Printable · GCSE Foundation · ages 14-16
Statistics worksheet — GCSE Foundation
Fifteen questions across the statistics statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Statistics worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (b) Treat them as outliers and check them before deciding — Method: a point lying a long way from the pattern the rest of the data make is called an outlier, and an outlier is investigated before anything is done with it, because it may be an error in the data or it may be a genuine but unusual case. Working: 48 of the 50 points lie close to the rising line of best fit, so the trend is set by those 48; the two remaining points do not follow it, so they are identified as outliers and checked — a mistake in measuring or recording would be corrected, while a genuine reading would be kept and reported. Answer: treat them as outliers and check them before deciding what to do with them. The distractors: deleting them at once assumes that every point far from the line must be an error, which throws away real data; moving the line so that it passes through them assumes a line of best fit must touch particular points, when it is drawn to follow all 50; taking them as proof that there is no correlation lets two points overturn the pattern that the other 48 agree on.
- (a) 144° — Method: a pie chart shares the 360° at its centre between the categories in proportion to their frequencies, so the angle of a sector is that category's fraction of the total multiplied by 360°. Working: the sector stands for 40 pupils out of 100, which is the fraction 40/100; one pupil is worth 360 ÷ 100 = 3.6°, so 40 pupils are worth 40 × 3.6° = 144°. Answer: 144°, and the answer is an angle in degrees, not a number of pupils. The distractors: 40° comes from sharing out 100 instead of 360, so the percentage is written straight down as a number of degrees; 216° comes from working out the angle for the other 60 pupils, 60 × 3.6°, which is the rest of the pie chart; 180° comes from assuming that the tallest line must stand for half of the pupils and so take half of the chart.
- (b) Ethan, 10 seconds — Method: over the same distance the fastest runner is the one who takes the least time, so the smallest time in the table is found first and the name is then read from the same row. Working: the four times are 12 seconds, 15 seconds, 10 seconds and 14 seconds; in order of size these are 10, 12, 14 and 15, so the least time is 10 seconds, and the row holding 10 seconds is the row for Ethan. Answer: Ethan, 10 seconds — the time is in seconds, and a smaller time means a faster runner. The distractors: Grace with 15 seconds comes from taking the largest number in the table to mean the fastest runner, which reverses the relationship between time and speed over a fixed distance; Oliver with 12 seconds comes from writing down the first row of the table without comparing the four times; Ethan with 15 seconds comes from identifying the right runner but then reading the time from a different row of the table.
- (a) 30 — Method: an outlier is a value that lies far away from the pattern set by the rest of the data, so compare each value with the group the others form. Working: five of the counts, 5, 7, 8, 9 and 11, lie within 6 of one another and the steps between them are 2, 1, 1 and 2; the remaining count of 30 is 19 above the nearest of them, so it is the value that does not belong to the pattern. Answer: 30. The distractors: 5 comes from picking the smallest value, on the idea that the odd one out must be at the bottom of the list; 11 comes from ordering the data and stopping one value short, taking the largest of the counts that sit close together; 8.5 comes from working out the median, (8 + 9) ÷ 2, and giving a measure of centre where a value standing apart was asked for.
- (d) £15.50 — 2 × 6 = 12, and 12 + 3.50 = 15.50, so the estimated fare is £15.50. Choosing £12.00 stops after 2 × 6 = 12 and forgets to add the £3.50. Choosing £19.00 adds the distance and the constant first and then multiplies: 6 + 3.50 = 9.50, and 9.50 × 2 = 19.00, applying the ×2 to the whole sum instead of only to the distance. Choosing £13.00 multiplies only the constant term by 2 instead of the distance: 2 × 3.50 = 7, and 7 + 6 = 13.00.
- (a) Leeds has a higher median and a greater range than York. — In order, Leeds's temperatures are 14, 16, 18, 19 and 23, so the median is the middle value, 18, and the range is 23 − 14 = 9. York's temperatures in order are 15, 17, 17, 18 and 18, so the median is 17, and the range is 18 − 15 = 3. Since 18 is higher than 17, and 9 is greater than 3, Leeds has both the higher median and the greater range. Choosing 'Leeds has a higher median but a smaller range than York' gets the median comparison right but the range comparison backwards — Leeds's range of 9 is actually greater than York's range of 3. Choosing 'York has a higher median and a greater range than Leeds' reverses both comparisons. Choosing 'York has a higher median but a smaller range than Leeds' reverses the median comparison; York's median of 17 is lower than Leeds's 18, even though it is correct that York's range is the smaller one.
- (b) All 2,000 members of the sports centre. — Method: in a survey, the population is the whole group the survey is trying to find out about, and the sample is the smaller group actually asked. Working: this survey wants to know what the sports centre's members think, so the population is every one of the 2,000 members — whether or not they were personally asked. Saying the population is the 100 members who were asked names the sample, not the population; the sample is drawn FROM the population, so it is smaller than it, not the same as it. Saying the population is everybody who lives in Ipswich widens the group far beyond who the survey is actually about — plenty of Ipswich residents are not members of the sports centre at all, so they are outside this survey altogether. Saying the population is the members who say they are unhappy confuses the population with a result of the survey: whether a member turns out to be happy or unhappy is something the survey finds out, not part of the definition of who is being studied. The population is always the whole group the question is about, before any sampling or any results come in.
- (a) Priya — A line of best fit should be drawn so that the plotted points are roughly balanced above and below it. Work out the difference between the two counts for each pupil: Amir 10 − 2 = 8; Kofi 10 − 2 = 8 (10 below and 2 above); Leah 12 − 0 = 12; Priya 6 − 6 = 0. Priya's line has the smallest difference, an exact balance of 6 above and 6 below, so her line is drawn correctly. Amir's line has 10 of the 12 points above it, so it is drawn too low. Kofi's line has 10 of the 12 points below it, so it is drawn too high. Leah's line has every single point below it, so it is not a line of best fit at all.
- (a) The means are equal, and Class B's marks are the more consistent because its range is smaller. — Method: comparing two distributions needs two things — a measure of average and a measure of spread — and each must be put into the context of the question. Working: both classes have a mean mark of 70, so on average the two classes scored the same; the range measures spread, and Class A's range of 30 marks is three times Class B's range of 10 marks, so Class B's marks sit closely around the mean while Class A's are far more spread out. Answer: the means are equal, and Class B's marks are the more consistent because its range is smaller. The distractors: the reply crediting Class A with more consistency reverses the meaning of the range, treating a larger range as tighter data when a larger range means more spread; the reply that Class A's mean mark is higher compares the wrong pair of figures, reading the range of 30 as an average; the reply that Class B's mean mark is higher reads the spread correctly but its claim about the means is false, since both means are 70.
- (c) 16 kg — Method: sort the seven weights before finding the middle value. Working: in order, the weights are 10, 12, 14, 16, 18, 20 and 50 kg. There are 7 values, so the median is the 4th one: 16 kg. Reading off the 4th weight in the order the vet recorded them, 10 kg, skips the sorting step and is not the median. Working out the mean, 140 ÷ 7 = 20 kg, finds a different average altogether. Working out the range, 50 − 10 = 40 kg, finds the spread, not the middle value. Always sort your data first — the median lives in the ordered list, not the collection order.
- (c) 20 kg ≤ mass < 30 kg — The modal class is the class with the highest frequency. Reading the plotted points, the frequencies are 6, 10, 16, 6 and 2, so the highest frequency is 16, plotted at the midpoint 25. A class of width 10 centred on 25 runs from 25 − 5 = 20 to 25 + 5 = 30, so the modal class is 20 kg ≤ mass < 30 kg. Writing '25 kg' gives only the midpoint, not the class — the modal class is an interval, not a single value. '10 kg ≤ mass < 20 kg' is the class before the peak, centred on 15, which has frequency 10, not the highest. '30 kg ≤ mass < 40 kg' is the class after the peak, centred on 35, which has frequency 6, not the highest.
- (c) The data show a link only; a third factor may affect both — Method: a study of this kind measures two quantities and reports how they change together; deciding that one of them produces the other is a further claim, and it needs evidence that the measurements alone cannot give. Working: the study shows that more coffee goes with better concentration, which is a positive correlation; but a third factor that was never measured, such as how motivated someone is, could raise both the coffee drinking and the concentration, and the concentration could equally be what leads to the extra coffee. Answer: the data show a link only, because a third factor may be affecting both quantities, so no claim about cause can be made. The distractors: calling the conclusion safe because the correlation is positive treats the direction of a correlation as proof of cause, which no direction can give; calling it wrong because the correlation is negative misreads the direction of the relationship, since the study reports both quantities rising together; saying the two quantities are not linked denies the correlation the study actually found, when what fails is only the claim about cause.
- (d) 1100 — Method: to combine two samples of different sizes, add the faulty counts together and add the sample sizes together before scaling up, rather than treating the two samples separately. Working: the combined sample found 34 + 21 = 55 scratched cases out of 100 + 50 = 150 cases checked, a proportion of 55 ÷ 150. Applying that proportion to the week's production of 3,000 gives an estimate of 55 ÷ 150 × 3000 = 1100 scratched cases. Averaging the two shifts' proportions instead of combining their totals, (34 ÷ 100 + 21 ÷ 50) ÷ 2 = 0.38, gives 0.38 × 3000 = 1140 — this treats the two samples as equally weighted even though Shift A checked twice as many cases as Shift B. Using only Shift A's sample, 34 ÷ 100 × 3000 = 1020, ignores Shift B's cases completely. Using only Shift B's sample, 21 ÷ 50 × 3000 = 1260, ignores Shift A's cases completely. When two samples are different sizes, combine their totals before finding the proportion — do not average the two proportions, and do not use only one shift's sample.
- (c) The median, £160,000, as one very high price lifts the mean — Method: find both averages, then choose the one that sits closer to the bulk of the data. Working: in order the prices are 140,000, 150,000, 160,000, 170,000 and 580,000, so the median is the third of the five, £160,000. For the mean, 140,000 + 150,000 + 160,000 + 170,000 + 580,000 = 1,200,000 and 1,200,000 ÷ 5 = 240,000, so the mean is £240,000. Four of the five houses sold for £170,000 or less, so a reader told that a typical price is £240,000 would expect to pay at least £70,000 more than any of those four cost. Answer: the median, £160,000, as one very high price lifts the mean. The distractors: £580,000 is the middle value of the list as it is printed, which is the median only when the values have first been put in order; £240,000 is the mean, chosen on the ground that a median ignores three of the five prices, but a median uses all five to find which one is central and is then untroubled by how extreme the outer values are; £155,000 comes from deleting the £580,000 house and taking the mean of what is left, since 140,000 + 150,000 + 160,000 + 170,000 = 620,000 and 620,000 ÷ 4 = 155,000, but a real sale may not be thrown away merely for being large.
- (d) 6 — Method: the mode, or modal value, is the value that occurs most often in the data set, and it is a value from the data rather than a count. Working: size 4 occurs twice, size 5 occurs once, size 6 occurs three times and size 9 occurs once, so the highest frequency is three and the size it belongs to is 6. Answer: 6. The distractors: 3 comes from writing down the frequency of the most common size instead of the size itself; 9 comes from picking the largest size in the list, which confuses the mode with the maximum; 4 comes from stopping at the first size that repeats rather than checking which size repeats most often.
Build your own mix at the worksheet builder.