Printable · GCSE Foundation · ages 14-16
Statistics worksheet — GCSE Foundation
Fifteen questions across the statistics statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Statistics worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (d) Route 1, as its times vary by 6 minutes rather than 20 — Method: work out an average and a measure of spread for each route, then decide which matters to a commuter who must arrive on time every day. Working: for Route 1, 22 + 23 + 24 + 24 + 25 + 25 + 26 + 26 + 27 + 28 = 250 and 250 ÷ 10 = 25, so the mean is 25 minutes, and the range is 28 − 22 = 6 minutes. For Route 2, 18 + 19 + 20 + 20 + 21 + 22 + 26 + 30 + 36 + 38 = 250 and 250 ÷ 10 = 25, so the mean is also 25 minutes, but the range is 38 − 18 = 20 minutes. The means give no reason to prefer either route; the spreads do, because a commuter who must never be late has to allow for the worst day, which is 28 minutes on Route 1 and 38 minutes on Route 2. Answer: Route 1, as its times vary by 6 minutes rather than 20. The distractors: saying Route 2 has the lower mean assumes that its quicker-looking early times must pull the average down, when both routes total 250 minutes over the ten days; choosing Route 2 for its fastest journey of 18 minutes judges a route by its best day, and the commuter has to survive its worst; saying either route will do uses the equal means and ignores the spread altogether, which is the one thing that separates the two routes.
- (d) 6 — Method: the mode, or modal value, is the value that occurs most often in the data set, and it is a value from the data rather than a count. Working: size 4 occurs twice, size 5 occurs once, size 6 occurs three times and size 9 occurs once, so the highest frequency is three and the size it belongs to is 6. Answer: 6. The distractors: 3 comes from writing down the frequency of the most common size instead of the size itself; 9 comes from picking the largest size in the list, which confuses the mode with the maximum; 4 comes from stopping at the first size that repeats rather than checking which size repeats most often.
- (c) Thursday — Method: on a bar chart the tallest bar belongs to the greatest value, so compare the five temperatures and then read off the day that the greatest one belongs to. Working: the temperatures are 20 °C, 22 °C, 18 °C, 25 °C and 23 °C; in order of size these are 18, 20, 22, 23 and 25, so the greatest temperature is 25 °C, and the day recorded with 25 °C is Thursday. Answer: Thursday — the answer is a day, not a temperature. The distractors: Friday comes from stopping at the final temperature listed instead of comparing all five; Wednesday comes from picking out the shortest bar, 18 °C, and so answering for the lowest temperature rather than the highest; Monday comes from writing down the first day in the chart without comparing any of the temperatures at all.
- (d) It asks two things at once and invites agreement — Method: a survey question is faulty when a reply to it cannot be read as evidence about one single thing, so check how many claims it contains and whether its wording pushes the reader one way. Working: the question joins two separate claims, that learning matters and that more homework should be set, so a reply of yes could mean either of them or both and cannot be counted as evidence about homework; the opening words “Do you agree” also invite agreement instead of leaving the reader free to say no. Answer: it asks two things at once and invites agreement. The distractors: the reply calling it too short mistakes length for clarity, when the fault is that too much has been packed in rather than too little; the reply about long words is false, since every word in the question is an everyday one and the fault lies in what is being asked rather than in the vocabulary used to ask it; the reply that the question is fine takes a yes or no answer as proof that the question works, which is exactly what a double question defeats.
- (b) Interpolation — The salary is being estimated for a value of x between 1 and 15, which is inside the range of x-values that were actually plotted, so this is interpolation. Extrapolation would apply if the estimate used a value of x below 1 or above 15, outside the plotted range. Correlation describes the relationship between the two variables, not the reliability of an estimate, and causation describes one variable actually causing a change in the other, which is a different idea altogether — neither is the word being asked for here.
- (d) £15.50 — 2 × 6 = 12, and 12 + 3.50 = 15.50, so the estimated fare is £15.50. Choosing £12.00 stops after 2 × 6 = 12 and forgets to add the £3.50. Choosing £19.00 adds the distance and the constant first and then multiplies: 6 + 3.50 = 9.50, and 9.50 × 2 = 19.00, applying the ×2 to the whole sum instead of only to the distance. Choosing £13.00 multiplies only the constant term by 2 instead of the distance: 2 × 3.50 = 7, and 7 + 6 = 13.00.
- (d) 0 — Method: the range is the largest value minus the smallest value, whatever those two values turn out to be. Working: every value is 10, so the largest value is 10 and the smallest value is 10 as well, and the range is 10 − 10 = 0. Answer: 0 — a range of nothing says the data do not vary at all. The distractors: 10 comes from writing down the repeated value itself instead of the difference between the extremes; 20 comes from adding the largest and the smallest, 10 + 10, instead of subtracting; 40 comes from adding all four values, which gives the total sold and not a measure of spread.
- (a) The relationship between two variables — Method: what a diagram shows is decided by what has to be known before a single mark can be plotted on it. Working: every point on a scatter graph is plotted from a pair of measurements taken from the same person or object, one read on the horizontal axis and one on the vertical axis; having two measurements for each point is what makes it possible to look for a pattern between them, and the pattern between two variables is what the graph displays. Answer: a scatter graph shows the relationship between two variables. The distractors: the frequency of each single value is what a bar chart or a vertical line chart shows, and it needs only one list of values; how a total is shared between categories is what a pie chart shows; how one quantity changes over time is what a time series line graph shows, in which one of the two axes is always time.
- (d) 19 kg — Method: estimate the mean of grouped data by multiplying each class's midpoint by its frequency, adding the four totals, then dividing by the total frequency. Working: the midpoints are 5, 15, 25 and 35 kg. The weighted totals are 11 × 5 = 55, 5 × 15 = 75, 5 × 25 = 125 and 9 × 35 = 315, which add to 570. Dividing by the 30 dogs gives an estimate of 570 ÷ 30 = 19 kg. Giving 5 kg reads off the midpoint of the modal class, 0 < m ≤ 10, the class with the most dogs — but the class with the most dogs is not where the mean falls, and neither is a substitute for actually calculating it. Giving 20 kg averages the four midpoints, (5 + 15 + 25 + 35) ÷ 4, treating every class as equally likely and ignoring that far more dogs are in the lightest and heaviest classes than in the middle two. Giving 570 kg stops after finding the correct weighted total and forgets the final division by the 30 dogs. Always weight each midpoint by its own frequency, and always finish by dividing by the total frequency, not the number of classes.
- (a) 15 — Year 11 has 50 − 28 = 22 pupils in total. Of the 22 pupils who walk in total, 15 are in Year 10, so 22 − 15 = 7 Year 11 pupils walk. Subtracting that from the Year 11 total gives 22 − 7 = 15 Year 11 pupils who are driven. Choosing 28 takes the whole school's driven total, 50 − 22 = 28, and treats it as if it were Year 11's alone, without separating the year groups. Choosing 7 correctly finds how many Year 11 pupils walk but stops there, giving that figure instead of the number who are driven. Choosing 35 comes from 50 − 15, subtracting the Year 10 walkers from the whole school total rather than working within Year 11.
- (a) Chloe's marks are far more spread out than Ben's — Method: a mean reports where a set of values sits, and two sets can sit in the same place while behaving quite differently, so a measure of spread has to be worked out as well. Working: Ben's marks add to 62 + 64 + 65 + 66 + 68 = 325 and 325 ÷ 5 = 65; Chloe's add to 40 + 52 + 65 + 78 + 90 = 325 and 325 ÷ 5 = 65, so the two means agree, as the question says. The ranges do not: Ben's is 68 − 62 = 6 marks, while Chloe's is 90 − 40 = 50 marks. Ben's five marks all sit within 3 marks of 65; Chloe's lowest is 25 marks below it and her highest 25 marks above it. Answer: Chloe's marks are far more spread out than Ben's, which is exactly what the mean cannot show. The distractors: saying Ben's marks are more spread out comes from subtracting in the order the values are written, 62 − 68 = −6 against 40 − 90 = −50, and then reading −6 as the larger spread; saying Chloe scored far more marks in total assumes a wider set of marks must add to more, when both totals are 325; saying the two sets vary by the same amount assumes that equal means force equal spread, when the two ranges are 6 and 50.
- (c) 140 — Method: the mean shares the total equally between the items, so add the values and then divide by how many there are. Working: the total is 120 + 200 + 160 + 80 = 560 pages and there are 4 books, so the mean is 560 ÷ 4 = 140 pages. Answer: 140. The distractors: 560 comes from stopping at the total number of pages and never dividing by 4; 280 comes from dividing the total by 2 instead of by the 4 books; 120 comes from working out the range, 200 − 80, which measures spread instead of centre.
- (c) It is not representative, as she picked her own friends — Method: judge a sample by asking whether the pupils in it were chosen in a way that gives the whole school a fair chance of being heard. Working: Isla's friends are a group she formed herself, and friends tend to share tastes, so their favourite programme is likely to match hers rather than the school's, and pupils in other year groups and other friendship groups had no chance at all of being asked; the fault lies in how the pupils were selected, not in how many of them there were. Answer: it is not representative, as she picked her own friends. The distractors: the reply blaming the size claims the pupils were picked at random, which is false here, and it is the common mistake of thinking a biased sample can be cured by making it bigger; the reply calling the sample too large is false in the other direction, as a survey is never spoilt by collecting more replies; the reply that the sample is fine treats attending the school as enough, which would make any group of pupils in the building a fair sample.
- (c) 67 — Method: the mean is the total of the values divided by how many values there are, so add first and divide second. Working: the total is 50 + 83 + 68 = 201 points and three matches were played, so the mean is 201 ÷ 3 = 67 points. Answer: 67. The distractors: 68 comes from writing down the median, the middle value of 50, 68, 83, instead of the mean; 33 comes from working out the range, 83 − 50, which measures spread and not centre; 100.5 comes from dividing the total by 2 instead of by the 3 matches played.
- (c) Yes — with an estimate of 320, above the 250 limit. — Method: scale the sample proportion up to the whole batch to get an estimate, then compare that estimate with the 250 limit to reach a decision. Working: in the sample, 4 out of 50 boards are faulty, a proportion of 4 ÷ 50 = 0.08. Applying that proportion to the batch of 4,000 gives an estimate of 0.08 × 4000 = 320 faulty boards. Since 320 is more than 250, the factory should scrap the batch. Inverting the proportion, 50 ÷ 4 = 12.5, and treating that as a percentage of the batch, 12.5% × 4000 = 500, still gives 'yes' but from the wrong fraction, so it overstates the estimate. Comparing the raw number of faulty boards found in the sample, 4, directly with the 250 limit skips the scaling up to the batch altogether, and 4 is nowhere near 250, so that route wrongly says 'no'. Dividing the batch by the sample size, 4000 ÷ 50 = 80, finds how many samples of 50 fit into the batch but stops before multiplying by the 4 faulty boards found, so it also wrongly says 'no'. Always find the proportion in the sample first, scale it up to the whole batch, and only then compare the estimate with the limit given.
Build your own mix at the worksheet builder.