Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- 1.p = 4. Work out the value of 2p³.
- 2.The area under a speed-time graph between t = 0 and t = 6 seconds is estimated using three strips of equal width, using the speeds, in m/s, at t = 0, 2, 4 and 6: 0, 5, 9 and 12. Using the trapezium rule with these three trapezia, estimate the distance travelled.
- 3.The nth term of a sequence is n² − 2n + 5. Work out the 10th term.
- 4.The first five terms of a quadratic sequence are −1, 4, 13, 26, 43. Work out an expression, in terms of n, for the nth term.
- 5.Make x the subject of the formula y = 4x − 3.y = 4x − 3
- 6.For the graph of y = 1/x, where x cannot be zero, which of these statements is correct?
- 7.A lift has a weight limit: it must carry no more than 630 kg. Let w be the total weight, in kg, carried by the lift. Which inequality describes this?
- 8.f(x) = 2x − 1. Work out ff(x).y = 2x − 1
- 9.A hiker's distance-time graph shows the following: he walks 5 km in the first 1 hour at a steady speed, rests for 1 hour, then walks a further 9 km in the next 2 hours, also at a steady speed. Work out his average speed for the whole journey, in km/h.
- 10.A cyclist's velocity increases from 3 m/s to 11 m/s over 5 seconds, at a constant rate. Work out the cyclist's acceleration, in m/s².
- 11.Work out the equation of the straight line through the points (−2, 1) and (0, 7).
- 12.A circle has centre (0, 0) and passes through the point (5, 12). Work out the equation of the circle.
- 13.The first four terms of a sequence are 4, 9, 14, 19. Work out an expression, in terms of n, for the nth term.
- 14.A circle has centre (0, 0) and passes through the point (7, 24). Work out the equation of the circle.
- 15.The nth term of a sequence is n² + 3. Work out the first term of the sequence that is greater than 50.
Answer key
- (d) 128 — In 2p³ the index belongs to p only, so cube p first and multiply by the coefficient afterwards. Cubing gives 4 × 4 × 4 = 64, and then 2 × 64 = 128. Cubing the coefficient as well would mean working out (2 × 4)³, which is 512. Reading the index as an instruction to multiply by 3 gives 2 × 4 × 3 = 24, and ignoring the coefficient altogether leaves 64.
- (d) 40 m — Each trapezium has width 2. Its area is width × the average of its two heights. Strip 1: average of 0 and 5 is 2.5, so area = 2 × 2.5 = 5. Strip 2: average of 5 and 9 is 7, so area = 2 × 7 = 14. Strip 3: average of 9 and 12 is 10.5, so area = 2 × 10.5 = 21. Total distance = 5 + 14 + 21 = 40 m. Leaving out the division by 2 in the averaging step doubles every strip, giving 80 m instead of 40 m. Using only the LEFT height of each strip as a rectangle, 0 × 2 + 5 × 2 + 9 × 2 = 28, or only the RIGHT height, 5 × 2 + 9 × 2 + 12 × 2 = 52, both ignore that the graph curves between the two ends of each strip — always average the two heights of a trapezium, never use just one of them.
- (b) 85 — Substitute n = 10: 10² − 2 × 10 + 5 = 100 − 20 + 5 = 85. A sign error on the −2n term, treating it as +2n, gives 100 + 20 + 5 = 125. Using n = 9 instead of n = 10 gives 81 − 18 + 5 = 68. Working out 10² − 2 × 10 but forgetting to add the final +5 gives 80.
- (d) 2n² − n − 2 — First differences: 5, 9, 13, 17. Second differences: 4, 4, 4, so a = 4 ÷ 2 = 2. Subtracting 2n² (2, 8, 18, 32, 50) from the terms (−1, 4, 13, 26, 43) leaves −3, −4, −5, −6, −7, which is the linear expression −n − 2. So the nth term is 2n² − n − 2. Using the second difference itself as a, without halving it, gives 4n² − n − 2. Finding a = 2 correctly but dropping the linear remainder −n − 2 entirely leaves 2n². Treating the first first difference (5) as a common difference and building a + (n − 1)d = −1 + 5(n − 1) gives 5n − 6, which only matches the first two terms.
- (d) x = (y + 3)/4 — Two operations have been applied to x: it has been multiplied by 4 and then 3 has been subtracted. Undo them in the opposite order. Adding 3 to both sides gives y + 3 = 4x. Dividing both sides by 4 then gives (y + 3)/4 = x, so x = (y + 3)/4. The bracket matters: writing y/4 + 3 divides only the y by 4 and leaves the 3 untouched. Writing (y − 3)/4 subtracts the 3 instead of adding it, and writing 4(y + 3) multiplies by 4 rather than dividing.
- (d) The graph never crosses either axis — Since x ≠ 0, there is no point on the graph where x = 0, so it cannot cross the y-axis; likewise 1/x is never equal to 0 for any x, so it cannot cross the x-axis either — the graph never touches either axis. A candidate who forgets the restriction x ≠ 0 might think the graph behaves like other graphs and passes through the origin, (0, 0). A candidate who correctly rules out the x-axis but forgets that x = 0 is also excluded might say the graph crosses the y-axis but never the x-axis. A candidate who only pictures the branch where x and y are both positive might say the graph has only one branch, in quadrant 1, forgetting the second branch where x and y are both negative.
- (d) w ≤ 630 — 'No more than 630 kg' means the weight can be exactly 630 kg or anything less, so the correct inequality is w ≤ 630, using 'less than or equal to' to include the limit itself. Writing w < 630 excludes 630 kg itself, as though the limit could not be reached exactly. Writing w ≥ 630 reverses the direction, describing a minimum weight rather than a maximum. Writing w > 630 both reverses the direction and excludes the boundary value. The inequality describing the lift's weight limit is w ≤ 630.
- (c) 4x − 3 — ff(x) means f(f(x)): substitute f(x) into f in place of x. f(f(x)) = 2 × f(x) − 1 = 2 × (2x − 1) − 1. Expanding the bracket: 2 × (2x − 1) = 4x − 2. Combining the constant terms: −2 − 1 = −3, so f(f(x)) = 4x − 3. Writing 4x − 2 comes from expanding 2(2x − 1) correctly to get 4x − 2, then forgetting to subtract the outer 1 at all. Writing 4x² − 4x + 1 comes from reading ff(x) as f(x) multiplied by itself, (2x − 1)(2x − 1) = 4x² − 4x + 1, instead of substituting f(x) into f. Writing 4x − 1 comes from doubling the coefficient of x in the original rule directly, without actually substituting f(x) into f at all.
- (a) 3.5 km/h — Average speed is total distance ÷ total time. Total distance = 5 + 9 = 14 km. Total time, including the rest, = 1 + 1 + 2 = 4 hours. So average speed = 14 ÷ 4 = 3.5 km/h. Leaving out the 1 hour rest and dividing by only the 3 hours of walking gives 14 ÷ 3 = 4.67 km/h. Averaging the two separate speeds, 5 km/h and 4.5 km/h, instead of using total distance over total time, gives (5 + 4.5) ÷ 2 = 4.75 km/h. Dividing only the second leg's distance by the total time, 9 ÷ 4 = 2.25 km/h, ignores the first leg's distance.
- (b) 1.6 m/s² — Acceleration is the change in velocity divided by the time taken: (11 − 3) ÷ 5 = 8 ÷ 5 = 1.6 m/s². Forgetting to subtract the initial velocity and dividing the final velocity by the time instead gives 11 ÷ 5 = 2.2 m/s². Inverting the fraction, dividing the time by the change in velocity, gives 5 ÷ 8 = 0.625 m/s². Finding the change in velocity, 8 m/s, but stopping without dividing by the time gives 8 m/s².
- (c) y = 3x + 7 — Method: the gradient is the change in y divided by the change in x with both taken in the same order, and a point whose x-coordinate is 0 gives the constant straight away because it lies on the y-axis. Working: m = (7 − 1) ÷ (0 − (−2)) = 6 ÷ 2 = 3; the point (0, 7) lies on the y-axis, so c = 7 and the line is y = 3x + 7. Answer: y = 3x + 7. The distractors: y = −3x + 7 comes from taking the y-difference as 1 − 7 while taking the x-difference as 0 − (−2), so the two subtractions run in opposite orders; y = 3x + 1 comes from using the y-coordinate of (−2, 1) as the constant instead of the point that actually lies on the y-axis; y = (1/3)x + 7 comes from writing the gradient upside down as the change in x over the change in y, 2 ÷ 6.
- (b) x² + y² = 169 — Method: a circle centred on the origin has equation x² + y² = r², and every point on it satisfies that equation, so substituting the coordinates of a point that lies on the circle gives r² directly. Working: substituting x = 5 and y = 12 gives 5² + 12² = 25 + 144 = 169, so r² = 169 and the circle is x² + y² = 169. Answer: x² + y² = 169. The distractors: x² + y² = 13 uses the radius, √169 = 13, where r² belongs, which is the confusion between r and r² made in the other direction; x² + y² = 17 adds the two coordinates, 5 + 12, instead of adding their squares; x² + y² = 119 subtracts the squares, 144 − 25, treating 12 as the hypotenuse of the right-angled triangle rather than as one of the shorter sides.
- (d) 5n − 1 — The common difference is 5 (9−4=5), so the expression starts 5n. To match the first term when n=1, 5×1+c=4, so c=−1: the nth term is 5n−1. A candidate who uses the first term itself as the constant, instead of first term minus the common difference, would write 5n+4 (giving 9, 14, 19, 24 — one term too high throughout). A candidate who omits the constant term altogether would write just 5n (giving 5, 10, 15, 20, not matching the sequence). A candidate who adds the common difference to n instead of multiplying would write n+5 (giving 6, 7, 8, 9, far too small).
- (b) x² + y² = 625 — Since (7, 24) lies on the circle, x² + y² = 7² + 24² = 49 + 576 = 625, so the equation is x² + y² = 625. Choosing x² + y² = 31 adds the coordinates 7 and 24 directly instead of squaring them first. Choosing x² + y² = 576 uses only 24² and forgets to add 7². Choosing x² + y² = 49 uses only 7² and forgets to add 24².
- (a) 52 — Test successive terms: n=6 gives 6²+3=39, which is not greater than 50. n=7 gives 7²+3=52, which is greater than 50, so the first term greater than 50 is 52. A candidate who stops at n=6, before checking whether 39 actually exceeds 50, would give 39. A candidate who solves n²>50 instead of n²+3>50, ignoring the +3 in the search, would find n=8 is the first value with n²>50 (since 7²=49) and compute 8²+3=67. A candidate who computes n² by doubling n instead of squaring it would compute 2×7+3=17.
Build your own mix at the worksheet builder.