Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- 1.The point (3, 6) lies on the circle x² + y² = 45. The tangent to the circle at (3, 6) crosses the x-axis at the point P. Work out the coordinates of P.
- 2.Solve x² − 2x − 24 = 0.
- 3.Which of these is a factor of 15x + 20?
- 4.By completing the square, find the turning point of the curve y = x² − 10x + 30.y = x² − 10x + 30
- 5.The graph of y = mx + 6 passes through the point (−2, 0). Work out the value of m.
- 6.A circle has centre (0, 0) and equation x² + y² = 36. Work out the coordinates of the two points where the circle crosses the y-axis.
- 7.Which of these rules generates the sequence 6, 11, 16, 21, …?
- 8.A cyclist's velocity increases from 3 m/s to 11 m/s over 5 seconds, at a constant rate. Work out the cyclist's acceleration, in m/s².
- 9.A delivery van's distance-time graph shows the following: it travels 9 km in the first 15 minutes at a steady speed, stops for 45 minutes to unload, then travels a further 21 km in the next 30 minutes, also at a steady speed. Work out the average speed, in km/h, for the whole journey.
- 10.Which of these statements is an equation with exactly one solution?
- 11.A plumber charges a call-out fee plus an hourly rate for a job. The total cost, £C, for a job lasting h hours is given by the formula C = 40 + 25h. What does the number 40 represent in this formula?
- 12.A line segment has one endpoint at (−6, 2) and its midpoint at (−1, 5). Work out the coordinates of the other endpoint.
- 13.The graph of y = 60 × (0.5)ˣ is sketched for x ≥ 0. Which statement correctly describes what happens to the curve as x increases?
- 14.Simplify 5a/6 − a/3
- 15.A circle has centre (0, 0) and passes through the point (7, 24). Work out the equation of the circle.
Answer key
- (a) (15, 0) — Method: the tangent is perpendicular to the radius at the point of contact, so find the gradient of the radius, take its negative reciprocal, write the equation of the tangent, then substitute y = 0 because every point on the x-axis has y-coordinate 0. Working: the radius from (0, 0) to (3, 6) has gradient 6 ÷ 3 = 2, so the tangent has gradient −1/2. Substituting into y − 6 = −1/2(x − 3) gives y = −0.5x + 7.5. Setting y = 0 gives 0.5x = 7.5, so x = 15 and P is (15, 0). Answer: (15, 0). The distractors: (0, 7.5) is where the same tangent crosses the y-axis, reached by setting x = 0 instead of y = 0; (0, 0) comes from using the gradient of the radius, 2, for the tangent, which gives the line y = 2x through the centre and so crosses the x-axis at the origin; (6, 0) comes from changing the sign of the radius gradient without turning it upside down, which gives y = −2x + 12.
- (a) x = 6 or x = −4 — We need two numbers that multiply to −24 and add to −2: these are −6 and 4, since −6 × 4 = −24 and −6 + 4 = −2. So x² − 2x − 24 = (x − 6)(x + 4) = 0, giving x = 6 or x = −4. A candidate who swaps the signs, using 6 and −4 the wrong way round in the brackets, gets x = −6 or x = 4. A candidate who picks the wrong factor pair, 8 and −3 (which multiply to −24 but add to +5, not −2), gets (x + 8)(x − 3) = 0 and answers x = −8 or x = 3. A candidate who makes both factors negative gets x = −6 or x = −4, which would require the constant term to be +24, not −24.
- (a) 5 — A factor of the whole expression must divide every term exactly. 15x + 20 = 5(3x + 4), so 5 is a factor. Distractor origins: 3 divides 15x exactly but does not divide 20 exactly; 4 divides 20 exactly but does not divide 15x exactly; 10 also divides 20 exactly but does not divide 15x exactly, so it is a factor of only one term, not of the whole expression.
- (c) x = 5, y = 5 — x² − 10x + 30 = (x − 5)² − 5² + 30 = (x − 5)² + 5. Substituting x = 5: 5² = 25, 10 × 5 = 50, so 25 − 50 + 30 = 5, confirming the minimum value 5 at x = 5: turning point (5, 5). Using −10 instead of half of it inside the bracket gives (x − 10)² − 70, turning point (10, −70) — wrong, because only half the coefficient of x belongs inside the bracket. Reading the bracket's sign directly as the turning point's x-coordinate gives (−5, 5) — wrong, because (x − 5)² is zero at x = 5, not x = −5. Computing 25 − 30 = −5 instead of 30 − 25 = 5 flips the sign of the constant, giving (5, −5) — wrong, since the completed square's constant must be evaluated as 30 minus 25, not 25 minus 30. Always check a turning point by substituting its x-value back into the original equation.
- (c) 3 — Method: a point that lies on a graph makes its equation true, so substituting the coordinates into y = mx + 6 leaves an equation in m alone. Working: substituting x = −2 and y = 0 gives 0 = m × (−2) + 6, which rearranges to −2m = −6, so m = (−6) ÷ (−2) = 3. Answer: 3. The distractors: −3 comes from dividing −6 by 2 and keeping the minus sign, overlooking that the divisor is negative too, so the two signs cancel; −2 comes from writing down the x-coordinate of the given point in place of the gradient; 6 comes from reading the constant in y = mx + 6 as the gradient, confusing m with c.
- (b) (0, 6) and (0, −6) — Method: every point on the y-axis has x-coordinate 0, so substitute x = 0 into the equation of the circle and solve for y, remembering that a square root has a negative value as well as a positive one. Working: putting x = 0 into x² + y² = 36 leaves y² = 36, so y = 6 or y = −6, and the two crossings are (0, 6) and (0, −6). Answer: (0, 6) and (0, −6). The distractors: (0, 36) and (0, −36) use 36 itself as the distance from the centre, which reads r² as r; (6, 0) and (−6, 0) are the right distance from the centre but are the crossings of the x-axis, found by setting y = 0 instead of x = 0; (0, 18) and (0, −18) halve 36, treating the right-hand side of the equation as a diameter.
- (c) 5n + 1 — Method: find the common difference, then use it as the coefficient of n in the position-to-term rule, and find the constant by checking against the first term. Working: the common difference is 5, so the rule has the form 5n + c. Using the 1st term: 5(1) + c = 6, so c = 1. The rule is 5n + 1. Answer: 5n + 1. 5n − 1 uses the correct coefficient but the wrong sign for the constant. 6n comes from using the first term as the coefficient of n instead of the common difference — it matches the 1st term by coincidence but fails from the 2nd term onward. n + 5 swaps the coefficient and the constant around, using the common difference as the constant instead of the coefficient of n.
- (b) 1.6 m/s² — Acceleration is the change in velocity divided by the time taken: (11 − 3) ÷ 5 = 8 ÷ 5 = 1.6 m/s². Forgetting to subtract the initial velocity and dividing the final velocity by the time instead gives 11 ÷ 5 = 2.2 m/s². Inverting the fraction, dividing the time by the change in velocity, gives 5 ÷ 8 = 0.625 m/s². Finding the change in velocity, 8 m/s, but stopping without dividing by the time gives 8 m/s².
- (d) 20 km/h — Method: total distance = 9 + 21 = 30 km. Total time = 15 + 45 + 30 = 90 minutes = 1.5 hours. Average speed = total distance ÷ total time = 30 ÷ 1.5 = 20 km/h. Distractor origins: 40 km/h ignores the 45-minute stop, dividing the total distance by the travel time only (30 km ÷ 45 minutes = 40 km/h); 39 km/h averages the two section speeds, 36 km/h and 42 km/h, instead of using total distance over total time; 36 km/h uses only the first section's speed (9 km in 15 minutes), ignoring the second section and the stop.
- (a) 5x − 3 = 12 — 5x − 3 = 12 is an equation with exactly one solution: adding 3 and dividing by 5 gives x = 3, and no other value works. 5x − 3 = 5x − 3 is true for every value of x, since both sides are identical — it has infinitely many solutions, not one. 5x − 3 > 12 is an inequality: any value of x greater than 3 satisfies it, so it has a whole range of solutions, not a single one. 5x − 3 = 5x + 2 has no solution at all, since subtracting 5x from both sides leaves −3 = 2, which is never true. The equation with exactly one solution is 5x − 3 = 12.
- (d) The fixed call-out fee, charged before the hourly rate. — Method: compare the formula with C = (fixed charge) + (rate) × h, where the fixed charge is the part that does not depend on h. Working: in C = 40 + 25h, the term 25h depends on the number of hours, h, but 40 does not change however many hours the job takes. Answer: 40 is the fixed call-out fee. 'The hourly rate' confuses the fixed term with the coefficient of h, which is actually 25. 'The total cost for a job lasting 1 hour' comes from substituting h = 1 into the formula (40 + 25 = 65) rather than reading off the constant term. 'The number of hours worked before charging starts' wrongly treats the constant, which is in pounds, as if it were measured in hours.
- (d) (4, 8) — The other endpoint is found from 2 × midpoint − known endpoint: x = 2 × (−1) − (−6) = −2 + 6 = 4, y = 2 × 5 − 2 = 10 − 2 = 8, giving (4, 8). (−3.5, 3.5) comes from averaging the given endpoint and the midpoint as if they were the two endpoints of a segment, instead of working backwards from the midpoint. (5, 3) comes from working out (−1 − (−6), 5 − 2) instead of doubling the midpoint before subtracting. (4, 5) comes from correctly finding the x-coordinate but copying the midpoint's y-coordinate of 5 instead of doubling it.
- (a) It gets closer to zero but never actually reaches it. — y = 60 × (0.5)ˣ is always positive, however large x is, because a positive number raised to any power stays positive. As x increases, (0.5)ˣ gets smaller and smaller but never equals zero, so y approaches zero without ever reaching it. Believing the curve reaches zero when x = 60, because 60 is the starting value, mixes up the y-intercept with a stopping point — an exponential decay curve like this one never actually reaches the x-axis, so this is wrong. Believing the curve goes negative for large x is wrong because multiplying a positive number by (0.5) any number of times can never produce a negative result. Believing the curve levels off at y = 0.5, confusing the base of the exponential with its eventual level, is wrong: the base only controls how fast the curve falls, not where it settles — this curve settles at y = 0, not y = 0.5. Whenever you sketch an exponential decay curve, draw it approaching the x-axis but never touching it.
- (d) a/2 — Method: write both terms over the same denominator, subtract the numerators, then cancel the fraction down. Working: 6 is a multiple of 3, so a/3 is rewritten as 2a/6; the calculation becomes 5a/6 − 2a/6 = 3a/6, and dividing numerator and denominator by 3 gives a/2. Answer: a/2. The distractors: 4a/3 comes from subtracting the denominators as well as the numerators, giving (5 − 1)a over (6 − 3); 2a/3 comes from subtracting 1 from 5 without first rewriting a/3 as 2a/6, giving 4a/6; 7a/6 comes from adding the two fractions instead of subtracting them, giving 5a/6 + 2a/6.
- (b) x² + y² = 625 — Since (7, 24) lies on the circle, x² + y² = 7² + 24² = 49 + 576 = 625, so the equation is x² + y² = 625. Choosing x² + y² = 31 adds the coordinates 7 and 24 directly instead of squaring them first. Choosing x² + y² = 576 uses only 24² and forgets to add 7². Choosing x² + y² = 49 uses only 7² and forgets to add 24².
Build your own mix at the worksheet builder.