Printable · GCSE Foundation · ages 14-16
Statistics worksheet — GCSE Foundation
Fifteen questions across the statistics statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Statistics worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (a) A straight line sloping down from left to right — Method: a line of best fit is a straight line drawn to follow the trend of the points, so its slope is decided by the direction of the relationship between the two quantities. Working: as the price rises, the satisfaction score falls, so the points start high on the left of the graph and finish low on the right; the straight line that follows them therefore slopes downwards as the graph is read from left to right, which is the line of a negative correlation. Answer: a straight line sloping down from left to right. The distractors: a line sloping up comes from reading a falling relationship as a rising one; a horizontal line comes from expecting no correlation, since a horizontal line says the satisfaction score does not change as the price changes; a curve passing through every point comes from thinking a line of best fit has to touch all of the plotted points, when it is a single straight line drawn through the middle of them.
- (c) 60 minutes — Method: the median is the middle value once the data have been put in order of size, so the list must be sorted before any position is read. Working: in order the times are 50, 55, 60, 65, 90 minutes; there are 5 values, so the middle position is the third and the time sitting there is 60 minutes. Answer: 60 minutes. The distractors: 64 minutes comes from working out the mean, 320 ÷ 5, instead of the median; 70 minutes comes from taking the time halfway between the shortest and the longest, (50 + 90) ÷ 2; 40 minutes comes from working out the range, 90 − 50, which measures spread rather than centre.
- (a) 30 — Method: an outlier is a value that lies far away from the pattern set by the rest of the data, so compare each value with the group the others form. Working: five of the counts, 5, 7, 8, 9 and 11, lie within 6 of one another and the steps between them are 2, 1, 1 and 2; the remaining count of 30 is 19 above the nearest of them, so it is the value that does not belong to the pattern. Answer: 30. The distractors: 5 comes from picking the smallest value, on the idea that the odd one out must be at the bottom of the list; 11 comes from ordering the data and stopping one value short, taking the largest of the counts that sit close together; 8.5 comes from working out the median, (8 + 9) ÷ 2, and giving a measure of centre where a value standing apart was asked for.
- (c) 80 — Method: the range is a measure of spread and is found by subtracting the smallest value from the largest. Working: the largest number sold is 100 and the smallest is 20, so the range is 100 − 20 = 80. Answer: 80. The distractors: 100 comes from writing down the largest value and never subtracting the smallest; 60 comes from working out the median, the middle value of 20, 40, 60, 70, 100, instead of the range; 58 comes from working out the mean, 290 ÷ 5, which measures centre rather than spread.
- (c) 7 — Method: the median is the middle value when the data are written in order of size, and with an odd number of values there is exactly one middle value. Working: the numbers are already in order, 2, 4, 7, 12, 26, and there are 5 of them, so the middle position is the third and the value sitting there is 7. Answer: 7, with two values below it and two above it. The distractors: 10.2 comes from working out the mean, 51 ÷ 5, instead of the median; 14 comes from taking the value halfway between the smallest and the largest, (2 + 26) ÷ 2; 24 comes from working out the range, 26 − 2, which measures spread rather than centre.
- (b) At 0 guests, the model predicts 2 m of table — The y-intercept of a line of best fit y = mx + c is the value of y when x = 0. Here y = 0.5 × 0 + 2 = 2, so the line predicts a table length of 2 m when there are 0 guests. The 2 m does not grow as more guests arrive — that role belongs to the gradient, 0.5 — so an option saying each extra guest adds 2 m has swapped the two numbers around. The 2 is a length in metres, not a number of guests, so an option requiring 2 guests before set-up has misread its units. And the table length does change with x, since it is 0.5x + 2 and not a fixed value, so an option claiming the table is always 2 m ignores the 0.5x term completely.
- (d) Correlation is a link; causation is one causing the other — Method: the two words describe different claims — one is about a pattern in the data, the other is about what produced that pattern. Working: correlation says only that two quantities tend to change together, which is something a scatter graph can display; causation says that a change in one quantity actually brings about the change in the other, which needs evidence a scatter graph cannot supply, because a third quantity may be driving both. Answer: correlation is a link between the quantities, while causation is one quantity causing the change in another. The distractors: the statement giving causation as the link and correlation as the cause simply swaps the two words over; the statement that the words mean the same thing is the classic error of reading a correlation as proof of cause; the statement that a scatter graph shows causation but not correlation reverses what a scatter graph can do, since the pattern it displays is exactly the correlation.
- (c) The frequency of that category — Method: a bar chart for categorical data has one bar for each category, and the vertical scale on which the bars are measured is a count. Working: a bar drawn twice as tall as another tells you that twice as many items of data fell into its category, so the height measures how many items of data belong to that one category, which is exactly what a frequency is. Answer: the height of each bar is the frequency of that category — a count of items of data. The distractors: the number of different categories comes from reading the vertical scale as though it counted the bars, which is shown along the horizontal axis instead; the total of all the data comes from treating one bar as though it stood for the whole data set rather than for one category; the mean of all the data comes from confusing a bar chart with a measure of average, which no single bar can show.
- (d) 0 — Method: the range is the largest value minus the smallest value, whatever those two values turn out to be. Working: every value is 10, so the largest value is 10 and the smallest value is 10 as well, and the range is 10 − 10 = 0. Answer: 0 — a range of nothing says the data do not vary at all. The distractors: 10 comes from writing down the repeated value itself instead of the difference between the extremes; 20 comes from adding the largest and the smallest, 10 + 10, instead of subtracting; 40 comes from adding all four values, which gives the total sold and not a measure of spread.
- (c) 28 — Method: multiply the number of whole symbols by the value of one symbol, then add the value of any half symbol shown. Working: 3 whole symbols represent 3 × 8 = 24 cars. The half symbol represents 4 cars. Total cars sold in March = 24 + 4 = 28. Leaving out the half symbol, 3 × 8 = 24, undercounts by exactly the value of that half symbol. Treating the half symbol as if it were a full symbol, 4 × 8 = 32, overcounts because it doubles the value the half symbol is worth. Giving 3.5 reports the number of symbols shown, not the number of cars they represent — the key still needs to be applied. Always apply the key to every symbol shown, including a half symbol, rather than reading off the symbol count itself.
- (b) No — in order the numbers are 1, 3, 5, 7, 9, so the median is 5. — Method: the median is the middle value of the data in order of size, so the data must be sorted before any position is read off. Working: Noah's list 9, 3, 7, 1, 5 is not in order; sorted it becomes 1, 3, 5, 7, 9, and with 5 values the middle position is the third, which now holds 5 rather than 7. Noah has read the third value of the unsorted list. Answer: no — in order the numbers are 1, 3, 5, 7, 9, so the median is 5. The distractors: the reply giving 3 as the median sorts the data correctly but then reads the value in the second place instead of the third; the reply that 7 is the third number he wrote accepts a position in the unsorted list, which is exactly the mistake the question is about; the reply using the mean claims a value of 7 for it, but the mean is 25 ÷ 5 = 5, so that reasoning is false as well.
- (c) Thursday — Method: on a bar chart the tallest bar belongs to the greatest value, so compare the five temperatures and then read off the day that the greatest one belongs to. Working: the temperatures are 20 °C, 22 °C, 18 °C, 25 °C and 23 °C; in order of size these are 18, 20, 22, 23 and 25, so the greatest temperature is 25 °C, and the day recorded with 25 °C is Thursday. Answer: Thursday — the answer is a day, not a temperature. The distractors: Friday comes from stopping at the final temperature listed instead of comparing all five; Wednesday comes from picking out the shortest bar, 18 °C, and so answering for the lowest temperature rather than the highest; Monday comes from writing down the first day in the chart without comparing any of the temperatures at all.
- (d) 648 kg — Method: to estimate a total from a sample, multiply the sample's mean by the number of items in the whole population, then check the units the question asks for. Working: 32.4 g × 20,000 = 648,000 g. Converting to kilograms, 648,000 ÷ 1,000 = 648 kg. This is only an estimate, not an exact total, because it assumes every one of the 20,000 packets has exactly the sample mean mass, when in reality individual packets vary above and below it. Giving 1.62 kg multiplies the mean by 50, the SAMPLE size, instead of by 20,000, the number of packets actually made that day — this finds the total mass of the 50 sampled packets, not the day's production. Giving 32.4 kg treats the sample mean itself, in grams, as if it already were the day's total mass in kilograms, skipping the scaling up altogether. Giving 648,000 kg correctly scales the mean up to the whole day's production but never converts the answer from grams to kilograms, leaving it 1,000 times too large. Always scale a sample's mean up by the SIZE OF THE WHOLE POPULATION, and always finish by checking the units the question asks for.
- (a) £16,000 — Method: first find the quarter with the highest sales figure, then subtract quarter 1's sales from it — remembering that every figure is given in THOUSANDS of pounds. Working: the highest sales figure is quarter 2, at £34,000 (34 thousand pounds). The increase from quarter 1 is £34,000 − £18,000 = £16,000. Giving £34,000 reads off the highest sales figure on its own, without subtracting quarter 1's sales — that is the highest quarter's total, not the increase. Giving £12,000 uses quarter 3's sales, 30, the SECOND-highest figure, instead of quarter 2's 34, the actual highest — 30 − 18 = 12, but quarter 3 is not the quarter with the highest sales. Giving £16 gets the subtraction right, 34 − 18 = 16, but forgets that every figure in the question is in thousands of pounds, so the increase is £16,000, not £16. Always identify the correct quarter FIRST, and always check the units the numbers are given in before writing your final answer.
- (b) All 2,000 members of the sports centre. — Method: in a survey, the population is the whole group the survey is trying to find out about, and the sample is the smaller group actually asked. Working: this survey wants to know what the sports centre's members think, so the population is every one of the 2,000 members — whether or not they were personally asked. Saying the population is the 100 members who were asked names the sample, not the population; the sample is drawn FROM the population, so it is smaller than it, not the same as it. Saying the population is everybody who lives in Ipswich widens the group far beyond who the survey is actually about — plenty of Ipswich residents are not members of the sports centre at all, so they are outside this survey altogether. Saying the population is the members who say they are unhappy confuses the population with a result of the survey: whether a member turns out to be happy or unhappy is something the survey finds out, not part of the definition of who is being studied. The population is always the whole group the question is about, before any sampling or any results come in.
Build your own mix at the worksheet builder.