Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- 1.A straight line has gradient −2 and passes through the point (3, 1). Work out the equation of the line.
- 2.A tap fills a tank at a varying rate. A graph shows the rate of flow, in litres per minute, against time, in minutes. What does the area under this graph represent?
- 3.f(x) = x³ − 3x − 5. Given that f(2.2) = −0.952 and f(2.3) = 0.267, work out what this shows about the equation x³ − 3x − 5 = 0.y = x
- 4.The tangent to a curve at the point where x = 4 passes through the points (2, 5) and (6, 21). Use these two points to estimate the gradient of the curve at x = 4.
- 5.A garden path runs along the line 4x + y = 12. A drainage pipe must be laid perpendicular to the path, passing through the point (3, 1) where a sprinkler sits. Work out the equation of the pipe's line, giving your answer in the form y = mx + c.
- 6.Expand and simplify 4(2x − 1) − 3(x + 2) − 5x
- 7.f(x) = x + 2 and g(x) = x². Work out the value of x for which fg(x) = gf(x).y = x + 2
- 8.To solve 5x − 4 = 2x + 8, Chloe's working is shown. Line 1: 5x − 4 = 2x + 8. Line 2: 3x − 4 = 8. Line 3: 3x = 4. Line 4: x = 4/3. Chloe has made a mistake in her working. Which line contains the mistake?
- 9.Write down the expression that means the same as m² × m × 3.
- 10.f(x) = 3x − 2. Find f⁻¹(x).y = 3x − 2
- 11.Factorise fully 56x − 24
- 12.A Fibonacci-type sequence begins 3, 5, 8, 13, ... where each term after the second is the sum of the two terms before it. Work out the 7th term of the sequence.
- 13.On a distance-time graph, a horizontal line segment shows a period when the graph's gradient is 0. What does this tell you about the journey during that time?
- 14.A regular hexagon has sides of length (x + 2) cm. Write down an expression, in terms of x, for the perimeter of the hexagon.
- 15.The graph of y = f(x) has a minimum turning point at (2, −3). The graph of y = −f(x) + a has a maximum turning point at (2, 9). Work out the value of a.
Answer key
- (a) y = −2x + 7 — Using y = −2x + c, and substituting the point (3, 1): 1 = −2(3) + c, so 1 = −6 + c, and c = 7, giving y = −2x + 7. A candidate who uses the y-coordinate of the point directly as the y-intercept, instead of solving for c, would write y = −2x + 1. A candidate who drops the negative sign on the gradient would write y = 2x + 7. A candidate who makes a sign error when isolating c, writing c = 1 − 6 = −5 instead of c = 1 + 6 = 7, would write y = −2x − 5.
- (b) The total volume of water, in litres, that has flowed in. — On a rate-time graph, the y-axis is in litres per minute and the x-axis is in minutes; multiplying a rate by a time gives litres per minute × minutes = litres, a total volume. So the area under the graph represents the total volume of water that has flowed in. Thinking the area itself represents the rate, rather than what the rate accumulates to, gives the wrong claim about the average rate of flow. Confusing the area with the gradient of the graph — which measures how the rate is changing — gives the wrong claim about litres per minute squared. Ignoring the flow-rate axis and focusing only on the time axis gives the wrong claim that the area is simply the total time.
- (d) It has a solution between x = 2.2 and x = 2.3 — Since f(2.2) is negative and f(2.3) is positive, the graph of f crosses the x-axis somewhere between x = 2.2 and x = 2.3, so the equation has a solution in that interval. Choosing 'between x = −2.2 and x = −2.3' confuses the negative f-VALUE at 2.2 with a negative x-value. Choosing 'no solution' misreads a change of sign as meaning the opposite of what it shows. Choosing 'exactly two solutions' assumes a single change of sign must give two roots, which is not what the rule guarantees.
- (a) 4 — The gradient of a straight line through two points is the change in y divided by the change in x. Change in y = 21 − 5 = 16. Change in x = 6 − 2 = 4. Gradient = 16 ÷ 4 = 4. Dividing x by y instead of y by x gives 0.25; forgetting to divide by the change in x at all leaves 16; dividing by only one of the two x-coordinates, 16 ÷ 2 = 8, uses the wrong denominator.
- (a) y = (1/4)x + 1/4 — Rearrange 4x + y = 12 to y = −4x + 12, so the path has gradient −4. The perpendicular gradient is 1/4. Substituting (3, 1) into y − 1 = (1/4)(x − 3): y = (1/4)x − 3/4 + 1 = (1/4)x + 1/4. Distractor routes: y = −4x + 13 uses the path's own gradient, −4, instead of the perpendicular gradient, giving a line PARALLEL to the path through (3, 1) rather than perpendicular to it. y = (1/4)x − 1/4 makes an arithmetic slip combining −3/4 and 1, landing on −1/4 instead of the correct 1/4. y = −(1/4)x + 1/4 takes the reciprocal of −4, which is −1/4, but forgets to change its sign, so it is not the true negative reciprocal.
- (a) −10 — Method: multiply each bracket out, treating the second bracket as being multiplied by −3 because it is subtracted, then collect like terms. Working: 4(2x − 1) = 8x − 4 and −3(x + 2) = −3x − 6, so the expression becomes 8x − 4 − 3x − 6 − 5x; the x terms give 8x − 3x − 5x = 0, so no term in x survives, and the numbers give −4 − 6 = −10. Answer: −10. The distractors: 2 comes from expanding −3(x + 2) as −3x + 6, leaving the numbers −4 + 6; 5x − 10 comes from forgetting the final −5x, so the x terms give 8x − 3x = 5x; −7 comes from multiplying the 4 over only the first term of its bracket, giving 8x − 1 and so the numbers −1 − 6.
- (c) −0.5 — fg(x) = f(g(x)) = f(x²) = x² + 2. gf(x) = g(f(x)) = g(x + 2) = (x + 2)² = x² + 4x + 4. Setting fg(x) = gf(x): x² + 2 = x² + 4x + 4. Subtract x² from both sides: 2 = 4x + 4. Subtract 4 from both sides: −2 = 4x, so x = −0.5. Writing 1.5 comes from adding the 4 instead of subtracting it: 4x = 2 + 4 = 6, giving x = 1.5. Writing 'no solution' comes from expanding (x + 2)² as x² + 4 using (a + b)² = a² + b², losing the middle term — the equation then reads x² + 2 = x² + 4, which has no solution, but the expansion itself is wrong. Writing 0 comes from treating gf(x) as g(x) + f(x) instead of g(f(x)): x² + (x + 2) = x² + 2 gives x = 0, but that adds the two functions rather than composing them.
- (d) Line 3 — Method: check each line of Chloe's working against the correct algebraic step. Working: Line 1 to Line 2 is correct, subtracting 2x from both sides gives 3x − 4 = 8. But Line 2 to Line 3 should add 4 to both sides, giving 3x = 12, not 3x = 4 — the constant −4 has been dropped rather than removed correctly. Line 4 follows correctly from Chloe's own, incorrect, Line 3. Answer: Line 3. Line 1 is simply the original equation, copied out correctly. Line 2 correctly subtracts 2x from both sides of Line 1. Line 4 divides Chloe's own Line 3 by 3 correctly — the arithmetic there is fine, the mistake happened one line earlier.
- (d) 3m³ — Method: multiply the powers of m by adding their indices, then bring the number coefficient to the front. Working: m² × m has indices 2 and 1; add them to get 3, giving m³, then × 3 gives 3m³. Answer: 3m³. 3m² comes from multiplying the indices instead of adding them: 2 × 1 = 2, giving m², then × 3 = 3m². m³ comes from correctly combining the m's but dropping the coefficient 3. m⁶ comes from multiplying the index by the coefficient instead of writing the coefficient in front: taking the 2 in m² and the 3 to give m raised to the power 2 × 3, which is m⁶, with the lone m left out.
- (b) (x + 2)/3 — Start with y = 3x − 2 and swap x and y: x = 3y − 2. Add 2 to both sides: x + 2 = 3y. Divide both sides by 3: y = (x + 2)/3, so f⁻¹(x) = (x + 2)/3. Writing x/3 + 2 comes from dividing only the 3y term by 3 and leaving the +2 outside the division — the 2 must be added before you divide, not after. Writing (x − 2)/3 comes from keeping the subtraction sign instead of flipping it to addition when the −2 is moved across the equals sign. Writing 3x + 2 comes from swapping x and y but never actually solving for y — just changing the sign of the constant term.
- (d) 8(7x − 3) — Method: find the highest common factor of the two terms, write it in front of a bracket and divide each term by it. Working: 56 = 8 × 7 and 24 = 8 × 3, so the highest common factor is 8; dividing gives 56x ÷ 8 = 7x and 24 ÷ 8 = 3, and the subtraction sign stays between them. Answer: 8(7x − 3), which multiplies back out to 56x − 24. The distractors: 8(7x + 3) comes from dropping the minus sign of −24 while dividing; 8(56x − 3) comes from dividing only the number term by 8 and leaving 56x untouched inside the bracket; 8(7x − 16) comes from subtracting 8 from 24 instead of dividing 24 by 8.
- (c) 55 — Continuing the pattern: 8+13=21 (5th term), 13+21=34 (6th term), 21+34=55 (7th term). A candidate who miscounts the position and stops one term early would give 34, the 6th term. A candidate who doubles the most recent term instead of adding the two before it would compute 34×2=68. A candidate who adds a non-adjacent pair — the 4th and 6th terms, skipping the 5th — would compute 13+34=47.
- (c) The object was stationary (not moving) — On a distance-time graph, the gradient at any point represents the speed at that point. A gradient of 0 means distance is not changing over time, so the object is stationary. A straight, sloped line (not flat) shows constant nonzero speed; a curve bending one way shows acceleration or deceleration; a flat section is not a maximum speed — it is no speed at all. Read the shape of the graph, not just how steep it looks.
- (a) 6x + 12 — A regular hexagon has 6 equal sides, so the perimeter is 6(x + 2) = 6x + 12. A candidate who multiplies only the x-term by 6 and forgets to multiply the 2 gets 6x + 2. A candidate who multiplies only the number term by 6 and forgets to multiply the x gets x + 12. A candidate who adds 6 and 2 to make a single coefficient of x instead of expanding the brackets gets 8x.
- (b) 6 — Reflecting y = f(x) in the x-axis turns the minimum point (2, −3) into a maximum point at (2, 3), since −f(x) negates every y-value: −(−3) = 3. Adding a then gives 3 + a = 9, so a = 9 − 3 = 6. Forgetting the reflection and using the original y-value of −3 gives −3 + a = 9, so a = 12 — this ignores that −f(x) changes the sign of the y-coordinate before a is added. Writing a = −12 comes from subtracting in the wrong order, working out 9 − (−3) as −3 − 9 instead. Writing a = −6 comes from taking the negative of the correct answer, as if the final value of a needed to be reflected too, on top of the turning point.
Build your own mix at the worksheet builder.