Printable · GCSE Foundation · ages 14-16
Statistics worksheet — GCSE Foundation
Fifteen questions across the statistics statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Statistics worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (a) 12 mm — Method: the range is the highest value minus the lowest value. Working: the highest rainfall is 15 mm and the lowest is 3 mm, so the range is 15 − 3 = 12 mm. Giving 15 mm alone states the highest value, not the range. Giving 3 mm alone states the lowest value, not the range. Sorting the six values, 3, 5, 9, 11, 12 and 15, and averaging the middle two, (9 + 11) ÷ 2 = 10 mm, finds the median, a completely different statistic. The range always needs BOTH the highest and the lowest value — never just one of them.
- (c) 80 — Method: the range is a measure of spread and is found by subtracting the smallest value from the largest. Working: the largest number sold is 100 and the smallest is 20, so the range is 100 − 20 = 80. Answer: 80. The distractors: 100 comes from writing down the largest value and never subtracting the smallest; 60 comes from working out the median, the middle value of 20, 40, 60, 70, 100, instead of the range; 58 comes from working out the mean, 290 ÷ 5, which measures centre rather than spread.
- (a) 144° — Method: a pie chart shares the 360° at its centre between the categories in proportion to their frequencies, so the angle of a sector is that category's fraction of the total multiplied by 360°. Working: the sector stands for 40 pupils out of 100, which is the fraction 40/100; one pupil is worth 360 ÷ 100 = 3.6°, so 40 pupils are worth 40 × 3.6° = 144°. Answer: 144°, and the answer is an angle in degrees, not a number of pupils. The distractors: 40° comes from sharing out 100 instead of 360, so the percentage is written straight down as a number of degrees; 216° comes from working out the angle for the other 60 pupils, 60 × 3.6°, which is the rest of the pie chart; 180° comes from assuming that the tallest line must stand for half of the pupils and so take half of the chart.
- (a) 23 minutes — Method: the equation of a line of best fit converts a value of x into a predicted value of y, so substitute the known number of pages for x and evaluate. Working: x is the number of pages, so put x = 10 into y = 2x + 3. Multiplication is carried out before addition, so 2 × 10 + 3 = 23. Answer: 23 minutes, and it is a prediction of the trend rather than a promise about any one chapter. The distractors: 20 minutes comes from working out 2 × 10 and stopping there, leaving out the 3 that the line adds; 26 minutes comes from reading the equation as y = 2(x + 3), adding first and then doubling, so 2 × 13 = 26; 13 minutes comes from adding 10 and 3 and never using the gradient at all, which treats the 2 as though it were not there.
- (a) 1.5 — Method: with an even number of values the median is the mean of the two middle values, which for 12 values are the 6th and the 7th once the data are in order. Working: the results are already in order, and 12 ÷ 2 = 6, so the middle pair are the 6th value, 1, and the 7th value, 2; the median is (1 + 2) ÷ 2 = 1.5. Answer: 1.5 brothers and sisters. The distractors: 1 comes from reading the 6th value and stopping there instead of averaging the middle pair; 2 comes from working out the mean, 24 ÷ 12, instead of the median; 6 comes from working out the range, 6 − 0, which measures spread rather than centre.
- (a) £16,000 — Method: first find the quarter with the highest sales figure, then subtract quarter 1's sales from it — remembering that every figure is given in THOUSANDS of pounds. Working: the highest sales figure is quarter 2, at £34,000 (34 thousand pounds). The increase from quarter 1 is £34,000 − £18,000 = £16,000. Giving £34,000 reads off the highest sales figure on its own, without subtracting quarter 1's sales — that is the highest quarter's total, not the increase. Giving £12,000 uses quarter 3's sales, 30, the SECOND-highest figure, instead of quarter 2's 34, the actual highest — 30 − 18 = 12, but quarter 3 is not the quarter with the highest sales. Giving £16 gets the subtraction right, 34 − 18 = 16, but forgets that every figure in the question is in thousands of pounds, so the increase is £16,000, not £16. Always identify the correct quarter FIRST, and always check the units the numbers are given in before writing your final answer.
- (a) 1.24 — Method: for data given as a frequency table, the mean is Σfx ÷ Σf — multiply each value by its frequency, add the results, then divide by the total frequency. Working: 0 × 6 = 0. 1 × 10 = 10. 2 × 6 = 12. 3 × 3 = 9. So Σfx = 0 + 10 + 12 + 9 = 31. The total frequency is Σf = 6 + 10 + 6 + 3 = 25. Mean = 31 ÷ 25 = 1.24 siblings. Averaging the frequency column itself, (6 + 10 + 6 + 3) ÷ 4 = 6.25, mixes up the frequencies with the values they belong to. Writing down 1, the number of siblings with the highest frequency, gives the mode, not the mean. Writing down 31 stops after finding Σfx and forgets to divide by the total frequency, 25. Always divide Σfx by Σf — never stop at the top of the fraction.
- (b) 1 — The four frequencies are 4, 7, 6 and 3 matches, and the largest of these is 7, which corresponds to 1 goal, so the modal number of goals is 1. Choosing 7 confuses the frequency, how many matches, with the number of goals itself. Choosing 2 uses the second-largest frequency, 6 matches, instead of the largest. Choosing 3 uses the smallest frequency, which belongs to the fewest matches, not the most.
- (d) Only internet users reach the website; others are excluded. — Method: a sample is biased when it systematically leaves out part of the population, or systematically over-represents another part. Working: anyone without internet access, or who does not visit the council's website, has NO chance of being included — the sample is drawn only from internet-using residents, which is not the whole town. Saying too many people might respond because the survey is free confuses bias with sample size — bias is about who CAN be reached, not how many respond. Saying people might lie describes a different problem, response honesty, not who was sampled in the first place. Saying online surveys cannot be anonymous is not a reason connected to bias at all. A sample is biased when part of the population has no chance of being included, whatever the reason for that.
- (a) The means are equal, and Class B's marks are the more consistent because its range is smaller. — Method: comparing two distributions needs two things — a measure of average and a measure of spread — and each must be put into the context of the question. Working: both classes have a mean mark of 70, so on average the two classes scored the same; the range measures spread, and Class A's range of 30 marks is three times Class B's range of 10 marks, so Class B's marks sit closely around the mean while Class A's are far more spread out. Answer: the means are equal, and Class B's marks are the more consistent because its range is smaller. The distractors: the reply crediting Class A with more consistency reverses the meaning of the range, treating a larger range as tighter data when a larger range means more spread; the reply that Class A's mean mark is higher compares the wrong pair of figures, reading the range of 30 as an average; the reply that Class B's mean mark is higher reads the spread correctly but its claim about the means is false, since both means are 70.
- (a) The relationship between two variables — Method: what a diagram shows is decided by what has to be known before a single mark can be plotted on it. Working: every point on a scatter graph is plotted from a pair of measurements taken from the same person or object, one read on the horizontal axis and one on the vertical axis; having two measurements for each point is what makes it possible to look for a pattern between them, and the pattern between two variables is what the graph displays. Answer: a scatter graph shows the relationship between two variables. The distractors: the frequency of each single value is what a bar chart or a vertical line chart shows, and it needs only one list of values; how a total is shared between categories is what a pie chart shows; how one quantity changes over time is what a time series line graph shows, in which one of the two axes is always time.
- (c) 72 — Method: when a pie chart is divided into equal sectors, each sector stands for the same share of the people asked, so the fraction of the sectors that are shaded is also the fraction of the people. Working: 6 sectors out of 10 are purple, which is the fraction 6/10 of the whole pie chart; one tenth of the 120 people is 120 ÷ 10 = 12 people, so six tenths is 6 × 12 = 72 people. Answer: 72 people, a count of people rather than a number of sectors. The distractors: 48 comes from working with the 4 sectors that are not purple, 4 × 12, and so answering for the wrong part of the chart; 60 comes from turning the fraction 6/10 into 60% and then writing the 60 down as though it were a number of people; 6 comes from writing down the number of purple sectors instead of the number of people those sectors stand for.
- (c) The median, £160,000, as one very high price lifts the mean — Method: find both averages, then choose the one that sits closer to the bulk of the data. Working: in order the prices are 140,000, 150,000, 160,000, 170,000 and 580,000, so the median is the third of the five, £160,000. For the mean, 140,000 + 150,000 + 160,000 + 170,000 + 580,000 = 1,200,000 and 1,200,000 ÷ 5 = 240,000, so the mean is £240,000. Four of the five houses sold for £170,000 or less, so a reader told that a typical price is £240,000 would expect to pay at least £70,000 more than any of those four cost. Answer: the median, £160,000, as one very high price lifts the mean. The distractors: £580,000 is the middle value of the list as it is printed, which is the median only when the values have first been put in order; £240,000 is the mean, chosen on the ground that a median ignores three of the five prices, but a median uses all five to find which one is central and is then untroubled by how extreme the outer values are; £155,000 comes from deleting the £580,000 house and taking the mean of what is left, since 140,000 + 150,000 + 160,000 + 170,000 = 620,000 and 620,000 ÷ 4 = 155,000, but a real sale may not be thrown away merely for being large.
- (d) Testing destroys bulbs, so testing all leaves none to sell. — Method: testing every item in a population instead of a sample is a census — sensible only when testing does not use up or destroy what is being tested. Working: here, testing a bulb to find its lifespan destroys it, so testing all 50,000 bulbs would leave nothing left to sell — a sample lets the company estimate the typical lifespan without destroying its whole stock. Extra electricity used in testing is not the real reason a census is avoided here — it is the destruction of the product that matters. Saying a sample is always more accurate than a full census is the wrong way round: a census, if it could be carried out, gives the exact figure for the whole population — it is testing being destructive, not a lack of accuracy, that rules it out here. There is no law against testing every item a company makes — nothing in the question suggests that. When testing destroys the item being tested, sampling is necessary, not just convenient.
- (b) A person's shoe size and their favourite colour — A person's shoe size is not linked to which colour they prefer, so these two show no correlation. The other three pairs are all genuinely correlated: distance travelled and fuel used rise together, which is positive correlation; hours of revision and test score generally rise together, which is also positive correlation; and as outdoor temperature rises, fewer woolly hats are sold, which is negative correlation. Negative correlation is still a real relationship between two variables — it is not the same thing as no relationship at all, so the temperature and hats pair is not the answer to this question.
Build your own mix at the worksheet builder.