Printable · GCSE Foundation · ages 14-16
Statistics worksheet — GCSE Foundation
Fifteen questions across the statistics statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Statistics worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (c) 10 — Method: work out the mean that can be found straight away, then use total = mean × number of values on the group of three to find the missing number. Working: the mean of 15 and 25 is (15 + 25) ÷ 2 = 40 ÷ 2 = 20, so the group of three must also have a mean of 20; three numbers with a mean of 20 have a total of 20 × 3 = 60, and 20 + 30 = 50 of that total is already accounted for, so x = 60 − 50 = 10. Answer: 10, and checking, (10 + 20 + 30) ÷ 3 = 20. The distractors: 20 comes from working out the mean the two groups share and writing that down as x; −10 comes from dividing the group of three by 2 instead of by 3, which gives x + 50 = 40; 70 comes from reading the total 15 + 25 = 40 as the mean of the pair, which sets the target total at 120 and leaves x = 70.
- (c) The frequency of that category — Method: a bar chart for categorical data has one bar for each category, and the vertical scale on which the bars are measured is a count. Working: a bar drawn twice as tall as another tells you that twice as many items of data fell into its category, so the height measures how many items of data belong to that one category, which is exactly what a frequency is. Answer: the height of each bar is the frequency of that category — a count of items of data. The distractors: the number of different categories comes from reading the vertical scale as though it counted the bars, which is shown along the horizontal axis instead; the total of all the data comes from treating one bar as though it stood for the whole data set rather than for one category; the mean of all the data comes from confusing a bar chart with a measure of average, which no single bar can show.
- (c) 7 — Method: the median is the middle value when the data are written in order of size, and with an odd number of values there is exactly one middle value. Working: the numbers are already in order, 2, 4, 7, 12, 26, and there are 5 of them, so the middle position is the third and the value sitting there is 7. Answer: 7, with two values below it and two above it. The distractors: 10.2 comes from working out the mean, 51 ÷ 5, instead of the median; 14 comes from taking the value halfway between the smallest and the largest, (2 + 26) ÷ 2; 24 comes from working out the range, 26 − 2, which measures spread rather than centre.
- (d) An outlier from the damaged wing, not the trend. — That bird's point lies a long way from the rising trend followed by every other bird, and its low wingspan is explained by the damaged wing rather than by its age — it is an outlier caused by an unusual factor, not part of the general relationship between age and wingspan, so it should not be used when drawing the line of best fit. Saying every point must be used ignores that an outlier caused by a separate, identifiable factor can rightly be set aside. Saying it shows no correlation ignores that the other 19 points do show a clear rising trend; one outlier does not remove that. Saying it proves the line is inaccurate confuses one unusual bird with a fault in the line itself, when the line correctly describes the trend followed by the rest of the data.
- (a) The modal size, 9, bought by more customers than any other — Method: work out both averages from the frequencies, then choose the one the shop can act on. Working: for the mean, multiply each size by the number of pairs sold at it and add: 6 × 4 + 7 × 5 + 8 × 8 + 9 × 13 + 10 × 10 = 340, and 340 ÷ 40 = 8.5, so the mean size is 8.5. The largest frequency is 13, which belongs to size 9, so the modal size is 9. The mean 8.5 is a size no customer in the record asked for, so 40 pairs of it would sit unsold, while 13 of the 40 customers wanted size 9, more than wanted any other size. Answer: the modal size, 9, bought by more customers than any other. The distractors: the mean size 8.5 does take account of all 40 pairs, but a mean of sizes is a summary figure and not a size the month's customers were buying; the mean size 8 comes from averaging the five sizes on sale, 6 + 7 + 8 + 9 + 10 = 40 and 40 ÷ 5 = 8, which ignores how many pairs were sold at each size and so treats the 4 pairs of size 6 as equal in weight to the 13 pairs of size 9; the range 4 comes from 10 − 6 and measures spread, so it says how wide a set of sizes the shop must stock, not which size to stock most of.
- (d) 0 — Method: the range is the largest value minus the smallest value, whatever those two values turn out to be. Working: every value is 10, so the largest value is 10 and the smallest value is 10 as well, and the range is 10 − 10 = 0. Answer: 0 — a range of nothing says the data do not vary at all. The distractors: 10 comes from writing down the repeated value itself instead of the difference between the extremes; 20 comes from adding the largest and the smallest, 10 + 10, instead of subtracting; 40 comes from adding all four values, which gives the total sold and not a measure of spread.
- (a) Priya — A line of best fit should be drawn so that the plotted points are roughly balanced above and below it. Work out the difference between the two counts for each pupil: Amir 10 − 2 = 8; Kofi 10 − 2 = 8 (10 below and 2 above); Leah 12 − 0 = 12; Priya 6 − 6 = 0. Priya's line has the smallest difference, an exact balance of 6 above and 6 below, so her line is drawn correctly. Amir's line has 10 of the 12 points above it, so it is drawn too low. Kofi's line has 10 of the 12 points below it, so it is drawn too high. Leah's line has every single point below it, so it is not a line of best fit at all.
- (a) 12 mm — Method: the range is the highest value minus the lowest value. Working: the highest rainfall is 15 mm and the lowest is 3 mm, so the range is 15 − 3 = 12 mm. Giving 15 mm alone states the highest value, not the range. Giving 3 mm alone states the lowest value, not the range. Sorting the six values, 3, 5, 9, 11, 12 and 15, and averaging the middle two, (9 + 11) ÷ 2 = 10 mm, finds the median, a completely different statistic. The range always needs BOTH the highest and the lowest value — never just one of them.
- (a) No, the size of the fire affects both of the quantities — Method: correlation says that two quantities change together; a claim that one of them produces the other is a further claim, and it needs evidence that a scatter graph on its own cannot give. Working: the graph does show strong positive correlation, so more engines did go with greater damage. But neither quantity was set by the researchers: both were decided by how large the fire was. A large blaze brings many appliances and also destroys a great deal, while a small one brings few and destroys little, so a third quantity is driving both of the recorded ones. Answer: no, because the size of the fire affects both of the quantities. The distractors: saying the correlation is negative contradicts the graph, which shows the two quantities rising together, and reaching the right verdict from a false reading of the data is not the reason the mark is for; saying that strong positive correlation shows one quantity causes the other is the assumption the question exists to test, and no strength of correlation can establish cause; saying the points lie close to the line of best fit describes how strong the correlation is, and strength and cause are different matters entirely.
- (c) No — 8 from one class is too small to represent the school. — Method: judge reliability by asking whether the sample is both large enough, and spread across the population, relative to what it is meant to represent. Working: 8 pupils is a tiny fraction of the school's 1,000 pupils, and all 8 come from a single class rather than a range of year groups, so the sample is both too small and too narrow to represent the whole school reliably. She is not right. Saying any sample size gives an equally reliable estimate ignores that reliability generally improves with a larger, more representative sample. Saying the method is unreliable because it was not done online is not a reason connected to sample size or representativeness at all. Saying 8 is reliable because it is more than half her class compares the sample to the wrong population — the school has 1,000 pupils, not one class. Always judge a sample's size against the population it is meant to represent, not against a smaller group within it.
- (d) Both the mean and the range increase. — The original mean is 150 + 152 + 155 + 158 + 160 = 775, and 775 ÷ 5 = 155 cm; the original range is 160 − 150 = 10 cm. Including the new height of 170 cm gives a new total of 775 + 170 = 945, and 945 ÷ 6 = 157.5 cm, which is higher than 155 cm, and a new range of 170 − 150 = 20 cm, which is higher than 10 cm, so both the mean and the range increase. Saying the range stays the same ignores that 170 cm is a new, higher maximum than the old 160 cm. Saying the mean stays the same ignores that 170 cm is above the original mean of 155 cm, which pulls the average up. Saying both decrease is the opposite of what happens here.
- (d) About 510 of the 600 bulbs are likely to have flowered — Method: the proportion found in a random sample is used as an estimate of the proportion in the whole population, and the conclusion is stated as an estimate, never as a fact about every member. Working: 17 of the 20 bulbs dug up had flowered, so the sample proportion is 17 ÷ 20 = 0.85, and applying that proportion to the whole planting gives 0.85 × 600 = 510 bulbs. A different random sample of 20 would very probably give a slightly different figure, so 510 is an estimate. Answer: about 510 of the 600 bulbs are likely to have flowered. The distractors: saying exactly 510 have flowered takes an estimate from a sample of 20 as a count of all 600, which no sample can deliver; saying exactly 17 of the 600 have flowered reports the sample count as though it were the population count, leaving the other 580 bulbs out of the answer altogether; saying about 20 have flowered uses the size of the sample as the estimate, when 20 is the number of bulbs she dug up rather than a number that flowered.
- (a) 62.5 — Method: a mean cannot be averaged with a new value — rebuild the total, add the new value to it, then divide by the new count. Working: three numbers with a mean of 50 have a total of 50 × 3 = 150; adding 100 makes the total 150 + 100 = 250; there are now 4 numbers, so the new mean is 250 ÷ 4 = 62.5. Answer: 62.5. The distractors: 75 comes from averaging the old mean with the new value, (50 + 100) ÷ 2, which ignores that three numbers pull against one; 50 comes from assuming an extra value leaves the mean unchanged; 37.5 comes from dividing the old total of 150 by the new count of 4, adding the new value to the count but not to the total.
- (a) 150 bulbs — Method: assume the proportion faulty in a random sample is the proportion faulty in the whole day's output, and scale the sample up to the population. Working: the sample of 80 has to be scaled up to 4,000 bulbs, and 4,000 ÷ 80 = 50, so the day's output is 50 sample-sized batches. Each batch is expected to contain the same 3 faulty bulbs, so the estimate is 3 × 50 = 150. Answer: 150 bulbs, and it is an estimate, because another sample of 80 would probably contain a different number of faulty bulbs. The distractors: 50 bulbs is the scale factor 4,000 ÷ 80 written down as though it were the answer, so it reports how many batches there are rather than how many faulty bulbs; 120 bulbs comes from reading 3 out of 80 as 3%, then taking 0.03 × 4,000 = 120, but 3 out of 80 is 3.75%; 240 bulbs comes from 3 × 80 = 240, multiplying the faulty bulbs by the size of the sample instead of by the scale factor, which uses the 80 twice and the 4,000 not at all.
- (a) 5 pupils are far too few to represent 900 pupils — Method: a sample can only support a claim about a population if it is chosen fairly and if it is large enough for the pattern in it to be more than chance. Working: Priya's method of choosing is fair, because the 5 pupils were picked at random, so every pupil had the same chance of being asked. The difficulty is the size: 900 ÷ 5 = 180, so each pupil she asks stands for 180 pupils. If two of the five happen to play in the same netball team, netball takes 40% of her sample on the strength of two answers, and a second sample of 5 could easily give a different favourite sport. Answer: 5 pupils are far too few to represent 900 pupils. The distractors: saying the pupils were not chosen at random contradicts the question, which states that they were; saying the 5 may each name a different sport describes what often happens in a small sample, but disagreement is not the fault, since 5 pupils who all named the same sport would be just as weak a basis for a claim about 900; saying a sample must hold at least half of the population is an invented rule, and a properly chosen sample of a few hundred can describe a population of many thousands.
Build your own mix at the worksheet builder.