Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- 1.f(x) = x³ − 5x − 6. Given that f(2.6) = −1.424 and f(2.7) = 0.183, work out what this shows about the equation x³ − 5x − 6 = 0.y = x
- 2.Which of these equations is equivalent to 5x − 2 = 3x + 8?
- 3.The tangent to a curve at the point where x = 4 passes through the points (2, 5) and (6, 21). Use these two points to estimate the gradient of the curve at x = 4.
- 4.The graph of y = x² − 7x + 2 crosses the x-axis at two points. One root, read from the graph, is approximately x = 0.30. Using the fact that the sum of the two roots of x² − 7x + 2 = 0 is 7, estimate the other root, correct to 2 decimal places.y = x² − 7x + 2
- 5.Point P has coordinates (5, 2). Point P is rotated 180° about the origin to point Q. Write down the coordinates of Q.
- 6.A circle has equation x² + y² = 49. Work out the coordinates of the point(s) on the circle where the tangent is horizontal.
- 7.An exponential model has equation y = A × bˣ, where b > 1. Its graph passes through the points (1, 135) and (2, 405). Work out the value of A.
- 8.A box holds n pencils. A shop has 6 full boxes and 4 loose pencils. All of these pencils are shared equally between 2 classes. Write down the expression for the number of pencils each class receives.
- 9.Water is poured into a container at a constant rate. A graph of the depth of the water, in cm, against the time since pouring began, in minutes, is a straight line through the origin, and it passes through the point (3, 12). Use the graph to work out the depth of the water after 7 minutes.
- 10.Work out the coordinates of the reflection of (6, −3) in the y-axis.
- 11.A geometric sequence has first term 3 and common ratio √2. Work out the 6th term of the sequence, giving your answer in the form a√2.
- 12.A pattern is made from tiles. Pattern 1 uses 4 tiles, pattern 2 uses 7 tiles, pattern 3 uses 10 tiles and pattern 4 uses 13 tiles, with each pattern using 3 more tiles than the one before. Work out an expression, in terms of n, for the number of tiles used in pattern n.
- 13.Which of these is a factor of 15x + 20?
- 14.A point has coordinates (x, y), where x + y = 0 and x is not 0. In which two quadrants could this point lie?
- 15.A candidate solves the simultaneous equations y = x − 2 and y = x² − 4x + 2 by substitution. They write: "x − 2 = x² − 4x + 2, so x² − 3x + 4 = 0." Which of these is a correct comment on the candidate's working?y = x − 2y = x² − 4x + 2
Answer key
- (a) It has a solution between x = 2.6 and x = 2.7 — f(2.6) is negative and f(2.7) is positive, so the graph of f crosses the x-axis between x = 2.6 and x = 2.7, meaning the equation has a solution there. Choosing 'x = 2.6 is a solution' reads an end of the interval as the root itself, but f(2.6) = −1.424, which is not zero — the change of sign locates a root between the two values, it does not land on either of them. Choosing 'between x = −2.6 and x = −2.7' confuses the negative f-VALUE at 2.6 with a negative x-value. Choosing 'no root in this interval' misapplies the rule, which needs a CHANGE of sign — and a change of sign is exactly what these two values show.
- (d) 2x = 10 — Method: collect the x-terms on one side and the constants on the other, keeping the equals sign balanced. Working: 5x − 3x = 8 + 2, giving 2x = 10. Answer: 2x = 10. 2x = 6 comes from a sign error moving the constant, subtracting instead of adding: 8 − 2 = 6. 8x = 6 comes from adding the x-terms instead of subtracting them (5x + 3x = 8x), alongside the constant sign error. 2x = −10 comes from a sign error moving the constant the other way: −2 − 8 = −10.
- (a) 4 — The gradient of a straight line through two points is the change in y divided by the change in x. Change in y = 21 − 5 = 16. Change in x = 6 − 2 = 4. Gradient = 16 ÷ 4 = 4. Dividing x by y instead of y by x gives 0.25; forgetting to divide by the change in x at all leaves 16; dividing by only one of the two x-coordinates, 16 ÷ 2 = 8, uses the wrong denominator.
- (a) x ≈ 6.70 — Since the two roots sum to 7, the other root is 7 − 0.30 = 6.70. The option 7.30 comes from adding the given root to 7 instead of subtracting it. The option 6.30 comes from subtracting 0.70 (one minus the given root) rather than the given root itself. The option 0.70 confuses the required root with the amount by which the given root falls short of 1.
- (b) (−5, −2) — A rotation of 180° about the origin reverses the sign of both coordinates, so Q = (−5, −2). A candidate who reverses the sign of only the y-coordinate, as if reflecting in the x-axis, gets (5, −2). A candidate who reverses the sign of only the x-coordinate, as if reflecting in the y-axis, gets (−5, 2). A candidate who swaps the coordinates instead of reversing their signs gets (2, 5).
- (a) (0, 7) and (0, −7) — A tangent is horizontal where the radius to that point is vertical, i.e. where the point lies on the y-axis. On x² + y² = 49, setting x = 0 gives y² = 49, so y = 7 or y = −7. The points are (0, 7) and (0, −7). (7, 0) and (−7, 0) comes from swapping the condition — these are the points where the tangent is VERTICAL, not horizontal (the radius there is horizontal). (0, 7) only comes from finding one valid point but forgetting that y² = 49 also gives the negative root, y = −7. (7, 0) only combines both mistakes: the wrong axis, and only one of the two roots.
- (a) 45 — The ratio between the two given points, one power of x apart, gives b: 405 ÷ 135 = 3, so b = 3. Substituting back, at x = 1, y = A × b, so 135 = A × 3, giving A = 45. Giving the common ratio b itself instead of A confuses which unknown was asked for and produces 3 — wrong, because the question asks for A, not b. Giving 135 instead treats the first given point as the y-intercept and reads A off it directly — wrong, because that point is at x = 1, not x = 0, so 135 is A × b, not A. Assuming A equals b⁰ = 1 by itself, rather than substituting a known point to solve for A, gives 1 — wrong, because b⁰ is always 1 regardless of A; A must be found using an actual (x, y) pair from the graph.
- (c) (6n + 4)/2 — Six full boxes hold 6 lots of n pencils, which is 6n, and the 4 loose pencils are added on, so the shop has 6n + 4 pencils altogether. Sharing them equally between 2 classes divides that whole total by 2, and brackets are what show that the division applies to all of it: (6n + 4)/2. Without the brackets, 6n + 4/2 halves only the loose pencils; 6(n + 4)/2 adds the loose pencils to every box before the division; 2(6n + 4) doubles the total instead of halving it.
- (d) 28 cm — Method: rate = 12 cm ÷ 3 min = 4 cm per minute. Depth after 7 minutes = 4 × 7 = 28 cm. Distractor origins: 84 cm multiplies the given depth by 7 directly, without first finding the rate per minute (12 × 7 = 84); 24 cm simply doubles the given depth instead of scaling correctly by the ratio of times; 16 cm combines the numbers with subtraction and addition (12 − 3 + 7 = 16) instead of finding a rate.
- (a) (−6, −3) — Reflecting in the y-axis changes the sign of the x-coordinate and keeps the y-coordinate the same: (−6, −3). (6, 3) comes from reflecting in the x-axis instead, which changes the sign of the y-coordinate. (−6, 3) comes from reflecting in both axes. (6, −3) comes from not applying the reflection at all.
- (d) 12√2 — The nth term of a geometric sequence is a × rⁿ⁻¹. Here a = 3, r = √2, n = 6, so the 6th term is 3 × (√2)⁵. Since (√2)² = 2, (√2)⁴ = (2)² = 4, so (√2)⁵ = (√2)⁴ × √2 = 4√2. The 6th term is 3 × 4√2 = 12√2. 15√2 comes from treating (√2)⁵ as 5√2 — multiplying the index by the surd instead of raising √2 to that power — then multiplying by 3 gives 3 × 5√2 = 15√2, which is wrong because powers of a surd do not scale linearly with the index. 24√2 comes from miscalculating (√2)⁴ as 8 instead of 4 (a squaring slip, since (√2)² = 2 but (√2)⁴ should be 2² = 4, not 2 × 4), giving 3 × 8√2 = 24√2. 4√2 comes from forgetting to multiply by the first term a = 3, leaving just (√2)⁵ = 4√2.
- (b) 3n + 1 — Method: find how many more tiles each pattern uses, then find the constant by adjusting pattern 1's total. Working: each pattern uses 3 more tiles than the last, so the coefficient of n is 3. The constant is pattern 1's total minus the common difference: 4 − 3 = 1. Answer: the nth term is 3n + 1. 3n + 4 comes from using pattern 1's total, 4, as the constant without subtracting the common difference. 3n − 2 comes from a slip in working out the constant, subtracting the common difference twice (4 − 3 − 3 = −2) instead of once. n + 3 comes from swapping the common difference and the constant.
- (a) 5 — A factor of the whole expression must divide every term exactly. 15x + 20 = 5(3x + 4), so 5 is a factor. Distractor origins: 3 divides 15x exactly but does not divide 20 exactly; 4 divides 20 exactly but does not divide 15x exactly; 10 also divides 20 exactly but does not divide 15x exactly, so it is a factor of only one term, not of the whole expression.
- (c) Second and fourth — If x + y = 0 then y = −x, so x and y always have opposite signs, one positive and one negative. A point with a negative x and a positive y lies in the second quadrant, and a point with a positive x and a negative y lies in the fourth quadrant, so the point lies in the second or the fourth. A candidate who reads x + y = 0 as meaning x and y have the same sign picks First and third, which is where x × y is positive, not where x + y = 0. A candidate who decides that y must be the positive coordinate picks the two quadrants above the x-axis, First and second. A candidate who decides that y must be the negative coordinate picks the two quadrants below the x-axis, Third and fourth.
- (c) Wrong — the correct equation is x² − 5x + 4 = 0. — Rearranging x − 2 = x² − 4x + 2 by moving every term across: 0 = x² − 4x + 2 − x + 2 = x² − 5x + 4. The candidate's x-term is wrong: combining −4x with the moved −x gives −4x − x = −5x, not −3x. So the correct equation is x² − 5x + 4 = 0. Distractor routes: "x² − 3x + 4 = 0 is correct" simply agrees with the candidate's sign error without checking it. "It should be x² − 5x − 4 = 0" correctly spots that something is wrong but blames the wrong term — the constant, 2 + 2 = 4, is correct; the error is in the x-term. "Subtracting is the same as adding" states something false: subtracting a term and adding it give different signs.
Build your own mix at the worksheet builder.