Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- 1.A plumber charges a call-out fee plus an hourly rate for a job. The total cost, £C, for a job lasting h hours is given by the formula C = 40 + 25h. What does the number 40 represent in this formula?
- 2.The nth term of a sequence is 4n − 3. Work out the 7th term of the sequence.
- 3.Which of these equations is equivalent to 5x − 2 = 3x + 8?
- 4.The tangent to a curve at the point (5, 2) is the line y = mx + c. This tangent crosses the y-axis at (0, −8). Work out the gradient, m, of the tangent.
- 5.The table shows some values of f(x): when x = 0, f(x) = 5; when x = 1, f(x) = 8; when x = 2, f(x) = 4; when x = 3, f(x) = 1. Work out the value of f(x − 1) when x = 2.
- 6.The first five terms of a quadratic sequence are −1, 4, 13, 26, 43. Work out an expression, in terms of n, for the nth term.
- 7.Solve 7x − 5 = 3x + 11
- 8.The graph of y = 60 × (0.5)ˣ is sketched for x ≥ 0. Which statement correctly describes what happens to the curve as x increases?
- 9.Two students each use the trapezium rule to estimate the area under the same curve between x = 0 and x = 8. Student A uses 4 strips of width 2. Student B uses 8 strips of width 1. Which estimate is more likely to be closer to the true area, and why?
- 10.A geometric sequence begins 80, 40, 20, 10, ... Work out the next term in the sequence.
- 11.Which of these rules generates the sequence 6, 11, 16, 21, …?
- 12.By completing the square, find the turning point of the curve y = x² − 4x + 9.y = x² − 4x + 9
- 13.Write down the expression that means the same as 'subtract 5 from n, then divide the result by 2'.
- 14.A circle has centre O(0, 0) and equation x² + y² = 169. The point Q has coordinates (10, 11). Work out which of these gives the correct position of Q together with correct working.
- 15.How many turning points does the graph of y = x² − 7x + 10 have?y = x² − 7x + 10
Answer key
- (d) The fixed call-out fee, charged before the hourly rate. — Method: compare the formula with C = (fixed charge) + (rate) × h, where the fixed charge is the part that does not depend on h. Working: in C = 40 + 25h, the term 25h depends on the number of hours, h, but 40 does not change however many hours the job takes. Answer: 40 is the fixed call-out fee. 'The hourly rate' confuses the fixed term with the coefficient of h, which is actually 25. 'The total cost for a job lasting 1 hour' comes from substituting h = 1 into the formula (40 + 25 = 65) rather than reading off the constant term. 'The number of hours worked before charging starts' wrongly treats the constant, which is in pounds, as if it were measured in hours.
- (b) 25 — Substitute n = 7: 4 × 7 − 3 = 28 − 3 = 25. Forgetting to subtract 3 gives 4 × 7 = 28. Subtracting 3 from 7 before multiplying by 4, 4 × (7 − 3) = 16, applies the operations in the wrong order. Substituting n = 8 by miscounting the position gives 4 × 8 − 3 = 29.
- (d) 2x = 10 — Method: collect the x-terms on one side and the constants on the other, keeping the equals sign balanced. Working: 5x − 3x = 8 + 2, giving 2x = 10. Answer: 2x = 10. 2x = 6 comes from a sign error moving the constant, subtracting instead of adding: 8 − 2 = 6. 8x = 6 comes from adding the x-terms instead of subtracting them (5x + 3x = 8x), alongside the constant sign error. 2x = −10 comes from a sign error moving the constant the other way: −2 − 8 = −10.
- (d) 2 — The gradient between two points on a line is the change in y divided by the change in x. Using (5, 2) and (0, −8): (2 − (−8)) ÷ (5 − 0) = 10 ÷ 5 = 2. Inverting the fraction, dividing the change in x by the change in y instead, gives 5 ÷ 10 = 0.5. Reversing the order of the x-values in the denominator, giving (2 − (−8)) ÷ (0 − 5) = 10 ÷ (−5), gives −2. Misreading the y-intercept as 8 instead of −8, giving (2 − 8) ÷ 5 = −6 ÷ 5, gives −1.2.
- (a) 8 — f(x − 1) means every input to f is reduced by 1 before it is looked up. At x = 2, the input to f becomes 2 − 1 = 1, so f(x − 1) at x = 2 is f(1) = 8. Reading f(2) = 4 directly from the table, without applying the shift, gives 4. Shifting in the wrong direction, using x + 1 = 3 instead of x − 1 = 1, gives f(3) = 1. Confusing f(x − 1) with f(x) − 1 — taking f(2) = 4 and then subtracting 1 — gives 3.
- (d) 2n² − n − 2 — First differences: 5, 9, 13, 17. Second differences: 4, 4, 4, so a = 4 ÷ 2 = 2. Subtracting 2n² (2, 8, 18, 32, 50) from the terms (−1, 4, 13, 26, 43) leaves −3, −4, −5, −6, −7, which is the linear expression −n − 2. So the nth term is 2n² − n − 2. Using the second difference itself as a, without halving it, gives 4n² − n − 2. Finding a = 2 correctly but dropping the linear remainder −n − 2 entirely leaves 2n². Treating the first first difference (5) as a common difference and building a + (n − 1)d = −1 + 5(n − 1) gives 5n − 6, which only matches the first two terms.
- (d) 4 — Method: collect the x terms on one side and the number terms on the other. Working: subtract 3x from both sides: 4x − 5 = 11. Add 5 to both sides: 4x = 16. Divide by 4: x = 4. Answer: 4. 0.6 comes from adding the x terms instead of subtracting when collecting them, 7x + 3x = 10x, and also subtracting the constants the wrong way round, 11 − 5 = 6, giving 10x = 6. 1.5 comes from correctly collecting the x terms as 4x but subtracting the constants the wrong way round, 11 − 5 instead of 11 + 5. −4 comes from moving the x terms to the wrong side, giving 3x − 7x instead of 7x − 3x, along with a matching sign error on the constants.
- (a) It gets closer to zero but never actually reaches it. — y = 60 × (0.5)ˣ is always positive, however large x is, because a positive number raised to any power stays positive. As x increases, (0.5)ˣ gets smaller and smaller but never equals zero, so y approaches zero without ever reaching it. Believing the curve reaches zero when x = 60, because 60 is the starting value, mixes up the y-intercept with a stopping point — an exponential decay curve like this one never actually reaches the x-axis, so this is wrong. Believing the curve goes negative for large x is wrong because multiplying a positive number by (0.5) any number of times can never produce a negative result. Believing the curve levels off at y = 0.5, confusing the base of the exponential with its eventual level, is wrong: the base only controls how fast the curve falls, not where it settles — this curve settles at y = 0, not y = 0.5. Whenever you sketch an exponential decay curve, draw it approaching the x-axis but never touching it.
- (b) Student B's — narrower strips fit the curve more closely. — The trapezium rule replaces the curve with straight-line segments; the narrower each strip, the more closely its straight edge follows the curve, so Student B's estimate with 8 narrower strips is more likely to be closer to the true area. Reasoning from the number of arithmetic steps rather than from how well the straight lines fit the curve gives the wrong claim that Student A makes fewer rounding errors. Believing the trapezium rule is exact, rather than an estimate that improves with narrower strips, gives the wrong claim that the two are always the same. Believing wider strips smooth out the curve better, rather than following it less closely, gives the wrong claim in favour of Student A's wider strips.
- (d) 5 — Each term is found by multiplying the previous term by the common ratio, 0.5: 80, 40, 20, 10, and the next term is 10 × 0.5 = 5. A candidate who instead subtracts the same amount each time (repeating the last difference of 10) would reach 10 − 10 = 0. A candidate who divides by 4 instead of by 2 would reach 10 ÷ 4 = 2.5. A candidate who multiplies by 2 instead of dividing (reversing the direction of the sequence) would reach 10 × 2 = 20.
- (c) 5n + 1 — Method: find the common difference, then use it as the coefficient of n in the position-to-term rule, and find the constant by checking against the first term. Working: the common difference is 5, so the rule has the form 5n + c. Using the 1st term: 5(1) + c = 6, so c = 1. The rule is 5n + 1. Answer: 5n + 1. 5n − 1 uses the correct coefficient but the wrong sign for the constant. 6n comes from using the first term as the coefficient of n instead of the common difference — it matches the 1st term by coincidence but fails from the 2nd term onward. n + 5 swaps the coefficient and the constant around, using the common difference as the constant instead of the coefficient of n.
- (c) x = 2, y = 5 — x² − 4x + 9 = (x − 2)² − 2² + 9 = (x − 2)² + 5. Substituting x = 2: 2² = 4, 4 × 2 = 8, so 4 − 8 + 9 = 5, confirming the minimum value 5 at x = 2: turning point (2, 5). Using −4 instead of half of it inside the bracket gives (x − 4)² − 7, turning point (4, −7) — wrong, because only half the coefficient of x belongs inside the bracket. Reading the bracket's sign directly as the turning point's x-coordinate gives (−2, 5) — wrong, because (x − 2)² is zero at x = 2, not x = −2. Computing 4 − 9 = −5 instead of 9 − 4 = 5 flips the sign of the constant, giving (2, −5) — wrong, since the completed square's constant must be evaluated as 9 minus 4, not 4 minus 9. Substitute the x-value back into the original equation whenever you are unsure of a sign.
- (a) (n − 5)/2 — Method: do the subtraction first, keep it together as a single bracket, then divide that whole bracket by 2. Working: 'subtract 5 from n' is (n − 5); 'divide the result by 2' means the whole bracket goes over 2, giving (n − 5)/2. Answer: (n − 5)/2. n/2 − 5 comes from dividing n by 2 first and only then subtracting 5, the wrong order. 2(n − 5) comes from multiplying by 2 instead of dividing. (5 − n)/2 comes from subtracting n from 5 instead of subtracting 5 from n, the wrong way round.
- (a) Outside: OQ² = 221 > r² = 169 — OQ² = 10² + 11² = 100 + 121 = 221. Comparing this with r² = 169: since 221 > 169, OQ > r, so Q lies outside the circle — this is the correct verdict AND the correct working. 'Outside: OQ = 21 (10 + 11) > r = 13' reaches the same Outside verdict, but by invalid working: it adds the coordinates instead of squaring them (10 + 11 = 21, rather than 10² + 11² = 221), so the stated 'OQ' of 21 is not a distance at all — the verdict happens to match, but the method is wrong. 'Inside: OQ ≈ 14.87 < r² = 169' correctly finds the distance OQ = √221 ≈ 14.87, but then compares that DISTANCE with r² = 169 instead of with r = 13 — comparing two different kinds of quantity gives a meaningless, and here wrong, verdict. 'Inside: OQ² = 221 < (2r)² = 676' confuses the radius with the diameter: it compares OQ² with the diameter squared, (2 × 13)² = 676, instead of with r² = 169.
- (b) One turning point. — Every quadratic graph, one with an x² term and no higher power of x, has exactly one turning point, since it is a single U-shaped or n-shaped curve. Saying two turning points describes a cubic graph, which can rise, turn, then turn again. Saying no turning points describes a straight line, which has none. Saying four turning points greatly overestimates how many times a simple quadratic curve changes direction — that would need a much higher power of x.
Build your own mix at the worksheet builder.