Printable · GCSE Higher · ages 14-16
Gradients and intercepts of linear functions worksheet — GCSE Higher
Fifteen questions on "gradients and intercepts of linear functions" — DfE statement A10. Print it, or print three versions so neighbours cannot copy by letter; the key gives the letter for each version.
Answer key: Gradients and intercepts of linear functions worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (d) The fixed call-out fee, charged before the hourly rate. — Method: compare the formula with C = (fixed charge) + (rate) × h, where the fixed charge is the part that does not depend on h. Working: in C = 40 + 25h, the term 25h depends on the number of hours, h, but 40 does not change however many hours the job takes. Answer: 40 is the fixed call-out fee. 'The hourly rate' confuses the fixed term with the coefficient of h, which is actually 25. 'The total cost for a job lasting 1 hour' comes from substituting h = 1 into the formula (40 + 25 = 65) rather than reading off the constant term. 'The number of hours worked before charging starts' wrongly treats the constant, which is in pounds, as if it were measured in hours.
- (c) 3 — Method: a point that lies on a graph makes its equation true, so substituting the coordinates into y = mx + 6 leaves an equation in m alone. Working: substituting x = −2 and y = 0 gives 0 = m × (−2) + 6, which rearranges to −2m = −6, so m = (−6) ÷ (−2) = 3. Answer: 3. The distractors: −3 comes from dividing −6 by 2 and keeping the minus sign, overlooking that the divisor is negative too, so the two signs cancel; −2 comes from writing down the x-coordinate of the given point in place of the gradient; 6 comes from reading the constant in y = mx + 6 as the gradient, confusing m with c.
- (c) The cost, in pounds, for each extra gigabyte of data used — In C = 15 + 2g, the number multiplying g is the gradient, which gives the extra cost for each extra unit of g — here, £2 for each extra gigabyte. 'The fixed monthly fee, in pounds' describes the constant term 15, not the coefficient of g. 'The total number of gigabytes included in the plan' misreads the coefficient as a quantity of data rather than a cost per gigabyte. 'The cost … for each extra 2 gigabytes' doubles the unit the coefficient actually applies to — it is the cost for each single extra gigabyte.
- (d) (0, 4) — Method: in the form y = mx + c the constant c is the y-coordinate of the point where the line crosses the y-axis, and every point on that axis has x-coordinate 0. Working: comparing y = 2x + 4 with y = mx + c gives c = 4, and substituting x = 0 confirms y = 2 × 0 + 4 = 4, so the crossing point is (0, 4). Answer: (0, 4). The distractors: (4, 0) is the same pair of numbers written in the wrong order and is a point on the x-axis; (0, 2) comes from reading the gradient 2 as the intercept, confusing m with c; (−2, 0) is where the line crosses the x-axis, found by solving 0 = 2x + 4 instead.
- (d) −2 — Method: a gradient can only be read off an equation that is written in the form y = mx + c, so y has to be made the subject first. Working: subtracting 2x from both sides of 2x + y = 8 gives y = −2x + 8, and comparing that with y = mx + c gives m = −2. Answer: −2. The distractors: 2 comes from reading the coefficient of x straight off the equation as it is printed, without rearranging, so the change of sign is missed; 8 comes from reading the constant as the gradient, confusing m with c; −1/2 comes from rearranging correctly and then writing the gradient upside down, as the change in x over the change in y.
- (a) (40, 0) — Method: a graph crosses the x-axis where y = 0, which in this context is the moment the tank holds no water, so substituting y = 0 and solving gives the time. Working: 0 = −5x + 200 gives 5x = 200, so x = 200 ÷ 5 = 40 and the crossing point is (40, 0); the tank is empty after 40 minutes. Answer: (40, 0). The distractors: (0, 200) is the y-axis crossing, the 200 litres in the tank at the start, found by substituting x = 0 instead of y = 0; (200, 0) comes from reading the constant 200 as the x-coordinate without dividing by the 5 litres lost each minute; (0, 40) has the right number in the wrong place, with the time written as a y-coordinate.
- (c) −2 — Method: rearrange the equation into the form y = mx + c, then read off the gradient. Working: 3y = 12 − 6x, so dividing every term by 3 gives y = 4 − 2x, so the gradient is −2. Answer: the gradient is −2. 2 comes from dropping the negative sign after dividing by 3. 4 comes from using the y-intercept, 4, instead of the gradient. −6 comes from reading off the coefficient of x before dividing the whole equation by 3.
- (a) 1 — Method: the value of y when x = 0 is where the line meets the y-axis, which is the constant c in y = mx + c, so the gradient is worked out from the two given points first and the constant follows by substituting one of them. Working: m = (16 − 7) ÷ (5 − 2) = 9 ÷ 3 = 3, so the line is y = 3x + c; substituting x = 2 and y = 7 gives 7 = 3 × 2 + c, so c = 7 − 6 = 1, and the value of y when x = 0 is that constant. Answer: 1. The distractors: 3 comes from stopping at the gradient and offering it as the intercept; 4 comes from stepping back from x = 2 to x = 0 by one unit of x instead of two, 7 − 3 = 4; −1 comes from working the constant out as mx − y, 3 × 2 − 7 = −1, instead of y − mx.
- (d) (3, 0) — Method: every point on the x-axis has y-coordinate 0, so substituting y = 0 into the equation and solving gives the x-coordinate of the crossing point. Working: 0 = 2x − 6 gives 2x = 6, so x = 6 ÷ 2 = 3 and the graph crosses the x-axis at (3, 0). Answer: (3, 0). The distractors: (0, −6) is where the graph crosses the y-axis, found by substituting x = 0 rather than y = 0; (−3, 0) comes from moving the 6 across the equals sign without changing its sign, giving 2x = −6; (6, 0) comes from reading the constant straight off as the crossing point and never dividing by the gradient 2.
- (b) No, because their gradients are 2 and −2 — Method: two lines are parallel exactly when their gradients are equal as signed numbers, so m is read from each equation written in the form y = mx + c and the two are compared. Working: y = 2x + 1 has gradient 2 and y = −2x + 3 has gradient −2; those are not equal, so the lines are not parallel, and indeed one slopes upwards while the other slopes downwards. Answer: No, because their gradients are 2 and −2. The distractors: saying yes because both gradients have size 2 comes from comparing the sizes of the gradients and ignoring their signs; saying yes because the gradients add to 0 comes from using a sum of zero as the test for parallel lines instead of equality of gradients; saying no because the y-intercepts are 1 and 3 reaches the right verdict by the wrong route, since the intercepts decide where the lines sit rather than whether they are parallel.
- (b) 20 — The rate is the gradient: the change in litres divided by the change in time. From 2 to 7 minutes, the tank gains 150 − 50 = 100 litres over 7 − 2 = 5 minutes, so the rate is 100 ÷ 5 = 20 litres per minute. 100 comes from working out the change in litres but forgetting to divide by the change in time. 25 comes from using only the first reading, 50 ÷ 2, and ignoring the second reading entirely. 0.05 comes from dividing the change in time by the change in litres instead of the other way round, 5 ÷ 100.
- (a) 0.25 — Method: gradient = vertical rise ÷ horizontal distance. Working: gradient = 3 ÷ 12 = 0.25. Answer: the gradient of the ramp is 0.25. 4 comes from inverting the gradient, dividing the horizontal distance by the vertical rise instead of the other way round. 9 comes from subtracting the rise from the horizontal distance instead of dividing. 36 comes from multiplying the rise and the horizontal distance instead of dividing.
- (b) 3 — Method: rearrange the equation into the form y = mx + c first, then read off the gradient. Working: dividing 4y = 12x + 20 by 4 gives y = 3x + 5, so the gradient is 3. The value 12 comes from reading the coefficient of x before dividing the equation by 4. The value 20 comes from using the constant term of the unsimplified equation instead of the gradient. The value 5 comes from finding the y-intercept, 20 / 4 = 5, and giving that instead of the gradient.
- (c) 6 — Method: rate = amount of fuel used ÷ time taken. Working: fuel used = 50 − 38 = 12 litres, time taken = 2 hours, so rate = 12 ÷ 2 = 6 litres per hour. Answer: the rate is 6 litres per hour. 44 comes from finding the average of the two fuel amounts, (50 + 38) ÷ 2, instead of the fuel used. 12 comes from working out the fuel used but forgetting to divide by the time taken. 19 comes from dividing the remaining fuel, 38, by the time taken instead of the fuel used.
- (a) 2/5 — Method: compare the equation with y = mx + c, where m is the gradient. Working: in y = (2x/5) − 3, the coefficient of x is 2/5. Answer: the gradient is 2/5. −3 comes from confusing the gradient with the y-intercept. 5/2 comes from inverting the fraction that multiplies x. −2/5 comes from wrongly carrying the negative sign from the −3 term onto the coefficient of x.
Build your own mix at the worksheet builder.