Printable · GCSE Foundation · ages 14-16
Statistics worksheet — GCSE Foundation
Fifteen questions across the statistics statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Statistics worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (d) 19 kg — Method: estimate the mean of grouped data by multiplying each class's midpoint by its frequency, adding the four totals, then dividing by the total frequency. Working: the midpoints are 5, 15, 25 and 35 kg. The weighted totals are 11 × 5 = 55, 5 × 15 = 75, 5 × 25 = 125 and 9 × 35 = 315, which add to 570. Dividing by the 30 dogs gives an estimate of 570 ÷ 30 = 19 kg. Giving 5 kg reads off the midpoint of the modal class, 0 < m ≤ 10, the class with the most dogs — but the class with the most dogs is not where the mean falls, and neither is a substitute for actually calculating it. Giving 20 kg averages the four midpoints, (5 + 15 + 25 + 35) ÷ 4, treating every class as equally likely and ignoring that far more dogs are in the lightest and heaviest classes than in the middle two. Giving 570 kg stops after finding the correct weighted total and forgets the final division by the 30 dogs. Always weight each midpoint by its own frequency, and always finish by dividing by the total frequency, not the number of classes.
- (c) 22 kg — Method: multiply the mean by the number of parcels to rebuild the total mass, then subtract the masses that are known. Working: four parcels with a mean mass of 17 kg have a total mass of 17 × 4 = 68 kg; the three known parcels total 12 + 16 + 18 = 46 kg; so the fourth parcel has mass 68 − 46 = 22 kg. Answer: 22 kg. The distractors: 68 kg comes from stopping at the total mass of all four parcels; 17 kg comes from assuming the missing parcel must have the mean mass; 5 kg comes from multiplying the mean by 3, the number of parcels whose mass is given, leaving 51 − 46 = 5.
- (b) 135 — Method: use the sample to find the PROPORTION of left-handed pupils, then apply that same proportion to the whole school population. Working: in the sample, 6 out of 40 pupils are left-handed, a proportion of 6 ÷ 40 = 0.15. Applying that proportion to the school's 900 pupils gives an estimate of 0.15 × 900 = 135 pupils. Giving 6 simply repeats the number of left-handed pupils IN THE SAMPLE, without scaling up to the whole school at all. Multiplying the population by the number of left-handed pupils in the sample without first dividing by the sample size, 900 × 6 = 5400, badly overestimates — that is more pupils than the whole school has. Dividing the population by the sample size but forgetting to multiply by the number of left-handed pupils found, 900 ÷ 40 = 22.5, finds the scale factor but stops one step short of using it. Always find the proportion in the sample first, then scale that same proportion up to the population.
- (c) A line of best fit — Method: the straight line drawn on a scatter graph is named from the job it does — it is chosen so that it follows the whole set of points as closely as possible. Working: the line passes through the middle of the points, with roughly as many points above it as below it, and it need not pass through any of the plotted points at all; the name given to the straight line chosen in that way is a line of best fit. Answer: a line of best fit. The distractors: a line of symmetry comes from confusing a trend with symmetry, which is a property of a shape rather than of a set of data; a horizontal line through the mean comes from thinking the trend is shown by an average, when a horizontal line would say that the vertical quantity does not change and so show no correlation; a line joining the first and last points comes from thinking the line must join the two extreme points, which lets two points decide a trend that all of the points should share in.
- (d) 75 — Method: to find a total from a bar chart, add together the height of every bar. Working: 12 + 18 + 9 + 15 + 21 = 75 books. Leaving out Wednesday's bar by mistake, 12 + 18 + 15 + 21 = 66, misses one day out of the total. Giving 21 states only Friday's bar, the tallest one, not the total of all five days. Dividing the total by the number of days, 75 ÷ 5 = 15, finds the mean number of books per day, not the total borrowed. Add up every single bar — do not stop at the biggest one, and do not divide once you have added them all.
- (a) Drawing 60 names at random from a list of all 1200 pupils — Method: a sample is random when every member of the population has the same chance of being chosen and nobody, including the pupils themselves, can influence who ends up in it; test each method against that. Working: drawing names from a list of all 1200 pupils gives each pupil the same chance, 60 out of 1200, whatever their year group, class or opinion, so the method is random. Answer: drawing 60 names at random from a list of all 1200 pupils. The distractors: asking the pupils who volunteer is self-selection, and the pupils with the strongest views volunteer first, so they decide the sample; asking the pupils nearest the door is convenience sampling, which reaches only those who happen to be in one place at one time; asking two Year 10 classes samples a cluster, so every pupil in the other year groups has no chance of being chosen at all.
- (c) Thursday — Method: on a bar chart the tallest bar belongs to the greatest value, so compare the five temperatures and then read off the day that the greatest one belongs to. Working: the temperatures are 20 °C, 22 °C, 18 °C, 25 °C and 23 °C; in order of size these are 18, 20, 22, 23 and 25, so the greatest temperature is 25 °C, and the day recorded with 25 °C is Thursday. Answer: Thursday — the answer is a day, not a temperature. The distractors: Friday comes from stopping at the final temperature listed instead of comparing all five; Wednesday comes from picking out the shortest bar, 18 °C, and so answering for the lowest temperature rather than the highest; Monday comes from writing down the first day in the chart without comparing any of the temperatures at all.
- (a) Leeds has a higher median and a greater range than York. — In order, Leeds's temperatures are 14, 16, 18, 19 and 23, so the median is the middle value, 18, and the range is 23 − 14 = 9. York's temperatures in order are 15, 17, 17, 18 and 18, so the median is 17, and the range is 18 − 15 = 3. Since 18 is higher than 17, and 9 is greater than 3, Leeds has both the higher median and the greater range. Choosing 'Leeds has a higher median but a smaller range than York' gets the median comparison right but the range comparison backwards — Leeds's range of 9 is actually greater than York's range of 3. Choosing 'York has a higher median and a greater range than Leeds' reverses both comparisons. Choosing 'York has a higher median but a smaller range than Leeds' reverses the median comparison; York's median of 17 is lower than Leeds's 18, even though it is correct that York's range is the smaller one.
- (c) 20 kg ≤ mass < 30 kg — The modal class is the class with the highest frequency. Reading the plotted points, the frequencies are 6, 10, 16, 6 and 2, so the highest frequency is 16, plotted at the midpoint 25. A class of width 10 centred on 25 runs from 25 − 5 = 20 to 25 + 5 = 30, so the modal class is 20 kg ≤ mass < 30 kg. Writing '25 kg' gives only the midpoint, not the class — the modal class is an interval, not a single value. '10 kg ≤ mass < 20 kg' is the class before the peak, centred on 15, which has frequency 10, not the highest. '30 kg ≤ mass < 40 kg' is the class after the peak, centred on 35, which has frequency 6, not the highest.
- (b) Positive correlation — Method: the type of correlation is named from the direction the points take as the scatter graph is read from left to right. Working: the points rise from left to right, so as the arm span read on the horizontal axis increases, the height read on the vertical axis increases as well; two quantities that increase together show positive correlation. Answer: positive correlation. The distractors: negative correlation comes from naming the direction the wrong way round, since a negative correlation needs the points to fall as the graph is read from left to right; no correlation comes from treating points that are spread out rather than sitting exactly on a line as though they showed no relationship; direct proportion comes from confusing a rising trend with proportion, which would additionally need the line through the points to pass through the origin and would mean doubling one quantity doubles the other.
- (d) 38, and fairly confident, as 12 °C is inside the range — Method: substitute the forecast temperature into the equation of the line of best fit, then judge the prediction by where that temperature sits among the data the line was drawn from. Working: putting x = 12 into y = −3x + 74 gives −3 × 12 + 74 = 38, so the line predicts 38 hot chocolates. The recorded temperatures run from 4 °C to 18 °C, and 12 °C lies inside that interval, so this is interpolation, the safer kind of prediction. Answer: 38, and fairly confident, as 12 °C is inside the range; the owner should still expect the true figure to differ a little, since the points only lie near the line and not on it. The distractors: being completely certain treats a line of best fit as a rule that fixes each day's sales, when it describes a trend that individual days depart from; saying 12 °C is outside the range misreads the interval 4 °C to 18 °C, and the wrong warning would be attached to a sound prediction; 110 comes from −3 × 12 being taken as +36, giving 36 + 74 = 110, which loses the negative gradient and so predicts that a warm day sells more hot chocolate than a cold one.
- (a) A straight line sloping down from left to right — Method: a line of best fit is a straight line drawn to follow the trend of the points, so its slope is decided by the direction of the relationship between the two quantities. Working: as the price rises, the satisfaction score falls, so the points start high on the left of the graph and finish low on the right; the straight line that follows them therefore slopes downwards as the graph is read from left to right, which is the line of a negative correlation. Answer: a straight line sloping down from left to right. The distractors: a line sloping up comes from reading a falling relationship as a rising one; a horizontal line comes from expecting no correlation, since a horizontal line says the satisfaction score does not change as the price changes; a curve passing through every point comes from thinking a line of best fit has to touch all of the plotted points, when it is a single straight line drawn through the middle of them.
- (c) It is not representative, as she picked her own friends — Method: judge a sample by asking whether the pupils in it were chosen in a way that gives the whole school a fair chance of being heard. Working: Isla's friends are a group she formed herself, and friends tend to share tastes, so their favourite programme is likely to match hers rather than the school's, and pupils in other year groups and other friendship groups had no chance at all of being asked; the fault lies in how the pupils were selected, not in how many of them there were. Answer: it is not representative, as she picked her own friends. The distractors: the reply blaming the size claims the pupils were picked at random, which is false here, and it is the common mistake of thinking a biased sample can be cured by making it bigger; the reply calling the sample too large is false in the other direction, as a survey is never spoilt by collecting more replies; the reply that the sample is fine treats attending the school as enough, which would make any group of pupils in the building a fair sample.
- (c) Yes — with an estimate of 320, above the 250 limit. — Method: scale the sample proportion up to the whole batch to get an estimate, then compare that estimate with the 250 limit to reach a decision. Working: in the sample, 4 out of 50 boards are faulty, a proportion of 4 ÷ 50 = 0.08. Applying that proportion to the batch of 4,000 gives an estimate of 0.08 × 4000 = 320 faulty boards. Since 320 is more than 250, the factory should scrap the batch. Inverting the proportion, 50 ÷ 4 = 12.5, and treating that as a percentage of the batch, 12.5% × 4000 = 500, still gives 'yes' but from the wrong fraction, so it overstates the estimate. Comparing the raw number of faulty boards found in the sample, 4, directly with the 250 limit skips the scaling up to the batch altogether, and 4 is nowhere near 250, so that route wrongly says 'no'. Dividing the batch by the sample size, 4000 ÷ 50 = 80, finds how many samples of 50 fit into the batch but stops before multiplying by the 4 faulty boards found, so it also wrongly says 'no'. Always find the proportion in the sample first, scale it up to the whole batch, and only then compare the estimate with the limit given.
- (a) £16,000 — Method: first find the quarter with the highest sales figure, then subtract quarter 1's sales from it — remembering that every figure is given in THOUSANDS of pounds. Working: the highest sales figure is quarter 2, at £34,000 (34 thousand pounds). The increase from quarter 1 is £34,000 − £18,000 = £16,000. Giving £34,000 reads off the highest sales figure on its own, without subtracting quarter 1's sales — that is the highest quarter's total, not the increase. Giving £12,000 uses quarter 3's sales, 30, the SECOND-highest figure, instead of quarter 2's 34, the actual highest — 30 − 18 = 12, but quarter 3 is not the quarter with the highest sales. Giving £16 gets the subtraction right, 34 − 18 = 16, but forgets that every figure in the question is in thousands of pounds, so the increase is £16,000, not £16. Always identify the correct quarter FIRST, and always check the units the numbers are given in before writing your final answer.
Build your own mix at the worksheet builder.