Printable · GCSE Foundation · ages 14-16
Statistics worksheet — GCSE Foundation
Fifteen questions across the statistics statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Statistics worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (c) No — 8 from one class is too small to represent the school. — Method: judge reliability by asking whether the sample is both large enough, and spread across the population, relative to what it is meant to represent. Working: 8 pupils is a tiny fraction of the school's 1,000 pupils, and all 8 come from a single class rather than a range of year groups, so the sample is both too small and too narrow to represent the whole school reliably. She is not right. Saying any sample size gives an equally reliable estimate ignores that reliability generally improves with a larger, more representative sample. Saying the method is unreliable because it was not done online is not a reason connected to sample size or representativeness at all. Saying 8 is reliable because it is more than half her class compares the sample to the wrong population — the school has 1,000 pupils, not one class. Always judge a sample's size against the population it is meant to represent, not against a smaller group within it.
- (a) 27 — Method: turn the mean into a total using total = mean × number of values, then subtract the numbers that are already known. Working: four numbers with a mean of 18 have a total of 18 × 4 = 72; the three known numbers give 10 + 15 + 20 = 45; so x = 72 − 45 = 27. Answer: 27, and checking, (10 + 15 + 20 + 27) ÷ 4 = 72 ÷ 4 = 18. The distractors: 72 comes from stopping at the total the four numbers must reach and never subtracting the known three; 18 comes from assuming the missing number must equal the mean; 45 comes from stopping at the total of the three known numbers.
- (b) 1 — Method: for data in a frequency table, find the position of the median using (n + 1) ÷ 2, then read off the value at that position from the cumulative frequencies. Working: there are 19 pupils, so the median is the 10th value. The cumulative frequencies are 7 (up to 0 pets), 10 (up to 1 pet), 14 (up to 2 pets) and 19 (up to 3 pets). The 10th value falls at the end of the '1 pet' group, so the median is 1 pet. Giving 0 pets is the mode — the category with the highest frequency, 7 — not the median. Giving 3, the highest number of pets minus the lowest, finds the range, a different statistic entirely. Giving 19 states the total number of pupils, not a number of pets at all. Find the middle POSITION first, then read off the value it belongs to — do not confuse it with the mode, the range or the total.
- (a) A vertical line chart (discrete numerical data) — The number of pets is discrete numerical data — whole-number values such as 0, 1, 2, 3 or 4 — recorded for one variable, so a vertical line chart is the chart specified for this kind of data. A bar chart is used for categorical data, such as favourite colour, not numerical values counted like this. A pie chart shows proportions of a whole and does not show the frequency of each separate value. A scatter graph compares two different variables against each other, and only one variable, the number of pets, is recorded here.
- (d) 19 kg — Method: estimate the mean of grouped data by multiplying each class's midpoint by its frequency, adding the four totals, then dividing by the total frequency. Working: the midpoints are 5, 15, 25 and 35 kg. The weighted totals are 11 × 5 = 55, 5 × 15 = 75, 5 × 25 = 125 and 9 × 35 = 315, which add to 570. Dividing by the 30 dogs gives an estimate of 570 ÷ 30 = 19 kg. Giving 5 kg reads off the midpoint of the modal class, 0 < m ≤ 10, the class with the most dogs — but the class with the most dogs is not where the mean falls, and neither is a substitute for actually calculating it. Giving 20 kg averages the four midpoints, (5 + 15 + 25 + 35) ÷ 4, treating every class as equally likely and ignoring that far more dogs are in the lightest and heaviest classes than in the middle two. Giving 570 kg stops after finding the correct weighted total and forgets the final division by the 30 dogs. Always weight each midpoint by its own frequency, and always finish by dividing by the total frequency, not the number of classes.
- (c) 7 — Method: the median is the middle value when the data are written in order of size, and with an odd number of values there is exactly one middle value. Working: the numbers are already in order, 2, 4, 7, 12, 26, and there are 5 of them, so the middle position is the third and the value sitting there is 7. Answer: 7, with two values below it and two above it. The distractors: 10.2 comes from working out the mean, 51 ÷ 5, instead of the median; 14 comes from taking the value halfway between the smallest and the largest, (2 + 26) ÷ 2; 24 comes from working out the range, 26 − 2, which measures spread rather than centre.
- (d) Route 1, as its times vary by 6 minutes rather than 20 — Method: work out an average and a measure of spread for each route, then decide which matters to a commuter who must arrive on time every day. Working: for Route 1, 22 + 23 + 24 + 24 + 25 + 25 + 26 + 26 + 27 + 28 = 250 and 250 ÷ 10 = 25, so the mean is 25 minutes, and the range is 28 − 22 = 6 minutes. For Route 2, 18 + 19 + 20 + 20 + 21 + 22 + 26 + 30 + 36 + 38 = 250 and 250 ÷ 10 = 25, so the mean is also 25 minutes, but the range is 38 − 18 = 20 minutes. The means give no reason to prefer either route; the spreads do, because a commuter who must never be late has to allow for the worst day, which is 28 minutes on Route 1 and 38 minutes on Route 2. Answer: Route 1, as its times vary by 6 minutes rather than 20. The distractors: saying Route 2 has the lower mean assumes that its quicker-looking early times must pull the average down, when both routes total 250 minutes over the ten days; choosing Route 2 for its fastest journey of 18 minutes judges a route by its best day, and the commuter has to survive its worst; saying either route will do uses the equal means and ignores the spread altogether, which is the one thing that separates the two routes.
- (d) No, the range uses only the fastest and slowest time — Method: check what the range is built from, then look at what it leaves out. Working: both teams have a fastest time of 20 seconds and a slowest of 40 seconds, so both ranges are 40 − 20 = 20 seconds and Tomás has that part right. But the range is calculated from those two values alone. Six of Team A's seven times lie between 20 and 25 seconds, with a single time far out at 40; Team B is the other way round, with six of its seven times at 30 seconds or more and a single time far out at 20. So Team A bunches at the fast end and Team B at the slow end. The two patterns are quite different, and the range cannot see the difference because the five middle times never enter the calculation. Answer: no, because the range uses only the fastest and slowest time. The distractors: comparing the means answers a different question, since a mean measures position rather than spread, and two sets with the same spread can have different means; saying that equal ranges mean equal spread is the very assumption that fails here; saying that seven times each forces the spreads to match confuses the size of a data set with how its values are arranged inside it.
- (c) 90° — Method: the sectors of a pie chart share the 360° at the centre of the chart in the same proportion as the data, so a sector's angle is its share of the data multiplied by 360°. Working: a share of 25% is the fraction 25/100, which is one quarter of the whole chart, and one quarter of 360° is 360 ÷ 4 = 90°. Answer: 90°, an angle in degrees rather than a percentage. The distractors: 25° comes from sharing out 100 instead of 360, so the percentage is written straight down as a number of degrees; 14.4° comes from dividing 360 by 25 instead of multiplying 360 by the fraction 25/100, which is the division done the wrong way round; 45° comes from taking a quarter of 180° instead of a quarter of 360°, treating the pie chart as a semicircle.
- (d) 30 — Method: on a dual bar chart each bar is a separate frequency, so a total for the whole class is found by combining the two frequencies the bars show. Working: the bars show 14 boys and 16 girls, and 14 + 16 = 30. Answer: 30 pupils, a count of pupils in the class. The distractors: 32 comes from doubling the taller bar, 16 + 16, as though the two bars were equal; 28 comes from doubling the shorter bar, 14 + 14, in the same way; 2 comes from finding the difference between the two bars, 16 − 14, which answers how many more girls there are rather than how many pupils there are.
- (a) No, 150 pupils are a tenth of the school, chosen at random — Method: judge a sample on two things, whether every member of the population had the same chance of being chosen, and whether the sample is large enough to carry a pattern. Working: the 150 pupils were drawn from the register of every pupil in the school, so no year group or set is shut out and no pupil chooses to take part; and 150 ÷ 1,500 = 0.1, so one pupil in ten has been asked. A random sample of that share is ample for an estimate of how long the school's pupils spend on homework. Answer: no, because 150 pupils are a tenth of the school and were chosen at random. The distractors: saying a random sample always gives the exact school figure reaches the same verdict for a reason that is false, since a second random sample of 150 would give a slightly different mean; saying 150 pupils cannot be picked at random from 1,500 treats randomness as something only a whole population can have, when drawing names from the register is exactly how a random sample is taken; saying that only asking all 1,500 could show anything rejects sampling altogether, which would leave no way to study any population too large to count.
- (c) 10 — Method: work out the mean that can be found straight away, then use total = mean × number of values on the group of three to find the missing number. Working: the mean of 15 and 25 is (15 + 25) ÷ 2 = 40 ÷ 2 = 20, so the group of three must also have a mean of 20; three numbers with a mean of 20 have a total of 20 × 3 = 60, and 20 + 30 = 50 of that total is already accounted for, so x = 60 − 50 = 10. Answer: 10, and checking, (10 + 20 + 30) ÷ 3 = 20. The distractors: 20 comes from working out the mean the two groups share and writing that down as x; −10 comes from dividing the group of three by 2 instead of by 3, which gives x + 50 = 40; 70 comes from reading the total 15 + 25 = 40 as the mean of the pair, which sets the target total at 120 and leaves x = 70.
- (c) 140 — Method: the mean shares the total equally between the items, so add the values and then divide by how many there are. Working: the total is 120 + 200 + 160 + 80 = 560 pages and there are 4 books, so the mean is 560 ÷ 4 = 140 pages. Answer: 140. The distractors: 560 comes from stopping at the total number of pages and never dividing by 4; 280 comes from dividing the total by 2 instead of by the 4 books; 120 comes from working out the range, 200 − 80, which measures spread instead of centre.
- (c) Club members probably eat differently from most people — Method: a sample is biased when the group it is drawn from differs from the population in the very thing the survey is measuring, so compare the subgroup with the population on that quantity. Working: the survey measures eating habits, and people who join a sports club take more exercise than average and are known to eat differently from the town as a whole, so their replies pull the results away from the true picture for the town however many of them are asked. Answer: club members probably eat differently from most people. The distractors: the reply about the number of members treats bias as a question of size, but a large biased sample is still biased; the reply that the members were picked at random is false, since the council picked a club rather than picking residents, and it confuses bias with non-response; the reply that everyone asked lives in the town notes something true of the members but draws the false conclusion that the sample therefore covers the town, when a sample must reflect a population and not merely be taken from inside it.
- (b) 20 — Method: each sector of a pie chart stands for a percentage of the whole set of data, so the number of pupils in a sector is that percentage of the total number of pupils. Working: the football sector is 50% and the whole pie chart stands for all 40 pupils, so the number of pupils is 50% of 40 = 0.5 × 40 = 20. Answer: 20 pupils, which is a count of pupils rather than a percentage. The distractors: 10 comes from taking the netball sector, 25% of 40, instead of the football sector; 80 comes from doubling the 40 pupils instead of halving them, which is what multiplying by 50% would do the wrong way round; 40 comes from writing down the total number of pupils in the class and never applying the percentage at all.
Build your own mix at the worksheet builder.