Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (a) 2/5 — Method: compare the equation with y = mx + c, where m is the gradient. Working: in y = (2x/5) − 3, the coefficient of x is 2/5. Answer: the gradient is 2/5. −3 comes from confusing the gradient with the y-intercept. 5/2 comes from inverting the fraction that multiplies x. −2/5 comes from wrongly carrying the negative sign from the −3 term onto the coefficient of x.
- (b) x = −3, y = −7 — x² + 6x + 2 = (x + 3)² − 3² + 2 = (x + 3)² − 7. Substituting x = −3: (−3)² = 9, 6 × (−3) = −18, so 9 − 18 + 2 = −7, confirming the minimum value −7 at x = −3: turning point (−3, −7). Using 6 instead of half of 6 inside the bracket gives (x + 6)² − 34, turning point (−6, −34) — wrong, because only half the coefficient of x belongs inside the bracket. Reading the bracket's sign directly as the turning point's x-coordinate gives (3, −7) — wrong, because (x + 3)² is zero at x = −3, not x = 3. Computing 9 − 2 = 7 instead of 2 − 9 = −7 flips the sign of the constant, giving (−3, 7) — wrong, since the completed square's constant must be evaluated as 2 minus 9, not 9 minus 2. Always check a turning point by substituting its x-value back into the original equation.
- (d) P lies outside the circle — The squared distance from the origin to P is 8² + 9² = 64 + 81 = 145, which is greater than 100, so P lies outside the circle. Choosing 'P lies inside the circle' comes from adding the coordinates directly (8 + 9 = 17) instead of squaring and adding them, and comparing 17 with 100. Choosing 'P lies on the circle' comes from squaring 9 incorrectly as 36 (as if it were 6²) instead of 81, giving 64 + 36 = 100, equal to the right-hand side. Choosing 'Cannot be determined' wrongly assumes the equation of the line itself is needed, when the radius and the distance from the origin to P are already enough.
- (d) 6th term — The terms are aₙ = 3 × (√3)ⁿ⁻¹: a₁ = 3, a₂ = 3√3 ≈ 5.196, a₃ = 9, a₄ = 9√3 ≈ 15.588, a₅ = 27, a₆ = 27√3 ≈ 46.765. Since a₅ = 27 is still below 30 and a₆ ≈ 46.8 is above 30, the 6th term is the first to exceed 30. 4th term comes from treating the common ratio as 3 instead of √3: 3, 9, 27, 81, … — under that wrong ratio, 81, the 4th term, is the first over 30. 5th term comes from misjudging a₅ = 27 as already greater than 30. 7th term comes from tracking only the whole-number terms (3, 9, 27, 81, …) and reporting the ORIGINAL position of 81 in the full sequence — 81 is indeed a₇, but a₆ ≈ 46.8 already exceeds 30 first.
- (d) n/2 + 5 — Half of n is n ÷ 2, which is written as the fraction n/2. 'More than' means add, and the addition happens after the halving, so the expression is n/2 + 5. Writing (n + 5)/2 halves the 5 as well, because everything inside a bracket is divided; writing 2n + 5 doubles n instead of halving it; writing 5n/2 multiplies half of n by 5 instead of adding 5 to it.
- (b) 19 — A line through (x₁, y₁) with gradient m has equation y − y₁ = m(x − x₁). Substituting (6, 1) and m = −3: y − 1 = −3(x − 6), so y = −3x + 18 + 1, which simplifies to y = −3x + 19; at x = 0 this gives 19. Making a sign error when distributing, writing −3(x − 6) as −3x − 18 instead of −3x + 18, gives the wrong line y = −3x − 17, so −17 at x = 0. Forgetting to add the y₁ = 1 at the end, using y = −3(x − 6) alone, gives 18 at x = 0. Substituting the y-coordinate into the gradient term instead of using x, working out 1 + (−3 × 1), gives −2.
- (a) (3, 7) — y = f(x) + 5 is a vertical translation of y = f(x) by 5 units up — the translation vector is (0, 5) — so only the y-coordinate of any point changes. Turning point (3, 2) → (3, 2 + 5) = (3, 7). Adding the 5 to the x-coordinate, or treating it as a horizontal shift like y = f(x + 5), moves the wrong coordinate — check first whether the number sits inside or outside the brackets.
- (a) 7 — Multiply the input by 2: 6 × 2 = 12. Then subtract 5: 12 − 5 = 7. A candidate who does the operations in the wrong order, subtracting 5 first and then multiplying by 2, gets (6 − 5) × 2 = 2. A candidate who only carries out the multiplication and forgets to subtract gets 12. A candidate who adds 5 instead of subtracting gets 6 × 2 + 5 = 17.
- (d) 12√2 — The nth term of a geometric sequence is a × rⁿ⁻¹. Here a = 3, r = √2, n = 6, so the 6th term is 3 × (√2)⁵. Since (√2)² = 2, (√2)⁴ = (2)² = 4, so (√2)⁵ = (√2)⁴ × √2 = 4√2. The 6th term is 3 × 4√2 = 12√2. 15√2 comes from treating (√2)⁵ as 5√2 — multiplying the index by the surd instead of raising √2 to that power — then multiplying by 3 gives 3 × 5√2 = 15√2, which is wrong because powers of a surd do not scale linearly with the index. 24√2 comes from miscalculating (√2)⁴ as 8 instead of 4 (a squaring slip, since (√2)² = 2 but (√2)⁴ should be 2² = 4, not 2 × 4), giving 3 × 8√2 = 24√2. 4√2 comes from forgetting to multiply by the first term a = 3, leaving just (√2)⁵ = 4√2.
- (c) y = 200 − 8x — Method: in a linear model the amount present at the start is the constant term and the steady rate of change is the gradient, which is negative because the amount is falling. Working: at x = 0 minutes there are 200 litres, so the constant term is 200; 8 litres are lost every minute, so after x minutes 8x litres have gone and the amount left is y = 200 − 8x. Answer: y = 200 − 8x. The distractors: y = 8x + 200 treats the draining as filling, so the butt would gain 8 litres a minute; y = 200x − 8 swaps the two numbers over, using the starting 200 litres as the rate per minute and the 8 litres per minute as the starting amount; y = −8x − 200 makes the starting amount negative as well as the rate, so the butt would begin 200 litres in deficit.
- (a) Outside: OQ² = 221 > r² = 169 — OQ² = 10² + 11² = 100 + 121 = 221. Comparing this with r² = 169: since 221 > 169, OQ > r, so Q lies outside the circle — this is the correct verdict AND the correct working. 'Outside: OQ = 21 (10 + 11) > r = 13' reaches the same Outside verdict, but by invalid working: it adds the coordinates instead of squaring them (10 + 11 = 21, rather than 10² + 11² = 221), so the stated 'OQ' of 21 is not a distance at all — the verdict happens to match, but the method is wrong. 'Inside: OQ ≈ 14.87 < r² = 169' correctly finds the distance OQ = √221 ≈ 14.87, but then compares that DISTANCE with r² = 169 instead of with r = 13 — comparing two different kinds of quantity gives a meaningless, and here wrong, verdict. 'Inside: OQ² = 221 < (2r)² = 676' confuses the radius with the diameter: it compares OQ² with the diameter squared, (2 × 13)² = 676, instead of with r² = 169.
- (c) n = 4 — Testing n = 4: 4² = 16, and 16 + 4 + 1 = 21, and 21 = 3 × 7 is not a prime number, so this value disproves the claim. Testing n = 1: 1² = 1, and 1 + 1 + 1 = 3, which is prime, so it does not disprove the claim. Testing n = 2: 2² = 4, and 4 + 2 + 1 = 7, which is prime. Testing n = 3: 3² = 9, and 9 + 3 + 1 = 13, which is also prime — a counterexample has to give a result that isn't prime, and only n = 4 does that.
- (a) 7n + 4 — Method: find the common difference, then find the constant that fits the first term. Working: 18 − 11 = 7, 25 − 18 = 7, 32 − 25 = 7, so the terms increase by 7 each time and the nth term has the form 7n + c. Substituting n = 1: 7(1) + c = 11, so c = 4. Answer: the correct nth term is 7n + 4. The value 7n is Ravi's value, which comes from using only the common difference and leaving out the constant. The value 7n + 11 comes from using the first term as the constant directly, without subtracting the common difference first. The value 11n + 7 comes from swapping the roles of the first term and the common difference — using the first term, 11, as the coefficient of n and the difference, 7, as the constant.
- (a) 4 — Rectangle 1: P = 2(9 + 4) = 2 × 13 = 26 cm. Rectangle 2: P = 2(6 + 5) = 2 × 11 = 22 cm. Difference = 26 − 22 = 4 cm. 2 comes from finding the difference between (l + w) for each rectangle, 13 − 11 = 2, but forgetting to double it. 26 comes from giving rectangle 1's whole perimeter instead of the difference between the two. 6 comes from doubling only the change in length, 2 × (9 − 6), and ignoring that the width also changed.
- (c) y = (5/12)x − 169/12 — The gradient of the radius to (5, −12) is (−12 − 0) ÷ (5 − 0) = −12/5. A tangent is perpendicular to the radius at that point, so its gradient is the negative reciprocal, 5/12. Using y − y₁ = m(x − x₁) with (5, −12): y + 12 = (5/12)(x − 5), which gives y = (5/12)x − 169/12. y = −(12/5)x comes from using the radius's own gradient, −12/5, instead of turning it into the perpendicular gradient, and building the line through the origin (as the radius itself does). y = −(5/12)x − 119/12 comes from taking the reciprocal of −12/5 correctly as a size but keeping the wrong sign, using −5/12 instead of 5/12. y = (5/12)x − 25/12 comes from using the correct gradient 5/12 but building the line through (5, 0) instead of (5, −12) — dropping the point's y-coordinate.
Build your own mix at the worksheet builder.