Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- 1.Write down the coefficient of xy in the expression 4x²y − 7xy + 2.
- 2.The first five terms of a sequence are 7, 9, 13, 19, 27. By finding the second difference, work out the coefficient of n² in the nth term.
- 3.A rule turns each input into an output. An input of 0 gives an output of −1, an input of 1 gives an output of 1, and an input of 2 gives an output of 3. Work out the rule, writing the input as x and the output as y.
- 4.The 2nd term of a geometric sequence is 6 and the 4th term is 24. Given that all the terms of the sequence are positive, work out the common ratio.
- 5.A square tile has an area of 144 cm². Work out the side length of the tile.
- 6.A car's speed-time graph shows the following: its speed increases steadily from 0 m/s to 20 m/s over the first 10 seconds, then stays constant at 20 m/s for the next 15 seconds. Work out the total distance travelled in the first 25 seconds.
- 7.Which of these statements is an identity?
- 8.A plumber charges a call-out fee of £30 plus £25 for each hour worked. The total bill for a job was £130. Work out how many hours the plumber worked.
- 9.The first four terms of a sequence are 4, 9, 14, 19. Work out an expression, in terms of n, for the nth term.
- 10.Which line of algebra shows that the sum of two consecutive odd numbers is always a multiple of 4?
- 11.Solve the inequality 3x + 6 ≤ 0.
- 12.The solution set of an inequality is described as: x is less than −3, or x is greater than or equal to 1. Write this solution set using set notation.
- 13.Points A(8, 15) and B(−8, 15) both lie on the circle x² + y² = 289, which has centre (0, 0). Work out the length of the chord AB.
- 14.A graph has equation y = x² − 6x + 5. A student says its turning point has x-coordinate 6, because that's the coefficient of x. Which statement corrects the student's mistake?y = x² − 6x + 5
- 15.A ball's height, h metres, t seconds after being thrown follows h = (t − 1)(9 − t). Given that the ball is at ground level at t = 1 and t = 9, work out at what time t the ball reaches its maximum height, using symmetry.
Answer key
- (a) −7 — The coefficient of xy is the number multiplying that exact term, including its sign: in 4x²y − 7xy + 2, the term in xy is −7xy, so the coefficient is −7. Answering 7 correctly picks out the number but drops the minus sign that belongs to it. Answering 4 picks the coefficient of the x²y term instead of the xy term — x²y and xy are different terms because their powers of x differ. Answering −5 combines −7 with the constant term +2, as though the coefficient of xy included the number with no letter attached to it. The coefficient of xy is −7.
- (b) 1 — First differences: 2, 4, 6, 8. Second differences: 2, 2, 2, a constant, confirming the sequence is quadratic. The coefficient of n² is half the constant second difference: 2 ÷ 2 = 1. Using the second difference itself as the coefficient, without halving it, gives 2. Halving twice, dividing the second difference by 4 instead of by 2, gives 0.5. Doubling the second difference instead of halving it, on the mistaken rule that the n² coefficient is twice the second difference, gives 2 × 2 = 4.
- (b) y = 2x − 1 — Method: in a rule that multiplies and then adds, the multiplier is the step in the outputs for each step of 1 in the input, and the number added on is the output when the input is 0. Working: the inputs 0, 1, 2 rise in ones while the outputs −1, 1, 3 rise by 2 each time, so the input is multiplied by 2; an input of 0 gives 2 × 0 = 0 and the output must be −1, so 1 is subtracted. Answer: y = 2x − 1, checked against the last pair by 2 × 2 − 1 = 3. The distractors: y = 2x + 1 comes from finding the multiplier 2 correctly and then reading the output at an input of 0 as +1 instead of −1; y = x − 1 comes from taking the multiplier as 1 because the inputs go up in ones, instead of using the step in the outputs; y = 3x − 1 comes from reading the largest output, 3, as the multiplier.
- (c) 2 — For a geometric sequence, a₄ = a₂ × r². So r² = a₄ ÷ a₂ = 24 ÷ 6 = 4, giving r = 2 or r = −2. Since all the terms are positive, r = 2. 4 comes from computing a₄ ÷ a₂ = 4 and stopping there, without taking the square root to find r. 18 comes from subtracting instead of dividing: a₄ − a₂ = 24 − 6 = 18, taken directly as the common ratio. −2 is the other square root of 4, but it is rejected because all the sequence's terms are given as positive.
- (c) 12 cm — For a square, area = side². So side² = 144, giving side = ±12. Since a length must be positive, the side length is 12 cm. A candidate who gives both square roots without rejecting the negative one, which cannot be a length, answers 12 cm or −12 cm. A candidate who halves 144 instead of taking its square root gets 72 cm. A candidate who divides 144 by 4, confusing the area formula with a perimeter calculation, gets 36 cm.
- (d) 400 m — The distance travelled equals the area under the speed-time graph. The first 10 seconds form a triangle with base 10 and height 20, giving an area of 0.5 × 10 × 20 = 100 m. The next 15 seconds form a rectangle with base 15 and height 20, giving an area of 15 × 20 = 300 m. The total distance is 100 + 300 = 400 m. The option 500 m treats the whole 25 seconds as travelled at the constant 20 m/s, ignoring that the speed was building up during the first 10 seconds: 25 × 20 = 500. The option 300 m only counts the constant-speed section and forgets the triangle section entirely. The option 200 m comes from working out the triangle's area without halving it (10 × 20 = 200) and forgetting the rectangle altogether.
- (c) 2(x + 4) ≡ 2x + 8 — 2(x + 4) ≡ 2x + 8 is an identity because expanding the bracket on the left gives exactly the right-hand side for every value of x — try any number and both sides match. 2(x + 4) = 20 is an equation: expanding gives 2x + 8 = 20, which is only true for the single value x = 6. 2(x + 4) = 2x + 4 is not true for any value of x at all: expanding the left side gives 2x + 8, which can never equal 2x + 4 since 8 ≠ 4. x + 4 = 2x is also an equation, true only for the single value x = 4. The identity is 2(x + 4) ≡ 2x + 8.
- (b) 4 — Method: form the equation 30 + 25h = 130, where h is the number of hours, then solve for h. Working: subtract the call-out fee from the total bill: 25h = 130 − 30 = 100. Divide by the hourly rate: h = 100 ÷ 25 = 4. Answer: 4 hours. 5.2 comes from dividing the whole bill by the hourly rate without subtracting the fixed fee first, 130 ÷ 25. 3.5 comes from swapping the fee and the rate, subtracting the rate from the bill and dividing by the fee, (130 − 25) ÷ 30. 6.4 comes from adding the call-out fee to the bill instead of subtracting it, before dividing by the rate, (130 + 30) ÷ 25.
- (d) 5n − 1 — The common difference is 5 (9−4=5), so the expression starts 5n. To match the first term when n=1, 5×1+c=4, so c=−1: the nth term is 5n−1. A candidate who uses the first term itself as the constant, instead of first term minus the common difference, would write 5n+4 (giving 9, 14, 19, 24 — one term too high throughout). A candidate who omits the constant term altogether would write just 5n (giving 5, 10, 15, 20, not matching the sequence). A candidate who adds the common difference to n instead of multiplying would write n+5 (giving 6, 7, 8, 9, far too small).
- (a) (2n + 1) + (2n + 3) = 4n + 4 = 4(n + 1) — Two consecutive odd numbers can be written as 2n + 1 and 2n + 3, for a whole number n. Adding them: (2n + 1) + (2n + 3) = 4n + 4 = 4(n + 1), which is a multiple of 4 for every whole number n, proving the general result. Using 2n + 1 twice does not represent two different numbers, so it proves nothing about a sum of two numbers; writing n + (n + 2) drops the +1 that makes the numbers odd in the first place, and only shows a multiple of 2; and check every constant term is added correctly — 1 + 3 is 4, not 3.
- (b) x ≤ −2 — Method: take the number term off both sides, then divide by the coefficient of x; the sign turns round only when you divide BY a negative number, and here you divide by 3. Working: subtracting 6 from both sides of 3x + 6 ≤ 0 gives 3x ≤ −6; dividing both sides by 3, which is positive, gives x ≤ −2. Answer: x ≤ −2. The distractors: x ≥ −2 comes from turning the sign round because the right-hand side has become negative, which is not the rule; it is the sign of the divisor that matters; x ≤ 2 comes from moving the 6 across without changing its sign, giving 3x ≤ 6; x ≤ −18 comes from multiplying both sides by 3 instead of dividing by it.
- (a) {x : x < −3} ∪ {x : x ≥ 1} — "Less than −3" stays strict, since the wording never says "or equal to": x < −3. "Greater than or equal to 1" is inclusive: x ≥ 1. These are two separate, non-overlapping ranges joined with "or", so in set notation they are combined with the union symbol: {x : x < −3} ∪ {x : x ≥ 1}. Distractor routes: {x : x ≤ −3} ∪ {x : x > 1} swaps the strict and inclusive signs, marking −3 as included and 1 as excluded, the opposite of the wording. {x : −3 < x ≤ 1} treats "or" as "and", joining the two conditions into one continuous interval between the values instead of a union of two separate ranges. {x : x > −3} ∪ {x : x ≤ 1} reverses both inequality directions; the two reversed ranges then overlap and between them cover every number on the number line, so that set is the whole of the real line rather than the two separate ranges the description asks for.
- (a) 16 — A and B share the same y-coordinate, so the distance between them is the horizontal difference between their x-coordinates: 8 − (−8) = 16, giving a chord of length 16. Choosing 8 gives only the x-coordinate of one point, not the full distance between the two points. Choosing 34 is the diameter of the circle (2 × 17), not the length of this particular chord. Choosing 17 is the radius — the distance from the centre to A or to B, not from A to B.
- (d) The roots of x² − 6x + 5 = 0 are x = 1 and x = 5 (since it factorises to (x − 1)(x − 5)), so by symmetry the turning point has x-coordinate 3, not 6. — Factorising, x² − 6x + 5 = (x − 1)(x − 5), so the roots are x = 1 and x = 5. The turning point lies midway between the roots by symmetry: (1 + 5) ÷ 2 = 3. The coefficient of x has no direct role in locating the turning point this way. The option giving −6 makes an arbitrary sign change with no mathematical basis. The option giving 5 wrongly takes just one of the two roots instead of their midpoint.
- (d) t = 5 — The maximum height occurs halfway between the two times when the ball is at ground level: the midpoint of t = 1 and t = 9 is (1 + 9) ÷ 2 = 5, so the ball reaches its maximum height at t = 5 seconds. Getting t = 4 comes from halving the DIFFERENCE between the times, 9 − 1 = 8, then 8 ÷ 2 = 4, instead of finding their midpoint. Getting t = 8 uses that difference, 9 − 1 = 8, as if the gap between the two times were itself the time of the maximum. Getting t = 10 adds the two times, 1 + 9 = 10, but forgets to divide by 2.
Build your own mix at the worksheet builder.