Printable · GCSE Foundation · ages 14-16
Statistics worksheet — GCSE Foundation
Fifteen questions across the statistics statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Statistics worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (d) An outlier from the damaged wing, not the trend. — That bird's point lies a long way from the rising trend followed by every other bird, and its low wingspan is explained by the damaged wing rather than by its age — it is an outlier caused by an unusual factor, not part of the general relationship between age and wingspan, so it should not be used when drawing the line of best fit. Saying every point must be used ignores that an outlier caused by a separate, identifiable factor can rightly be set aside. Saying it shows no correlation ignores that the other 19 points do show a clear rising trend; one outlier does not remove that. Saying it proves the line is inaccurate confuses one unusual bird with a fault in the line itself, when the line correctly describes the trend followed by the rest of the data.
- (c) Thursday — Method: on a bar chart the tallest bar belongs to the greatest value, so compare the five temperatures and then read off the day that the greatest one belongs to. Working: the temperatures are 20 °C, 22 °C, 18 °C, 25 °C and 23 °C; in order of size these are 18, 20, 22, 23 and 25, so the greatest temperature is 25 °C, and the day recorded with 25 °C is Thursday. Answer: Thursday — the answer is a day, not a temperature. The distractors: Friday comes from stopping at the final temperature listed instead of comparing all five; Wednesday comes from picking out the shortest bar, 18 °C, and so answering for the lowest temperature rather than the highest; Monday comes from writing down the first day in the chart without comparing any of the temperatures at all.
- (a) 26 — Method: a line of best fit lets one quantity be predicted from the other, so the score is substituted into the equation of the line and the resulting inequality is solved for the number of hours. Working: a score of at least 80 means 2.5x + 15 ≥ 80; taking 15 from both sides gives 2.5x ≥ 65, and dividing both sides by 2.5 gives x ≥ 26, so the least whole number of hours is 26. Checking, 2.5 × 26 + 15 = 80, which does reach the target. Answer: 26 hours — and this is only an estimate, because a line of best fit predicts a trend rather than an individual result, and a prediction made outside the range of hours the pupils actually revised for would be an extrapolation and less reliable still. The distractors: 27 comes from reaching 26 and then rounding up again, although 26 hours already gives a score of exactly 80; 32 comes from 80 ÷ 2.5, which ignores the 15 in the equation of the line; 38 comes from (80 + 15) ÷ 2.5, that is from adding the 15 instead of subtracting it when rearranging.
- (c) 76 marks — Method: a mean of means only works when the groups are the same size, so rebuild each class's total mark, add the totals and divide by the number of pupils altogether. Working: Class A scored 30 × 72 = 2160 marks and Class B scored 20 × 82 = 1640 marks, giving 2160 + 1640 = 3800 marks between 50 pupils, so the overall mean is 3800 ÷ 50 = 76 marks. Answer: 76 marks. The distractors: 77 marks comes from averaging the two class means, (72 + 82) ÷ 2, which ignores the different class sizes; 78 marks comes from attaching each mean to the other class's size, (30 × 82 + 20 × 72) ÷ 50; 3800 marks comes from stopping at the combined total and never dividing by 50.
- (d) Testing destroys bulbs, so testing all leaves none to sell. — Method: testing every item in a population instead of a sample is a census — sensible only when testing does not use up or destroy what is being tested. Working: here, testing a bulb to find its lifespan destroys it, so testing all 50,000 bulbs would leave nothing left to sell — a sample lets the company estimate the typical lifespan without destroying its whole stock. Extra electricity used in testing is not the real reason a census is avoided here — it is the destruction of the product that matters. Saying a sample is always more accurate than a full census is the wrong way round: a census, if it could be carried out, gives the exact figure for the whole population — it is testing being destructive, not a lack of accuracy, that rules it out here. There is no law against testing every item a company makes — nothing in the question suggests that. When testing destroys the item being tested, sampling is necessary, not just convenient.
- (c) It is not representative, as she picked her own friends — Method: judge a sample by asking whether the pupils in it were chosen in a way that gives the whole school a fair chance of being heard. Working: Isla's friends are a group she formed herself, and friends tend to share tastes, so their favourite programme is likely to match hers rather than the school's, and pupils in other year groups and other friendship groups had no chance at all of being asked; the fault lies in how the pupils were selected, not in how many of them there were. Answer: it is not representative, as she picked her own friends. The distractors: the reply blaming the size claims the pupils were picked at random, which is false here, and it is the common mistake of thinking a biased sample can be cured by making it bigger; the reply calling the sample too large is false in the other direction, as a survey is never spoilt by collecting more replies; the reply that the sample is fine treats attending the school as enough, which would make any group of pupils in the building a fair sample.
- (a) x = 0 gives y = −20: a negative number sold — The y-intercept is the value the line predicts when x = 0: y = 3 × 0 − 20 = −20. A kiosk cannot sell a negative number of ice creams, so this is not a sensible estimate. The 3 in the equation is the gradient, not the intercept, so an option claiming x = 0 gives y = 3 has swapped the two numbers around — substituting x = 0 makes the 3x term equal 0, leaving −20, not 3. The danger of extrapolating to very high temperatures is a real issue with this line, but it is a different issue from the y-intercept, so it does not answer this question. And whether x = 0 could occur on a trading day is beside the point: the model still makes that prediction, and it is the prediction itself, −20, that is impossible.
- (d) 0 — Method: the range is the largest value minus the smallest value, whatever those two values turn out to be. Working: every value is 10, so the largest value is 10 and the smallest value is 10 as well, and the range is 10 − 10 = 0. Answer: 0 — a range of nothing says the data do not vary at all. The distractors: 10 comes from writing down the repeated value itself instead of the difference between the extremes; 20 comes from adding the largest and the smallest, 10 + 10, instead of subtracting; 40 comes from adding all four values, which gives the total sold and not a measure of spread.
- (c) Height 170 cm, mass 65 kg — Method: a point on a scatter graph is written as a pair of coordinates in which the horizontal value is written first and the vertical value second, so each value is matched to the quantity named on its own axis. Working: in (170, 65) the value 170 is the horizontal coordinate and the horizontal axis shows height in centimetres, so the height is 170 cm; the value 65 is the vertical coordinate and the vertical axis shows mass in kilograms, so the mass is 65 kg. Answer: height 170 cm, mass 65 kg, each with the unit named on its own axis. The distractors: height 65 cm and mass 170 kg come from reading the pair the wrong way round, which would describe an impossible person; height 170 cm and mass 170 kg come from reading the horizontal coordinate for both quantities and never using the second number; height 235 cm and mass 105 kg come from combining the two coordinates, 170 + 65 and 170 − 65, instead of reading them separately.
- (c) 156 cm — Method: to combine two groups' means, multiply each group's mean by its own number of pupils, add the two totals together, then divide by the total number of pupils in both groups. Working: 20 × 150 = 3,000 cm for the boys and 10 × 168 = 1,680 cm for the girls, giving a combined total of 3,000 + 1,680 = 4,680 cm. Dividing by all 30 pupils gives 4,680 ÷ 30 = 156 cm. Giving 159 cm averages the two means, (150 + 168) ÷ 2, treating the two groups as if they had the same number of pupils, when there are twice as many boys as girls. Giving 4,680 cm finds the correct combined total height but stops there, forgetting the final division by the 30 pupils. Giving 234 cm divides the combined total by 20, the number of boys only, forgetting that the total also includes the 10 girls. Always weight each mean by its own group size, and always divide by the TOTAL number of pupils in both groups combined.
- (c) Because every pupil has an equal chance of being picked — Method: whether a sample represents its population is decided by the selection method, not by the size of the sample, so ask whether the method gives every member of the population the same chance of being chosen. Working: the names are drawn at random from a list of all 10,000 pupils, so each pupil has the same chance, 500 out of 10,000, of being drawn, and no group of pupils is more likely to appear than any other; that is what keeps bias out of the sample. Answer: because every pupil has an equal chance of being picked. The distractors: the reply about 5% treats the sampling fraction as the test of fairness, but a badly chosen 5% is still biased and a well chosen 1% is not; the reply about 500 being large enough makes size the test instead, which is the same mistake in another form, since a large sample drawn from one school would still misrepresent the city; the reply about the most willing pupils describes self-selection, which hands the choice of who is in the sample to the pupils who feel most strongly about the question.
- (b) 74 marks — Method: the two groups are different sizes, so their means cannot simply be averaged — rebuild each group's total mark, add the totals and divide by all 50 pupils. Working: Group A scored 20 × 80 = 1600 marks and Group B scored 30 × 70 = 2100 marks, giving 1600 + 2100 = 3700 marks altogether, so the overall mean is 3700 ÷ 50 = 74 marks. Answer: 74 marks, which sits nearer to 70 than to 80 because the larger group scored 70. The distractors: 75 marks comes from averaging the two group means, (80 + 70) ÷ 2, as though the groups were the same size; 76 marks comes from attaching each mean to the other group's size, (20 × 70 + 30 × 80) ÷ 50; 150 marks comes from adding the two means together and never dividing at all.
- (b) A person's shoe size and their favourite colour — A person's shoe size is not linked to which colour they prefer, so these two show no correlation. The other three pairs are all genuinely correlated: distance travelled and fuel used rise together, which is positive correlation; hours of revision and test score generally rise together, which is also positive correlation; and as outdoor temperature rises, fewer woolly hats are sold, which is negative correlation. Negative correlation is still a real relationship between two variables — it is not the same thing as no relationship at all, so the temperature and hats pair is not the answer to this question.
- (d) Both the mean and the range increase. — The original mean is 150 + 152 + 155 + 158 + 160 = 775, and 775 ÷ 5 = 155 cm; the original range is 160 − 150 = 10 cm. Including the new height of 170 cm gives a new total of 775 + 170 = 945, and 945 ÷ 6 = 157.5 cm, which is higher than 155 cm, and a new range of 170 − 150 = 20 cm, which is higher than 10 cm, so both the mean and the range increase. Saying the range stays the same ignores that 170 cm is a new, higher maximum than the old 160 cm. Saying the mean stays the same ignores that 170 cm is above the original mean of 155 cm, which pulls the average up. Saying both decrease is the opposite of what happens here.
- (b) All 2,000 members of the sports centre. — Method: in a survey, the population is the whole group the survey is trying to find out about, and the sample is the smaller group actually asked. Working: this survey wants to know what the sports centre's members think, so the population is every one of the 2,000 members — whether or not they were personally asked. Saying the population is the 100 members who were asked names the sample, not the population; the sample is drawn FROM the population, so it is smaller than it, not the same as it. Saying the population is everybody who lives in Ipswich widens the group far beyond who the survey is actually about — plenty of Ipswich residents are not members of the sports centre at all, so they are outside this survey altogether. Saying the population is the members who say they are unhappy confuses the population with a result of the survey: whether a member turns out to be happy or unhappy is something the survey finds out, not part of the definition of who is being studied. The population is always the whole group the question is about, before any sampling or any results come in.
Build your own mix at the worksheet builder.