Printable · GCSE Foundation · ages 14-16
Statistics worksheet — GCSE Foundation
Fifteen questions across the statistics statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Statistics worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (c) The frequency of that category — Method: a bar chart for categorical data has one bar for each category, and the vertical scale on which the bars are measured is a count. Working: a bar drawn twice as tall as another tells you that twice as many items of data fell into its category, so the height measures how many items of data belong to that one category, which is exactly what a frequency is. Answer: the height of each bar is the frequency of that category — a count of items of data. The distractors: the number of different categories comes from reading the vertical scale as though it counted the bars, which is shown along the horizontal axis instead; the total of all the data comes from treating one bar as though it stood for the whole data set rather than for one category; the mean of all the data comes from confusing a bar chart with a measure of average, which no single bar can show.
- (c) 72 — Method: when a pie chart is divided into equal sectors, each sector stands for the same share of the people asked, so the fraction of the sectors that are shaded is also the fraction of the people. Working: 6 sectors out of 10 are purple, which is the fraction 6/10 of the whole pie chart; one tenth of the 120 people is 120 ÷ 10 = 12 people, so six tenths is 6 × 12 = 72 people. Answer: 72 people, a count of people rather than a number of sectors. The distractors: 48 comes from working with the 4 sectors that are not purple, 4 × 12, and so answering for the wrong part of the chart; 60 comes from turning the fraction 6/10 into 60% and then writing the 60 down as though it were a number of people; 6 comes from writing down the number of purple sectors instead of the number of people those sectors stand for.
- (d) Testing destroys bulbs, so testing all leaves none to sell. — Method: testing every item in a population instead of a sample is a census — sensible only when testing does not use up or destroy what is being tested. Working: here, testing a bulb to find its lifespan destroys it, so testing all 50,000 bulbs would leave nothing left to sell — a sample lets the company estimate the typical lifespan without destroying its whole stock. Extra electricity used in testing is not the real reason a census is avoided here — it is the destruction of the product that matters. Saying a sample is always more accurate than a full census is the wrong way round: a census, if it could be carried out, gives the exact figure for the whole population — it is testing being destructive, not a lack of accuracy, that rules it out here. There is no law against testing every item a company makes — nothing in the question suggests that. When testing destroys the item being tested, sampling is necessary, not just convenient.
- (c) 10 — Method: work out the mean that can be found straight away, then use total = mean × number of values on the group of three to find the missing number. Working: the mean of 15 and 25 is (15 + 25) ÷ 2 = 40 ÷ 2 = 20, so the group of three must also have a mean of 20; three numbers with a mean of 20 have a total of 20 × 3 = 60, and 20 + 30 = 50 of that total is already accounted for, so x = 60 − 50 = 10. Answer: 10, and checking, (10 + 20 + 30) ÷ 3 = 20. The distractors: 20 comes from working out the mean the two groups share and writing that down as x; −10 comes from dividing the group of three by 2 instead of by 3, which gives x + 50 = 40; 70 comes from reading the total 15 + 25 = 40 as the mean of the pair, which sets the target total at 120 and leaves x = 70.
- (c) 16 kg — Method: sort the seven weights before finding the middle value. Working: in order, the weights are 10, 12, 14, 16, 18, 20 and 50 kg. There are 7 values, so the median is the 4th one: 16 kg. Reading off the 4th weight in the order the vet recorded them, 10 kg, skips the sorting step and is not the median. Working out the mean, 140 ÷ 7 = 20 kg, finds a different average altogether. Working out the range, 50 − 10 = 40 kg, finds the spread, not the middle value. Always sort your data first — the median lives in the ordered list, not the collection order.
- (b) 1 — The four frequencies are 4, 7, 6 and 3 matches, and the largest of these is 7, which corresponds to 1 goal, so the modal number of goals is 1. Choosing 7 confuses the frequency, how many matches, with the number of goals itself. Choosing 2 uses the second-largest frequency, 6 matches, instead of the largest. Choosing 3 uses the smallest frequency, which belongs to the fewest matches, not the most.
- (a) Minutes a candle has burned and length remaining — As a candle burns for longer, less of it remains, so these two variables move in opposite directions as one increases — that is negative correlation. A pupil's shoe size generally increases as they get older, so age and shoe size show positive correlation, not negative, since both rise together. A football team's shirt colour is not a numerical quantity linked to how many matches it wins, so shirt colour and number of wins show no correlation at all. The number of letters in a pupil's name has no real connection to their ability in maths, so that pair also shows no correlation.
- (d) 75 — Method: to find a total from a bar chart, add together the height of every bar. Working: 12 + 18 + 9 + 15 + 21 = 75 books. Leaving out Wednesday's bar by mistake, 12 + 18 + 15 + 21 = 66, misses one day out of the total. Giving 21 states only Friday's bar, the tallest one, not the total of all five days. Dividing the total by the number of days, 75 ÷ 5 = 15, finds the mean number of books per day, not the total borrowed. Add up every single bar — do not stop at the biggest one, and do not divide once you have added them all.
- (c) No, the mode here is the lowest value of the nine — Method: an average is meant to stand for the data as a whole, so test any proposed average by asking how many values it sits near. Working: the value 4 appears three times and every other count appears once, so 4 is indeed the mode. But those three hours are the quiet ones at the start of the day, and the other six counts run from 11 up to 25; putting the nine counts in order, the middle one is the fifth, which is 13. So the mode sits at the very bottom of the data, with six of the nine hours far above it. Answer: no, because the mode here is the lowest value of the nine, so it describes the quiet opening hours rather than a typical hour. The distractors: saying the mode can only be used when no value repeats reverses the definition, since a mode exists only because a value does repeat; saying the mode is the value that occurs most often is a correct definition, but being the commonest value does not make a value typical when it lies at one end of the data; saying the mode is the best average for any list of numbers ignores the fact that mean, median and mode each describe a population well in different circumstances.
- (d) It asks two things at once and invites agreement — Method: a survey question is faulty when a reply to it cannot be read as evidence about one single thing, so check how many claims it contains and whether its wording pushes the reader one way. Working: the question joins two separate claims, that learning matters and that more homework should be set, so a reply of yes could mean either of them or both and cannot be counted as evidence about homework; the opening words “Do you agree” also invite agreement instead of leaving the reader free to say no. Answer: it asks two things at once and invites agreement. The distractors: the reply calling it too short mistakes length for clarity, when the fault is that too much has been packed in rather than too little; the reply about long words is false, since every word in the question is an everyday one and the fault lies in what is being asked rather than in the vocabulary used to ask it; the reply that the question is fine takes a yes or no answer as proof that the question works, which is exactly what a double question defeats.
- (a) 30 — Method: an outlier is a value that lies far away from the pattern set by the rest of the data, so compare each value with the group the others form. Working: five of the counts, 5, 7, 8, 9 and 11, lie within 6 of one another and the steps between them are 2, 1, 1 and 2; the remaining count of 30 is 19 above the nearest of them, so it is the value that does not belong to the pattern. Answer: 30. The distractors: 5 comes from picking the smallest value, on the idea that the odd one out must be at the bottom of the list; 11 comes from ordering the data and stopping one value short, taking the largest of the counts that sit close together; 8.5 comes from working out the median, (8 + 9) ÷ 2, and giving a measure of centre where a value standing apart was asked for.
- (c) No — 8 from one class is too small to represent the school. — Method: judge reliability by asking whether the sample is both large enough, and spread across the population, relative to what it is meant to represent. Working: 8 pupils is a tiny fraction of the school's 1,000 pupils, and all 8 come from a single class rather than a range of year groups, so the sample is both too small and too narrow to represent the whole school reliably. She is not right. Saying any sample size gives an equally reliable estimate ignores that reliability generally improves with a larger, more representative sample. Saying the method is unreliable because it was not done online is not a reason connected to sample size or representativeness at all. Saying 8 is reliable because it is more than half her class compares the sample to the wrong population — the school has 1,000 pupils, not one class. Always judge a sample's size against the population it is meant to represent, not against a smaller group within it.
- (c) 80 — Method: the range is a measure of spread and is found by subtracting the smallest value from the largest. Working: the largest number sold is 100 and the smallest is 20, so the range is 100 − 20 = 80. Answer: 80. The distractors: 100 comes from writing down the largest value and never subtracting the smallest; 60 comes from working out the median, the middle value of 20, 40, 60, 70, 100, instead of the range; 58 comes from working out the mean, 290 ÷ 5, which measures centre rather than spread.
- (d) 6 — Method: the mode, or modal value, is the value that occurs most often in the data set, and it is a value from the data rather than a count. Working: size 4 occurs twice, size 5 occurs once, size 6 occurs three times and size 9 occurs once, so the highest frequency is three and the size it belongs to is 6. Answer: 6. The distractors: 3 comes from writing down the frequency of the most common size instead of the size itself; 9 comes from picking the largest size in the list, which confuses the mode with the maximum; 4 comes from stopping at the first size that repeats rather than checking which size repeats most often.
- (a) 144° — Method: a pie chart shares the 360° at its centre between the categories in proportion to their frequencies, so the angle of a sector is that category's fraction of the total multiplied by 360°. Working: the sector stands for 40 pupils out of 100, which is the fraction 40/100; one pupil is worth 360 ÷ 100 = 3.6°, so 40 pupils are worth 40 × 3.6° = 144°. Answer: 144°, and the answer is an angle in degrees, not a number of pupils. The distractors: 40° comes from sharing out 100 instead of 360, so the percentage is written straight down as a number of degrees; 216° comes from working out the angle for the other 60 pupils, 60 × 3.6°, which is the rest of the pie chart; 180° comes from assuming that the tallest line must stand for half of the pupils and so take half of the chart.
Build your own mix at the worksheet builder.