Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (c) y = 200 − 8x — Method: in a linear model the amount present at the start is the constant term and the steady rate of change is the gradient, which is negative because the amount is falling. Working: at x = 0 minutes there are 200 litres, so the constant term is 200; 8 litres are lost every minute, so after x minutes 8x litres have gone and the amount left is y = 200 − 8x. Answer: y = 200 − 8x. The distractors: y = 8x + 200 treats the draining as filling, so the butt would gain 8 litres a minute; y = 200x − 8 swaps the two numbers over, using the starting 200 litres as the rate per minute and the 8 litres per minute as the starting amount; y = −8x − 200 makes the starting amount negative as well as the rate, so the butt would begin 200 litres in deficit.
- (b) 6 — Reflecting y = f(x) in the x-axis turns the minimum point (2, −3) into a maximum point at (2, 3), since −f(x) negates every y-value: −(−3) = 3. Adding a then gives 3 + a = 9, so a = 9 − 3 = 6. Forgetting the reflection and using the original y-value of −3 gives −3 + a = 9, so a = 12 — this ignores that −f(x) changes the sign of the y-coordinate before a is added. Writing a = −12 comes from subtracting in the wrong order, working out 9 − (−3) as −3 − 9 instead. Writing a = −6 comes from taking the negative of the correct answer, as if the final value of a needed to be reflected too, on top of the turning point.
- (d) x = 3 — The table is symmetrical about the turning point: y = 0 at both x = 1 and x = 5, and the lowest value, y = −4, occurs exactly halfway between them, at x = 3. Choosing x = 5 picks one of the roots rather than the midpoint between them. Choosing x = 1 picks the other root for the same reason. Choosing x = 6 picks the x-value where y returns to its starting value of 5, which is not the turning point.
- (a) (3, 7) — y = f(x) + 5 is a vertical translation of y = f(x) by 5 units up — the translation vector is (0, 5) — so only the y-coordinate of any point changes. Turning point (3, 2) → (3, 2 + 5) = (3, 7). Adding the 5 to the x-coordinate, or treating it as a horizontal shift like y = f(x + 5), moves the wrong coordinate — check first whether the number sits inside or outside the brackets.
- (d) x = 4 and x = −4 — Substituting y = 3 gives x² + 9 = 25, which simplifies to x² = 16, so x = 4 or x = −4. Choosing 'x = 3 and x = −3' uses the given value y = 3 as if it were the x-coordinate. Choosing 'x = 4' alone finds the positive square root of 16 but forgets the negative root. Choosing 'x = 5 and x = −5' skips subtracting 3² = 9 from 25 and takes the square root of 25 directly.
- (b) x = (y − 3)/5 — To make x the subject of y = 5x + 3, first subtract 3 from both sides to get y − 3 = 5x, then divide both sides by 5: x = (y − 3)/5. Writing x = (y + 3)/5 keeps the division correct but does not change the sign of the 3 when moving it across. Writing x = y/5 − 3 divides only the y term by 5 and leaves the 3 as a separate subtraction, instead of subtracting first and dividing the whole expression. Writing x = 5(y − 3) applies the correct order of subtracting 3 first, but then multiplies by 5 instead of dividing — the inverse of 5x is division, not multiplication. The correct rearrangement is x = (y − 3)/5.
- (b) 4 — Adding the two equations: the y-terms, −2y and +2y, cancel, and the x-terms combine to 5x + 3x = 8x; the right-hand sides add to 16 + 16 = 32. This gives 8x = 32, so x = 4. A candidate who adds only one of the right-hand sides, instead of both, would get 8x = 16, so x = 2. A candidate who divides 32 by 4 instead of 8 would get x = 8. A candidate who subtracts the equations instead of adding them, getting 2x − 4y = 0, and then wrongly assumes y = 0, would get x = 0.
- (b) y decreases towards zero but never reaches it — Method: as x gets larger, dividing 20 by a bigger number gives a smaller result, so y decreases; because 20/x can never be exactly zero for any positive x, the curve gets closer to zero without ever reaching it, so y decreases towards zero but never reaches it. Distractor origins: 'y increases towards a limit but never reaches it' has the relationship backwards, treating y as increasing when it is actually decreasing; 'y decreases at a steady rate and reaches zero' wrongly assumes the graph behaves like a straight line that eventually hits zero; 'y stays the same however large x becomes' wrongly assumes there is no change in y at all.
- (a) 52 — Test successive terms: n=6 gives 6²+3=39, which is not greater than 50. n=7 gives 7²+3=52, which is greater than 50, so the first term greater than 50 is 52. A candidate who stops at n=6, before checking whether 39 actually exceeds 50, would give 39. A candidate who solves n²>50 instead of n²+3>50, ignoring the +3 in the search, would find n=8 is the first value with n²>50 (since 7²=49) and compute 8²+3=67. A candidate who computes n² by doubling n instead of squaring it would compute 2×7+3=17.
- (b) y ≥ 2, y ≤ x, x ≤ 6 — "On or above the line y = 2" means y ≥ 2. "On or below the line y = x" means y ≤ x. "On or to the left of the line x = 6" means x ≤ 6. Together these give y ≥ 2, y ≤ x, x ≤ 6. Distractor routes: y ≤ 2, y ≤ x, x ≤ 6 flips the first inequality, describing "on or below" y = 2 instead of "on or above". y ≥ 2, y ≥ x, x ≤ 6 flips the second, describing "on or above" y = x instead of "on or below". y ≥ 2, y ≤ x, x ≥ 6 flips the third, describing "on or to the right of" x = 6 instead of "on or to the left".
- (a) (2n + 1) + (2n + 3) = 4n + 4 = 4(n + 1) — Two consecutive odd numbers can be written as 2n + 1 and 2n + 3, for a whole number n. Adding them: (2n + 1) + (2n + 3) = 4n + 4 = 4(n + 1), which is a multiple of 4 for every whole number n, proving the general result. Using 2n + 1 twice does not represent two different numbers, so it proves nothing about a sum of two numbers; writing n + (n + 2) drops the +1 that makes the numbers odd in the first place, and only shows a multiple of 2; and check every constant term is added correctly — 1 + 3 is 4, not 3.
- (d) x = 6 — Method: with an unknown on both sides, first collect the x terms on one side by subtracting the smaller x term from both sides, then deal with the numbers. Working: subtracting x from both sides gives x + 7 = 13, and subtracting 7 from both sides gives x = 6. Answer: x = 6. The distractors: x = 20 comes from adding 7 to 13 instead of subtracting it once the x terms have been collected; x = 2 comes from collecting the x terms by adding them, giving 3x + 7 = 13 and then 3x = 6; x = −6 comes from subtracting 2x from both sides to get 7 = −x + 13, reaching −6 = −x and then copying the sign straight across instead of dividing by −1.
- (d) 47 — To reach the 8th term from the 1st term, the difference of 6 is added 7 times (8 − 1 = 7): 5 + 7 × 6 = 47. A candidate who multiplies by the term number itself, rather than one less, would compute 5 + 8 × 6 = 53. A candidate who uses one step too few (6 instead of 7) would reach 5 + 6 × 6 = 41. A candidate who forgets to include the first term at all would compute just 8 × 6 = 48.
- (a) 25 — Gradient = change in y ÷ change in x = (100 − 0) ÷ (4 − 0) = 100 ÷ 4 = 25. Dividing time by distance instead of distance by time gives 0.04; multiplying the two values instead of dividing gives 400; stopping at the change in distance, 100, forgets to divide by the change in time.
- (d) $y = x^2 - 2x - 3$ — Method: read the two x-intercepts (roots) from the graph, write the quadratic as the product of the corresponding factors, then expand. Working: the curve crosses the x-axis at x = −1 and x = 3, so the equation factorises as (x + 1)(x − 3), which expands to x² − 2x − 3. Answer: y = x² − 2x − 3. Distractor refutation: y = x² − x − 6 comes from misreading the left-hand crossing point as x = −2 instead of x = −1, giving factors (x + 2)(x − 3). y = x² − x − 2 comes from misreading the right-hand crossing point as x = 2 instead of x = 3, giving factors (x + 1)(x − 2). y = x² + 2x − 3 comes from writing the factors as (x − 1)(x + 3), swapping which root gets the plus sign and which gets the minus sign, giving the wrong sign on the x term.
Build your own mix at the worksheet builder.