Printable · GCSE Foundation · ages 14-16
Statistics worksheet — GCSE Foundation
Fifteen questions across the statistics statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Statistics worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (c) No — median £505 at A vs £510 at B. — Branch A's seven wages in order are £480, £495, £500, £505, £510, £515 and £1,200, so the median, the 4th value, is £505. Branch B's in order are £480, £490, £500, £510, £520, £530 and £540, so the median is £510. Since £505 is lower than £510, the median wage is not higher at Branch A, so the claim is not fairly supported. Choosing 'Yes — mean £600.71 at A vs £510 at B' uses the mean: 480 + 495 + 500 + 505 + 510 + 515 + 1200 = 4205, and 4205 ÷ 7 = 600.71, a figure pulled upward by the £1,200 outlier that does not represent a typical wage. Choosing 'Yes — median £515 at A vs £510 at B' miscounts the middle position, taking the 6th wage, £515, instead of the correct 4th value, £505. Choosing 'Yes — highest wage £1,200 at A vs £540 at B' compares the highest wage at each branch rather than a measure of the typical, or average, wage.
- (a) Drawing 60 names at random from a list of all 1200 pupils — Method: a sample is random when every member of the population has the same chance of being chosen and nobody, including the pupils themselves, can influence who ends up in it; test each method against that. Working: drawing names from a list of all 1200 pupils gives each pupil the same chance, 60 out of 1200, whatever their year group, class or opinion, so the method is random. Answer: drawing 60 names at random from a list of all 1200 pupils. The distractors: asking the pupils who volunteer is self-selection, and the pupils with the strongest views volunteer first, so they decide the sample; asking the pupils nearest the door is convenience sampling, which reaches only those who happen to be in one place at one time; asking two Year 10 classes samples a cluster, so every pupil in the other year groups has no chance of being chosen at all.
- (a) A vertical line chart (discrete numerical data) — The number of pets is discrete numerical data — whole-number values such as 0, 1, 2, 3 or 4 — recorded for one variable, so a vertical line chart is the chart specified for this kind of data. A bar chart is used for categorical data, such as favourite colour, not numerical values counted like this. A pie chart shows proportions of a whole and does not show the frequency of each separate value. A scatter graph compares two different variables against each other, and only one variable, the number of pets, is recorded here.
- (b) £1,000 — Wages take up 150° out of 360°, so the amount spent on wages is 150 ÷ 360 × 2400 = £1,000. Choosing £600 uses the repairs angle, 90°, instead of the wages angle: 90 ÷ 360 × 2400 = 600. Choosing £3,600 treats the angle in degrees as if it were a percentage, 150 ÷ 100 × 2400 = 3600, instead of dividing by 360°. Choosing £800 uses the angle for the 'other costs' sector, 360 − 90 − 150 = 120°, instead of the wages sector: 120 ÷ 360 × 2400 = 800.
- (d) £15.50 — 2 × 6 = 12, and 12 + 3.50 = 15.50, so the estimated fare is £15.50. Choosing £12.00 stops after 2 × 6 = 12 and forgets to add the £3.50. Choosing £19.00 adds the distance and the constant first and then multiplies: 6 + 3.50 = 9.50, and 9.50 × 2 = 19.00, applying the ×2 to the whole sum instead of only to the distance. Choosing £13.00 multiplies only the constant term by 2 instead of the distance: 2 × 3.50 = 7, and 7 + 6 = 13.00.
- (c) The frequency of that category — Method: a bar chart for categorical data has one bar for each category, and the vertical scale on which the bars are measured is a count. Working: a bar drawn twice as tall as another tells you that twice as many items of data fell into its category, so the height measures how many items of data belong to that one category, which is exactly what a frequency is. Answer: the height of each bar is the frequency of that category — a count of items of data. The distractors: the number of different categories comes from reading the vertical scale as though it counted the bars, which is shown along the horizontal axis instead; the total of all the data comes from treating one bar as though it stood for the whole data set rather than for one category; the mean of all the data comes from confusing a bar chart with a measure of average, which no single bar can show.
- (b) £11.00 — 1.5 × 6 = 9, and 9 + 2 = 11, so the estimated cost is £11.00. Choosing £9.00 stops after 1.5 × 6 = 9 and forgets to add the £2. Choosing £12.00 adds the mass and the constant first and then multiplies: 6 + 2 = 8, and 8 × 1.5 = 12.00. Choosing £13.50 swaps the gradient and the intercept, using y = 2x + 1.5 instead: 2 × 6 = 12, and 12 + 1.5 = 13.50.
- (b) Interpolation — The salary is being estimated for a value of x between 1 and 15, which is inside the range of x-values that were actually plotted, so this is interpolation. Extrapolation would apply if the estimate used a value of x below 1 or above 15, outside the plotted range. Correlation describes the relationship between the two variables, not the reliability of an estimate, and causation describes one variable actually causing a change in the other, which is a different idea altogether — neither is the word being asked for here.
- (a) Equal means; Class A is more consistent, smaller range. — Method: when two data sets share a measure of location, compare a measure of spread to say more about consistency. Working: both classes have the same mean mark, 14, so on average they performed equally well. Class A has the smaller range, 6, so its marks are more tightly grouped around 14 than Class B's marks, which vary by as much as 14. So Class A's marks were more consistent, even though neither class did better on average. Saying Class B did better because it has the bigger range confuses a wide spread with a high score — a big range describes variability, not performance. Saying Class A did better because it has the smaller range makes the same mistake in the other direction: the two classes are tied on the mean, so neither one 'did better'. Saying the classes cannot be compared because their means are equal misses the whole point of also comparing the range. Always compare both an average AND a spread before describing two data sets — either one alone tells only half the story.
- (a) Chloe's marks are far more spread out than Ben's — Method: a mean reports where a set of values sits, and two sets can sit in the same place while behaving quite differently, so a measure of spread has to be worked out as well. Working: Ben's marks add to 62 + 64 + 65 + 66 + 68 = 325 and 325 ÷ 5 = 65; Chloe's add to 40 + 52 + 65 + 78 + 90 = 325 and 325 ÷ 5 = 65, so the two means agree, as the question says. The ranges do not: Ben's is 68 − 62 = 6 marks, while Chloe's is 90 − 40 = 50 marks. Ben's five marks all sit within 3 marks of 65; Chloe's lowest is 25 marks below it and her highest 25 marks above it. Answer: Chloe's marks are far more spread out than Ben's, which is exactly what the mean cannot show. The distractors: saying Ben's marks are more spread out comes from subtracting in the order the values are written, 62 − 68 = −6 against 40 − 90 = −50, and then reading −6 as the larger spread; saying Chloe scored far more marks in total assumes a wider set of marks must add to more, when both totals are 325; saying the two sets vary by the same amount assumes that equal means force equal spread, when the two ranges are 6 and 50.
- (d) 24 — Method: for a sample in proportion to the population, apply the same fraction that each group makes up of the whole population to the size of the sample. Working: women make up 300 out of the 500 members, a fraction of 300 ÷ 500 = 0.6. Applying that fraction to the sample of 40 gives 0.6 × 40 = 24 women. Splitting the sample evenly, 40 ÷ 2 = 20, ignores that the club has more women than men and treats the two groups as equal in size, which they are not. Misreading the sample size as 50 instead of 40, then applying the 3:2 ratio of women to men, 3 ÷ 5 × 50 = 30, uses the right ratio but the wrong sample total. Working out the number of MEN instead of women, 200 ÷ 500 × 40 = 16, answers a different question — how many men, not how many women, belong in the sample. Always apply each group's own share of the population to the sample size, and check which group the question is actually asking about.
- (b) 135 — Method: use the sample to find the PROPORTION of left-handed pupils, then apply that same proportion to the whole school population. Working: in the sample, 6 out of 40 pupils are left-handed, a proportion of 6 ÷ 40 = 0.15. Applying that proportion to the school's 900 pupils gives an estimate of 0.15 × 900 = 135 pupils. Giving 6 simply repeats the number of left-handed pupils IN THE SAMPLE, without scaling up to the whole school at all. Multiplying the population by the number of left-handed pupils in the sample without first dividing by the sample size, 900 × 6 = 5400, badly overestimates — that is more pupils than the whole school has. Dividing the population by the sample size but forgetting to multiply by the number of left-handed pupils found, 900 ÷ 40 = 22.5, finds the scale factor but stops one step short of using it. Always find the proportion in the sample first, then scale that same proportion up to the population.
- (a) Minutes a candle has burned and length remaining — As a candle burns for longer, less of it remains, so these two variables move in opposite directions as one increases — that is negative correlation. A pupil's shoe size generally increases as they get older, so age and shoe size show positive correlation, not negative, since both rise together. A football team's shirt colour is not a numerical quantity linked to how many matches it wins, so shirt colour and number of wins show no correlation at all. The number of letters in a pupil's name has no real connection to their ability in maths, so that pair also shows no correlation.
- (d) Correlation is a link; causation is one causing the other — Method: the two words describe different claims — one is about a pattern in the data, the other is about what produced that pattern. Working: correlation says only that two quantities tend to change together, which is something a scatter graph can display; causation says that a change in one quantity actually brings about the change in the other, which needs evidence a scatter graph cannot supply, because a third quantity may be driving both. Answer: correlation is a link between the quantities, while causation is one quantity causing the change in another. The distractors: the statement giving causation as the link and correlation as the cause simply swaps the two words over; the statement that the words mean the same thing is the classic error of reading a correlation as proof of cause; the statement that a scatter graph shows causation but not correlation reverses what a scatter graph can do, since the pattern it displays is exactly the correlation.
- (a) 15 — Year 11 has 50 − 28 = 22 pupils in total. Of the 22 pupils who walk in total, 15 are in Year 10, so 22 − 15 = 7 Year 11 pupils walk. Subtracting that from the Year 11 total gives 22 − 7 = 15 Year 11 pupils who are driven. Choosing 28 takes the whole school's driven total, 50 − 22 = 28, and treats it as if it were Year 11's alone, without separating the year groups. Choosing 7 correctly finds how many Year 11 pupils walk but stops there, giving that figure instead of the number who are driven. Choosing 35 comes from 50 − 15, subtracting the Year 10 walkers from the whole school total rather than working within Year 11.
Build your own mix at the worksheet builder.