Printable · GCSE Foundation · ages 14-16
Statistics worksheet — GCSE Foundation
Fifteen questions across the statistics statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Statistics worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (b) Treat them as outliers and check them before deciding — Method: a point lying a long way from the pattern the rest of the data make is called an outlier, and an outlier is investigated before anything is done with it, because it may be an error in the data or it may be a genuine but unusual case. Working: 48 of the 50 points lie close to the rising line of best fit, so the trend is set by those 48; the two remaining points do not follow it, so they are identified as outliers and checked — a mistake in measuring or recording would be corrected, while a genuine reading would be kept and reported. Answer: treat them as outliers and check them before deciding what to do with them. The distractors: deleting them at once assumes that every point far from the line must be an error, which throws away real data; moving the line so that it passes through them assumes a line of best fit must touch particular points, when it is drawn to follow all 50; taking them as proof that there is no correlation lets two points overturn the pattern that the other 48 agree on.
- (d) 6 — Method: the mode, or modal value, is the value that occurs most often in the data set, and it is a value from the data rather than a count. Working: size 4 occurs twice, size 5 occurs once, size 6 occurs three times and size 9 occurs once, so the highest frequency is three and the size it belongs to is 6. Answer: 6. The distractors: 3 comes from writing down the frequency of the most common size instead of the size itself; 9 comes from picking the largest size in the list, which confuses the mode with the maximum; 4 comes from stopping at the first size that repeats rather than checking which size repeats most often.
- (d) Only families with strong feelings bothered to reply. — Method: a survey has non-response bias when only some of the people asked actually reply, and those who do are not a typical cross-section of everyone who was asked. Working: only 30 of the 200 families sent back their questionnaire, and 27 of those 30 — the great majority — said they were unhappy. Families who feel strongly about an issue, particularly those with a complaint, are far more likely to make the effort to reply than families who are simply satisfied and see no need to say anything, so the 30 replies over-represent unhappy families. Saying the families who replied were picked at random by the school gets the sampling the wrong way round: nobody picked them — they picked themselves by deciding to reply, and that is precisely why they are not a typical cross-section of all 200. Saying postal surveys always have low response rates restates that the response was low without explaining why a low response rate, on its own, makes a result unrepresentative — it is the reason FOR the low response, not the low response itself, that causes the bias here. Saying that the 27 unhappy replies show most families are unhappy is exactly the mistake the question is warning against: it treats the loudest 30 replies as if they stood for the other 170 who never sent theirs back. A low response rate is a warning sign only because the people who bother to reply are rarely typical of everyone who was asked.
- (a) A straight line sloping down from left to right — Method: a line of best fit is a straight line drawn to follow the trend of the points, so its slope is decided by the direction of the relationship between the two quantities. Working: as the price rises, the satisfaction score falls, so the points start high on the left of the graph and finish low on the right; the straight line that follows them therefore slopes downwards as the graph is read from left to right, which is the line of a negative correlation. Answer: a straight line sloping down from left to right. The distractors: a line sloping up comes from reading a falling relationship as a rising one; a horizontal line comes from expecting no correlation, since a horizontal line says the satisfaction score does not change as the price changes; a curve passing through every point comes from thinking a line of best fit has to touch all of the plotted points, when it is a single straight line drawn through the middle of them.
- (a) Minutes a candle has burned and length remaining — As a candle burns for longer, less of it remains, so these two variables move in opposite directions as one increases — that is negative correlation. A pupil's shoe size generally increases as they get older, so age and shoe size show positive correlation, not negative, since both rise together. A football team's shirt colour is not a numerical quantity linked to how many matches it wins, so shirt colour and number of wins show no correlation at all. The number of letters in a pupil's name has no real connection to their ability in maths, so that pair also shows no correlation.
- (d) 24 — Method: for a sample in proportion to the population, apply the same fraction that each group makes up of the whole population to the size of the sample. Working: women make up 300 out of the 500 members, a fraction of 300 ÷ 500 = 0.6. Applying that fraction to the sample of 40 gives 0.6 × 40 = 24 women. Splitting the sample evenly, 40 ÷ 2 = 20, ignores that the club has more women than men and treats the two groups as equal in size, which they are not. Misreading the sample size as 50 instead of 40, then applying the 3:2 ratio of women to men, 3 ÷ 5 × 50 = 30, uses the right ratio but the wrong sample total. Working out the number of MEN instead of women, 200 ÷ 500 × 40 = 16, answers a different question — how many men, not how many women, belong in the sample. Always apply each group's own share of the population to the sample size, and check which group the question is actually asking about.
- (d) The modal class, as the class with most pupils is shown — Method: a grouped frequency table records how many values fall into each class, but not the values themselves, so any average that needs the individual times can only be estimated from it. Working: the four frequencies are 8, 12, 6 and 4, and 8 + 12 + 6 + 4 = 30, so every pupil is counted. The largest frequency is 12, which belongs to the class 10 < t ≤ 20, and that class can be written down exactly, because finding it needs nothing but the counts the table already gives. Answer: the modal class, as the class with most pupils is shown. The distractors: the mean is said to use all 30 times, but the table does not hold them; the usual method replaces each class by its midpoint, 5, 15, 25 and 35, which gives an estimate of the mean and not its true value; the median is said to be shown, but the table locates only the class holding the 15th and 16th times, which is 10 < t ≤ 20, without saying what either time was; the range is said to be shown, but 0 and 40 are the boundaries of the first and last classes, not the fastest and slowest times actually recorded.
- (a) Leeds has a higher median and a greater range than York. — In order, Leeds's temperatures are 14, 16, 18, 19 and 23, so the median is the middle value, 18, and the range is 23 − 14 = 9. York's temperatures in order are 15, 17, 17, 18 and 18, so the median is 17, and the range is 18 − 15 = 3. Since 18 is higher than 17, and 9 is greater than 3, Leeds has both the higher median and the greater range. Choosing 'Leeds has a higher median but a smaller range than York' gets the median comparison right but the range comparison backwards — Leeds's range of 9 is actually greater than York's range of 3. Choosing 'York has a higher median and a greater range than Leeds' reverses both comparisons. Choosing 'York has a higher median but a smaller range than Leeds' reverses the median comparison; York's median of 17 is lower than Leeds's 18, even though it is correct that York's range is the smaller one.
- (c) No, 90 cm is far outside the heights on the graph — Method: a line of best fit describes the trend only across the stretch of data it was drawn through; predicting beyond that stretch is extrapolation, and nothing in the data supports it. Working: the heights used to draw this line run from 150 cm to 180 cm, all of them Year 10 pupils, while 90 cm is 60 cm below the shortest of them and belongs to a two-year-old child, whose build follows no trend the graph has measured. Substituting anyway gives 0.9 × 90 − 85 = −4, a mass of −4 kg, which cannot exist. Answer: no, because 90 cm is far outside the heights on the graph. The distractors: saying a line of best fit cannot be used to predict at all throws away its main purpose, since a prediction made between the plotted values is perfectly sound; saying the line passes through all 20 points misdescribes a line of best fit, which is drawn to follow the trend of the points and will normally pass through few of them; saying the equation works for any value put into it treats an equation fitted to Year 10 heights as a law of nature, and the mass of −4 kg shows what that assumption produces.
- (c) Height 170 cm, mass 65 kg — Method: a point on a scatter graph is written as a pair of coordinates in which the horizontal value is written first and the vertical value second, so each value is matched to the quantity named on its own axis. Working: in (170, 65) the value 170 is the horizontal coordinate and the horizontal axis shows height in centimetres, so the height is 170 cm; the value 65 is the vertical coordinate and the vertical axis shows mass in kilograms, so the mass is 65 kg. Answer: height 170 cm, mass 65 kg, each with the unit named on its own axis. The distractors: height 65 cm and mass 170 kg come from reading the pair the wrong way round, which would describe an impossible person; height 170 cm and mass 170 kg come from reading the horizontal coordinate for both quantities and never using the second number; height 235 cm and mass 105 kg come from combining the two coordinates, 170 + 65 and 170 − 65, instead of reading them separately.
- (b) Tea — Method: the mode is the category with the highest frequency. Working: tea has a frequency of 8, which is higher than coffee's 7, hot chocolate's 4 and juice's 1. Mode = tea. Coffee has the second-highest frequency, 7, not the highest, so it is not the mode. Hot chocolate, with a frequency of 4, and juice, with a frequency of 1, both have lower frequencies still. Always compare every frequency in the table before naming the mode — the highest number wins, however close the next one is.
- (d) 25% — First find the number of fruit cakes: 80 − 34 − 26 = 20. Then write this as a percentage of the total: 20 ÷ 80 × 100 = 25%. Giving 20% comes from reporting the count of fruit cakes, 20, directly as a percentage, without dividing by the total of 80 first. Giving 32.5% computes the percentage of chocolate cakes instead of fruit cakes: 26 ÷ 80 × 100 = 32.5%. Giving 42.5% computes the percentage of sponge cakes instead of fruit cakes: 34 ÷ 80 × 100 = 42.5%.
- (a) 30 — Method: an outlier is a value that lies far away from the pattern set by the rest of the data, so compare each value with the group the others form. Working: five of the counts, 5, 7, 8, 9 and 11, lie within 6 of one another and the steps between them are 2, 1, 1 and 2; the remaining count of 30 is 19 above the nearest of them, so it is the value that does not belong to the pattern. Answer: 30. The distractors: 5 comes from picking the smallest value, on the idea that the odd one out must be at the bottom of the list; 11 comes from ordering the data and stopping one value short, taking the largest of the counts that sit close together; 8.5 comes from working out the median, (8 + 9) ÷ 2, and giving a measure of centre where a value standing apart was asked for.
- (d) The mode, because colours cannot be added or ordered — Method: an average can only be used on data that supports the operation it needs. A mean needs the values to be added and divided, a median needs them to be placed in order, and a range needs one value to be taken away from another; a mode needs only counting, so it is the average available when the data are categories rather than numbers. Working: the data collected here are colours, silver, black, blue and red. The numbers 74, 52, 40 and 34 count the cars of each colour, they do not measure them, and 74 + 52 + 40 + 34 = 200 simply returns the size of the survey. No colour can be added to another, and there is no order that puts blue before red, so of the four averages only the one found by counting survives. Answer: the mode, because colours cannot be added or ordered, and the mode is silver. The distractors: the mean is said to use all 200 colours, and a mean of the four frequencies, 200 ÷ 4 = 50, is a number of cars rather than a colour, so it describes nothing about a typical car; the median is said to put the colours in order, but ordering the frequencies 34, 40, 52, 74 orders the counts, not the colours, and gives 46, again a number of cars; the range is not an average at all, and 74 − 34 = 40 measures the gap between the commonest and rarest counts, which is a measure of spread.
- (a) No, the size of the fire affects both of the quantities — Method: correlation says that two quantities change together; a claim that one of them produces the other is a further claim, and it needs evidence that a scatter graph on its own cannot give. Working: the graph does show strong positive correlation, so more engines did go with greater damage. But neither quantity was set by the researchers: both were decided by how large the fire was. A large blaze brings many appliances and also destroys a great deal, while a small one brings few and destroys little, so a third quantity is driving both of the recorded ones. Answer: no, because the size of the fire affects both of the quantities. The distractors: saying the correlation is negative contradicts the graph, which shows the two quantities rising together, and reaching the right verdict from a false reading of the data is not the reason the mark is for; saying that strong positive correlation shows one quantity causes the other is the assumption the question exists to test, and no strength of correlation can establish cause; saying the points lie close to the line of best fit describes how strong the correlation is, and strength and cause are different matters entirely.
Build your own mix at the worksheet builder.