Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- 1.The perimeter of a rectangle is given by the formula P = 2(l + w), where l is the length and w is the width. A rectangular garden has a perimeter of 46 m and a length of 14 m. Rearrange the formula to make w the subject, then work out the width of the garden.
- 2.A speed-time graph for a car shows the speed increasing steadily from 5 m/s to 17 m/s over 6 seconds. Work out the acceleration of the car, in m/s².
- 3.Solve (3x + 2)/5 = (x + 4)/3
- 4.A Fibonacci-type sequence is defined by aₙ = aₙ₋₁ + aₙ₋₂ for n ≥ 3. Given that a₁ = 5 and a₃ = 17, work out a₂.
- 5.The 2nd term of a geometric sequence is 6 and the 4th term is 24. Given that all the terms of the sequence are positive, work out the common ratio.
- 6.The graph of y = x² − 2x − 8 takes these values: when x = −2, y = 0; when x = −1, y = −5; when x = 0, y = −8; when x = 3, y = −5; when x = 4, y = 0. Use these values to write down the two solutions of x² − 2x − 8 = 0.y = x² − 2x − 8
- 7.By completing the square, find the turning point of the curve y = 3x² + 12x + 7.y = 3x² + 12x + 7
- 8.A walker's distance-time graph is described as follows: she walks 3 km in the first 15 minutes at a steady speed, rests for 10 minutes, then walks a further 3 km in the next 20 minutes, also at a steady speed. Work out her speed, in km/h, during the first 15 minutes.
- 9.Simplify 5a/6 − a/3
- 10.Write down the gradient of the line with equation y = −x + 3.y = −x + 3
- 11.A sequence begins at 50, and each term after that is found by subtracting 8 from the term before it. Priya says the 8th term of the sequence is negative. Is Priya correct?
- 12.A circle has centre (0, 0) and equation x² + y² = 50. Work out the length of the diameter of the circle, correct to 1 decimal place.
- 13.The nth term of a sequence is 2n² + 1. Work out the 4th term of the sequence.
- 14.A ball is thrown in the air. Its height, h metres, above the ground after t seconds is given in this table: when t = 0, h = 0; when t = 1, h = 15; when t = 2, h = 20; when t = 3, h = 15; when t = 4, h = 0. Use the table to find the two times, in seconds, at which the ball is at ground level.
- 15.f(x) = (x + 1)/2. Find f⁻¹(x).
Answer key
- (a) 9 m — Undo the multiplication by the bracket first: dividing both sides by 2 gives P/2 = l + w. Subtracting the length from both sides gives w = P/2 − l. Substituting the measurements, 46 ÷ 2 = 23, and 23 − 14 = 9, so the width is 9 m. Taking the length off before halving gives (46 − 14) ÷ 2 = 16, which halves the length as well; expanding to P = 2l + 2w and then forgetting to divide by 2 gives 46 − 28 = 18; subtracting the length in the wrong direction gives 23 + 14 = 37.
- (a) 2 m/s² — Method: acceleration = change in speed ÷ time = (17 − 5) ÷ 6 = 12 ÷ 6 = 2 m/s². Distractor origins: 12 m/s² stops after finding the change in speed and forgets to divide by the time; 22 m/s² adds the two speeds instead of subtracting them, and also forgets to divide by time (5 + 17 = 22); 72 m/s² multiplies the change in speed by the time instead of dividing (12 × 6 = 72).
- (a) x = 3.5 — Method: clear the fractions by multiplying both sides by 15, expand both brackets, then collect the x terms on one side and the numbers on the other. Working: multiplying both sides by 15 gives 3(3x + 2) = 5(x + 4), which expands to 9x + 6 = 5x + 20; subtracting 5x and 6 from both sides gives 4x = 14, and dividing both sides by 4 gives x = 3.5. Answer: x = 3.5. The distractors: x = 1 comes from collecting the x terms by adding the 5x instead of subtracting it, giving 9x + 5x = 20 − 6 and so 14x = 14; x = 4.5 comes from expanding 3(3x + 2) as 9x + 2, multiplying only the x term by the 3, which leads to 4x = 18; x = 10 comes from reaching 4x = 14 correctly and then subtracting 4 instead of dividing by 4.
- (d) 12 — Since a₃ = a₂ + a₁, rearranging gives a₂ = a₃ − a₁ = 17 − 5 = 12. 22 comes from adding instead of subtracting: a₃ + a₁ = 17 + 5 = 22. 11 comes from treating the sequence as if it were arithmetic and averaging the two given terms: (5 + 17) ÷ 2 = 11 — but a Fibonacci-type sequence isn't arithmetic, so this doesn't apply. −12 comes from subtracting in the wrong order: a₁ − a₃ = 5 − 17 = −12.
- (c) 2 — For a geometric sequence, a₄ = a₂ × r². So r² = a₄ ÷ a₂ = 24 ÷ 6 = 4, giving r = 2 or r = −2. Since all the terms are positive, r = 2. 4 comes from computing a₄ ÷ a₂ = 4 and stopping there, without taking the square root to find r. 18 comes from subtracting instead of dividing: a₄ − a₂ = 24 − 6 = 18, taken directly as the common ratio. −2 is the other square root of 4, but it is rejected because all the sequence's terms are given as positive.
- (c) x = −2 or x = 4 — The solutions of x² − 2x − 8 = 0 are the x-values where y = 0. From the table, y = 0 when x = −2 and when x = 4, so those are the two solutions. Distractor origins: x = −1 or x = 3 picks the pair of x-values that give equal (but non-zero) y-values instead of y = 0; x = 0 or x = −8 mixes up an x-value with its corresponding y-value; x = −2 only reads off one of the two roots and misses the other.
- (d) x = −2, y = −5 — 3x² + 12x + 7 rewrites as 3(x² + 4x) + 7, then as 3[(x + 2)² − 4] + 7, which simplifies to 3(x + 2)² − 5, since −3 × 4 + 7 = −5. Substituting x = −2: 3 × (−2)² = 12, 12 × (−2) = −24, so 12 − 24 + 7 = −5, confirming the minimum value −5 at x = −2: turning point x = −2, y = −5. Halving b instead of halving b/a — using −4 as the shift instead of −2 — lands on turning point x = −4, y = −41, which is wrong because when a ≠ 1 the shift inside the bracket is b/(2a), not b/a alone. Reading the bracket's sign directly as the turning point's x-coordinate gives x = 2, y = −5 — wrong, because (x + 2)² is zero at x = −2, not x = 2. Computing 12 − 7 = 5 instead of 7 − 12 = −5 flips the sign of the constant, giving x = −2, y = 5 — wrong, since the completed square's constant must be evaluated as 7 minus 12, not 12 minus 7. Whenever a ≠ 1, factor a out of the x² and x terms first, and always check a turning point by substituting back into the original equation.
- (a) 12 km/h — Method: convert 15 minutes to hours: 15 ÷ 60 = 0.25 h. Speed = distance ÷ time = 3 ÷ 0.25 = 12 km/h. Distractor origins: 9 km/h is the speed for the second section (3 km in 20 minutes) instead of the first; 8 km/h is the average speed for the whole journey (6 km in 45 minutes) instead of just the first section; 0.2 km/h divides 3 km by 15 without converting the minutes into hours.
- (d) a/2 — Method: write both terms over the same denominator, subtract the numerators, then cancel the fraction down. Working: 6 is a multiple of 3, so a/3 is rewritten as 2a/6; the calculation becomes 5a/6 − 2a/6 = 3a/6, and dividing numerator and denominator by 3 gives a/2. Answer: a/2. The distractors: 4a/3 comes from subtracting the denominators as well as the numerators, giving (5 − 1)a over (6 − 3); 2a/3 comes from subtracting 1 from 5 without first rewriting a/3 as 2a/6, giving 4a/6; 7a/6 comes from adding the two fractions instead of subtracting them, giving 5a/6 + 2a/6.
- (b) −1 — Method: in the form y = mx + c the gradient m is the number multiplying x, and an x term written with no number in front of it has a coefficient of 1. Working: y = −x + 3 is the same equation as y = (−1)x + 3, so comparing it with y = mx + c gives m = −1 and c = 3. Answer: −1. The distractors: 1 comes from taking the coefficient as 1 and leaving the minus sign out of the answer; 3 comes from reading the constant as the gradient, confusing m with c; −3 comes from moving the minus sign across to the constant term and then reading the gradient off that term instead of the x term.
- (d) Yes: the 8th term is 50 − 8 × 7 = −6, which is negative. — Method: find the 8th term by subtracting 8 a total of 7 times from the first term, since the 1st term itself needs 0 subtractions. Working: 8th term = 50 − 8 × 7 = 50 − 56 = −6, which is negative, so Priya is correct. Answer: Yes, the 8th term is 50 − 8 × 7 = −6, which is negative. The "50 − 8 × 6 = 2" option subtracts 8 only six times instead of seven, an off-by-one error in counting the steps. The "50 − 8 × 8 = −14" option subtracts 8 eight times instead of seven, the opposite off-by-one error. The claim that repeated subtraction "can never go negative" ignores that subtracting enough times from any starting value eventually gives a negative result.
- (c) 14.1 — Method: in x² + y² = r² the right-hand side is the square of the radius, so take its square root to find the radius, then double the radius because the diameter is twice the radius. Working: r² = 50, so r = √50 = 7.07106…, and the diameter is 2 × 7.07106… = 14.14213…, which is 14.1 correct to 1 decimal place. Answer: 14.1. The distractors: 7.1 is the radius, worked out correctly but never doubled, so it answers a question about the radius rather than the diameter; 100.0 comes from doubling the 50 on the right-hand side, treating r² as though it were already the radius; 25.0 comes from halving the 50, treating r² as though it were already the diameter.
- (a) 33 — Substitute n=4 into 2n²+1: 2×4²+1=2×16+1=33. A candidate who computes n² as 2×n instead of n×n would compute 2×(2×4)+1=2×8+1=17. A candidate who correctly finds 2×16 but forgets to add the constant 1 would stop at 32. A candidate who squares the whole term 2n, rather than squaring n before multiplying by 2, would compute (2×4)²+1=64+1=65.
- (a) t = 0 or t = 4 — The ball is at ground level exactly when h = 0. From the table, h = 0 at t = 0 and at t = 4, so those are the two times. Distractor origins: t = 1 or t = 3 picks the times with equal (but non-zero) height instead of ground level; t = 2 picks the time of maximum height instead of ground level; t = 0 finds only the starting time and misses the second one.
- (a) 2x − 1 — Swap x and y: x = (y + 1)/2. Multiply both sides by 2: 2x = y + 1. Subtract 1 from both sides: y = 2x − 1, so f⁻¹(x) = 2x − 1. Writing 2x + 1 comes from not flipping the sign on the 1 when it is moved across the equals sign. Writing (x − 1)/2 comes from reversing the sign of the 1 but leaving the ÷2 from the original rule in place, instead of turning it into ×2. Writing x/2 − 1 comes from dividing only the x by 2 and treating the 1 as already outside the fraction.
Build your own mix at the worksheet builder.