Printable · GCSE Foundation · ages 14-16
Statistics worksheet — GCSE Foundation
Fifteen questions across the statistics statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Statistics worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (d) Both the mean and the range increase. — The original mean is 150 + 152 + 155 + 158 + 160 = 775, and 775 ÷ 5 = 155 cm; the original range is 160 − 150 = 10 cm. Including the new height of 170 cm gives a new total of 775 + 170 = 945, and 945 ÷ 6 = 157.5 cm, which is higher than 155 cm, and a new range of 170 − 150 = 20 cm, which is higher than 10 cm, so both the mean and the range increase. Saying the range stays the same ignores that 170 cm is a new, higher maximum than the old 160 cm. Saying the mean stays the same ignores that 170 cm is above the original mean of 155 cm, which pulls the average up. Saying both decrease is the opposite of what happens here.
- (c) The data show a link only; a third factor may affect both — Method: a study of this kind measures two quantities and reports how they change together; deciding that one of them produces the other is a further claim, and it needs evidence that the measurements alone cannot give. Working: the study shows that more coffee goes with better concentration, which is a positive correlation; but a third factor that was never measured, such as how motivated someone is, could raise both the coffee drinking and the concentration, and the concentration could equally be what leads to the extra coffee. Answer: the data show a link only, because a third factor may be affecting both quantities, so no claim about cause can be made. The distractors: calling the conclusion safe because the correlation is positive treats the direction of a correlation as proof of cause, which no direction can give; calling it wrong because the correlation is negative misreads the direction of the relationship, since the study reports both quantities rising together; saying the two quantities are not linked denies the correlation the study actually found, when what fails is only the claim about cause.
- (c) 80 — Method: the range is a measure of spread and is found by subtracting the smallest value from the largest. Working: the largest number sold is 100 and the smallest is 20, so the range is 100 − 20 = 80. Answer: 80. The distractors: 100 comes from writing down the largest value and never subtracting the smallest; 60 comes from working out the median, the middle value of 20, 40, 60, 70, 100, instead of the range; 58 comes from working out the mean, 290 ÷ 5, which measures centre rather than spread.
- (d) It asks two things at once and invites agreement — Method: a survey question is faulty when a reply to it cannot be read as evidence about one single thing, so check how many claims it contains and whether its wording pushes the reader one way. Working: the question joins two separate claims, that learning matters and that more homework should be set, so a reply of yes could mean either of them or both and cannot be counted as evidence about homework; the opening words “Do you agree” also invite agreement instead of leaving the reader free to say no. Answer: it asks two things at once and invites agreement. The distractors: the reply calling it too short mistakes length for clarity, when the fault is that too much has been packed in rather than too little; the reply about long words is false, since every word in the question is an everyday one and the fault lies in what is being asked rather than in the vocabulary used to ask it; the reply that the question is fine takes a yes or no answer as proof that the question works, which is exactly what a double question defeats.
- (c) 22 kg — Method: multiply the mean by the number of parcels to rebuild the total mass, then subtract the masses that are known. Working: four parcels with a mean mass of 17 kg have a total mass of 17 × 4 = 68 kg; the three known parcels total 12 + 16 + 18 = 46 kg; so the fourth parcel has mass 68 − 46 = 22 kg. Answer: 22 kg. The distractors: 68 kg comes from stopping at the total mass of all four parcels; 17 kg comes from assuming the missing parcel must have the mean mass; 5 kg comes from multiplying the mean by 3, the number of parcels whose mass is given, leaving 51 − 46 = 5.
- (a) 1.24 — Method: for data given as a frequency table, the mean is Σfx ÷ Σf — multiply each value by its frequency, add the results, then divide by the total frequency. Working: 0 × 6 = 0. 1 × 10 = 10. 2 × 6 = 12. 3 × 3 = 9. So Σfx = 0 + 10 + 12 + 9 = 31. The total frequency is Σf = 6 + 10 + 6 + 3 = 25. Mean = 31 ÷ 25 = 1.24 siblings. Averaging the frequency column itself, (6 + 10 + 6 + 3) ÷ 4 = 6.25, mixes up the frequencies with the values they belong to. Writing down 1, the number of siblings with the highest frequency, gives the mode, not the mean. Writing down 31 stops after finding Σfx and forgets to divide by the total frequency, 25. Always divide Σfx by Σf — never stop at the top of the fraction.
- (a) 62.5 — Method: a mean cannot be averaged with a new value — rebuild the total, add the new value to it, then divide by the new count. Working: three numbers with a mean of 50 have a total of 50 × 3 = 150; adding 100 makes the total 150 + 100 = 250; there are now 4 numbers, so the new mean is 250 ÷ 4 = 62.5. Answer: 62.5. The distractors: 75 comes from averaging the old mean with the new value, (50 + 100) ÷ 2, which ignores that three numbers pull against one; 50 comes from assuming an extra value leaves the mean unchanged; 37.5 comes from dividing the old total of 150 by the new count of 4, adding the new value to the count but not to the total.
- (b) Positive correlation — Method: the type of correlation is named from the direction the points take as the scatter graph is read from left to right. Working: the points rise from left to right, so as the arm span read on the horizontal axis increases, the height read on the vertical axis increases as well; two quantities that increase together show positive correlation. Answer: positive correlation. The distractors: negative correlation comes from naming the direction the wrong way round, since a negative correlation needs the points to fall as the graph is read from left to right; no correlation comes from treating points that are spread out rather than sitting exactly on a line as though they showed no relationship; direct proportion comes from confusing a rising trend with proportion, which would additionally need the line through the points to pass through the origin and would mean doubling one quantity doubles the other.
- (c) The median, £160,000, as one very high price lifts the mean — Method: find both averages, then choose the one that sits closer to the bulk of the data. Working: in order the prices are 140,000, 150,000, 160,000, 170,000 and 580,000, so the median is the third of the five, £160,000. For the mean, 140,000 + 150,000 + 160,000 + 170,000 + 580,000 = 1,200,000 and 1,200,000 ÷ 5 = 240,000, so the mean is £240,000. Four of the five houses sold for £170,000 or less, so a reader told that a typical price is £240,000 would expect to pay at least £70,000 more than any of those four cost. Answer: the median, £160,000, as one very high price lifts the mean. The distractors: £580,000 is the middle value of the list as it is printed, which is the median only when the values have first been put in order; £240,000 is the mean, chosen on the ground that a median ignores three of the five prices, but a median uses all five to find which one is central and is then untroubled by how extreme the outer values are; £155,000 comes from deleting the £580,000 house and taking the mean of what is left, since 140,000 + 150,000 + 160,000 + 170,000 = 620,000 and 620,000 ÷ 4 = 155,000, but a real sale may not be thrown away merely for being large.
- (b) Tea — Method: the mode is the category with the highest frequency. Working: tea has a frequency of 8, which is higher than coffee's 7, hot chocolate's 4 and juice's 1. Mode = tea. Coffee has the second-highest frequency, 7, not the highest, so it is not the mode. Hot chocolate, with a frequency of 4, and juice, with a frequency of 1, both have lower frequencies still. Always compare every frequency in the table before naming the mode — the highest number wins, however close the next one is.
- (d) Only families with strong feelings bothered to reply. — Method: a survey has non-response bias when only some of the people asked actually reply, and those who do are not a typical cross-section of everyone who was asked. Working: only 30 of the 200 families sent back their questionnaire, and 27 of those 30 — the great majority — said they were unhappy. Families who feel strongly about an issue, particularly those with a complaint, are far more likely to make the effort to reply than families who are simply satisfied and see no need to say anything, so the 30 replies over-represent unhappy families. Saying the families who replied were picked at random by the school gets the sampling the wrong way round: nobody picked them — they picked themselves by deciding to reply, and that is precisely why they are not a typical cross-section of all 200. Saying postal surveys always have low response rates restates that the response was low without explaining why a low response rate, on its own, makes a result unrepresentative — it is the reason FOR the low response, not the low response itself, that causes the bias here. Saying that the 27 unhappy replies show most families are unhappy is exactly the mistake the question is warning against: it treats the loudest 30 replies as if they stood for the other 170 who never sent theirs back. A low response rate is a warning sign only because the people who bother to reply are rarely typical of everyone who was asked.
- (a) 12 mm — Method: the range is the highest value minus the lowest value. Working: the highest rainfall is 15 mm and the lowest is 3 mm, so the range is 15 − 3 = 12 mm. Giving 15 mm alone states the highest value, not the range. Giving 3 mm alone states the lowest value, not the range. Sorting the six values, 3, 5, 9, 11, 12 and 15, and averaging the middle two, (9 + 11) ÷ 2 = 10 mm, finds the median, a completely different statistic. The range always needs BOTH the highest and the lowest value — never just one of them.
- (c) 10 — Method: work out the mean that can be found straight away, then use total = mean × number of values on the group of three to find the missing number. Working: the mean of 15 and 25 is (15 + 25) ÷ 2 = 40 ÷ 2 = 20, so the group of three must also have a mean of 20; three numbers with a mean of 20 have a total of 20 × 3 = 60, and 20 + 30 = 50 of that total is already accounted for, so x = 60 − 50 = 10. Answer: 10, and checking, (10 + 20 + 30) ÷ 3 = 20. The distractors: 20 comes from working out the mean the two groups share and writing that down as x; −10 comes from dividing the group of three by 2 instead of by 3, which gives x + 50 = 40; 70 comes from reading the total 15 + 25 = 40 as the mean of the pair, which sets the target total at 120 and leaves x = 70.
- (a) 150 bulbs — Method: assume the proportion faulty in a random sample is the proportion faulty in the whole day's output, and scale the sample up to the population. Working: the sample of 80 has to be scaled up to 4,000 bulbs, and 4,000 ÷ 80 = 50, so the day's output is 50 sample-sized batches. Each batch is expected to contain the same 3 faulty bulbs, so the estimate is 3 × 50 = 150. Answer: 150 bulbs, and it is an estimate, because another sample of 80 would probably contain a different number of faulty bulbs. The distractors: 50 bulbs is the scale factor 4,000 ÷ 80 written down as though it were the answer, so it reports how many batches there are rather than how many faulty bulbs; 120 bulbs comes from reading 3 out of 80 as 3%, then taking 0.03 × 4,000 = 120, but 3 out of 80 is 3.75%; 240 bulbs comes from 3 × 80 = 240, multiplying the faulty bulbs by the size of the sample instead of by the scale factor, which uses the 80 twice and the 4,000 not at all.
- (a) Leeds has a higher median and a greater range than York. — In order, Leeds's temperatures are 14, 16, 18, 19 and 23, so the median is the middle value, 18, and the range is 23 − 14 = 9. York's temperatures in order are 15, 17, 17, 18 and 18, so the median is 17, and the range is 18 − 15 = 3. Since 18 is higher than 17, and 9 is greater than 3, Leeds has both the higher median and the greater range. Choosing 'Leeds has a higher median but a smaller range than York' gets the median comparison right but the range comparison backwards — Leeds's range of 9 is actually greater than York's range of 3. Choosing 'York has a higher median and a greater range than Leeds' reverses both comparisons. Choosing 'York has a higher median but a smaller range than Leeds' reverses the median comparison; York's median of 17 is lower than Leeds's 18, even though it is correct that York's range is the smaller one.
Build your own mix at the worksheet builder.