (discrete numerical data) — The number of pets is discrete numerical data — whole-number values such as 0, 1, 2, 3 or 4 — recorded for one variable, so a vertical line chart is the chart specified for this kind of data. A bar chart is used for categorical data, such as favourite colour, not numerical values counted like this. A pie chart shows proportions of a whole and does not show the frequency of each separate value. A scatter graph compares two different variables against each other, and only one variable, the number of pets, is recorded here.
- (b) 120, unreliable — x = 25 is outside 1 to 12 — The line of best fit is y = 4x + 20. 4 × 25 = 100, and 100 + 20 = 120, so the estimate is y = 120. But x = 25 lies far outside the plotted range of 1 to 12 years, so this is an extrapolation, and the estimate is not reliable. Reaching 100 instead of 120 comes from 4 × 25 = 100 with the intercept of 20 left out — still correctly flagged as unreliable, but the wrong value. Calling the estimate reliable simply because it was calculated correctly, giving 120, wrongly assumes that a correct calculation is automatically trustworthy, ignoring that x = 25 lies far beyond the data actually collected. Reaching 68, from 4 × 12 = 48 and 48 + 20 = 68, substitutes x = 12, the top of the plotted range, instead of the assistant's actual x = 25, and wrongly calls that reliable because 12 lies inside the range.
- (d) The modal class, as the class with most pupils is shown — Method: a grouped frequency table records how many values fall into each class, but not the values themselves, so any average that needs the individual times can only be estimated from it. Working: the four frequencies are 8, 12, 6 and 4, and 8 + 12 + 6 + 4 = 30, so every pupil is counted. The largest frequency is 12, which belongs to the class 10 < t ≤ 20, and that class can be written down exactly, because finding it needs nothing but the counts the table already gives. Answer: the modal class, as the class with most pupils is shown. The distractors: the mean is said to use all 30 times, but the table does not hold them; the usual method replaces each class by its midpoint, 5, 15, 25 and 35, which gives an estimate of the mean and not its true value; the median is said to be shown, but the table locates only the class holding the 15th and 16th times, which is 10 < t ≤ 20, without saying what either time was; the range is said to be shown, but 0 and 40 are the boundaries of the first and last classes, not the fastest and slowest times actually recorded.
- (c) Strong negative correlation — Method: correlation is described by two things — the direction the points take as the graph is read from left to right, and how closely the points lie to a single straight line. Working: reading the pairs in order of age, the ages rise 14, 18, 23, 27, 31, 36, 42, 49 while the scores fall 92, 88, 85, 80, 78, 74, 70, 65; the score falls at every single step, with no reversal anywhere, so the points fall from left to right and lie close to a straight line. Answer: strong negative correlation — negative for the falling direction, strong because every point follows the pattern. The distractors: strong positive correlation comes from noticing a clear pattern and calling any clear pattern positive, without checking the direction; weak negative correlation comes from reading the direction correctly but judging points that do not lie exactly on a straight line to be only loosely related, when these eight fall without a single exception; no correlation comes from reading a falling trend as though it showed no relationship at all, when a falling trend is itself a relationship.
- (d) 20 — 0.4x + 1 = 9, so 0.4x = 9 − 1 = 8, and 8 ÷ 0.4 = 20, so 20 sessions are needed. Choosing 23 divides 9 by 0.4 without first subtracting the 1: 9 ÷ 0.4 = 22.5, rounded up to 23. Choosing 25 subtracts the wrong way, adding the 1 instead of taking it away: 9 + 1 = 10, and 10 ÷ 0.4 = 25. Choosing 2 misplaces the decimal point in the gradient, dividing by 4 instead of by 0.4: 8 ÷ 4 = 2.
- (a) No, the size of the fire affects both of the quantities — Method: correlation says that two quantities change together; a claim that one of them produces the other is a further claim, and it needs evidence that a scatter graph on its own cannot give. Working: the graph does show strong positive correlation, so more engines did go with greater damage. But neither quantity was set by the researchers: both were decided by how large the fire was. A large blaze brings many appliances and also destroys a great deal, while a small one brings few and destroys little, so a third quantity is driving both of the recorded ones. Answer: no, because the size of the fire affects both of the quantities. The distractors: saying the correlation is negative contradicts the graph, which shows the two quantities rising together, and reaching the right verdict from a false reading of the data is not the reason the mark is for; saying that strong positive correlation shows one quantity causes the other is the assumption the question exists to test, and no strength of correlation can establish cause; saying the points lie close to the line of best fit describes how strong the correlation is, and strength and cause are different matters entirely.
- (b) 15 pupils — The frequencies are 5, 4, 3 and 3 pupils, and 5 + 4 + 3 + 3 = 15, so there are 15 pupils in the class. Choosing 6 pupils comes from adding the numbers of pets, 0 + 1 + 2 + 3 = 6, instead of the frequencies. Choosing 10 pupils comes from leaving out the '0 pets' row: 4 + 3 + 3 = 10. Choosing 18 pupils comes from counting the '3 pets' row twice: 5 + 4 + 3 + 3 + 3 = 18.
- (c) 69 — Method: multiply the mean by the number of values to find the total, then subtract the total of the known values. Working: the total of all five scores is 68 × 5 = 340. The total of the four known scores is 55 + 62 + 74 + 80 = 271. The fifth score is 340 − 271 = 69. Subtracting the other way round, 271 − 340 = −69, gives the right size answer with the wrong sign. Guessing that the missing score simply equals the mean, 68, ignores that the four known scores are not themselves centred on 68. Multiplying the mean by 4 instead of 5, 68 × 4 = 272, then 272 − 271 = 1, undercounts how many scores there are. Always multiply the mean by the TOTAL number of values before subtracting.
- (d) Correlation is a link; causation is one causing the other — Method: the two words describe different claims — one is about a pattern in the data, the other is about what produced that pattern. Working: correlation says only that two quantities tend to change together, which is something a scatter graph can display; causation says that a change in one quantity actually brings about the change in the other, which needs evidence a scatter graph cannot supply, because a third quantity may be driving both. Answer: correlation is a link between the quantities, while causation is one quantity causing the change in another. The distractors: the statement giving causation as the link and correlation as the cause simply swaps the two words over; the statement that the words mean the same thing is the classic error of reading a correlation as proof of cause; the statement that a scatter graph shows causation but not correlation reverses what a scatter graph can do, since the pattern it displays is exactly the correlation.
- (d) Only families with strong feelings bothered to reply. — Method: a survey has non-response bias when only some of the people asked actually reply, and those who do are not a typical cross-section of everyone who was asked. Working: only 30 of the 200 families sent back their questionnaire, and 27 of those 30 — the great majority — said they were unhappy. Families who feel strongly about an issue, particularly those with a complaint, are far more likely to make the effort to reply than families who are simply satisfied and see no need to say anything, so the 30 replies over-represent unhappy families. Saying the families who replied were picked at random by the school gets the sampling the wrong way round: nobody picked them — they picked themselves by deciding to reply, and that is precisely why they are not a typical cross-section of all 200. Saying postal surveys always have low response rates restates that the response was low without explaining why a low response rate, on its own, makes a result unrepresentative — it is the reason FOR the low response, not the low response itself, that causes the bias here. Saying that the 27 unhappy replies show most families are unhappy is exactly the mistake the question is warning against: it treats the loudest 30 replies as if they stood for the other 170 who never sent theirs back. A low response rate is a warning sign only because the people who bother to reply are rarely typical of everyone who was asked.
- (d) An outlier from the damaged wing, not the trend. — That bird's point lies a long way from the rising trend followed by every other bird, and its low wingspan is explained by the damaged wing rather than by its age — it is an outlier caused by an unusual factor, not part of the general relationship between age and wingspan, so it should not be used when drawing the line of best fit. Saying every point must be used ignores that an outlier caused by a separate, identifiable factor can rightly be set aside. Saying it shows no correlation ignores that the other 19 points do show a clear rising trend; one outlier does not remove that. Saying it proves the line is inaccurate confuses one unusual bird with a fault in the line itself, when the line correctly describes the trend followed by the rest of the data.
Build your own mix at the worksheet builder.