Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- 1.Which of these equations represents the graph of y = 2ˣ translated by 3 units in the positive y-direction?
- 2.A company's weekly profit, P thousand pounds, when it makes x thousand items is modelled by P = x² − 8x + 12, for x ≥ 0. Work out the values of x for which the company makes a loss.
- 3.A rectangular photo has length (x + 3) cm and width x cm. Its area is 40 cm². Work out the value of x.
- 4.A square tile has an area of 144 cm². Work out the side length of the tile.
- 5.Work out the period of the graph of y = cos x, in degrees.y = cos(x)
- 6.Solve 5x² − 15x = 0.
- 7.Make x the subject of the formula y = 4x − 3.y = 4x − 3
- 8.A plumber charges a call-out fee plus an hourly rate for a job. The total cost, £C, for a job lasting h hours is given by the formula C = 40 + 25h. What does the number 40 represent in this formula?
- 9.The first four terms of a sequence are 6, 13, 20, 27. Work out an expression, in terms of n, for the nth term.
- 10.Factorise 3x² + 10x − 8.
- 11.A candle is 30 cm tall when lit and burns at a constant rate. After burning for 5 minutes, its height is 20 cm. The height h cm after t minutes is given by h = 30 − mt. Work out the value of m.
- 12.Make x the subject of the formula y = 3(x + 2).
- 13.A water butt holds 200 litres and is being drained at a steady 8 litres per minute. Write down the function for the amount of water y, in litres, left after x minutes.
- 14.A geometric sequence has first term 3 and common ratio √3. Work out the position of the first term of the sequence that exceeds 30.
- 15.Point R has coordinates (3, −5). Point R is reflected in the line y = 2 to point S. Write down the coordinates of S.
Answer key
- (a) y = 2ˣ + 3 — A translation of 3 units in the positive y-direction shifts the whole graph up, which means adding to the output: y = f(x) + k with k = 3, so the image is y = 2ˣ + 3. Adding the 3 inside the power instead of outside it, which translates the graph horizontally instead of vertically, gives y = 2ˣ⁺³. Using a negative 3, which moves the graph down instead of up, gives y = 2ˣ − 3. Mistaking 2ˣ for the linear expression 2x and adding 3 inside brackets gives y = 2(x + 3).
- (b) 2 < x < 6 — Factorise: x² − 8x + 12 = (x − 2)(x − 6), giving roots at x = 2 and x = 6. Since the coefficient of x² is positive, the graph is a U-shape that is negative, below the axis, between its roots. So P < 0 for 2 < x < 6. Distractor routes: x < 2 or x > 6 takes the region outside the roots, which is where P is positive, a profit, the opposite of a loss. 2 ≤ x ≤ 6 includes the endpoints, where P = 0 exactly, break-even rather than a loss, since the inequality is strict. −6 < x < −2 comes from factorising as (x + 2)(x + 6), reversing the sign of both roots.
- (b) x = 5 — Area = length × width, so x(x + 3) = 40, which rearranges to x² + 3x − 40 = 0. This factorises as (x + 8)(x − 5) = 0: the two numbers in the brackets must multiply to −40 and add to +3, and the pair 8 and −5 does both. This gives x = −8 or x = 5. Since x is a length, it cannot be negative, so x = 5. A candidate who gives both solutions without rejecting the negative one, which cannot be a length, answers x = 5 or x = −8. A candidate who picks the wrong factor pair of 40, such as 10 and −4 instead of 8 and −5, gets (x + 10)(x − 4) = 0 and answers x = 4. A candidate who rejects the wrong root, keeping the negative solution instead of the positive one, answers x = −8.
- (c) 12 cm — For a square, area = side². So side² = 144, giving side = ±12. Since a length must be positive, the side length is 12 cm. A candidate who gives both square roots without rejecting the negative one, which cannot be a length, answers 12 cm or −12 cm. A candidate who halves 144 instead of taking its square root gets 72 cm. A candidate who divides 144 by 4, confusing the area formula with a perimeter calculation, gets 36 cm.
- (c) 360° — The graph of y = cos x repeats itself every 360°, so its period is 360°. 180° is the period of y = tan x, not y = cos x — confusing the two graphs gives this. 90° is the horizontal distance from a maximum of y = cos x to the next point where the graph crosses the x-axis, a quarter of the period, mistaken for the whole period. 720° comes from counting the interval containing two full repeats of the graph, from one maximum to the second repeat of that maximum, instead of the first.
- (c) x = 0 or x = 3 — Method: take out the common factor 5x: 5x(x − 3) = 0, so 5x = 0 or x − 3 = 0, giving x = 0 or x = 3. Distractor origins: x = 0 or x = 15 comes from forgetting to divide the second term by the common factor 5x correctly, leaving 15 instead of 3; x = 3 loses the solution x = 0 by dividing both sides by x; x = 5 or x = 3 mistakes the coefficient 5 itself for one of the solutions.
- (d) x = (y + 3)/4 — Two operations have been applied to x: it has been multiplied by 4 and then 3 has been subtracted. Undo them in the opposite order. Adding 3 to both sides gives y + 3 = 4x. Dividing both sides by 4 then gives (y + 3)/4 = x, so x = (y + 3)/4. The bracket matters: writing y/4 + 3 divides only the y by 4 and leaves the 3 untouched. Writing (y − 3)/4 subtracts the 3 instead of adding it, and writing 4(y + 3) multiplies by 4 rather than dividing.
- (d) The fixed call-out fee, charged before the hourly rate. — Method: compare the formula with C = (fixed charge) + (rate) × h, where the fixed charge is the part that does not depend on h. Working: in C = 40 + 25h, the term 25h depends on the number of hours, h, but 40 does not change however many hours the job takes. Answer: 40 is the fixed call-out fee. 'The hourly rate' confuses the fixed term with the coefficient of h, which is actually 25. 'The total cost for a job lasting 1 hour' comes from substituting h = 1 into the formula (40 + 25 = 65) rather than reading off the constant term. 'The number of hours worked before charging starts' wrongly treats the constant, which is in pounds, as if it were measured in hours.
- (c) 7n − 1 — Method: find the common difference, then find the constant that fits the first term. Working: 13 − 6 = 7, 20 − 13 = 7, 27 − 20 = 7, so the terms increase by 7 each time and the nth term has the form 7n + c. Substituting n = 1: 7(1) + c = 6, so c = −1. Answer: the nth term is 7n − 1. The value 7n comes from leaving out the constant altogether. The value 7n + 6 comes from using the first term as the constant directly, without subtracting the common difference first. The value 6n + 1 comes from using the first term, 6, as the coefficient of n instead of the common difference, and then attaching +1 with the sign of the constant flipped.
- (d) (3x − 2)(x + 4) — For 3x² + 10x − 8, find two numbers multiplying to 3 × (−8) = −24 and adding to 10: these are 12 and −2. Rewrite: 3x² + 12x − 2x − 8 = 3x(x + 4) − 2(x + 4) = (3x − 2)(x + 4). Choosing (3x + 2)(x − 4) expands to 3x² − 10x − 8 — the correct factor pair but the wrong signs, giving the middle term the wrong sign. Choosing (x − 2)(3x + 4) expands to 3x² − 2x − 8 — the 3 is attached to the wrong bracket, changing which terms combine for the x-coefficient. Choosing (3x − 4)(x + 2) expands to 3x² + 2x − 8 — this uses 4 and 2 instead of the correct pair 12 and 2, so the middle term does not come to 10x.
- (a) 2 — The candle's height falls from 30 cm to 20 cm, a drop of 10 cm, over 5 minutes, so m = 10 ÷ 5 = 2. 10 comes from using the drop in height but forgetting to divide by the time. 0.5 comes from dividing the time by the drop instead of the drop by the time (5 ÷ 10). 4 comes from dividing the final height by the time, 20 ÷ 5, instead of using the drop in height.
- (b) x = y/3 − 2 — The bracket containing x has been multiplied by 3, so divide both sides by 3 first, which gives y/3 = x + 2. Subtracting 2 from both sides then leaves y/3 − 2 = x, so x = y/3 − 2. Taking the 2 away before dividing gives (y − 2)/3, which divides the 2 by 3 as well, although the 2 was never divided in the original formula. Adding 2 rather than subtracting it gives y/3 + 2, and multiplying by 3 instead of dividing gives 3y − 2.
- (c) y = 200 − 8x — Method: in a linear model the amount present at the start is the constant term and the steady rate of change is the gradient, which is negative because the amount is falling. Working: at x = 0 minutes there are 200 litres, so the constant term is 200; 8 litres are lost every minute, so after x minutes 8x litres have gone and the amount left is y = 200 − 8x. Answer: y = 200 − 8x. The distractors: y = 8x + 200 treats the draining as filling, so the butt would gain 8 litres a minute; y = 200x − 8 swaps the two numbers over, using the starting 200 litres as the rate per minute and the 8 litres per minute as the starting amount; y = −8x − 200 makes the starting amount negative as well as the rate, so the butt would begin 200 litres in deficit.
- (d) 6th term — The terms are aₙ = 3 × (√3)ⁿ⁻¹: a₁ = 3, a₂ = 3√3 ≈ 5.196, a₃ = 9, a₄ = 9√3 ≈ 15.588, a₅ = 27, a₆ = 27√3 ≈ 46.765. Since a₅ = 27 is still below 30 and a₆ ≈ 46.8 is above 30, the 6th term is the first to exceed 30. 4th term comes from treating the common ratio as 3 instead of √3: 3, 9, 27, 81, … — under that wrong ratio, 81, the 4th term, is the first over 30. 5th term comes from misjudging a₅ = 27 as already greater than 30. 7th term comes from tracking only the whole-number terms (3, 9, 27, 81, …) and reporting the ORIGINAL position of 81 in the full sequence — 81 is indeed a₇, but a₆ ≈ 46.8 already exceeds 30 first.
- (c) (3, 9) — Reflecting in the horizontal line y = 2 keeps the x-coordinate the same and maps y to 2 × 2 − y = 4 − (−5) = 9, so S = (3, 9). A candidate who uses k − y instead of 2k − y gets 2 − (−5) = 7, giving (3, 7). A candidate who reflects in the x-axis instead of the line y = 2, simply changing the sign of y, gets (3, 5). A candidate who also changes the sign of the x-coordinate, as if reflecting in both axes, gets (−3, 9).
Build your own mix at the worksheet builder.