Printable · GCSE Foundation · ages 14-16
Statistics worksheet — GCSE Foundation
Fifteen questions across the statistics statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Statistics worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (b) 15 pupils — The frequencies are 5, 4, 3 and 3 pupils, and 5 + 4 + 3 + 3 = 15, so there are 15 pupils in the class. Choosing 6 pupils comes from adding the numbers of pets, 0 + 1 + 2 + 3 = 6, instead of the frequencies. Choosing 10 pupils comes from leaving out the '0 pets' row: 4 + 3 + 3 = 10. Choosing 18 pupils comes from counting the '3 pets' row twice: 5 + 4 + 3 + 3 + 3 = 18.
- (c) Yes — with an estimate of 320, above the 250 limit. — Method: scale the sample proportion up to the whole batch to get an estimate, then compare that estimate with the 250 limit to reach a decision. Working: in the sample, 4 out of 50 boards are faulty, a proportion of 4 ÷ 50 = 0.08. Applying that proportion to the batch of 4,000 gives an estimate of 0.08 × 4000 = 320 faulty boards. Since 320 is more than 250, the factory should scrap the batch. Inverting the proportion, 50 ÷ 4 = 12.5, and treating that as a percentage of the batch, 12.5% × 4000 = 500, still gives 'yes' but from the wrong fraction, so it overstates the estimate. Comparing the raw number of faulty boards found in the sample, 4, directly with the 250 limit skips the scaling up to the batch altogether, and 4 is nowhere near 250, so that route wrongly says 'no'. Dividing the batch by the sample size, 4000 ÷ 50 = 80, finds how many samples of 50 fit into the batch but stops before multiplying by the 4 faulty boards found, so it also wrongly says 'no'. Always find the proportion in the sample first, scale it up to the whole batch, and only then compare the estimate with the limit given.
- (a) 144° — Method: a pie chart shares the 360° at its centre between the categories in proportion to their frequencies, so the angle of a sector is that category's fraction of the total multiplied by 360°. Working: the sector stands for 40 pupils out of 100, which is the fraction 40/100; one pupil is worth 360 ÷ 100 = 3.6°, so 40 pupils are worth 40 × 3.6° = 144°. Answer: 144°, and the answer is an angle in degrees, not a number of pupils. The distractors: 40° comes from sharing out 100 instead of 360, so the percentage is written straight down as a number of degrees; 216° comes from working out the angle for the other 60 pupils, 60 × 3.6°, which is the rest of the pie chart; 180° comes from assuming that the tallest line must stand for half of the pupils and so take half of the chart.
- (c) Strong negative correlation — Method: correlation is described by two things — the direction the points take as the graph is read from left to right, and how closely the points lie to a single straight line. Working: reading the pairs in order of age, the ages rise 14, 18, 23, 27, 31, 36, 42, 49 while the scores fall 92, 88, 85, 80, 78, 74, 70, 65; the score falls at every single step, with no reversal anywhere, so the points fall from left to right and lie close to a straight line. Answer: strong negative correlation — negative for the falling direction, strong because every point follows the pattern. The distractors: strong positive correlation comes from noticing a clear pattern and calling any clear pattern positive, without checking the direction; weak negative correlation comes from reading the direction correctly but judging points that do not lie exactly on a straight line to be only loosely related, when these eight fall without a single exception; no correlation comes from reading a falling trend as though it showed no relationship at all, when a falling trend is itself a relationship.
- (a) 15 — Year 11 has 50 − 28 = 22 pupils in total. Of the 22 pupils who walk in total, 15 are in Year 10, so 22 − 15 = 7 Year 11 pupils walk. Subtracting that from the Year 11 total gives 22 − 7 = 15 Year 11 pupils who are driven. Choosing 28 takes the whole school's driven total, 50 − 22 = 28, and treats it as if it were Year 11's alone, without separating the year groups. Choosing 7 correctly finds how many Year 11 pupils walk but stops there, giving that figure instead of the number who are driven. Choosing 35 comes from 50 − 15, subtracting the Year 10 walkers from the whole school total rather than working within Year 11.
- (d) No, the range uses only the fastest and slowest time — Method: check what the range is built from, then look at what it leaves out. Working: both teams have a fastest time of 20 seconds and a slowest of 40 seconds, so both ranges are 40 − 20 = 20 seconds and Tomás has that part right. But the range is calculated from those two values alone. Six of Team A's seven times lie between 20 and 25 seconds, with a single time far out at 40; Team B is the other way round, with six of its seven times at 30 seconds or more and a single time far out at 20. So Team A bunches at the fast end and Team B at the slow end. The two patterns are quite different, and the range cannot see the difference because the five middle times never enter the calculation. Answer: no, because the range uses only the fastest and slowest time. The distractors: comparing the means answers a different question, since a mean measures position rather than spread, and two sets with the same spread can have different means; saying that equal ranges mean equal spread is the very assumption that fails here; saying that seven times each forces the spreads to match confuses the size of a data set with how its values are arranged inside it.
- (d) 44 — Method: the frequency of a category in a frequency table is the number of times that category was counted, and it is read from the row for that category. Working: the rows of the table pair each colour with its count, and the row for black is paired with the count 44, so the frequency of black cars is 44. Answer: 44 cars — a frequency is a count of cars, not a colour and not a percentage. The distractors: 37 comes from reading the count paired with silver, that is from reading the wrong row of the table; 137 comes from adding every count in the table, 44 + 37 + 26 + 18 + 12, which gives the total number of cars rather than the frequency of one colour; 5 comes from counting how many different colours the table lists instead of how many cars were black.
- (d) Route 1, as its times vary by 6 minutes rather than 20 — Method: work out an average and a measure of spread for each route, then decide which matters to a commuter who must arrive on time every day. Working: for Route 1, 22 + 23 + 24 + 24 + 25 + 25 + 26 + 26 + 27 + 28 = 250 and 250 ÷ 10 = 25, so the mean is 25 minutes, and the range is 28 − 22 = 6 minutes. For Route 2, 18 + 19 + 20 + 20 + 21 + 22 + 26 + 30 + 36 + 38 = 250 and 250 ÷ 10 = 25, so the mean is also 25 minutes, but the range is 38 − 18 = 20 minutes. The means give no reason to prefer either route; the spreads do, because a commuter who must never be late has to allow for the worst day, which is 28 minutes on Route 1 and 38 minutes on Route 2. Answer: Route 1, as its times vary by 6 minutes rather than 20. The distractors: saying Route 2 has the lower mean assumes that its quicker-looking early times must pull the average down, when both routes total 250 minutes over the ten days; choosing Route 2 for its fastest journey of 18 minutes judges a route by its best day, and the commuter has to survive its worst; saying either route will do uses the equal means and ignores the spread altogether, which is the one thing that separates the two routes.
- (b) At 0 guests, the model predicts 2 m of table — The y-intercept of a line of best fit y = mx + c is the value of y when x = 0. Here y = 0.5 × 0 + 2 = 2, so the line predicts a table length of 2 m when there are 0 guests. The 2 m does not grow as more guests arrive — that role belongs to the gradient, 0.5 — so an option saying each extra guest adds 2 m has swapped the two numbers around. The 2 is a length in metres, not a number of guests, so an option requiring 2 guests before set-up has misread its units. And the table length does change with x, since it is 0.5x + 2 and not a fixed value, so an option claiming the table is always 2 m ignores the 0.5x term completely.
- (b) 29 — There are 40 − 24 = 16 males, and 15 of them prefer cardio, so 16 − 15 = 1 male prefers weights. There are 24 females, and 10 prefer weights, so 24 − 10 = 14 females prefer cardio. Altogether, 15 + 14 = 29 people prefer cardio. Choosing 15 only counts the males who prefer cardio and forgets the females. Choosing 11 adds the two weights figures, 1 + 10 = 11, instead of the two cardio figures. Choosing 30 comes from 40 − 10, subtracting only the number of females who prefer weights from the grand total, rather than finding both cardio sub-totals separately.
- (a) Minutes a candle has burned and length remaining — As a candle burns for longer, less of it remains, so these two variables move in opposite directions as one increases — that is negative correlation. A pupil's shoe size generally increases as they get older, so age and shoe size show positive correlation, not negative, since both rise together. A football team's shirt colour is not a numerical quantity linked to how many matches it wins, so shirt colour and number of wins show no correlation at all. The number of letters in a pupil's name has no real connection to their ability in maths, so that pair also shows no correlation.
- (d) Only internet users reach the website; others are excluded. — Method: a sample is biased when it systematically leaves out part of the population, or systematically over-represents another part. Working: anyone without internet access, or who does not visit the council's website, has NO chance of being included — the sample is drawn only from internet-using residents, which is not the whole town. Saying too many people might respond because the survey is free confuses bias with sample size — bias is about who CAN be reached, not how many respond. Saying people might lie describes a different problem, response honesty, not who was sampled in the first place. Saying online surveys cannot be anonymous is not a reason connected to bias at all. A sample is biased when part of the population has no chance of being included, whatever the reason for that.
- (c) Neither causes the other; sunshine links both. — Both ice cream sales and sunburn cases tend to rise on hot, sunny days, so the amount of sunshine is a third factor linked to both — neither variable causes the other. Saying ice cream sales cause the sunburn assumes a causal link in one direction that the correlation alone cannot establish. Saying sunburn cases cause the ice cream sales assumes the reverse causal link, which is no more justified. Saying a strong correlation always means causation is the general error this question is testing: correlation, however strong, does not by itself prove that one variable causes the other.
- (d) 6 — Method: the mode, or modal value, is the value that occurs most often in the data set, and it is a value from the data rather than a count. Working: size 4 occurs twice, size 5 occurs once, size 6 occurs three times and size 9 occurs once, so the highest frequency is three and the size it belongs to is 6. Answer: 6. The distractors: 3 comes from writing down the frequency of the most common size instead of the size itself; 9 comes from picking the largest size in the list, which confuses the mode with the maximum; 4 comes from stopping at the first size that repeats rather than checking which size repeats most often.
- (b) A line graph — Sales recorded at the end of each of the twelve months are time series data, and a line graph is the chart built to show how a value changes over time, with the points usually joined in order. A pie chart is for showing categorical data as shares of a whole, not a trend over time. A pictogram shows a frequency for separate categories using symbols, not a continuous trend. A scatter graph is for comparing two different variables against each other, not one variable over time.
Build your own mix at the worksheet builder.