Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- 1.To rearrange y = 2x − 5 to make x the subject, Sam writes: 'Add 5 to both sides to get y + 5 = 2x, then divide both sides by 2 to get x = (y + 5)/2.' Which statement about Sam's method is correct?y = 2x − 5
- 2.A taxi charges a £3 fixed fee plus £2 for each mile travelled. Write an expression, in pounds, for the total cost of a journey of n miles.
- 3.The table shows the height, in metres, of a firework rocket at various times, in seconds, during its flight: 40 at t = 2, 54 at t = 3, and 60 at t = 4. Use the chord between t = 2 and t = 4 to estimate the gradient of the height-time graph at t = 3, stating the correct units.
- 4.A speed-time graph for a car shows the speed increasing steadily from 5 m/s to 17 m/s over 6 seconds. Work out the acceleration of the car, in m/s².
- 5.Work out the value of the discriminant b² − 4ac for the equation 2x² + 3x − 2 = 0.
- 6.The graph of y = x² + 2x − 15 crosses the x-axis at two points. By factorising, work out the x-coordinates of these two points.y = x² + 2x − 15
- 7.The graph of y = f(x) has a root (an x-intercept) at x = 5. Work out the x-coordinate of the corresponding root on the graph of y = f(x + 2).
- 8.f(x) = x³ − 3x² − 4. Work out the pair of consecutive integers between which the solution of f(x) = 0 lies.y = x
- 9.A student is asked to simplify (6x³ − 15x²)/(4x² − 10x) fully. Four attempts are shown below. Which one is correct?
- 10.A speed-time graph shows a constant speed of 15 m/s for 20 seconds. Work out the distance travelled, using the area under the graph.
- 11.Three vertices of a rectangle are (−4, −1), (2, −1) and (2, 3). The sides of the rectangle are parallel to the axes. Write down the coordinates of the fourth vertex.
- 12.The nth term of a sequence is n² + 2n − 4. Work out the 7th term.
- 13.Make x the subject of the formula y = 4x − 3.y = 4x − 3
- 14.The equation x² − 4x + k = 0 has two different real solutions. Work out the range of values of k.
- 15.A sequence begins at 60, and each term after that is found by subtracting 7 from the term before it. Work out the 5th term of the sequence.
Answer key
- (c) Yes; x = (y + 5)/2 is right — Sam's method is correct throughout: adding 5 to both sides gives y + 5 = 2x, and dividing both sides by 2 gives x = (y + 5)/2, so Sam is right. The option giving x = (y − 5)/2 assumes 5 should be subtracted again, but 2x − 5 = y means 5 has already been subtracted, so it must be added back, not taken away a second time. The option giving x = y/2 + 5 divides only the y term by 2 and leaves the 5 unhalved, which is not a valid rearrangement. The option agreeing Sam is correct but changing step 2 to x = 2(y + 5) confuses '2x' with 'x divided by 2' — since x is multiplied by 2, the inverse is division, not multiplication. Sam's working, and his final formula x = (y + 5)/2, are both correct.
- (b) 2n + 3 — Method: multiply the cost per mile by the number of miles to get an expression, then add the fixed fee as a separate term. Working: n miles at £2 each is 2n; add the £3 fixed fee: 2n + 3. Answer: 2n + 3. 3n + 2 comes from swapping the fee and the rate round, treating £3 as the rate per mile and £2 as the fixed fee. 5n comes from adding the fee and the rate together first (3 + 2 = 5) and multiplying the result by n, instead of keeping the fixed fee as its own term. 2n − 3 comes from subtracting the fixed fee instead of adding it.
- (c) 10 m/s — A symmetric chord gradient uses the two points either side of t = 3: (2, 40) and (4, 60). The gradient is the change in height divided by the change in time: (60 − 40) ÷ (4 − 2) = 20 ÷ 2 = 10 m/s. Using only the values either side of one gap, (2, 40) and (3, 54), instead of the full symmetric chord, gives (54 − 40) ÷ (3 − 2) = 14 m/s. Getting the correct number but dropping the time unit, leaving only metres, gives 10 m. Dividing time by height instead of height by time inverts the calculation to (4 − 2) ÷ (60 − 40) = 0.1 s/m.
- (a) 2 m/s² — Method: acceleration = change in speed ÷ time = (17 − 5) ÷ 6 = 12 ÷ 6 = 2 m/s². Distractor origins: 12 m/s² stops after finding the change in speed and forgets to divide by the time; 22 m/s² adds the two speeds instead of subtracting them, and also forgets to divide by time (5 + 17 = 22); 72 m/s² multiplies the change in speed by the time instead of dividing (12 × 6 = 72).
- (c) 25 — Method: read off a, b and c with their signs and substitute them into b² − 4ac. Working: for 2x² + 3x − 2 = 0, a = 2, b = 3 and c = −2, so b² − 4ac = 3² − 4 × 2 × (−2) = 9 − (−16) = 9 + 16 = 25. Answer: 25. The distractors: −7 comes from taking c as +2, which gives 9 − 16; 22 comes from working b² as 2 × 3 = 6 and then 6 + 16; 13 comes from leaving the 4 out of 4ac and working 9 − 2 × (−2).
- (c) x = 3 and x = −5 — To factorise x² + 2x − 15, find two numbers that multiply to −15 and add to 2: these are 5 and −3, since 5 × (−3) = −15 and 5 + (−3) = 2. So x² + 2x − 15 = (x + 5)(x − 3). Setting each factor to zero gives x = −5 and x = 3. Choosing x = −3 and x = 5 comes from swapping the signs of the correct roots. Choosing x = 5 and x = 3 uses the right pair of numbers, 5 and 3, but forgets that one of them must be negative for the product to equal −15. Choosing x = −15 and x = 1 mistakes the constant term, −15, for one of the roots, and pairs it oddly with x = 1.
- (a) 3 — y = f(x + 2) is f(x) translated 2 units to the LEFT (inside the bracket, adding moves the graph in the negative x-direction). The root moves with the whole graph: 5 − 2 = 3. Moving right instead of left gives 7; assuming a bracket shift leaves the root unchanged gives 5; writing down the shift amount 2 itself skips the translation altogether.
- (d) 3 and 4 — f(3) = 3³ − 3 × 3² − 4 = 27 − 27 − 4 = −4, and f(4) = 4³ − 3 × 4² − 4 = 64 − 48 − 4 = 12. Since f(3) is negative and f(4) is positive, there is a change of sign, so the solution lies between 3 and 4. A sign slip when expanding −3x², treating it as +3x², gives f(3) = 27 + 27 − 4 = 50, a positive value; taken with the correctly negative f(2) = 8 − 12 − 4 = −8, this reads as a change of sign between 2 and 3. The same sign slip applied at x = 1 gives f(1) = 1 + 3 − 4 = 0, read as the point the sign changes, against f(0) = 0 + 0 − 4 = −4, giving 0 and 1. Shifting the correctly found interval up by one integer, an indexing slip, reports the change as lying between 4 and 5 instead of 3 and 4.
- (a) 3x/2 — Factorise top and bottom first: 6x³ − 15x² = 3x²(2x − 5), and 4x² − 10x = 2x(2x − 5). The bracket (2x − 5) is common to both, so it cancels, leaving 3x²/(2x); dividing the power of x, 3x² ÷ x = 3x, gives 3x/2. Writing 3x²/2 cancels the (2x − 5) correctly and removes the denominator's x, but never reduces the power of x left in the numerator — 3x² ÷ x should give 3x, not stay as 3x². Writing 3/2 cancels the (2x − 5) correctly but then drops the x from the numerator altogether, treating 3x² over x as if it cancelled completely to 3 instead of reducing to 3x. Writing −3x/2 comes from factorising the denominator with the wrong sign, as 2x(5 − 2x) instead of 2x(2x − 5); cancelling (5 − 2x) against the numerator's (2x − 5) then needs an extra minus sign, which flips the answer to −3x/2.
- (d) 300 m — For a constant speed, the speed-time graph is a horizontal line, and the area underneath is a rectangle: distance = speed × time = 15 × 20 = 300 m. Adding the two numbers instead of multiplying gives 35 m; dividing instead of multiplying gives 1.33 m; halving the product, as you would for a triangle, gives 7.5 m — but this section of the graph is a rectangle, not a triangle, so there is no halving to do.
- (b) (−4, 3) — Method: in a rectangle whose sides are parallel to the axes only two different x-coordinates and two different y-coordinates appear, and each of them is shared by a pair of vertices, so the missing vertex takes the x-coordinate and the y-coordinate that so far appear only once. Working: the x-coordinates given are −4, 2 and 2, so 2 is already used twice and −4 is used once; the y-coordinates given are −1, −1 and 3, so −1 is already used twice and 3 is used once; the fourth vertex therefore has x = −4 and y = 3. Answer: (−4, 3). The distractors: (3, −4) comes from picking the two unpaired coordinates correctly and then writing them in the wrong order; (−4, −5) comes from matching the 4-unit vertical side but measuring it downwards from (−4, −1) instead of upwards; (8, 3) comes from carrying on round the shape with the horizontal step used earlier, adding 6 to the x-coordinate of (2, 3) instead of closing the rectangle.
- (c) 59 — Substitute n = 7: 7² + 2 × 7 − 4 = 49 + 14 − 4 = 59. A sign error on the +2n term, treating it as −2n, gives 49 − 14 − 4 = 31. Working out 7² + 2 × 7 but forgetting to subtract the final 4 gives 49 + 14 = 63. Using n = 6 instead of n = 7 gives 36 + 12 − 4 = 44.
- (d) x = (y + 3)/4 — Two operations have been applied to x: it has been multiplied by 4 and then 3 has been subtracted. Undo them in the opposite order. Adding 3 to both sides gives y + 3 = 4x. Dividing both sides by 4 then gives (y + 3)/4 = x, so x = (y + 3)/4. The bracket matters: writing y/4 + 3 divides only the y by 4 and leaves the 3 untouched. Writing (y − 3)/4 subtracts the 3 instead of adding it, and writing 4(y + 3) multiplies by 4 rather than dividing.
- (d) k < 4 — Method: the number of real solutions of ax² + bx + c = 0 is decided by the discriminant b² − 4ac, and two different real solutions need it to be greater than zero. Working: here a = 1, b = −4 and c = k, so b² − 4ac = 16 − 4k; the condition is 16 − 4k > 0, which gives 16 > 4k and then k < 4. Answer: k < 4; for example k = 3 gives x² − 4x + 3 = 0, whose solutions are 1 and 3. The distractors: k ≤ 4 comes from using b² − 4ac ≥ 0, which also allows the single repeated solution at k = 4; k > 4 comes from dividing −4k > −16 by −4 without reversing the inequality sign; k < 16 comes from leaving the factor 4 out of 4ac and solving 16 − k > 0.
- (c) 32 — The terms are 60, 53, 46, 39, 32 — each found by subtracting 7 from the term before, so the 5th term is 32. Subtracting 7 five times from the first term instead of four times, 60 − 7 × 5 = 25, treats the first term as if it came before the sequence starts. Adding 7 four times instead of subtracting, 60 + 7 × 4 = 88, uses the wrong operation. Stopping one term early gives the 4th term, 39.
Build your own mix at the worksheet builder.