Printable · GCSE Foundation · ages 14-16
Statistics worksheet — GCSE Foundation
Fifteen questions across the statistics statements at Foundation tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Answer key: Statistics worksheet — GCSE Foundation
MathsUKwww.geekhero.co.uk
- (d) £15.50 — 2 × 6 = 12, and 12 + 3.50 = 15.50, so the estimated fare is £15.50. Choosing £12.00 stops after 2 × 6 = 12 and forgets to add the £3.50. Choosing £19.00 adds the distance and the constant first and then multiplies: 6 + 3.50 = 9.50, and 9.50 × 2 = 19.00, applying the ×2 to the whole sum instead of only to the distance. Choosing £13.00 multiplies only the constant term by 2 instead of the distance: 2 × 3.50 = 7, and 7 + 6 = 13.00.
- (c) 80 — Method: the range is a measure of spread and is found by subtracting the smallest value from the largest. Working: the largest number sold is 100 and the smallest is 20, so the range is 100 − 20 = 80. Answer: 80. The distractors: 100 comes from writing down the largest value and never subtracting the smallest; 60 comes from working out the median, the middle value of 20, 40, 60, 70, 100, instead of the range; 58 comes from working out the mean, 290 ÷ 5, which measures centre rather than spread.
- (d) No, the range uses only the fastest and slowest time — Method: check what the range is built from, then look at what it leaves out. Working: both teams have a fastest time of 20 seconds and a slowest of 40 seconds, so both ranges are 40 − 20 = 20 seconds and Tomás has that part right. But the range is calculated from those two values alone. Six of Team A's seven times lie between 20 and 25 seconds, with a single time far out at 40; Team B is the other way round, with six of its seven times at 30 seconds or more and a single time far out at 20. So Team A bunches at the fast end and Team B at the slow end. The two patterns are quite different, and the range cannot see the difference because the five middle times never enter the calculation. Answer: no, because the range uses only the fastest and slowest time. The distractors: comparing the means answers a different question, since a mean measures position rather than spread, and two sets with the same spread can have different means; saying that equal ranges mean equal spread is the very assumption that fails here; saying that seven times each forces the spreads to match confuses the size of a data set with how its values are arranged inside it.
- (a) Minutes a candle has burned and length remaining — As a candle burns for longer, less of it remains, so these two variables move in opposite directions as one increases — that is negative correlation. A pupil's shoe size generally increases as they get older, so age and shoe size show positive correlation, not negative, since both rise together. A football team's shirt colour is not a numerical quantity linked to how many matches it wins, so shirt colour and number of wins show no correlation at all. The number of letters in a pupil's name has no real connection to their ability in maths, so that pair also shows no correlation.
- (a) 40 — Method: the mean is the total divided by how many values there are, so rearranging gives total = mean × number of values. Working: the mean is 8 and there are 5 numbers, so the total is 8 × 5 = 40. Answer: 40, and checking, 40 ÷ 5 = 8, which is the mean given. The distractors: 13 comes from adding the mean and the count, 8 + 5, instead of multiplying them; 1.6 comes from dividing the mean by the count, 8 ÷ 5, which reverses the relationship; 8 comes from quoting the mean itself as the total, which is only true when there is a single number.
- (d) 6 — Method: the mode, or modal value, is the value that occurs most often in the data set, and it is a value from the data rather than a count. Working: size 4 occurs twice, size 5 occurs once, size 6 occurs three times and size 9 occurs once, so the highest frequency is three and the size it belongs to is 6. Answer: 6. The distractors: 3 comes from writing down the frequency of the most common size instead of the size itself; 9 comes from picking the largest size in the list, which confuses the mode with the maximum; 4 comes from stopping at the first size that repeats rather than checking which size repeats most often.
- (b) 13 — The total is 50, and the two known parts are 22 (tea) and 15 (coffee), so 50 − 22 − 15 = 13 hot chocolates. Choosing 28 comes from 50 − 22, subtracting only the tea and forgetting the coffee. Choosing 35 comes from 50 − 15, subtracting only the coffee and forgetting the tea. Choosing 37 comes from 22 + 15, which finds how many drinks were tea or coffee, not the number left over for hot chocolate.
- (b) A line graph — Sales recorded at the end of each of the twelve months are time series data, and a line graph is the chart built to show how a value changes over time, with the points usually joined in order. A pie chart is for showing categorical data as shares of a whole, not a trend over time. A pictogram shows a frequency for separate categories using symbols, not a continuous trend. A scatter graph is for comparing two different variables against each other, not one variable over time.
- (d) How much the temperatures varied over the seven days — Method: the range of a set of values is the largest value take away the smallest, so it is built from two values only and it measures the gap they leave between them. Working: the largest of the seven readings is 7 °C and the smallest is 2 °C, so the range is 7 − 2 = 5 °C. That figure says the week's readings covered a band 5 °C wide; it names no particular day and no particular reading. Answer: the range describes how much the temperatures varied over the seven days. The distractors: the temperature that occurred most often is the mode, which here is 3 °C, and a mode counts repeats instead of measuring a gap; the temperature typical of the week is an average, and the range is not an average, since it throws away every value lying between the two extremes; the number of different temperatures recorded is 6, a count of how many distinct values appear, while the range is a difference between two of them.
- (c) 22 kg — Method: multiply the mean by the number of parcels to rebuild the total mass, then subtract the masses that are known. Working: four parcels with a mean mass of 17 kg have a total mass of 17 × 4 = 68 kg; the three known parcels total 12 + 16 + 18 = 46 kg; so the fourth parcel has mass 68 − 46 = 22 kg. Answer: 22 kg. The distractors: 68 kg comes from stopping at the total mass of all four parcels; 17 kg comes from assuming the missing parcel must have the mean mass; 5 kg comes from multiplying the mean by 3, the number of parcels whose mass is given, leaving 51 − 46 = 5.
- (c) Yes — with an estimate of 320, above the 250 limit. — Method: scale the sample proportion up to the whole batch to get an estimate, then compare that estimate with the 250 limit to reach a decision. Working: in the sample, 4 out of 50 boards are faulty, a proportion of 4 ÷ 50 = 0.08. Applying that proportion to the batch of 4,000 gives an estimate of 0.08 × 4000 = 320 faulty boards. Since 320 is more than 250, the factory should scrap the batch. Inverting the proportion, 50 ÷ 4 = 12.5, and treating that as a percentage of the batch, 12.5% × 4000 = 500, still gives 'yes' but from the wrong fraction, so it overstates the estimate. Comparing the raw number of faulty boards found in the sample, 4, directly with the 250 limit skips the scaling up to the batch altogether, and 4 is nowhere near 250, so that route wrongly says 'no'. Dividing the batch by the sample size, 4000 ÷ 50 = 80, finds how many samples of 50 fit into the batch but stops before multiplying by the 4 faulty boards found, so it also wrongly says 'no'. Always find the proportion in the sample first, scale it up to the whole batch, and only then compare the estimate with the limit given.
- (c) 20 kg ≤ mass < 30 kg — The modal class is the class with the highest frequency. Reading the plotted points, the frequencies are 6, 10, 16, 6 and 2, so the highest frequency is 16, plotted at the midpoint 25. A class of width 10 centred on 25 runs from 25 − 5 = 20 to 25 + 5 = 30, so the modal class is 20 kg ≤ mass < 30 kg. Writing '25 kg' gives only the midpoint, not the class — the modal class is an interval, not a single value. '10 kg ≤ mass < 20 kg' is the class before the peak, centred on 15, which has frequency 10, not the highest. '30 kg ≤ mass < 40 kg' is the class after the peak, centred on 35, which has frequency 6, not the highest.
- (d) 210 — 350 − 150 = 200. 200 ÷ 10 = 20, so the gradient is 20. Using the point (5, 150): 20 × 5 = 100, so 150 − 100 = 50 is the intercept, giving the line y = 20x + 50. At x = 8: 20 × 8 = 160, and 160 + 50 = 210, so the estimated number of visitors is 210. Choosing 160 stops after 20 × 8 = 160 and forgets to add the intercept of 50. Choosing 250 comes from averaging the two given y-values: 150 + 350 = 500, and 500 ÷ 2 = 250, instead of using the line's equation. Choosing 240 assumes the visitors are directly proportional to the hours of sunshine using the first point, 150 × 8 ÷ 5 = 240, which ignores that the line does not pass through the origin.
- (a) 150 bulbs — Method: assume the proportion faulty in a random sample is the proportion faulty in the whole day's output, and scale the sample up to the population. Working: the sample of 80 has to be scaled up to 4,000 bulbs, and 4,000 ÷ 80 = 50, so the day's output is 50 sample-sized batches. Each batch is expected to contain the same 3 faulty bulbs, so the estimate is 3 × 50 = 150. Answer: 150 bulbs, and it is an estimate, because another sample of 80 would probably contain a different number of faulty bulbs. The distractors: 50 bulbs is the scale factor 4,000 ÷ 80 written down as though it were the answer, so it reports how many batches there are rather than how many faulty bulbs; 120 bulbs comes from reading 3 out of 80 as 3%, then taking 0.03 × 4,000 = 120, but 3 out of 80 is 3.75%; 240 bulbs comes from 3 × 80 = 240, multiplying the faulty bulbs by the size of the sample instead of by the scale factor, which uses the 80 twice and the 4,000 not at all.
- (d) An outlier from the damaged wing, not the trend. — That bird's point lies a long way from the rising trend followed by every other bird, and its low wingspan is explained by the damaged wing rather than by its age — it is an outlier caused by an unusual factor, not part of the general relationship between age and wingspan, so it should not be used when drawing the line of best fit. Saying every point must be used ignores that an outlier caused by a separate, identifiable factor can rightly be set aside. Saying it shows no correlation ignores that the other 19 points do show a clear rising trend; one outlier does not remove that. Saying it proves the line is inaccurate confuses one unusual bird with a fault in the line itself, when the line correctly describes the trend followed by the rest of the data.
Build your own mix at the worksheet builder.