Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- 1.Look at the statement 2x + 5 = 17. Considering whether it is an expression, an equation, a formula, or an identity, which classification is correct?
- 2.Which expression is equivalent to 3(x + 4) − 2(x − 1)?
- 3.The height, h metres, of a ball t seconds after a stopwatch is started follows h = (t − 1)(5 − t) for 1 ≤ t ≤ 5, where h = 0 means the ball is at ground level. Work out the two times at which the ball is at ground level.
- 4.Which expression is equivalent to 7x − 3(2x − 6)?
- 5.Two students each use the trapezium rule to estimate the area under the same curve between x = 0 and x = 8. Student A uses 4 strips of width 2. Student B uses 8 strips of width 1. Which estimate is more likely to be closer to the true area, and why?
- 6.The point (9, 40) lies on the circle x² + y² = 1681, which has centre (0, 0). Work out the equation of the tangent to the circle at (9, 40), giving your answer in the form ax + by = c.
- 7.The nth term of a sequence is 2n² + 1. Work out the 4th term of the sequence.
- 8.Which expression means 'add 3 to n, then multiply the result by 4'?
- 9.The area under a speed-time graph between t = 0 and t = 6 seconds is estimated using three strips of equal width, using the speeds, in m/s, at t = 0, 2, 4 and 6: 0, 5, 9 and 12. Using the trapezium rule with these three trapezia, estimate the distance travelled.
- 10.Water is poured into a container at a constant rate. A graph of the depth of the water, in cm, against the time since pouring began, in minutes, is a straight line through the origin, and it passes through the point (3, 12). Use the graph to work out the depth of the water after 7 minutes.
- 11.A circle has centre (0, 0) and equation x² + y² = 50. Work out the radius of the circle, giving your answer as a surd in its simplest form.
- 12.The table shows some values of f(x): when x = 0, f(x) = 5; when x = 1, f(x) = 8; when x = 2, f(x) = 4; when x = 3, f(x) = 1. Work out the value of f(x − 1) when x = 2.
- 13.Make x the subject of the formula y = 4x − 3.y = 4x − 3
- 14.Rosie is asked whether 4(x + 3) = 4x + 12 is an equation or an identity. Which statement is correct? Give a reason for your answer.
- 15.The graph of y = f(x) has a minimum point at (4, −1). Write down the coordinates of the corresponding turning point on the graph of y = −f(x).
Answer key
- (d) An equation, true for one value of x — 2x + 5 = 17 is only true when x = 6, so it is an equation. A candidate who ignores the equals sign and focuses only on the x terms and numbers present picks the expression option. A candidate who sees an equals sign and assumes it must relate two different quantities, as a formula does, picks that option, missing that there is only one quantity, x, involved here. A candidate who wrongly checks whether both sides look similar in structure rather than testing specific values picks the identity option, missing that the two sides are not equal for every value of x.
- (a) x + 14 — Expand each bracket separately: 3(x + 4) = 3x + 12, and −2(x − 1) = −2x + 2 (multiply −2 by both x and −1). Combine: 3x + 12 − 2x + 2 = x + 14. Writing x + 10 comes from taking −2(x − 1) as −2x − 2, not flipping the sign of the −1 inside the bracket. Writing 5x + 10 comes from treating the second bracket as +2(x − 1) instead of subtracting it, so the x-terms are added rather than subtracted. Writing x + 13 comes from only multiplying the 2 by the x, and carrying the −1 across unmultiplied.
- (c) t = 1 second and t = 5 seconds — The ball is at ground level when h = 0, which happens when either bracket is zero. t − 1 = 0 gives t = 1, and 5 − t = 0 gives t = 5. The option with t = −1 makes a sign error solving the first bracket. The option with t = −5 makes a sign error solving the second bracket, treating 5 − t = 0 as if it gave a negative solution. The option with t = 4 seconds is an arithmetic slip in solving 5 − t = 0.
- (c) x + 18 — Expand −3(2x − 6) by multiplying both terms by −3: −3 × 2x = −6x and −3 × (−6) = 18, giving 7x − 6x + 18 = x + 18. Writing x − 18 comes from not flipping the sign of the −6 inside the bracket, so −3 × (−6) is treated as −18 instead of +18. Writing x + 6 comes from forgetting to multiply the −6 by 3, only carrying its sign. Writing 13x − 18 comes from treating the whole bracket as being added rather than subtracted, so 3(2x − 6) = 6x − 18 is added to 7x.
- (b) Student B's — narrower strips fit the curve more closely. — The trapezium rule replaces the curve with straight-line segments; the narrower each strip, the more closely its straight edge follows the curve, so Student B's estimate with 8 narrower strips is more likely to be closer to the true area. Reasoning from the number of arithmetic steps rather than from how well the straight lines fit the curve gives the wrong claim that Student A makes fewer rounding errors. Believing the trapezium rule is exact, rather than an estimate that improves with narrower strips, gives the wrong claim that the two are always the same. Believing wider strips smooth out the curve better, rather than following it less closely, gives the wrong claim in favour of Student A's wider strips.
- (b) 9x + 40y = 1681 — For a circle x² + y² = r² centred at the origin, the tangent at a point (a, b) on the circle has equation ax + by = r². Here (a, b) = (9, 40) and r² = 1681, so the tangent is 9x + 40y = 1681. Choosing 40x + 9y = 1681 swaps the coefficients, using the y-coordinate as the x-coefficient and the x-coordinate as the y-coefficient. Choosing 9x + 40y = 41 uses the radius 41 instead of r² = 1681 as the constant. Choosing 9x − 40y = 1681 has the correct coefficients and constant but the wrong sign on the y-term.
- (a) 33 — Substitute n=4 into 2n²+1: 2×4²+1=2×16+1=33. A candidate who computes n² as 2×n instead of n×n would compute 2×(2×4)+1=2×8+1=17. A candidate who correctly finds 2×16 but forgets to add the constant 1 would stop at 32. A candidate who squares the whole term 2n, rather than squaring n before multiplying by 2, would compute (2×4)²+1=64+1=65.
- (c) 4(n + 3) — 'Add 3 to n' must happen before 'multiply the result by 4', so the addition needs brackets to show it happens first: 4(n + 3). Writing 4n + 3 multiplies n by 4 immediately and only adds the 3 afterwards, which reverses the order the words describe. Writing n + 3 × 4 only multiplies the 3 by 4, and adds n as a separate, unmultiplied term — it treats 'the result' as just the 3, not the whole of n + 3. Writing 3(n + 4) keeps the correct structure but swaps which number is added and which is multiplied. The expression for 'add 3 to n, then multiply the result by 4' is 4(n + 3).
- (d) 40 m — Each trapezium has width 2. Its area is width × the average of its two heights. Strip 1: average of 0 and 5 is 2.5, so area = 2 × 2.5 = 5. Strip 2: average of 5 and 9 is 7, so area = 2 × 7 = 14. Strip 3: average of 9 and 12 is 10.5, so area = 2 × 10.5 = 21. Total distance = 5 + 14 + 21 = 40 m. Leaving out the division by 2 in the averaging step doubles every strip, giving 80 m instead of 40 m. Using only the LEFT height of each strip as a rectangle, 0 × 2 + 5 × 2 + 9 × 2 = 28, or only the RIGHT height, 5 × 2 + 9 × 2 + 12 × 2 = 52, both ignore that the graph curves between the two ends of each strip — always average the two heights of a trapezium, never use just one of them.
- (d) 28 cm — Method: rate = 12 cm ÷ 3 min = 4 cm per minute. Depth after 7 minutes = 4 × 7 = 28 cm. Distractor origins: 84 cm multiplies the given depth by 7 directly, without first finding the rate per minute (12 × 7 = 84); 24 cm simply doubles the given depth instead of scaling correctly by the ratio of times; 16 cm combines the numbers with subtraction and addition (12 − 3 + 7 = 16) instead of finding a rate.
- (d) 5√2 — For a circle x² + y² = r², the 50 on the right-hand side is r², not r, so the radius is √50. Writing 50 as 25 × 2, the largest square factor times what remains, gives √50 = √25 × √2 = 5√2. Forgetting to square-root 50 at all and giving the value of r² instead gives 50. Halving 50 instead of taking its square root gives 25. Using 25 as the number left outside the square root sign, instead of as the number under it, gives the wrongly simplified 25√2.
- (a) 8 — f(x − 1) means every input to f is reduced by 1 before it is looked up. At x = 2, the input to f becomes 2 − 1 = 1, so f(x − 1) at x = 2 is f(1) = 8. Reading f(2) = 4 directly from the table, without applying the shift, gives 4. Shifting in the wrong direction, using x + 1 = 3 instead of x − 1 = 1, gives f(3) = 1. Confusing f(x − 1) with f(x) − 1 — taking f(2) = 4 and then subtracting 1 — gives 3.
- (d) x = (y + 3)/4 — Two operations have been applied to x: it has been multiplied by 4 and then 3 has been subtracted. Undo them in the opposite order. Adding 3 to both sides gives y + 3 = 4x. Dividing both sides by 4 then gives (y + 3)/4 = x, so x = (y + 3)/4. The bracket matters: writing y/4 + 3 divides only the y by 4 and leaves the 3 untouched. Writing (y − 3)/4 subtracts the 3 instead of adding it, and writing 4(y + 3) multiplies by 4 rather than dividing.
- (a) An identity, because it is true for every value of x — Expanding the brackets multiplies both terms inside by 4, giving 4x + 12, which is exactly the right-hand side. The two sides are therefore equal whatever x is, and a statement true for every value of the letter is an identity. An equation is true only for particular values, and trying to solve this one leads to 0 = 0, which places no restriction on x at all. Being able to expand brackets is not what makes a statement an identity, since any equation with brackets can be expanded. Nor is it a formula: a formula links two different quantities, and only one letter appears here.
- (a) (4, 1) — y = −f(x) reflects the graph of y = f(x) in the x-axis: every point (x, y) maps to (x, −y). Applying this to (4, −1): the x-coordinate stays 4, and the y-coordinate −1 becomes its negative, 1. Leaving the y-coordinate unchanged skips the reflection entirely, giving (4, −1); reflecting the x-coordinate instead, or reflecting both, mixes this up with a reflection in the y-axis or a rotation, giving (−4, −1) or (−4, 1).
Build your own mix at the worksheet builder.