Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- 1.Two numbers have a sum of 50. The larger number is twice the smaller number. Work out the smaller number.
- 2.The table shows the height, in metres, of a firework rocket at various times, in seconds, during its flight: 40 at t = 2, 54 at t = 3, and 60 at t = 4. Use the chord between t = 2 and t = 4 to estimate the gradient of the height-time graph at t = 3, stating the correct units.
- 3.A ball is dropped and bounces. The height of each bounce after the first is 8 cm less than the bounce before it. The first bounce reaches 60 cm. Work out the height of the 5th bounce.
- 4.The graph of y = x² − 7x + 2 crosses the x-axis at two points. One root, read from the graph, is approximately x = 0.30. Using the fact that the sum of the two roots of x² − 7x + 2 = 0 is 7, estimate the other root, correct to 2 decimal places.y = x² − 7x + 2
- 5.A ribbon of length L metres is cut into 5 equal pieces, and then 3 metres is removed from one piece. Write down an expression, in metres, for the length of that piece after 3 metres is removed.
- 6.Work out the smallest positive value of x, in degrees, for which y = tan x is undefined.y = tan(x)
- 7.The function f(x) = x² for all real values of x has no inverse function, but g(x) = x² for x ≥ 0 does have one. Which statement correctly explains this?y = x²
- 8.The graph of y = x² − 5x + 6 crosses the x-axis at two points. By factorising, work out the x-coordinates of these two points.y = x² − 5x + 6
- 9.The graph of y = f(x) has a minimum turning point at (3, 2). Write down the coordinates of the minimum turning point of the graph of y = f(x) + 5.
- 10.A speed-time graph shows a constant speed of 15 m/s for 20 seconds. Work out the distance travelled, using the area under the graph.
- 11.A taxi fare, in pounds, for a journey of m miles is given by the formula F = 3 + 2.5m. A journey costs £15.50. Work out the distance travelled, m, by first rearranging the formula to make m the subject, then substituting F = 15.50.
- 12.Factorise x² − 64.
- 13.Work out the value of m² + 3m when m = −2
- 14.A rectangular garden has width w metres and length (w + 3) metres. A gardener writes its perimeter as 2w + 3. Which statement corrects the gardener's mistake?
- 15.Two students each use the trapezium rule to estimate the area under the same curve between x = 0 and x = 8. Student A uses 4 strips of width 2. Student B uses 8 strips of width 1. Which estimate is more likely to be closer to the true area, and why?
Answer key
- (d) 50/3 — Method: call the smaller number x, write the larger number in terms of x and use the total. Working: the larger number is 2x, so x + 2x = 50, that is 3x = 50 and x = 50/3. Answer: 50/3, since 50/3 added to 100/3 makes 50 and 100/3 is twice 50/3. The distractors: 100/3 is the larger of the two numbers rather than the smaller one asked for; 25 comes from halving 50 and treating the two numbers as equal; 24 comes from reading 'twice the smaller number' as 'two more than the smaller number' and solving x + (x + 2) = 50.
- (c) 10 m/s — A symmetric chord gradient uses the two points either side of t = 3: (2, 40) and (4, 60). The gradient is the change in height divided by the change in time: (60 − 40) ÷ (4 − 2) = 20 ÷ 2 = 10 m/s. Using only the values either side of one gap, (2, 40) and (3, 54), instead of the full symmetric chord, gives (54 − 40) ÷ (3 − 2) = 14 m/s. Getting the correct number but dropping the time unit, leaving only metres, gives 10 m. Dividing time by height instead of height by time inverts the calculation to (4 − 2) ÷ (60 − 40) = 0.1 s/m.
- (d) 28 — The height decreases by 8 cm at each bounce after the first, so the nth bounce reaches 60−(n−1)×8 cm. For the 5th bounce: 60−4×8=60−32=28. A candidate who subtracts 8 one time too many, five times instead of four, would compute 60−5×8=20. A candidate who adds the decrease instead of subtracting it, a sign error, would compute 60+4×8=92. A candidate who works out only the total decrease and forgets to include the starting height of 60 cm would compute just 5×8=40.
- (a) x ≈ 6.70 — Since the two roots sum to 7, the other root is 7 − 0.30 = 6.70. The option 7.30 comes from adding the given root to 7 instead of subtracting it. The option 6.30 comes from subtracting 0.70 (one minus the given root) rather than the given root itself. The option 0.70 confuses the required root with the amount by which the given root falls short of 1.
- (c) L/5 − 3 — Each of the 5 equal pieces is L/5 metres long, and removing 3 metres from one piece gives L/5 − 3. Subtracting the 3 metres before dividing by 5, (L − 3)/5, divides the removed length between all 5 pieces instead of taking it from just one. Dividing only the 3 by 5 instead of dividing L by 5, L − 3/5, divides the wrong number. Writing 5/L − 3 inverts the fraction, swapping which number is the numerator.
- (c) 90° — The graph of y = tan x has a vertical asymptote at x = 90°, the smallest positive value for which it is undefined. tan 0° = 0, a defined value, not an undefined one — confusing where the graph equals zero with where it is undefined gives 0°. x = 270° is also a value where y = tan x is undefined, but it is not the smallest positive one, since 90° comes first. tan 45° = 1, a defined value — confusing the asymptote with the angle at which tan x = 1 gives 45°.
- (d) g is one-to-one: f(3) = f(−3), removed by x ≥ 0 — A function has an inverse only if it is one-to-one: every output must come from exactly one input. f(3) = 9 and f(−3) = 9, so two different inputs give the same output, and there is no way to send 9 back to a single input — f is not one-to-one over all real x. Restricting the domain to x ≥ 0 removes one of the two inputs behind every such pair, so g is one-to-one and does have an inverse. 'g's outputs are positive; f's could be negative' is wrong because f(x) = x² also only gives outputs of 0 or more — the outputs of f and g are identical sets; it is the INPUTS that differ, not the outputs. 'Restricting any domain always creates an inverse' is wrong because a restriction only helps if it actually removes the repeated outputs: restricting f(x) = x² to x ≥ −3 still leaves f(1) = f(−1) = 1, so that restricted function is still not one-to-one and still has no inverse. 'Squares can never be reversed, under any conditions' is wrong because √9 = 3 does reverse 3² = 9 once you know the input was non-negative — a square root just cannot tell you WHICH of two inputs you started from unless the domain has already ruled one of them out.
- (c) x = 2 and x = 3 — x² − 5x + 6 factorises as (x − 2)(x − 3), since −2 and −3 multiply to give 6 and add to give −5. The graph crosses the x-axis where each bracket equals zero: x − 2 = 0 gives x = 2, and x − 3 = 0 gives x = 3. The option x = −2 and x = −3 comes from reading the signs inside the brackets directly instead of solving x − 2 = 0 and x − 3 = 0. The option x = 2 and x = −3 mixes up the sign of only one root. The option x = −1 and x = −6 comes from picking the wrong pair of factors of 6 (1 and 6 instead of 2 and 3) and then reading their signs directly from the brackets.
- (a) (3, 7) — y = f(x) + 5 is a vertical translation of y = f(x) by 5 units up — the translation vector is (0, 5) — so only the y-coordinate of any point changes. Turning point (3, 2) → (3, 2 + 5) = (3, 7). Adding the 5 to the x-coordinate, or treating it as a horizontal shift like y = f(x + 5), moves the wrong coordinate — check first whether the number sits inside or outside the brackets.
- (d) 300 m — For a constant speed, the speed-time graph is a horizontal line, and the area underneath is a rectangle: distance = speed × time = 15 × 20 = 300 m. Adding the two numbers instead of multiplying gives 35 m; dividing instead of multiplying gives 1.33 m; halving the product, as you would for a triangle, gives 7.5 m — but this section of the graph is a rectangle, not a triangle, so there is no halving to do.
- (d) 5 — Method: rearrange the formula to make m the subject, then substitute F = 15.50. Working: F = 3 + 2.5m, so subtracting 3 from both sides gives F − 3 = 2.5m, then dividing by 2.5 gives m = (F − 3) / 2.5. Substituting F = 15.50: m = (15.50 − 3) / 2.5 = 12.50 / 2.5 = 5. The value 6.2 comes from dividing 15.50 by 2.5 without subtracting the fixed £3 first. The value 3.2 comes from dividing first and subtracting afterwards, in the wrong order: (15.50 / 2.5) − 3 = 3.2. The value 7.4 comes from adding £3 instead of subtracting it before dividing: (15.50 + 3) / 2.5 = 7.4.
- (d) (x − 8)(x + 8) — x² − 64 = x² − 8², a difference of two squares, which factorises as (x − 8)(x + 8). A candidate who treats it as a perfect square with a repeated negative factor gets (x − 8)(x − 8), which expands to x² − 16x + 64 — wrong on both the middle and constant terms. A candidate who uses a repeated positive factor gets (x + 8)(x + 8), which expands to x² + 16x + 64. A candidate who picks a different factor pair of 64, such as 4 and 16, without checking that the middle term cancels, gets (x − 4)(x + 16), which expands to x² + 12x − 64 — the wrong middle term.
- (d) −2 — Method: substitute the value into both terms, working out the index and the multiplication before the addition. Working: m² = (−2) × (−2) = 4 and 3m = 3 × (−2) = −6, so the expression becomes 4 + (−6), which is −2. Answer: −2. The distractors: −10 comes from squaring −2 as −4, giving −4 + (−6); 10 comes from working out 3m as +6 and losing the minus sign, giving 4 + 6; −14 comes from working from left to right instead of multiplying first, giving (4 + 3) × (−2).
- (a) It is 2(w + (w + 3)) = 4w + 6, not 2w + 3. — The perimeter of a rectangle is twice the width plus twice the length: 2 × w + 2 × (w + 3) = 2w + 2w + 6 = 4w + 6, so the gardener's 2w + 3 is wrong. Writing w + (w + 3) = 2w + 3 forgets to double the sides at all, only adding one width and one length once. Writing 4(w + 3) = 4w + 12 wrongly treats all four sides as equal to the length, as if the garden were a square. Writing 3w + 6 comes from doubling the length correctly but adding the width only once instead of doubling it too.
- (b) Student B's — narrower strips fit the curve more closely. — The trapezium rule replaces the curve with straight-line segments; the narrower each strip, the more closely its straight edge follows the curve, so Student B's estimate with 8 narrower strips is more likely to be closer to the true area. Reasoning from the number of arithmetic steps rather than from how well the straight lines fit the curve gives the wrong claim that Student A makes fewer rounding errors. Believing the trapezium rule is exact, rather than an estimate that improves with narrower strips, gives the wrong claim that the two are always the same. Believing wider strips smooth out the curve better, rather than following it less closely, gives the wrong claim in favour of Student A's wider strips.
Build your own mix at the worksheet builder.