Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- 1.To solve 6x − 4 = 2x + 20, Yusuf's first step is to subtract 2x from both sides. Work out what equation this gives.
- 2.y = 5 − 2x. Work out the value of x when y = 11.
- 3.Rosie is asked whether 4(x + 3) = 4x + 12 is an equation or an identity. Which statement is correct? Give a reason for your answer.
- 4.Two students each use the trapezium rule to estimate the area under the same curve between x = 0 and x = 8. Student A uses 4 strips of width 2. Student B uses 8 strips of width 1. Which estimate is more likely to be closer to the true area, and why?
- 5.A straight line passes through the points (2, 7) and (5, 16). Work out the value of y when x = 0.
- 6.The table shows the height, in metres, of a firework rocket at various times, in seconds, during its flight: 40 at t = 2, 54 at t = 3, and 60 at t = 4. Use the chord between t = 2 and t = 4 to estimate the gradient of the height-time graph at t = 3, stating the correct units.
- 7.A ball's height, h metres, t seconds after being thrown follows h = (t − 1)(9 − t). Given that the ball is at ground level at t = 1 and t = 9, work out at what time t the ball reaches its maximum height, using symmetry.
- 8.The function f(x) = x² for all real values of x has no inverse function, but g(x) = x² for x ≥ 0 does have one. Which statement correctly explains this?y = x²
- 9.Water is poured into a container at a constant rate. A graph of the depth of the water, in cm, against the time since pouring began, in minutes, is a straight line through the origin, and it passes through the point (3, 12). Use the graph to work out the depth of the water after 7 minutes.
- 10.The numbers x and y satisfy x + y = 10 and xy = 21. Work out the pair of values.
- 11.The graph of y = f(x) has a minimum turning point at (2, −3). The graph of y = −f(x) + a has a maximum turning point at (2, 9). Work out the value of a.
- 12.A distance-time graph is a straight line from (0, 0) to (4, 100), where time is in hours and distance is in kilometres. Work out the gradient of the line.
- 13.x = 5. Work out the value of 3x² − 4.
- 14.Write down the gradient of the line with equation y = −x + 3.y = −x + 3
- 15.A rectangular field has length (3a + 2) metres and width (a − 1) metres. Write a simplified expression for the perimeter of the field.
Answer key
- (b) 4x − 4 = 20 — Method: subtract 2x from both sides of the equation, and simplify each side separately. Working: left side: 6x − 4 − 2x = 4x − 4. Right side: 2x + 20 − 2x = 20. Answer: 4x − 4 = 20. 4x = 20 drops the −4 from the left side, as though subtracting 2x also removes the constant term. 8x − 4 = 20 comes from moving the 2x across to the left without changing its sign: it is taken off the right side correctly, leaving 20, but added to the left side instead of subtracted, giving 6x + 2x = 8x. 4x − 4 = 2x + 20 comes from subtracting 2x from the left-hand side only and leaving the right-hand side unchanged; whatever is done to one side must be done to the other.
- (d) −3 — Substitute y = 11 into y = 5 − 2x, giving 11 = 5 − 2x. Subtracting 5 from both sides gives 6 = −2x, so x = 6 ÷ (−2) = −3. A candidate who mishandles the negative sign when rearranging, treating the equation as 6 = 2x, gets x = 3. A candidate who correctly finds −2x = 6 but forgets to divide by 2 at all gets x = 6. A candidate who adds 5 and 11 instead of subtracting, getting 2x = 16, gets x = 8.
- (a) An identity, because it is true for every value of x — Expanding the brackets multiplies both terms inside by 4, giving 4x + 12, which is exactly the right-hand side. The two sides are therefore equal whatever x is, and a statement true for every value of the letter is an identity. An equation is true only for particular values, and trying to solve this one leads to 0 = 0, which places no restriction on x at all. Being able to expand brackets is not what makes a statement an identity, since any equation with brackets can be expanded. Nor is it a formula: a formula links two different quantities, and only one letter appears here.
- (b) Student B's — narrower strips fit the curve more closely. — The trapezium rule replaces the curve with straight-line segments; the narrower each strip, the more closely its straight edge follows the curve, so Student B's estimate with 8 narrower strips is more likely to be closer to the true area. Reasoning from the number of arithmetic steps rather than from how well the straight lines fit the curve gives the wrong claim that Student A makes fewer rounding errors. Believing the trapezium rule is exact, rather than an estimate that improves with narrower strips, gives the wrong claim that the two are always the same. Believing wider strips smooth out the curve better, rather than following it less closely, gives the wrong claim in favour of Student A's wider strips.
- (a) 1 — Method: the value of y when x = 0 is where the line meets the y-axis, which is the constant c in y = mx + c, so the gradient is worked out from the two given points first and the constant follows by substituting one of them. Working: m = (16 − 7) ÷ (5 − 2) = 9 ÷ 3 = 3, so the line is y = 3x + c; substituting x = 2 and y = 7 gives 7 = 3 × 2 + c, so c = 7 − 6 = 1, and the value of y when x = 0 is that constant. Answer: 1. The distractors: 3 comes from stopping at the gradient and offering it as the intercept; 4 comes from stepping back from x = 2 to x = 0 by one unit of x instead of two, 7 − 3 = 4; −1 comes from working the constant out as mx − y, 3 × 2 − 7 = −1, instead of y − mx.
- (c) 10 m/s — A symmetric chord gradient uses the two points either side of t = 3: (2, 40) and (4, 60). The gradient is the change in height divided by the change in time: (60 − 40) ÷ (4 − 2) = 20 ÷ 2 = 10 m/s. Using only the values either side of one gap, (2, 40) and (3, 54), instead of the full symmetric chord, gives (54 − 40) ÷ (3 − 2) = 14 m/s. Getting the correct number but dropping the time unit, leaving only metres, gives 10 m. Dividing time by height instead of height by time inverts the calculation to (4 − 2) ÷ (60 − 40) = 0.1 s/m.
- (d) t = 5 — The maximum height occurs halfway between the two times when the ball is at ground level: the midpoint of t = 1 and t = 9 is (1 + 9) ÷ 2 = 5, so the ball reaches its maximum height at t = 5 seconds. Getting t = 4 comes from halving the DIFFERENCE between the times, 9 − 1 = 8, then 8 ÷ 2 = 4, instead of finding their midpoint. Getting t = 8 uses that difference, 9 − 1 = 8, as if the gap between the two times were itself the time of the maximum. Getting t = 10 adds the two times, 1 + 9 = 10, but forgets to divide by 2.
- (d) g is one-to-one: f(3) = f(−3), removed by x ≥ 0 — A function has an inverse only if it is one-to-one: every output must come from exactly one input. f(3) = 9 and f(−3) = 9, so two different inputs give the same output, and there is no way to send 9 back to a single input — f is not one-to-one over all real x. Restricting the domain to x ≥ 0 removes one of the two inputs behind every such pair, so g is one-to-one and does have an inverse. 'g's outputs are positive; f's could be negative' is wrong because f(x) = x² also only gives outputs of 0 or more — the outputs of f and g are identical sets; it is the INPUTS that differ, not the outputs. 'Restricting any domain always creates an inverse' is wrong because a restriction only helps if it actually removes the repeated outputs: restricting f(x) = x² to x ≥ −3 still leaves f(1) = f(−1) = 1, so that restricted function is still not one-to-one and still has no inverse. 'Squares can never be reversed, under any conditions' is wrong because √9 = 3 does reverse 3² = 9 once you know the input was non-negative — a square root just cannot tell you WHICH of two inputs you started from unless the domain has already ruled one of them out.
- (d) 28 cm — Method: rate = 12 cm ÷ 3 min = 4 cm per minute. Depth after 7 minutes = 4 × 7 = 28 cm. Distractor origins: 84 cm multiplies the given depth by 7 directly, without first finding the rate per minute (12 × 7 = 84); 24 cm simply doubles the given depth instead of scaling correctly by the ratio of times; 16 cm combines the numbers with subtraction and addition (12 − 3 + 7 = 16) instead of finding a rate.
- (a) 3 and 7 — Method: one equation is linear and the other is not, so rearrange the linear equation and substitute it into the other to leave a single quadratic in one letter. Working: x + y = 10 gives y = 10 − x, so xy = 21 becomes x(10 − x) = 21, which rearranges to x² − 10x + 21 = 0; factorising gives (x − 3)(x − 7) = 0, so the two values are 3 and 7, and 3 + 7 = 10 with 3 × 7 = 21. Answer: 3 and 7. The distractors: 1 and 21 comes from using only the product and taking the first factor pair of 21; −3 and −7 comes from factorising as (x + 3)(x + 7), which reverses the sign of both values; 5 and 5 comes from using only the sum and splitting 10 into two equal parts.
- (b) 6 — Reflecting y = f(x) in the x-axis turns the minimum point (2, −3) into a maximum point at (2, 3), since −f(x) negates every y-value: −(−3) = 3. Adding a then gives 3 + a = 9, so a = 9 − 3 = 6. Forgetting the reflection and using the original y-value of −3 gives −3 + a = 9, so a = 12 — this ignores that −f(x) changes the sign of the y-coordinate before a is added. Writing a = −12 comes from subtracting in the wrong order, working out 9 − (−3) as −3 − 9 instead. Writing a = −6 comes from taking the negative of the correct answer, as if the final value of a needed to be reflected too, on top of the turning point.
- (a) 25 — Gradient = change in y ÷ change in x = (100 − 0) ÷ (4 − 0) = 100 ÷ 4 = 25. Dividing time by distance instead of distance by time gives 0.04; multiplying the two values instead of dividing gives 400; stopping at the change in distance, 100, forgets to divide by the change in time.
- (c) 71 — Method: square x first, then multiply by 3, then subtract 4, following the order of operations. Working: x² = 5² = 25; 3 × 25 = 75; 75 − 4 = 71. Answer: 71. 221 comes from squaring (3x) as a whole first: (3 × 5)² = 225, then − 4 = 221, squaring the coefficient along with x. 75 comes from correctly working out 3x² but forgetting to subtract the 4. 3 comes from subtracting the 4 from x before squaring: (5 − 4)² × 3 = 3, doing the operations in the wrong order.
- (b) −1 — Method: in the form y = mx + c the gradient m is the number multiplying x, and an x term written with no number in front of it has a coefficient of 1. Working: y = −x + 3 is the same equation as y = (−1)x + 3, so comparing it with y = mx + c gives m = −1 and c = 3. Answer: −1. The distractors: 1 comes from taking the coefficient as 1 and leaving the minus sign out of the answer; 3 comes from reading the constant as the gradient, confusing m with c; −3 comes from moving the minus sign across to the constant term and then reading the gradient off that term instead of the x term.
- (c) 8a + 2 — The perimeter of a rectangle is twice the length plus twice the width: P = 2(3a + 2) + 2(a − 1) = (6a + 4) + (2a − 2) = 8a + 2. Answering 5a adds the length and width once each but doubles only one of them, missing that a rectangle has two of each side. Answering 8a + 6 distributes the 2 into (a − 1) correctly as far as 2a, but then adds 2 instead of subtracting it, as though the bracket had been (a + 1). Answering 12a + 8 uses the length for all four sides instead of using the length twice and the width twice, as if the field were a square with side (3a + 2). The perimeter of the field is (8a + 2) metres.
Build your own mix at the worksheet builder.