Printable · GCSE Higher · ages 14-16

Gradients and intercepts of linear functions worksheet — GCSE Higher

Fifteen questions on "gradients and intercepts of linear functions" — DfE statement A10. Print it, or print three versions so neighbours cannot copy by letter; the key gives the letter for each version.

VersionsA only A + B A + B + Csame questions, different order

AnswersQuestions only With answer key Key only

CalculatorMixed Non-calculator (Paper 1)Calculator (Papers 2 and 3)

New sheet

Answer key: Gradients and intercepts of linear functions worksheet — GCSE Higher

Maths · GCSE Higher · A10 · Gradients and intercepts of linear functions · 15 questions

MathsUKwww.geekhero.co.uk

(d) The fixed call-out fee, charged before the hourly rate. — Method: compare the formula with C = (fixed charge) + (rate) × h, where the fixed charge is the part that does not depend on h. Working: in C = 40 + 25h, the term 25h depends on the number of hours, h, but 40 does not change however many hours the job takes. Answer: 40 is the fixed call-out fee. 'The hourly rate' confuses the fixed term with the coefficient of h, which is actually 25. 'The total cost for a job lasting 1 hour' comes from substituting h = 1 into the formula (40 + 25 = 65) rather than reading off the constant term. 'The number of hours worked before charging starts' wrongly treats the constant, which is in pounds, as if it were measured in hours.
(c) 6 — Method: rate = amount of fuel used ÷ time taken. Working: fuel used = 50 − 38 = 12 litres, time taken = 2 hours, so rate = 12 ÷ 2 = 6 litres per hour. Answer: the rate is 6 litres per hour. 44 comes from finding the average of the two fuel amounts, (50 + 38) ÷ 2, instead of the fuel used. 12 comes from working out the fuel used but forgetting to divide by the time taken. 19 comes from dividing the remaining fuel, 38, by the time taken instead of the fuel used.
(a) 20 — Method: the paper has run out when S = 0, so substitute S = 0 into the equation and solve for t. Working: 0 = 480 − 24t, so 24t = 480, and t = 480 / 24 = 20. Answer: it takes 20 minutes. The value 480 comes from giving the starting number of sheets, the intercept of the equation, instead of solving for t. The value 456 comes from working out 480 − 24 and stopping after one step instead of solving the equation fully. The value 0.05 comes from inverting the division, working out 24 / 480 instead of 480 / 24.
(b) 20 — The rate is the gradient: the change in litres divided by the change in time. From 2 to 7 minutes, the tank gains 150 − 50 = 100 litres over 7 − 2 = 5 minutes, so the rate is 100 ÷ 5 = 20 litres per minute. 100 comes from working out the change in litres but forgetting to divide by the change in time. 25 comes from using only the first reading, 50 ÷ 2, and ignoring the second reading entirely. 0.05 comes from dividing the change in time by the change in litres instead of the other way round, 5 ÷ 100.
(a) 1 — Method: the value of y when x = 0 is where the line meets the y-axis, which is the constant c in y = mx + c, so the gradient is worked out from the two given points first and the constant follows by substituting one of them. Working: m = (16 − 7) ÷ (5 − 2) = 9 ÷ 3 = 3, so the line is y = 3x + c; substituting x = 2 and y = 7 gives 7 = 3 × 2 + c, so c = 7 − 6 = 1, and the value of y when x = 0 is that constant. Answer: 1. The distractors: 3 comes from stopping at the gradient and offering it as the intercept; 4 comes from stepping back from x = 2 to x = 0 by one unit of x instead of two, 7 − 3 = 4; −1 comes from working the constant out as mx − y, 3 × 2 − 7 = −1, instead of y − mx.
(c) The cost, in pounds, for each extra gigabyte of data used — In C = 15 + 2g, the number multiplying g is the gradient, which gives the extra cost for each extra unit of g — here, £2 for each extra gigabyte. 'The fixed monthly fee, in pounds' describes the constant term 15, not the coefficient of g. 'The total number of gigabytes included in the plan' misreads the coefficient as a quantity of data rather than a cost per gigabyte. 'The cost … for each extra 2 gigabytes' doubles the unit the coefficient actually applies to — it is the cost for each single extra gigabyte.
(a) (40, 0) — Method: a graph crosses the x-axis where y = 0, which in this context is the moment the tank holds no water, so substituting y = 0 and solving gives the time. Working: 0 = −5x + 200 gives 5x = 200, so x = 200 ÷ 5 = 40 and the crossing point is (40, 0); the tank is empty after 40 minutes. Answer: (40, 0). The distractors: (0, 200) is the y-axis crossing, the 200 litres in the tank at the start, found by substituting x = 0 instead of y = 0; (200, 0) comes from reading the constant 200 as the x-coordinate without dividing by the 5 litres lost each minute; (0, 40) has the right number in the wrong place, with the time written as a y-coordinate.
(d) −3 — Method: rewrite the equation in the form y = mx + c, then read off the gradient. Working: y = 4 − 3x can be written as y = −3x + 4, so comparing with y = mx + c gives m = −3. Answer: the gradient is −3. The value 3 comes from ignoring the negative sign on the x term. The value 4 comes from reading off the y-intercept instead of the gradient. The value −4 comes from a sign error, applying the negative sign to the intercept instead of the gradient.
(c) Line D — Method: the steeper of two lines is the one whose gradient is greater, and the gradient of a line through two points is the change in y divided by the change in x. Working: line C rises 2 for a run of 4, so its gradient is 2 ÷ 4 = 1/2; the other line rises 2 for a run of 2, so its gradient is 2 ÷ 2 = 1; since 1 is greater than 1/2, it is line D that is the steeper. Answer: Line D. The distractors: Line C is chosen by comparing the x-coordinates and calling the line that reaches further along the x-axis the steeper one; They are equally steep comes from comparing only the y-coordinates, which are both 2, without dividing by the two different runs; There is not enough information comes from believing that a gradient can only be measured off a drawn graph, when two points on a line are enough to work it out.
(d) −2 — Method: a gradient can only be read off an equation that is written in the form y = mx + c, so y has to be made the subject first. Working: subtracting 2x from both sides of 2x + y = 8 gives y = −2x + 8, and comparing that with y = mx + c gives m = −2. Answer: −2. The distractors: 2 comes from reading the coefficient of x straight off the equation as it is printed, without rearranging, so the change of sign is missed; 8 comes from reading the constant as the gradient, confusing m with c; −1/2 comes from rearranging correctly and then writing the gradient upside down, as the change in x over the change in y.
(b) −0.5 — Method: gradient = change in height ÷ horizontal distance, and the height decreases so the change is negative. Working: change in height = 5 − 25 = −20, horizontal distance = 40, so gradient = −20 ÷ 40 = −0.5. Answer: the gradient is −0.5. 0.5 comes from dropping the negative sign, ignoring that the zip-line descends. 2 comes from inverting the gradient, dividing the horizontal distance by the drop in height instead of the other way round. −0.8 comes from dividing the drop by the platform height, 25, instead of by the horizontal distance, 40.
(c) 3 — Method: a point that lies on a graph makes its equation true, so substituting the coordinates into y = mx + 6 leaves an equation in m alone. Working: substituting x = −2 and y = 0 gives 0 = m × (−2) + 6, which rearranges to −2m = −6, so m = (−6) ÷ (−2) = 3. Answer: 3. The distractors: −3 comes from dividing −6 by 2 and keeping the minus sign, overlooking that the divisor is negative too, so the two signs cancel; −2 comes from writing down the x-coordinate of the given point in place of the gradient; 6 comes from reading the constant in y = mx + 6 as the gradient, confusing m with c.
(d) (3, 0) — Method: every point on the x-axis has y-coordinate 0, so substituting y = 0 into the equation and solving gives the x-coordinate of the crossing point. Working: 0 = 2x − 6 gives 2x = 6, so x = 6 ÷ 2 = 3 and the graph crosses the x-axis at (3, 0). Answer: (3, 0). The distractors: (0, −6) is where the graph crosses the y-axis, found by substituting x = 0 rather than y = 0; (−3, 0) comes from moving the 6 across the equals sign without changing its sign, giving 2x = −6; (6, 0) comes from reading the constant straight off as the crossing point and never dividing by the gradient 2.
(b) −3 — Method: the gradient of a straight line is the change in y divided by the change in x, with the two coordinates taken in the same order in the numerator as in the denominator. Working: going from (−1, 5) to (3, −7), the change in y is −7 − 5 = −12 and the change in x is 3 − (−1) = 4, so the gradient is −12 ÷ 4 = −3. Answer: −3. The distractors: 3 comes from subtracting the y-coordinates in one order and the x-coordinates in the other, giving 12 ÷ 4; −1/3 comes from dividing the change in x by the change in y instead of the other way round, giving 4 ÷ (−12); −6 comes from working out 3 − (−1) as 3 − 1 = 2, so that the change in y is divided by 2 rather than by 4.
(b) 60 km/h — Method: the gradient of a distance-time graph is the change in distance divided by the change in time, and for a journey at a steady rate that gradient is the speed. Working: the change in distance is 195 − 15 = 180 km and the change in time is 3 hours, so the gradient is 180 ÷ 3 = 60 km/h. Answer: 60 km/h. The distractors: 180 km/h comes from stopping at the change in distance and never dividing by the 3 hours; 195 km/h comes from reading the final marker as the rate instead of working with the change between the two markers; 3 km/h comes from quoting the time taken, which belongs on the bottom of the fraction, as though it were the value of the fraction itself.

Build your own mix at the worksheet builder.