Printable · GCSE Foundation · ages 14-16
Statistics worksheet — GCSE Foundation
Fifteen questions across the statistics statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Calculator
Answer key: Statistics worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (c) No, the mode here is the lowest value of the nine — Method: an average is meant to stand for the data as a whole, so test any proposed average by asking how many values it sits near. Working: the value 4 appears three times and every other count appears once, so 4 is indeed the mode. But those three hours are the quiet ones at the start of the day, and the other six counts run from 11 up to 25; putting the nine counts in order, the middle one is the fifth, which is 13. So the mode sits at the very bottom of the data, with six of the nine hours far above it. Answer: no, because the mode here is the lowest value of the nine, so it describes the quiet opening hours rather than a typical hour. The distractors: saying the mode can only be used when no value repeats reverses the definition, since a mode exists only because a value does repeat; saying the mode is the value that occurs most often is a correct definition, but being the commonest value does not make a value typical when it lies at one end of the data; saying the mode is the best average for any list of numbers ignores the fact that mean, median and mode each describe a population well in different circumstances.
- (d) 23.57 °C — Method: add all seven temperatures, divide by the number of readings and round only at the end. Working: 22 + 24 + 23 + 25 + 26 + 21 + 24 = 165, and 165 ÷ 7 = 23.5714…, which rounds to 23.57 to 2 decimal places. Answer: 23.57 °C. The distractors: 24 °C comes from writing down the mode, the only temperature recorded twice, instead of the mean; 27.5 °C comes from dividing the total by 6 instead of by the 7 days recorded; 5 °C comes from working out the range, 26 − 21, which is a measure of spread and not an average.
- (c) 40 minutes — Method: for grouped data, estimate the mean using the midpoint of each class — multiply each midpoint by its frequency, add the results, then divide by the total frequency. Working: the midpoints are 10, 30, 50 and 70 minutes. 10 × 5 = 50. 30 × 10 = 300. 50 × 10 = 500. 70 × 5 = 350. Σfx = 50 + 300 + 500 + 350 = 1200. Σf = 5 + 10 + 10 + 5 = 30. Estimated mean = 1200 ÷ 30 = 40 minutes. Using the upper boundary of each class instead of the midpoint — 20 × 5 = 100, 40 × 10 = 400, 60 × 10 = 600, 80 × 5 = 400 — gives a total of 1500 and an estimate of 1500 ÷ 30 = 50 minutes, too high because a boundary is not the middle of the class. Averaging the frequencies themselves, 5, 10, 10 and 5, ignores the times altogether and gives 7.5. Stopping after Σfx = 1200 without dividing by the total frequency gives a number far too large to be a time in minutes. Always find the midpoint of each class before multiplying by the frequency, and always divide by Σf at the end.
- (d) Only families with strong feelings bothered to reply. — Method: a survey has non-response bias when only some of the people asked actually reply, and those who do are not a typical cross-section of everyone who was asked. Working: only 30 of the 200 families sent back their questionnaire, and 27 of those 30 — the great majority — said they were unhappy. Families who feel strongly about an issue, particularly those with a complaint, are far more likely to make the effort to reply than families who are simply satisfied and see no need to say anything, so the 30 replies over-represent unhappy families. Saying the families who replied were picked at random by the school gets the sampling the wrong way round: nobody picked them — they picked themselves by deciding to reply, and that is precisely why they are not a typical cross-section of all 200. Saying postal surveys always have low response rates restates that the response was low without explaining why a low response rate, on its own, makes a result unrepresentative — it is the reason FOR the low response, not the low response itself, that causes the bias here. Saying that the 27 unhappy replies show most families are unhappy is exactly the mistake the question is warning against: it treats the loudest 30 replies as if they stood for the other 170 who never sent theirs back. A low response rate is a warning sign only because the people who bother to reply are rarely typical of everyone who was asked.
- (a) A vertical line chart (discrete numerical data) — The number of pets is discrete numerical data — whole-number values such as 0, 1, 2, 3 or 4 — recorded for one variable, so a vertical line chart is the chart specified for this kind of data. A bar chart is used for categorical data, such as favourite colour, not numerical values counted like this. A pie chart shows proportions of a whole and does not show the frequency of each separate value. A scatter graph compares two different variables against each other, and only one variable, the number of pets, is recorded here.
- (b) 135 — Method: use the sample to find the PROPORTION of left-handed pupils, then apply that same proportion to the whole school population. Working: in the sample, 6 out of 40 pupils are left-handed, a proportion of 6 ÷ 40 = 0.15. Applying that proportion to the school's 900 pupils gives an estimate of 0.15 × 900 = 135 pupils. Giving 6 simply repeats the number of left-handed pupils IN THE SAMPLE, without scaling up to the whole school at all. Multiplying the population by the number of left-handed pupils in the sample without first dividing by the sample size, 900 × 6 = 5400, badly overestimates — that is more pupils than the whole school has. Dividing the population by the sample size but forgetting to multiply by the number of left-handed pupils found, 900 ÷ 40 = 22.5, finds the scale factor but stops one step short of using it. Always find the proportion in the sample first, then scale that same proportion up to the population.
- (d) How much the temperatures varied over the seven days — Method: the range of a set of values is the largest value take away the smallest, so it is built from two values only and it measures the gap they leave between them. Working: the largest of the seven readings is 7 °C and the smallest is 2 °C, so the range is 7 − 2 = 5 °C. That figure says the week's readings covered a band 5 °C wide; it names no particular day and no particular reading. Answer: the range describes how much the temperatures varied over the seven days. The distractors: the temperature that occurred most often is the mode, which here is 3 °C, and a mode counts repeats instead of measuring a gap; the temperature typical of the week is an average, and the range is not an average, since it throws away every value lying between the two extremes; the number of different temperatures recorded is 6, a count of how many distinct values appear, while the range is a difference between two of them.
- (c) It is not representative, as she picked her own friends — Method: judge a sample by asking whether the pupils in it were chosen in a way that gives the whole school a fair chance of being heard. Working: Isla's friends are a group she formed herself, and friends tend to share tastes, so their favourite programme is likely to match hers rather than the school's, and pupils in other year groups and other friendship groups had no chance at all of being asked; the fault lies in how the pupils were selected, not in how many of them there were. Answer: it is not representative, as she picked her own friends. The distractors: the reply blaming the size claims the pupils were picked at random, which is false here, and it is the common mistake of thinking a biased sample can be cured by making it bigger; the reply calling the sample too large is false in the other direction, as a survey is never spoilt by collecting more replies; the reply that the sample is fine treats attending the school as enough, which would make any group of pupils in the building a fair sample.
- (d) 38, and fairly confident, as 12 °C is inside the range — Method: substitute the forecast temperature into the equation of the line of best fit, then judge the prediction by where that temperature sits among the data the line was drawn from. Working: putting x = 12 into y = −3x + 74 gives −3 × 12 + 74 = 38, so the line predicts 38 hot chocolates. The recorded temperatures run from 4 °C to 18 °C, and 12 °C lies inside that interval, so this is interpolation, the safer kind of prediction. Answer: 38, and fairly confident, as 12 °C is inside the range; the owner should still expect the true figure to differ a little, since the points only lie near the line and not on it. The distractors: being completely certain treats a line of best fit as a rule that fixes each day's sales, when it describes a trend that individual days depart from; saying 12 °C is outside the range misreads the interval 4 °C to 18 °C, and the wrong warning would be attached to a sound prediction; 110 comes from −3 × 12 being taken as +36, giving 36 + 74 = 110, which loses the negative gradient and so predicts that a warm day sells more hot chocolate than a cold one.
- (a) 1.24 — Method: for data given as a frequency table, the mean is Σfx ÷ Σf — multiply each value by its frequency, add the results, then divide by the total frequency. Working: 0 × 6 = 0. 1 × 10 = 10. 2 × 6 = 12. 3 × 3 = 9. So Σfx = 0 + 10 + 12 + 9 = 31. The total frequency is Σf = 6 + 10 + 6 + 3 = 25. Mean = 31 ÷ 25 = 1.24 siblings. Averaging the frequency column itself, (6 + 10 + 6 + 3) ÷ 4 = 6.25, mixes up the frequencies with the values they belong to. Writing down 1, the number of siblings with the highest frequency, gives the mode, not the mean. Writing down 31 stops after finding Σfx and forgets to divide by the total frequency, 25. Always divide Σfx by Σf — never stop at the top of the fraction.
- (a) 5 pupils are far too few to represent 900 pupils — Method: a sample can only support a claim about a population if it is chosen fairly and if it is large enough for the pattern in it to be more than chance. Working: Priya's method of choosing is fair, because the 5 pupils were picked at random, so every pupil had the same chance of being asked. The difficulty is the size: 900 ÷ 5 = 180, so each pupil she asks stands for 180 pupils. If two of the five happen to play in the same netball team, netball takes 40% of her sample on the strength of two answers, and a second sample of 5 could easily give a different favourite sport. Answer: 5 pupils are far too few to represent 900 pupils. The distractors: saying the pupils were not chosen at random contradicts the question, which states that they were; saying the 5 may each name a different sport describes what often happens in a small sample, but disagreement is not the fault, since 5 pupils who all named the same sport would be just as weak a basis for a claim about 900; saying a sample must hold at least half of the population is an invented rule, and a properly chosen sample of a few hundred can describe a population of many thousands.
- (d) Correlation is a link; causation is one causing the other — Method: the two words describe different claims — one is about a pattern in the data, the other is about what produced that pattern. Working: correlation says only that two quantities tend to change together, which is something a scatter graph can display; causation says that a change in one quantity actually brings about the change in the other, which needs evidence a scatter graph cannot supply, because a third quantity may be driving both. Answer: correlation is a link between the quantities, while causation is one quantity causing the change in another. The distractors: the statement giving causation as the link and correlation as the cause simply swaps the two words over; the statement that the words mean the same thing is the classic error of reading a correlation as proof of cause; the statement that a scatter graph shows causation but not correlation reverses what a scatter graph can do, since the pattern it displays is exactly the correlation.
- (d) 210 — 350 − 150 = 200. 200 ÷ 10 = 20, so the gradient is 20. Using the point (5, 150): 20 × 5 = 100, so 150 − 100 = 50 is the intercept, giving the line y = 20x + 50. At x = 8: 20 × 8 = 160, and 160 + 50 = 210, so the estimated number of visitors is 210. Choosing 160 stops after 20 × 8 = 160 and forgets to add the intercept of 50. Choosing 250 comes from averaging the two given y-values: 150 + 350 = 500, and 500 ÷ 2 = 250, instead of using the line's equation. Choosing 240 assumes the visitors are directly proportional to the hours of sunshine using the first point, 150 × 8 ÷ 5 = 240, which ignores that the line does not pass through the origin.
- (a) No, 150 pupils are a tenth of the school, chosen at random — Method: judge a sample on two things, whether every member of the population had the same chance of being chosen, and whether the sample is large enough to carry a pattern. Working: the 150 pupils were drawn from the register of every pupil in the school, so no year group or set is shut out and no pupil chooses to take part; and 150 ÷ 1,500 = 0.1, so one pupil in ten has been asked. A random sample of that share is ample for an estimate of how long the school's pupils spend on homework. Answer: no, because 150 pupils are a tenth of the school and were chosen at random. The distractors: saying a random sample always gives the exact school figure reaches the same verdict for a reason that is false, since a second random sample of 150 would give a slightly different mean; saying 150 pupils cannot be picked at random from 1,500 treats randomness as something only a whole population can have, when drawing names from the register is exactly how a random sample is taken; saying that only asking all 1,500 could show anything rejects sampling altogether, which would leave no way to study any population too large to count.
- (b) At 0 guests, the model predicts 2 m of table — The y-intercept of a line of best fit y = mx + c is the value of y when x = 0. Here y = 0.5 × 0 + 2 = 2, so the line predicts a table length of 2 m when there are 0 guests. The 2 m does not grow as more guests arrive — that role belongs to the gradient, 0.5 — so an option saying each extra guest adds 2 m has swapped the two numbers around. The 2 is a length in metres, not a number of guests, so an option requiring 2 guests before set-up has misread its units. And the table length does change with x, since it is 0.5x + 2 and not a fixed value, so an option claiming the table is always 2 m ignores the 0.5x term completely.
Build your own mix at the worksheet builder.