Printable · GCSE Foundation · ages 14-16
Statistics worksheet — GCSE Foundation
Fifteen questions across the statistics statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Statistics worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (b) Interpolation — The salary is being estimated for a value of x between 1 and 15, which is inside the range of x-values that were actually plotted, so this is interpolation. Extrapolation would apply if the estimate used a value of x below 1 or above 15, outside the plotted range. Correlation describes the relationship between the two variables, not the reliability of an estimate, and causation describes one variable actually causing a change in the other, which is a different idea altogether — neither is the word being asked for here.
- (c) The median, £160,000, as one very high price lifts the mean — Method: find both averages, then choose the one that sits closer to the bulk of the data. Working: in order the prices are 140,000, 150,000, 160,000, 170,000 and 580,000, so the median is the third of the five, £160,000. For the mean, 140,000 + 150,000 + 160,000 + 170,000 + 580,000 = 1,200,000 and 1,200,000 ÷ 5 = 240,000, so the mean is £240,000. Four of the five houses sold for £170,000 or less, so a reader told that a typical price is £240,000 would expect to pay at least £70,000 more than any of those four cost. Answer: the median, £160,000, as one very high price lifts the mean. The distractors: £580,000 is the middle value of the list as it is printed, which is the median only when the values have first been put in order; £240,000 is the mean, chosen on the ground that a median ignores three of the five prices, but a median uses all five to find which one is central and is then untroubled by how extreme the outer values are; £155,000 comes from deleting the £580,000 house and taking the mean of what is left, since 140,000 + 150,000 + 160,000 + 170,000 = 620,000 and 620,000 ÷ 4 = 155,000, but a real sale may not be thrown away merely for being large.
- (a) 1.24 — Method: for data given as a frequency table, the mean is Σfx ÷ Σf — multiply each value by its frequency, add the results, then divide by the total frequency. Working: 0 × 6 = 0. 1 × 10 = 10. 2 × 6 = 12. 3 × 3 = 9. So Σfx = 0 + 10 + 12 + 9 = 31. The total frequency is Σf = 6 + 10 + 6 + 3 = 25. Mean = 31 ÷ 25 = 1.24 siblings. Averaging the frequency column itself, (6 + 10 + 6 + 3) ÷ 4 = 6.25, mixes up the frequencies with the values they belong to. Writing down 1, the number of siblings with the highest frequency, gives the mode, not the mean. Writing down 31 stops after finding Σfx and forgets to divide by the total frequency, 25. Always divide Σfx by Σf — never stop at the top of the fraction.
- (d) 44 — Method: the frequency of a category in a frequency table is the number of times that category was counted, and it is read from the row for that category. Working: the rows of the table pair each colour with its count, and the row for black is paired with the count 44, so the frequency of black cars is 44. Answer: 44 cars — a frequency is a count of cars, not a colour and not a percentage. The distractors: 37 comes from reading the count paired with silver, that is from reading the wrong row of the table; 137 comes from adding every count in the table, 44 + 37 + 26 + 18 + 12, which gives the total number of cars rather than the frequency of one colour; 5 comes from counting how many different colours the table lists instead of how many cars were black.
- (c) 5 — Method: the mode is the value that occurs most often, so count how many times each different value appears and compare the counts. Working: 3 appears twice, 5 appears three times, 7 appears once and 8 appears once, so the highest frequency is three and the value carrying it is 5. Answer: 5. The distractors: 3 comes from writing down the frequency of the most common answer instead of the answer itself; 7 comes from taking the middle number of the list as it was written, which applies the median without ordering the data and without answering the question asked; 8 comes from picking the largest value, which confuses the mode with the maximum.
- (d) 29 — Method: with an even number of values there is no single middle value, so the median is the mean of the two values either side of the middle. Working: the six numbers are already in order and 6 ÷ 2 = 3, so the middle pair are the third and fourth values, 22 and 36; their mean is (22 + 36) ÷ 2 = 58 ÷ 2 = 29. Answer: 29, which lies between the two middle values as a median of an even data set must. The distractors: 22 comes from taking the lower of the two middle values and stopping there instead of averaging the pair; 36 comes from taking the larger value of that pair because it sits just past the halfway point of the list; 34 comes from working out the range, 47 − 13, instead of a measure of centre.
- (b) No — in order the numbers are 1, 3, 5, 7, 9, so the median is 5. — Method: the median is the middle value of the data in order of size, so the data must be sorted before any position is read off. Working: Noah's list 9, 3, 7, 1, 5 is not in order; sorted it becomes 1, 3, 5, 7, 9, and with 5 values the middle position is the third, which now holds 5 rather than 7. Noah has read the third value of the unsorted list. Answer: no — in order the numbers are 1, 3, 5, 7, 9, so the median is 5. The distractors: the reply giving 3 as the median sorts the data correctly but then reads the value in the second place instead of the third; the reply that 7 is the third number he wrote accepts a position in the unsorted list, which is exactly the mistake the question is about; the reply using the mean claims a value of 7 for it, but the mean is 25 ÷ 5 = 5, so that reasoning is false as well.
- (d) 20 — 0.4x + 1 = 9, so 0.4x = 9 − 1 = 8, and 8 ÷ 0.4 = 20, so 20 sessions are needed. Choosing 23 divides 9 by 0.4 without first subtracting the 1: 9 ÷ 0.4 = 22.5, rounded up to 23. Choosing 25 subtracts the wrong way, adding the 1 instead of taking it away: 9 + 1 = 10, and 10 ÷ 0.4 = 25. Choosing 2 misplaces the decimal point in the gradient, dividing by 4 instead of by 0.4: 8 ÷ 4 = 2.
- (d) Both the mean and the range increase. — The original mean is 150 + 152 + 155 + 158 + 160 = 775, and 775 ÷ 5 = 155 cm; the original range is 160 − 150 = 10 cm. Including the new height of 170 cm gives a new total of 775 + 170 = 945, and 945 ÷ 6 = 157.5 cm, which is higher than 155 cm, and a new range of 170 − 150 = 20 cm, which is higher than 10 cm, so both the mean and the range increase. Saying the range stays the same ignores that 170 cm is a new, higher maximum than the old 160 cm. Saying the mean stays the same ignores that 170 cm is above the original mean of 155 cm, which pulls the average up. Saying both decrease is the opposite of what happens here.
- (b) Treat them as outliers and check them before deciding — Method: a point lying a long way from the pattern the rest of the data make is called an outlier, and an outlier is investigated before anything is done with it, because it may be an error in the data or it may be a genuine but unusual case. Working: 48 of the 50 points lie close to the rising line of best fit, so the trend is set by those 48; the two remaining points do not follow it, so they are identified as outliers and checked — a mistake in measuring or recording would be corrected, while a genuine reading would be kept and reported. Answer: treat them as outliers and check them before deciding what to do with them. The distractors: deleting them at once assumes that every point far from the line must be an error, which throws away real data; moving the line so that it passes through them assumes a line of best fit must touch particular points, when it is drawn to follow all 50; taking them as proof that there is no correlation lets two points overturn the pattern that the other 48 agree on.
- (c) 72° — The angle is 12 ÷ 60 × 360 = 72°. Choosing 150° divides football's frequency of 25 instead of badminton's 12: 25 ÷ 60 × 360 = 150. Choosing 20° finds badminton as a percentage of the members, 12 ÷ 60 × 100 = 20, rather than an angle in degrees. Choosing 90° uses 48, the total of the other three activities, as the total instead of the full 60 members: 12 ÷ 48 × 360 = 90.
- (b) 4 — The difference, Bristol minus Leeds, on each day is: Monday 4 − 3 = 1, Tuesday 4 − 5 = −1, Wednesday 6 − 2 = 4, Thursday 2 − 4 = −2. The greatest amount by which Bristol exceeded Leeds is 4 hours, on Wednesday. Choosing 1 takes Monday's smaller positive difference instead of the greatest one. Choosing 2 takes the size of Thursday's difference, but that is the amount by which Leeds exceeded Bristol, the opposite direction to the one asked for. Choosing 6 takes Bristol's raw figure on Wednesday without subtracting Leeds's 2 hours first.
- (d) 19 kg — Method: estimate the mean of grouped data by multiplying each class's midpoint by its frequency, adding the four totals, then dividing by the total frequency. Working: the midpoints are 5, 15, 25 and 35 kg. The weighted totals are 11 × 5 = 55, 5 × 15 = 75, 5 × 25 = 125 and 9 × 35 = 315, which add to 570. Dividing by the 30 dogs gives an estimate of 570 ÷ 30 = 19 kg. Giving 5 kg reads off the midpoint of the modal class, 0 < m ≤ 10, the class with the most dogs — but the class with the most dogs is not where the mean falls, and neither is a substitute for actually calculating it. Giving 20 kg averages the four midpoints, (5 + 15 + 25 + 35) ÷ 4, treating every class as equally likely and ignoring that far more dogs are in the lightest and heaviest classes than in the middle two. Giving 570 kg stops after finding the correct weighted total and forgets the final division by the 30 dogs. Always weight each midpoint by its own frequency, and always finish by dividing by the total frequency, not the number of classes.
- (a) No, 150 pupils are a tenth of the school, chosen at random — Method: judge a sample on two things, whether every member of the population had the same chance of being chosen, and whether the sample is large enough to carry a pattern. Working: the 150 pupils were drawn from the register of every pupil in the school, so no year group or set is shut out and no pupil chooses to take part; and 150 ÷ 1,500 = 0.1, so one pupil in ten has been asked. A random sample of that share is ample for an estimate of how long the school's pupils spend on homework. Answer: no, because 150 pupils are a tenth of the school and were chosen at random. The distractors: saying a random sample always gives the exact school figure reaches the same verdict for a reason that is false, since a second random sample of 150 would give a slightly different mean; saying 150 pupils cannot be picked at random from 1,500 treats randomness as something only a whole population can have, when drawing names from the register is exactly how a random sample is taken; saying that only asking all 1,500 could show anything rejects sampling altogether, which would leave no way to study any population too large to count.
- (a) Drawing 60 names at random from a list of all 1200 pupils — Method: a sample is random when every member of the population has the same chance of being chosen and nobody, including the pupils themselves, can influence who ends up in it; test each method against that. Working: drawing names from a list of all 1200 pupils gives each pupil the same chance, 60 out of 1200, whatever their year group, class or opinion, so the method is random. Answer: drawing 60 names at random from a list of all 1200 pupils. The distractors: asking the pupils who volunteer is self-selection, and the pupils with the strongest views volunteer first, so they decide the sample; asking the pupils nearest the door is convenience sampling, which reaches only those who happen to be in one place at one time; asking two Year 10 classes samples a cluster, so every pupil in the other year groups has no chance of being chosen at all.
Build your own mix at the worksheet builder.