Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (d) a/2 — Method: write both terms over the same denominator, subtract the numerators, then cancel the fraction down. Working: 6 is a multiple of 3, so a/3 is rewritten as 2a/6; the calculation becomes 5a/6 − 2a/6 = 3a/6, and dividing numerator and denominator by 3 gives a/2. Answer: a/2. The distractors: 4a/3 comes from subtracting the denominators as well as the numerators, giving (5 − 1)a over (6 − 3); 2a/3 comes from subtracting 1 from 5 without first rewriting a/3 as 2a/6, giving 4a/6; 7a/6 comes from adding the two fractions instead of subtracting them, giving 5a/6 + 2a/6.
- (d) 50/3 — Method: call the smaller number x, write the larger number in terms of x and use the total. Working: the larger number is 2x, so x + 2x = 50, that is 3x = 50 and x = 50/3. Answer: 50/3, since 50/3 added to 100/3 makes 50 and 100/3 is twice 50/3. The distractors: 100/3 is the larger of the two numbers rather than the smaller one asked for; 25 comes from halving 50 and treating the two numbers as equal; 24 comes from reading 'twice the smaller number' as 'two more than the smaller number' and solving x + (x + 2) = 50.
- (b) xₙ₊₁ = (xₙ² + 3) ÷ 5 — Starting from x² = 5x − 3, add 3 to both sides: x² + 3 = 5x. Divide both sides by 5: x = (x² + 3) ÷ 5. Writing this as an iteration gives xₙ₊₁ = (xₙ² + 3) ÷ 5. xₙ₊₁ = (xₙ² − 3) ÷ 5 comes from a sign error when moving the −3 across the equals sign — it should become +3, not stay as −3. xₙ₊₁ = 5(xₙ² + 3) comes from multiplying by 5 instead of dividing by 5 when isolating x. xₙ₊₁ = (xₙ + 3) ÷ 5 comes from dropping the index on x², using xₙ instead of xₙ².
- (c) 4 — x² + 12x + 40 = (x + 6)² − 6² + 40 = (x + 6)² + 4, so a = 6 and b = 4. Since (x + 6)² can never be negative, y = (x + 6)² + 4 is smallest when the bracket is zero, so the minimum value of y is 4. Giving 40 instead reads off the ORIGINAL constant term and ignores the completing-the-square step entirely — wrong, because 40 is the value of y when x = 0, not the minimum value. Giving −6 instead answers with the x-coordinate of the turning point (where the bracket is zero) rather than the minimum y-value itself — wrong, because the question asks for the minimum value of y, not the value of x that produces it. Giving 36 instead stops after squaring half the coefficient, 6² = 36, without combining it with the 40 already in the expression — wrong, because the minimum value is 40 minus 36, not 36 on its own.
- (d) 10 — The right angle is at (1, 1). The vertical side has length 5 − 1 = 4 and the horizontal side has length 6 − 1 = 5, so the area is (4 × 5) ÷ 2 = 20 ÷ 2 = 10. A candidate who forgets to halve the product of the two sides gets 4 × 5 = 20. A candidate who forgets to subtract the shared vertex's coordinate and uses the raw coordinates 6 and 5 as the side lengths gets (6 × 5) ÷ 2 = 30 ÷ 2 = 15. A candidate who uses only one side length as the area gets 5.
- (a) 7 — Subtract 4 from both sides: 3h ≤ 21. Divide both sides by 3: h ≤ 7, so the greatest whole number of hours is 7. A candidate who forgets the £4 fixed fee solves 3h ≤ 25, getting h ≤ 8.33, rounded down to 8. A candidate who adds the £4 instead of subtracting it solves 3h ≤ 29, getting h ≤ 9.67, rounded down to 9. A candidate who reaches h ≤ 7 but wrongly assumes the boundary value cannot be used, thinking that spending the whole £25 is not allowed, answers 6.
- (a) Positive x-direction, 90°; image is y = sin x. — Writing cos(x − 90°) as cos(x − a) with a = 90 shows this is a horizontal translation, y = f(x − a), which moves the graph 90° in the positive x-direction; the identity cos(x − 90°) = sin x confirms the image is y = sin x. Choosing the negative x-direction reverses the sign inside the bracket — subtracting inside the bracket always translates in the positive x-direction, not the negative one, so that statement is wrong on direction. Getting the direction right but conflating the subtraction inside the bracket with an extra reflection of the output flips the sign of the resulting graph, wrongly giving y = −sin x. Treating the subtraction as if it changed the output directly, rather than the input, wrongly calls this a vertical translation even while still correctly recalling that the image simplifies to y = sin x.
- (b) 4 — Method: form the equation 30 + 25h = 130, where h is the number of hours, then solve for h. Working: subtract the call-out fee from the total bill: 25h = 130 − 30 = 100. Divide by the hourly rate: h = 100 ÷ 25 = 4. Answer: 4 hours. 5.2 comes from dividing the whole bill by the hourly rate without subtracting the fixed fee first, 130 ÷ 25. 3.5 comes from swapping the fee and the rate, subtracting the rate from the bill and dividing by the fee, (130 − 25) ÷ 30. 6.4 comes from adding the call-out fee to the bill instead of subtracting it, before dividing by the rate, (130 + 30) ÷ 25.
- (d) Overestimate — the curve bends upward (convex). — The first differences of the speeds are 3, 5, 7 and 9, so the second differences are 2, 2 and 2 — constant and positive, which means the speed-time graph curves upwards (is convex). On a convex curve, each straight chord used by the trapezium rule lies above the curve, so the trapezium rule overestimates the true distance. 'Underestimate — the curve bends upward' states the same correct geometry but gets the conclusion backwards — a chord above the curve means too much area is counted, not too little. 'Overestimate — the speed values are increasing' uses the wrong evidence: increasing speed alone doesn't tell you whether the curve bends up or down, only the second differences do. 'Underestimate — second differences are constant' confuses a constant second difference with a steady rate of change in speed, which isn't what the second difference of a speed-time table measures.
- (d) It is n-shaped, since the x² coefficient is negative. — The coefficient of x² is −2, which is negative, so the quadratic curve opens downward — shaped like an n, with a maximum turning point. Saying it is U-shaped focuses only on x² being non-negative and ignores that the −2 in front of it flips the whole curve to open downward. Saying it is a straight line confuses having a constant term with being linear — any equation with an x² term is a curve, not a line. Saying it repeatedly rises and falls like a wave describes a trigonometric graph such as y = sin x, not a quadratic.
- (c) −2 — Method: rearrange the equation into the form y = mx + c, then read off the gradient. Working: 3y = 12 − 6x, so dividing every term by 3 gives y = 4 − 2x, so the gradient is −2. Answer: the gradient is −2. 2 comes from dropping the negative sign after dividing by 3. 4 comes from using the y-intercept, 4, instead of the gradient. −6 comes from reading off the coefficient of x before dividing the whole equation by 3.
- (a) y = −2x + 7 — Using y = −2x + c, and substituting the point (3, 1): 1 = −2(3) + c, so 1 = −6 + c, and c = 7, giving y = −2x + 7. A candidate who uses the y-coordinate of the point directly as the y-intercept, instead of solving for c, would write y = −2x + 1. A candidate who drops the negative sign on the gradient would write y = 2x + 7. A candidate who makes a sign error when isolating c, writing c = 1 − 6 = −5 instead of c = 1 + 6 = 7, would write y = −2x − 5.
- (d) x = 3 or x = −3 — Method: get x² on its own with a coefficient of 1, then take the square root of both sides and keep both the positive and the negative root. Working: dividing 2x² = 18 by 2 gives x² = 9, and the square root of 9 is 3, so x = 3 or x = −3; both check, because 2 × 9 = 18 either way. Answer: x = 3 or x = −3. The distractors: x = 9 or x = −9 comes from dividing by 2 and then forgetting to take the square root; x = 4 or x = −4 comes from subtracting 2 from 18 instead of dividing by it, giving x² = 16; x = 6 or x = −6 comes from multiplying by 2 instead of dividing, giving x² = 36.
- (c) Wrong — the correct equation is x² − 5x + 4 = 0. — Rearranging x − 2 = x² − 4x + 2 by moving every term across: 0 = x² − 4x + 2 − x + 2 = x² − 5x + 4. The candidate's x-term is wrong: combining −4x with the moved −x gives −4x − x = −5x, not −3x. So the correct equation is x² − 5x + 4 = 0. Distractor routes: "x² − 3x + 4 = 0 is correct" simply agrees with the candidate's sign error without checking it. "It should be x² − 5x − 4 = 0" correctly spots that something is wrong but blames the wrong term — the constant, 2 + 2 = 4, is correct; the error is in the x-term. "Subtracting is the same as adding" states something false: subtracting a term and adding it give different signs.
- (d) 7 — Method: substitute both values, work out the two multiplications first, and only then subtract. Working: 3a = 3 × 5 = 15 and 2b = 2 × 4 = 8, so the expression becomes 15 − 8 = 7. Answer: 7. The distractors: 23 comes from adding the two products instead of subtracting, giving 15 + 8; −7 comes from subtracting the wrong way round and working out 8 − 15; 52 comes from working from left to right instead of following the order of operations, giving 3 × 5 = 15, then 15 − 2 = 13, then 13 × 4.
Build your own mix at the worksheet builder.