Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- 1.Amelia's mother is three times as old as Amelia. Four years ago her mother was five times as old as Amelia was then. Work out Amelia's age now.
- 2.A sequence begins at 50, and each term after that is found by subtracting 8 from the term before it. Priya says the 8th term of the sequence is negative. Is Priya correct?
- 3.The point (9, 12) lies on the circle x² + y² = 225, which has centre (0, 0). The tangent to the circle at (9, 12) crosses the x-axis at the point P. Work out the x-coordinate of P.
- 4.Write down the gradient of the line with equation y = −x + 3.y = −x + 3
- 5.Water is poured into a container at a constant rate. A graph of the depth of the water, in cm, against the time since pouring began, in minutes, is a straight line through the origin, and it passes through the point (3, 12). Use the graph to work out the depth of the water after 7 minutes.
- 6.A mobile phone plan charges a fixed monthly fee plus an amount for each gigabyte of data used. The total cost £C for using g gigabytes in a month is given by C = 15 + 2g. What does the number 2 represent in this formula?
- 7.The area under a speed-time graph between t = 0 and t = 6 seconds is estimated using three strips of equal width, using the speeds, in m/s, at t = 0, 2, 4 and 6: 0, 5, 9 and 12. Using the trapezium rule with these three trapezia, estimate the distance travelled.
- 8.p = 4. Work out the value of 2p³.
- 9.A plumber charges a £35 call-out fee plus £20 for each hour worked, h. On a certain job the total charge was £115. Work out how many hours the plumber worked.
- 10.Make x the subject of the formula y = x/2 − 5.y = x
- 11.A region S consists of every point that lies on or above the line y = 2, on or below the line y = x, and on or to the left of the line x = 6. Which of these is the system of inequalities that defines S?y = x
- 12.A geometric sequence begins 162, 54, 18, 6, ... Work out the next term in the sequence.
- 13.A printer starts a job with 480 sheets of paper loaded and prints at a steady rate. The number of sheets left, S, after t minutes is given by S = 480 − 24t. Work out how many minutes it takes for the paper to run out completely.
- 14.A quadratic graph has equation y = (x − 4)². A student says this graph crosses the x-axis at two different points. Explain why the student is wrong.
- 15.To rearrange the formula y = 3x − 8 to make x the subject, Priya writes: 'Add 8 to both sides to get y + 8 = 3x, then divide both sides by 3 to get x = y + 8 ÷ 3.' Work out the correct expression for x.y = 3x − 8
Answer key
- (d) 8 — Method: write both present ages in terms of one letter, take four years off each of them, and form an equation from the comparison four years ago. Working: let Amelia be y, so her mother is 3y; four years ago they were y − 4 and 3y − 4, giving 3y − 4 = 5(y − 4); expanding gives 3y − 4 = 5y − 20; adding 20 and subtracting 3y from both sides gives 16 = 2y, and dividing by 2 gives y = 8. Checking: Amelia is 8 and her mother 24; four years ago they were 4 and 20, and 20 = 5 × 4. Answer: 8. The distractors: 4 comes from solving correctly but giving Amelia's age four years ago instead of her age now; 16 comes from stopping at 2y = 16 and giving 16 as her age; 2 comes from collecting the y terms by adding the 5y instead of subtracting it, giving 3y + 5y = 20 − 4 and so 8y = 16.
- (d) Yes: the 8th term is 50 − 8 × 7 = −6, which is negative. — Method: find the 8th term by subtracting 8 a total of 7 times from the first term, since the 1st term itself needs 0 subtractions. Working: 8th term = 50 − 8 × 7 = 50 − 56 = −6, which is negative, so Priya is correct. Answer: Yes, the 8th term is 50 − 8 × 7 = −6, which is negative. The "50 − 8 × 6 = 2" option subtracts 8 only six times instead of seven, an off-by-one error in counting the steps. The "50 − 8 × 8 = −14" option subtracts 8 eight times instead of seven, the opposite off-by-one error. The claim that repeated subtraction "can never go negative" ignores that subtracting enough times from any starting value eventually gives a negative result.
- (b) 25 — The tangent at (9, 12) is 9x + 12y = 225. Setting y = 0 (the x-axis): 9x = 225, so x = 25. Choosing 18.75 comes from swapping the coefficients in the tangent equation (using 12x + 9y = 225) before setting y = 0. Choosing 15 is where the circle itself meets the x-axis (from x² = 225), not where the tangent does. Choosing 9 is just the x-coordinate of the original point (9, 12), not the point P.
- (b) −1 — Method: in the form y = mx + c the gradient m is the number multiplying x, and an x term written with no number in front of it has a coefficient of 1. Working: y = −x + 3 is the same equation as y = (−1)x + 3, so comparing it with y = mx + c gives m = −1 and c = 3. Answer: −1. The distractors: 1 comes from taking the coefficient as 1 and leaving the minus sign out of the answer; 3 comes from reading the constant as the gradient, confusing m with c; −3 comes from moving the minus sign across to the constant term and then reading the gradient off that term instead of the x term.
- (d) 28 cm — Method: rate = 12 cm ÷ 3 min = 4 cm per minute. Depth after 7 minutes = 4 × 7 = 28 cm. Distractor origins: 84 cm multiplies the given depth by 7 directly, without first finding the rate per minute (12 × 7 = 84); 24 cm simply doubles the given depth instead of scaling correctly by the ratio of times; 16 cm combines the numbers with subtraction and addition (12 − 3 + 7 = 16) instead of finding a rate.
- (c) The cost, in pounds, for each extra gigabyte of data used — In C = 15 + 2g, the number multiplying g is the gradient, which gives the extra cost for each extra unit of g — here, £2 for each extra gigabyte. 'The fixed monthly fee, in pounds' describes the constant term 15, not the coefficient of g. 'The total number of gigabytes included in the plan' misreads the coefficient as a quantity of data rather than a cost per gigabyte. 'The cost … for each extra 2 gigabytes' doubles the unit the coefficient actually applies to — it is the cost for each single extra gigabyte.
- (d) 40 m — Each trapezium has width 2. Its area is width × the average of its two heights. Strip 1: average of 0 and 5 is 2.5, so area = 2 × 2.5 = 5. Strip 2: average of 5 and 9 is 7, so area = 2 × 7 = 14. Strip 3: average of 9 and 12 is 10.5, so area = 2 × 10.5 = 21. Total distance = 5 + 14 + 21 = 40 m. Leaving out the division by 2 in the averaging step doubles every strip, giving 80 m instead of 40 m. Using only the LEFT height of each strip as a rectangle, 0 × 2 + 5 × 2 + 9 × 2 = 28, or only the RIGHT height, 5 × 2 + 9 × 2 + 12 × 2 = 52, both ignore that the graph curves between the two ends of each strip — always average the two heights of a trapezium, never use just one of them.
- (d) 128 — In 2p³ the index belongs to p only, so cube p first and multiply by the coefficient afterwards. Cubing gives 4 × 4 × 4 = 64, and then 2 × 64 = 128. Cubing the coefficient as well would mean working out (2 × 4)³, which is 512. Reading the index as an instruction to multiply by 3 gives 2 × 4 × 3 = 24, and ignoring the coefficient altogether leaves 64.
- (a) 4 — Method: set up the equation 35 + 20h = 115, then subtract the fixed fee and divide by the hourly rate. Working: 20h = 115 − 35 = 80; h = 80 ÷ 20 = 4. Answer: 4 hours. 5.75 comes from dividing the whole £115 by £20 without first subtracting the fixed fee: 115 ÷ 20 = 5.75. 2.71 comes from swapping the fee and the rate round, subtracting £20 and dividing by £35: (115 − 20) ÷ 35 ≈ 2.71. 7.5 comes from adding the fixed fee instead of subtracting it: (115 + 35) ÷ 20 = 7.5.
- (c) x = 2y + 10 — Method: undo the operations done to x in reverse order — add 5, then multiply by 2. Working: y = x/2 − 5, so y + 5 = x/2, so x = 2(y + 5) = 2y + 10. Answer: x = 2y + 10. x = 2y + 5 comes from multiplying only the x/2 term by 2 and forgetting to multiply the 5 as well. x = 2y − 10 comes from a sign error, subtracting 5 instead of adding it before multiplying by 2. x = (y + 5)/2 comes from dividing by 2 instead of multiplying, the wrong operation to undo a division.
- (b) y ≥ 2, y ≤ x, x ≤ 6 — "On or above the line y = 2" means y ≥ 2. "On or below the line y = x" means y ≤ x. "On or to the left of the line x = 6" means x ≤ 6. Together these give y ≥ 2, y ≤ x, x ≤ 6. Distractor routes: y ≤ 2, y ≤ x, x ≤ 6 flips the first inequality, describing "on or below" y = 2 instead of "on or above". y ≥ 2, y ≥ x, x ≤ 6 flips the second, describing "on or above" y = x instead of "on or below". y ≥ 2, y ≤ x, x ≥ 6 flips the third, describing "on or to the right of" x = 6 instead of "on or to the left".
- (a) 2 — The common ratio is 54 ÷ 162 = 1/3, confirmed by 18 ÷ 54 = 1/3 and 6 ÷ 18 = 1/3. The next term is 6 × 1/3 = 2. A candidate who wrongly treats the sequence as arithmetic and subtracts the last difference (18 − 6 = 12) again gets 6 − 12 = −6. A candidate who multiplies by 3 instead of dividing, effectively reversing the sequence, gets 18. A candidate who guesses the ratio is 1/2 gets 6 × 1/2 = 3.
- (a) 20 — Method: the paper has run out when S = 0, so substitute S = 0 into the equation and solve for t. Working: 0 = 480 − 24t, so 24t = 480, and t = 480 / 24 = 20. Answer: it takes 20 minutes. The value 480 comes from giving the starting number of sheets, the intercept of the equation, instead of solving for t. The value 456 comes from working out 480 − 24 and stopping after one step instead of solving the equation fully. The value 0.05 comes from inverting the division, working out 24 / 480 instead of 480 / 24.
- (a) It touches the x-axis once, only at x = 4. — (x − 4)² is a square, so it equals zero only when x − 4 = 0, that is at x = 4 — the curve just touches the x-axis there rather than crossing it, since a square cannot be negative on either side to cross through. Saying it crosses at x = 4 and x = −4 wrongly introduces a plus-or-minus, as if taking a square root of x, rather than recognising the bracket is already squared and only zero once. Saying it never touches the x-axis forgets that a squared term CAN equal zero, even though it can never be negative. Saying it crosses at x = 2 and x = −2 confuses (x − 4)² with the different expression x² − 4.
- (d) x = (y + 8) / 3 — Method: add 8 to both sides, then divide the whole side by 3. Working: y = 3x − 8, so adding 8 to both sides gives y + 8 = 3x, then dividing both sides by 3 gives x = (y + 8) / 3. The value x = y + 8 / 3 is Priya's version, which comes from dividing only the 8 by 3 instead of dividing the whole expression y + 8 by 3. The value x = (y − 8) / 3 comes from a sign error, keeping −8 instead of moving it to +8. The value x = 3(y + 8) comes from multiplying by 3 instead of dividing.
Build your own mix at the worksheet builder.