Printable · GCSE Foundation · ages 14-16
Statistics worksheet — GCSE Foundation
Fifteen questions across the statistics statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Statistics worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (b) On average a plant grew 1.5 cm taller for each extra day — Method: in the equation of a line, the number multiplying x is the gradient, and a gradient states the change in y produced by an increase of 1 in x, read in the units of the two axes. Working: here x is measured in days and y in centimetres, so the gradient 1.5 carries the units centimetres per day. Testing it on the line, 5 days gives 1.5 × 5 + 4 = 11.5 cm and 6 days gives 1.5 × 6 + 4 = 13 cm, a rise of 1.5 cm for the one extra day. Answer: on average a plant grew 1.5 cm taller for each extra day of watering. The distractors: 1.5 cm as the height before any watering is the value of y when x is 0, which is the other number in the equation, 4 cm, so this swaps the gradient and the intercept; 1.5 cm as the gap between the tallest and the shortest plant reads the gradient as a range, when a range is a difference between two of the 16 plants and a gradient is a rate; 1.5 days for each extra centimetre inverts the rate, dividing days by centimetres instead of centimetres by days, and the line gives 1 cm of growth in two thirds of a day.
- (d) An outlier from the damaged wing, not the trend. — That bird's point lies a long way from the rising trend followed by every other bird, and its low wingspan is explained by the damaged wing rather than by its age — it is an outlier caused by an unusual factor, not part of the general relationship between age and wingspan, so it should not be used when drawing the line of best fit. Saying every point must be used ignores that an outlier caused by a separate, identifiable factor can rightly be set aside. Saying it shows no correlation ignores that the other 19 points do show a clear rising trend; one outlier does not remove that. Saying it proves the line is inaccurate confuses one unusual bird with a fault in the line itself, when the line correctly describes the trend followed by the rest of the data.
- (c) 5 — Method: the mode is the value that occurs most often, so count how many times each different value appears and compare the counts. Working: 3 appears twice, 5 appears three times, 7 appears once and 8 appears once, so the highest frequency is three and the value carrying it is 5. Answer: 5. The distractors: 3 comes from writing down the frequency of the most common answer instead of the answer itself; 7 comes from taking the middle number of the list as it was written, which applies the median without ordering the data and without answering the question asked; 8 comes from picking the largest value, which confuses the mode with the maximum.
- (c) 7 — Method: the median is the middle value when the data are written in order of size, and with an odd number of values there is exactly one middle value. Working: the numbers are already in order, 2, 4, 7, 12, 26, and there are 5 of them, so the middle position is the third and the value sitting there is 7. Answer: 7, with two values below it and two above it. The distractors: 10.2 comes from working out the mean, 51 ÷ 5, instead of the median; 14 comes from taking the value halfway between the smallest and the largest, (2 + 26) ÷ 2; 24 comes from working out the range, 26 − 2, which measures spread rather than centre.
- (d) Full-time workers, as most are at work at that time — Method: a sample is biased when the method of contact makes part of the population much less likely to be reached, so test each group against where its members actually are between 10 am and 2 pm on a weekday, and test each stated reason against the facts. Working: those hours are the middle of the working day, so people in full-time employment are at work and not beside a landline telephone, while people who are retired and people who are unemployed are far more likely to be at home and are reached at the usual rate; the method therefore collects far fewer replies from full-time workers than their share of the adult population the council is consulting. Answer: full-time workers, as most are at work at that time. The distractors: the reply naming retired people rests on the false claim that most retired people are at work in the daytime, when in fact a daytime call reaches them more easily than anyone; the reply naming unemployed people rests on the false claim that they are out during the day, when they too are among the easiest people to reach by a daytime call; the reply naming children rests on the false claim that children are at home at 11 am on a Tuesday, when they are at school and so are not reached by the call at all, and school-age children are in any case not the adults whose views the council is collecting.
- (c) Strong negative correlation — Method: correlation is described by two things — the direction the points take as the graph is read from left to right, and how closely the points lie to a single straight line. Working: reading the pairs in order of age, the ages rise 14, 18, 23, 27, 31, 36, 42, 49 while the scores fall 92, 88, 85, 80, 78, 74, 70, 65; the score falls at every single step, with no reversal anywhere, so the points fall from left to right and lie close to a straight line. Answer: strong negative correlation — negative for the falling direction, strong because every point follows the pattern. The distractors: strong positive correlation comes from noticing a clear pattern and calling any clear pattern positive, without checking the direction; weak negative correlation comes from reading the direction correctly but judging points that do not lie exactly on a straight line to be only loosely related, when these eight fall without a single exception; no correlation comes from reading a falling trend as though it showed no relationship at all, when a falling trend is itself a relationship.
- (d) Testing destroys bulbs, so testing all leaves none to sell. — Method: testing every item in a population instead of a sample is a census — sensible only when testing does not use up or destroy what is being tested. Working: here, testing a bulb to find its lifespan destroys it, so testing all 50,000 bulbs would leave nothing left to sell — a sample lets the company estimate the typical lifespan without destroying its whole stock. Extra electricity used in testing is not the real reason a census is avoided here — it is the destruction of the product that matters. Saying a sample is always more accurate than a full census is the wrong way round: a census, if it could be carried out, gives the exact figure for the whole population — it is testing being destructive, not a lack of accuracy, that rules it out here. There is no law against testing every item a company makes — nothing in the question suggests that. When testing destroys the item being tested, sampling is necessary, not just convenient.
- (b) Tea — Method: the mode is the category with the highest frequency. Working: tea has a frequency of 8, which is higher than coffee's 7, hot chocolate's 4 and juice's 1. Mode = tea. Coffee has the second-highest frequency, 7, not the highest, so it is not the mode. Hot chocolate, with a frequency of 4, and juice, with a frequency of 1, both have lower frequencies still. Always compare every frequency in the table before naming the mode — the highest number wins, however close the next one is.
- (a) 35 minutes — Chloe arrives at 09:30, so she needs the first departure time that is at or after 09:30. The bus at 09:25 has already left five minutes before she arrives, so it is missed, not caught; the next one on the timetable is 10:05. From 09:30 to 10:00 is 30 minutes, then a further 5 minutes to 10:05, so the wait is 35 minutes. Giving 40 minutes measures the gap from the missed 09:25 bus to the 10:05 bus, counting from the bus Chloe missed instead of from the time she arrived. Giving 5 minutes uses the missed 09:25 bus, working out 09:30 − 09:25 the wrong way round. Giving 45 minutes comes from treating the times as decimals — 10.05 − 9.30 = 0.75, then × 60 = 45 — instead of working in hours and minutes, where 05 minutes past the hour is not 0.05 of an hour.
- (a) 26 — Method: a line of best fit lets one quantity be predicted from the other, so the score is substituted into the equation of the line and the resulting inequality is solved for the number of hours. Working: a score of at least 80 means 2.5x + 15 ≥ 80; taking 15 from both sides gives 2.5x ≥ 65, and dividing both sides by 2.5 gives x ≥ 26, so the least whole number of hours is 26. Checking, 2.5 × 26 + 15 = 80, which does reach the target. Answer: 26 hours — and this is only an estimate, because a line of best fit predicts a trend rather than an individual result, and a prediction made outside the range of hours the pupils actually revised for would be an extrapolation and less reliable still. The distractors: 27 comes from reaching 26 and then rounding up again, although 26 hours already gives a score of exactly 80; 32 comes from 80 ÷ 2.5, which ignores the 15 in the equation of the line; 38 comes from (80 + 15) ÷ 2.5, that is from adding the 15 instead of subtracting it when rearranging.
- (c) The frequency of that category — Method: a bar chart for categorical data has one bar for each category, and the vertical scale on which the bars are measured is a count. Working: a bar drawn twice as tall as another tells you that twice as many items of data fell into its category, so the height measures how many items of data belong to that one category, which is exactly what a frequency is. Answer: the height of each bar is the frequency of that category — a count of items of data. The distractors: the number of different categories comes from reading the vertical scale as though it counted the bars, which is shown along the horizontal axis instead; the total of all the data comes from treating one bar as though it stood for the whole data set rather than for one category; the mean of all the data comes from confusing a bar chart with a measure of average, which no single bar can show.
- (b) No — in order the numbers are 1, 3, 5, 7, 9, so the median is 5. — Method: the median is the middle value of the data in order of size, so the data must be sorted before any position is read off. Working: Noah's list 9, 3, 7, 1, 5 is not in order; sorted it becomes 1, 3, 5, 7, 9, and with 5 values the middle position is the third, which now holds 5 rather than 7. Noah has read the third value of the unsorted list. Answer: no — in order the numbers are 1, 3, 5, 7, 9, so the median is 5. The distractors: the reply giving 3 as the median sorts the data correctly but then reads the value in the second place instead of the third; the reply that 7 is the third number he wrote accepts a position in the unsorted list, which is exactly the mistake the question is about; the reply using the mean claims a value of 7 for it, but the mean is 25 ÷ 5 = 5, so that reasoning is false as well.
- (a) A vertical line chart (discrete numerical data) — The number of pets is discrete numerical data — whole-number values such as 0, 1, 2, 3 or 4 — recorded for one variable, so a vertical line chart is the chart specified for this kind of data. A bar chart is used for categorical data, such as favourite colour, not numerical values counted like this. A pie chart shows proportions of a whole and does not show the frequency of each separate value. A scatter graph compares two different variables against each other, and only one variable, the number of pets, is recorded here.
- (c) 16 kg — Method: sort the seven weights before finding the middle value. Working: in order, the weights are 10, 12, 14, 16, 18, 20 and 50 kg. There are 7 values, so the median is the 4th one: 16 kg. Reading off the 4th weight in the order the vet recorded them, 10 kg, skips the sorting step and is not the median. Working out the mean, 140 ÷ 7 = 20 kg, finds a different average altogether. Working out the range, 50 − 10 = 40 kg, finds the spread, not the middle value. Always sort your data first — the median lives in the ordered list, not the collection order.
- (d) 24 — Method: for a sample in proportion to the population, apply the same fraction that each group makes up of the whole population to the size of the sample. Working: women make up 300 out of the 500 members, a fraction of 300 ÷ 500 = 0.6. Applying that fraction to the sample of 40 gives 0.6 × 40 = 24 women. Splitting the sample evenly, 40 ÷ 2 = 20, ignores that the club has more women than men and treats the two groups as equal in size, which they are not. Misreading the sample size as 50 instead of 40, then applying the 3:2 ratio of women to men, 3 ÷ 5 × 50 = 30, uses the right ratio but the wrong sample total. Working out the number of MEN instead of women, 200 ÷ 500 × 40 = 16, answers a different question — how many men, not how many women, belong in the sample. Always apply each group's own share of the population to the sample size, and check which group the question is actually asking about.
Build your own mix at the worksheet builder.