Printable · GCSE Foundation · ages 14-16
Statistics worksheet — GCSE Foundation
Fifteen questions across the statistics statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Statistics worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (b) On average a plant grew 1.5 cm taller for each extra day — Method: in the equation of a line, the number multiplying x is the gradient, and a gradient states the change in y produced by an increase of 1 in x, read in the units of the two axes. Working: here x is measured in days and y in centimetres, so the gradient 1.5 carries the units centimetres per day. Testing it on the line, 5 days gives 1.5 × 5 + 4 = 11.5 cm and 6 days gives 1.5 × 6 + 4 = 13 cm, a rise of 1.5 cm for the one extra day. Answer: on average a plant grew 1.5 cm taller for each extra day of watering. The distractors: 1.5 cm as the height before any watering is the value of y when x is 0, which is the other number in the equation, 4 cm, so this swaps the gradient and the intercept; 1.5 cm as the gap between the tallest and the shortest plant reads the gradient as a range, when a range is a difference between two of the 16 plants and a gradient is a rate; 1.5 days for each extra centimetre inverts the rate, dividing days by centimetres instead of centimetres by days, and the line gives 1 cm of growth in two thirds of a day.
- (d) 25% — First find the number of fruit cakes: 80 − 34 − 26 = 20. Then write this as a percentage of the total: 20 ÷ 80 × 100 = 25%. Giving 20% comes from reporting the count of fruit cakes, 20, directly as a percentage, without dividing by the total of 80 first. Giving 32.5% computes the percentage of chocolate cakes instead of fruit cakes: 26 ÷ 80 × 100 = 32.5%. Giving 42.5% computes the percentage of sponge cakes instead of fruit cakes: 34 ÷ 80 × 100 = 42.5%.
- (c) No, 90 cm is far outside the heights on the graph — Method: a line of best fit describes the trend only across the stretch of data it was drawn through; predicting beyond that stretch is extrapolation, and nothing in the data supports it. Working: the heights used to draw this line run from 150 cm to 180 cm, all of them Year 10 pupils, while 90 cm is 60 cm below the shortest of them and belongs to a two-year-old child, whose build follows no trend the graph has measured. Substituting anyway gives 0.9 × 90 − 85 = −4, a mass of −4 kg, which cannot exist. Answer: no, because 90 cm is far outside the heights on the graph. The distractors: saying a line of best fit cannot be used to predict at all throws away its main purpose, since a prediction made between the plotted values is perfectly sound; saying the line passes through all 20 points misdescribes a line of best fit, which is drawn to follow the trend of the points and will normally pass through few of them; saying the equation works for any value put into it treats an equation fitted to Year 10 heights as a law of nature, and the mass of −4 kg shows what that assumption produces.
- (a) The relationship between two variables — Method: what a diagram shows is decided by what has to be known before a single mark can be plotted on it. Working: every point on a scatter graph is plotted from a pair of measurements taken from the same person or object, one read on the horizontal axis and one on the vertical axis; having two measurements for each point is what makes it possible to look for a pattern between them, and the pattern between two variables is what the graph displays. Answer: a scatter graph shows the relationship between two variables. The distractors: the frequency of each single value is what a bar chart or a vertical line chart shows, and it needs only one list of values; how a total is shared between categories is what a pie chart shows; how one quantity changes over time is what a time series line graph shows, in which one of the two axes is always time.
- (d) The mode, because colours cannot be added or ordered — Method: an average can only be used on data that supports the operation it needs. A mean needs the values to be added and divided, a median needs them to be placed in order, and a range needs one value to be taken away from another; a mode needs only counting, so it is the average available when the data are categories rather than numbers. Working: the data collected here are colours, silver, black, blue and red. The numbers 74, 52, 40 and 34 count the cars of each colour, they do not measure them, and 74 + 52 + 40 + 34 = 200 simply returns the size of the survey. No colour can be added to another, and there is no order that puts blue before red, so of the four averages only the one found by counting survives. Answer: the mode, because colours cannot be added or ordered, and the mode is silver. The distractors: the mean is said to use all 200 colours, and a mean of the four frequencies, 200 ÷ 4 = 50, is a number of cars rather than a colour, so it describes nothing about a typical car; the median is said to put the colours in order, but ordering the frequencies 34, 40, 52, 74 orders the counts, not the colours, and gives 46, again a number of cars; the range is not an average at all, and 74 − 34 = 40 measures the gap between the commonest and rarest counts, which is a measure of spread.
- (a) 5 pupils are far too few to represent 900 pupils — Method: a sample can only support a claim about a population if it is chosen fairly and if it is large enough for the pattern in it to be more than chance. Working: Priya's method of choosing is fair, because the 5 pupils were picked at random, so every pupil had the same chance of being asked. The difficulty is the size: 900 ÷ 5 = 180, so each pupil she asks stands for 180 pupils. If two of the five happen to play in the same netball team, netball takes 40% of her sample on the strength of two answers, and a second sample of 5 could easily give a different favourite sport. Answer: 5 pupils are far too few to represent 900 pupils. The distractors: saying the pupils were not chosen at random contradicts the question, which states that they were; saying the 5 may each name a different sport describes what often happens in a small sample, but disagreement is not the fault, since 5 pupils who all named the same sport would be just as weak a basis for a claim about 900; saying a sample must hold at least half of the population is an invented rule, and a properly chosen sample of a few hundred can describe a population of many thousands.
- (b) Positive correlation — Method: the type of correlation is named from the direction the points take as the scatter graph is read from left to right. Working: the points rise from left to right, so as the arm span read on the horizontal axis increases, the height read on the vertical axis increases as well; two quantities that increase together show positive correlation. Answer: positive correlation. The distractors: negative correlation comes from naming the direction the wrong way round, since a negative correlation needs the points to fall as the graph is read from left to right; no correlation comes from treating points that are spread out rather than sitting exactly on a line as though they showed no relationship; direct proportion comes from confusing a rising trend with proportion, which would additionally need the line through the points to pass through the origin and would mean doubling one quantity doubles the other.
- (c) Yes — with an estimate of 320, above the 250 limit. — Method: scale the sample proportion up to the whole batch to get an estimate, then compare that estimate with the 250 limit to reach a decision. Working: in the sample, 4 out of 50 boards are faulty, a proportion of 4 ÷ 50 = 0.08. Applying that proportion to the batch of 4,000 gives an estimate of 0.08 × 4000 = 320 faulty boards. Since 320 is more than 250, the factory should scrap the batch. Inverting the proportion, 50 ÷ 4 = 12.5, and treating that as a percentage of the batch, 12.5% × 4000 = 500, still gives 'yes' but from the wrong fraction, so it overstates the estimate. Comparing the raw number of faulty boards found in the sample, 4, directly with the 250 limit skips the scaling up to the batch altogether, and 4 is nowhere near 250, so that route wrongly says 'no'. Dividing the batch by the sample size, 4000 ÷ 50 = 80, finds how many samples of 50 fit into the batch but stops before multiplying by the 4 faulty boards found, so it also wrongly says 'no'. Always find the proportion in the sample first, scale it up to the whole batch, and only then compare the estimate with the limit given.
- (b) Interpolation — The salary is being estimated for a value of x between 1 and 15, which is inside the range of x-values that were actually plotted, so this is interpolation. Extrapolation would apply if the estimate used a value of x below 1 or above 15, outside the plotted range. Correlation describes the relationship between the two variables, not the reliability of an estimate, and causation describes one variable actually causing a change in the other, which is a different idea altogether — neither is the word being asked for here.
- (b) Treat them as outliers and check them before deciding — Method: a point lying a long way from the pattern the rest of the data make is called an outlier, and an outlier is investigated before anything is done with it, because it may be an error in the data or it may be a genuine but unusual case. Working: 48 of the 50 points lie close to the rising line of best fit, so the trend is set by those 48; the two remaining points do not follow it, so they are identified as outliers and checked — a mistake in measuring or recording would be corrected, while a genuine reading would be kept and reported. Answer: treat them as outliers and check them before deciding what to do with them. The distractors: deleting them at once assumes that every point far from the line must be an error, which throws away real data; moving the line so that it passes through them assumes a line of best fit must touch particular points, when it is drawn to follow all 50; taking them as proof that there is no correlation lets two points overturn the pattern that the other 48 agree on.
- (c) 72° — The angle is 12 ÷ 60 × 360 = 72°. Choosing 150° divides football's frequency of 25 instead of badminton's 12: 25 ÷ 60 × 360 = 150. Choosing 20° finds badminton as a percentage of the members, 12 ÷ 60 × 100 = 20, rather than an angle in degrees. Choosing 90° uses 48, the total of the other three activities, as the total instead of the full 60 members: 12 ÷ 48 × 360 = 90.
- (b) 135 — Method: use the sample to find the PROPORTION of left-handed pupils, then apply that same proportion to the whole school population. Working: in the sample, 6 out of 40 pupils are left-handed, a proportion of 6 ÷ 40 = 0.15. Applying that proportion to the school's 900 pupils gives an estimate of 0.15 × 900 = 135 pupils. Giving 6 simply repeats the number of left-handed pupils IN THE SAMPLE, without scaling up to the whole school at all. Multiplying the population by the number of left-handed pupils in the sample without first dividing by the sample size, 900 × 6 = 5400, badly overestimates — that is more pupils than the whole school has. Dividing the population by the sample size but forgetting to multiply by the number of left-handed pupils found, 900 ÷ 40 = 22.5, finds the scale factor but stops one step short of using it. Always find the proportion in the sample first, then scale that same proportion up to the population.
- (a) Drawing 60 names at random from a list of all 1200 pupils — Method: a sample is random when every member of the population has the same chance of being chosen and nobody, including the pupils themselves, can influence who ends up in it; test each method against that. Working: drawing names from a list of all 1200 pupils gives each pupil the same chance, 60 out of 1200, whatever their year group, class or opinion, so the method is random. Answer: drawing 60 names at random from a list of all 1200 pupils. The distractors: asking the pupils who volunteer is self-selection, and the pupils with the strongest views volunteer first, so they decide the sample; asking the pupils nearest the door is convenience sampling, which reaches only those who happen to be in one place at one time; asking two Year 10 classes samples a cluster, so every pupil in the other year groups has no chance of being chosen at all.
- (c) The frequency of that category — Method: a bar chart for categorical data has one bar for each category, and the vertical scale on which the bars are measured is a count. Working: a bar drawn twice as tall as another tells you that twice as many items of data fell into its category, so the height measures how many items of data belong to that one category, which is exactly what a frequency is. Answer: the height of each bar is the frequency of that category — a count of items of data. The distractors: the number of different categories comes from reading the vertical scale as though it counted the bars, which is shown along the horizontal axis instead; the total of all the data comes from treating one bar as though it stood for the whole data set rather than for one category; the mean of all the data comes from confusing a bar chart with a measure of average, which no single bar can show.
- (a) Minutes a candle has burned and length remaining — As a candle burns for longer, less of it remains, so these two variables move in opposite directions as one increases — that is negative correlation. A pupil's shoe size generally increases as they get older, so age and shoe size show positive correlation, not negative, since both rise together. A football team's shirt colour is not a numerical quantity linked to how many matches it wins, so shirt colour and number of wins show no correlation at all. The number of letters in a pupil's name has no real connection to their ability in maths, so that pair also shows no correlation.
Build your own mix at the worksheet builder.