Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- 1.The curve y = −x² + 6x − 5 has a maximum point. Use completing the square to find its coordinates.y = −x² + 6x − 5
- 2.Solve the inequality x² ≥ 16, giving your answer using set notation.
- 3.Which of these equations is equivalent to 5x − 2 = 3x + 8?
- 4.A quadratic graph y = ax² + bx + c has its turning point on the y-axis. Which statement about its roots must be true?
- 5.The nth term of a sequence is n² + 2n − 4. Work out the 7th term.
- 6.A circle has centre (0, 0) and equation x² + y² = 64. Write down the radius of the circle.
- 7.A ball is thrown in the air. Its height, h metres, above the ground after t seconds is given in this table: when t = 0, h = 0; when t = 1, h = 15; when t = 2, h = 20; when t = 3, h = 15; when t = 4, h = 0. Use the table to find the two times, in seconds, at which the ball is at ground level.
- 8.The first four terms of a sequence are 6, 13, 20, 27. Work out an expression, in terms of n, for the nth term.
- 9.A tap's flow rate, in litres per minute, is plotted against time, in minutes, on a graph. What are the units of the area under this graph?
- 10.Describe a sequence of two transformations that maps the graph of y = x² onto the graph of y = −(x − 5)².y = x²
- 11.A straight line has gradient −2 and passes through the point (3, 1). Work out the equation of the line.
- 12.The graph of y = f(x) passes through the point (2, 5). Write down the coordinates of the corresponding point on the graph of y = f(x − 4) + 1.
- 13.Describe the single transformation that maps the graph of y = x² onto the graph of y = x² + 3.y = x²y = x² + 3
- 14.f(x) = x² − 1 and g(x) = 3x. Work out fg(4).y = x² − 1
- 15.Solve the simultaneous equations y = 3 − x and x² + y² = 9, giving both pairs of solutions.
Answer key
- (b) x = 3, y = 4 — −x² + 6x − 5 = −(x² − 6x) − 5 = −[(x − 3)² − 9] − 5 = −(x − 3)² + 9 − 5 = −(x − 3)² + 4. Because the coefficient of x² is negative, −(x − 3)² is at most zero, so this turning point is a maximum. Substituting x = 3 gives (x − 3)² = 0, so y = 4, confirming the maximum value 4 at x = 3: turning point (3, 4). Using 6 instead of half of 6 inside the bracket — forgetting to halve before completing the square — lands on turning point (6, 31), wrong, because only half the coefficient belongs inside the bracket. Reading the bracket's sign directly as the turning point's x-coordinate gives (−3, 4) — wrong, because (x − 3)² is zero at x = 3, not x = −3. Computing 5 − 9 = −4 instead of 9 − 5 = 4 flips the sign of the constant, giving (3, −4) — wrong, since the constant must be evaluated as 9 minus 5, not 5 minus 9. Whenever the leading coefficient is negative, the turning point is a maximum, not a minimum — check by substituting back into the original equation.
- (c) {x : x ≤ −4} ∪ {x : x ≥ 4} — Rearrange so one side is zero: x² − 16 ≥ 0, then factorise: (x − 4)(x + 4) ≥ 0. The critical values are x = −4 and x = 4. Since the coefficient of x² is positive, the graph is a U-shape that is on or above the x-axis outside its roots, so the solution is x ≤ −4 or x ≥ 4, written as {x : x ≤ −4} ∪ {x : x ≥ 4}. Distractor routes: {x : −4 ≤ x ≤ 4} takes the region BETWEEN the roots, which is where x² − 16 is negative, the opposite region. {x : x ≥ 4} keeps only the positive square root and drops the negative branch entirely. {x : x ≤ 4} comes from a sign error, treating the inequality as if it were x² ≤ 16.
- (d) 2x = 10 — Method: collect the x-terms on one side and the constants on the other, keeping the equals sign balanced. Working: 5x − 3x = 8 + 2, giving 2x = 10. Answer: 2x = 10. 2x = 6 comes from a sign error moving the constant, subtracting instead of adding: 8 − 2 = 6. 8x = 6 comes from adding the x-terms instead of subtracting them (5x + 3x = 8x), alongside the constant sign error. 2x = −10 comes from a sign error moving the constant the other way: −2 − 8 = −10.
- (d) If the graph has two real roots, they are equal and opposite in value, so they sum to zero. — A turning point on the y-axis means the graph's axis of symmetry is the line x = 0, so any two roots must be symmetrical about x = 0 — equal in size but opposite in sign, summing to zero. The graph could still have no real roots, but that is not guaranteed just from the turning point's position, so the option claiming it must have none is too strong. The roots do not have to both be positive — if real, one is positive and one negative (or both are zero). The graph does not have to touch the x-axis at exactly one point either; it could cross at two symmetrical points, touch at one point, or miss the x-axis entirely.
- (c) 59 — Substitute n = 7: 7² + 2 × 7 − 4 = 49 + 14 − 4 = 59. A sign error on the +2n term, treating it as −2n, gives 49 − 14 − 4 = 31. Working out 7² + 2 × 7 but forgetting to subtract the final 4 gives 49 + 14 = 63. Using n = 6 instead of n = 7 gives 36 + 12 − 4 = 44.
- (b) 8 — Method: a circle centred on the origin has equation x² + y² = r², where r is the radius, so the number on the right-hand side is the square of the radius and not the radius itself. Working: comparing x² + y² = 64 with x² + y² = r² gives r² = 64, so r = √64 = 8. Answer: the radius is 8. The distractors: 64 is r² read straight off the equation as though the right-hand side were the radius, which is the commonest error on this form; 32 comes from halving 64, treating the right-hand side as a diameter that has to be halved; 16 is the diameter, 2 × 8, quoted in place of the radius.
- (a) t = 0 or t = 4 — The ball is at ground level exactly when h = 0. From the table, h = 0 at t = 0 and at t = 4, so those are the two times. Distractor origins: t = 1 or t = 3 picks the times with equal (but non-zero) height instead of ground level; t = 2 picks the time of maximum height instead of ground level; t = 0 finds only the starting time and misses the second one.
- (c) 7n − 1 — Method: find the common difference, then find the constant that fits the first term. Working: 13 − 6 = 7, 20 − 13 = 7, 27 − 20 = 7, so the terms increase by 7 each time and the nth term has the form 7n + c. Substituting n = 1: 7(1) + c = 6, so c = −1. Answer: the nth term is 7n − 1. The value 7n comes from leaving out the constant altogether. The value 7n + 6 comes from using the first term as the constant directly, without subtracting the common difference first. The value 6n + 1 comes from using the first term, 6, as the coefficient of n instead of the common difference, and then attaching +1 with the sign of the constant flipped.
- (a) Litres — The area under a graph is found by multiplying a y-value by an x-value, so its units are the y-axis units multiplied by the x-axis units: litres per minute × minutes = litres, since the 'per minute' cancels with the 'minutes'. Answering 'litres per minute' keeps the y-axis units unchanged, as if multiplying by time did nothing to the units at all. Answering 'litres per minute squared' treats the x-axis as also being measured 'per minute', squaring a unit that should instead cancel. Answering 'minutes' keeps only the x-axis units and drops the rate altogether.
- (b) Translate +5 in x, then reflect in the x-axis. — Translating y = x² by 5 units in the positive x-direction gives y = (x − 5)². Reflecting this in the x-axis, which replaces y with −y, gives y = −(x − 5)², matching the target. Using a translation of −5 in x instead gives y = (x + 5)², and reflecting that in the x-axis gives y = −(x + 5)² — the sign inside the bracket is wrong. Reflecting in the y-axis first does nothing to y = x², since (−x)² = x², so translating afterwards only reaches y = (x − 5)² with no negative sign at all. Translating by 5 units in y instead of x gives y = x² + 5, and reflecting that in the x-axis gives y = −x² − 5, a different curve altogether — a vertical shift does not create the (x − 5)² term the target equation needs.
- (a) y = −2x + 7 — Using y = −2x + c, and substituting the point (3, 1): 1 = −2(3) + c, so 1 = −6 + c, and c = 7, giving y = −2x + 7. A candidate who uses the y-coordinate of the point directly as the y-intercept, instead of solving for c, would write y = −2x + 1. A candidate who drops the negative sign on the gradient would write y = 2x + 7. A candidate who makes a sign error when isolating c, writing c = 1 − 6 = −5 instead of c = 1 + 6 = 7, would write y = −2x − 5.
- (d) (6, 6) — y = f(x − 4) + 1 combines two translations: the −4 inside the brackets moves the graph 4 units to the RIGHT, and the +1 outside the brackets moves it 1 unit UP. Applying both to (2, 5): add 4 to the x-coordinate 2, and add 1 to the y-coordinate 5, giving (6, 6). Moving left instead of right, as the minus sign inside the bracket might suggest, gives (−2, 6) or (−2, 4); forgetting the horizontal shift altogether and only applying the vertical one gives (2, 6).
- (a) A translation by vector (0, 3) — y = x² + 3 adds a constant outside the squaring, so it is a vertical translation of y = x² — every point moves the same distance parallel to the y-axis, with no change in x. The vector is (0, 3), matching the +3. A vector of (3, 0) confuses this with a horizontal shift; (0, −3) has the right axis but the wrong sign, since the graph moves up, not down; a stretch changes the shape of the curve, which adding a constant term never does.
- (b) 143 — fg(4) means f(g(4)): work out g(4) first, then substitute the result into f. g(4) = 3 × 4 = 12, then f(12) = 12² − 1 = 144 − 1 = 143. Working out gf(4) instead swaps the order: f(4) = 4² − 1 = 15, then g(15) = 3 × 15 = 45 — that is the wrong composition. Treating f(x) as x − 1 (forgetting to square the input) gives f(12) = 12 − 1 = 11. Applying g twice instead of applying g then f gives g(g(4)) = g(12) = 3 × 12 = 36, which mixes up which function should be applied second.
- (c) x = 0, y = 3 and x = 3, y = 0 — Substitute y = 3 − x into x² + y² = 9: x² + (3 − x)² = 9. Expanding (3 − x)² = 9 − 6x + x² gives x² + 9 − 6x + x² = 9, which simplifies to 2x² − 6x = 0, or 2x(x − 3) = 0, so x = 0 or x = 3. Using y = 3 − x: x = 0 gives y = 3; x = 3 gives y = 0. Distractor routes: x = 0, y = 3 alone stops after the factor 2x = 0 and never checks the second factor, x − 3 = 0. x = 0, y = 3 and x = −3, y = 6 comes from factorising 2x² − 6x as 2x(x + 3), a sign error that gives a second root of −3 instead of 3. x = 0, y = 3 and x = 6, y = −3 comes from expanding (3 − x)² as 9 − 6x, dropping the x² term, which changes the quadratic to x² − 6x = 0 and its second root to 6.
Build your own mix at the worksheet builder.