Printable · GCSE Higher · ages 14-16
Algebra worksheet — GCSE Higher
Fifteen questions across the algebra statements at Higher tier. Choose the non-calculator filter to rehearse Paper 1, which counts for a third of the marks.
Non-calculator
Answer key: Algebra worksheet — GCSE Higher
MathsUKwww.geekhero.co.uk
- (a) Subtracting 4x gives 3 = 10, which is never true. — Method: try to solve the equation as normal and see what happens. Working: subtract 4x from both sides: 4x + 3 − 4x = 4x + 10 − 4x, giving 3 = 10. This statement is false for every value of x, so the equation has no solution. Answer: subtracting 4x gives 3 = 10, which is never true. "x would have to be negative" invents a constraint on x that the equation never states. "It's true for every x" confuses this equation with an identity, where both sides would simplify to the same expression. "x = 7" misreads the false statement 3 = 10 as something to solve for x, rather than recognising it means no solution exists.
- (a) 3y² — 'y squared, multiplied by 3' means the square is applied to y only, and the result is then multiplied by 3, written as 3y². Writing y³ mistakes the multiplication by 3 for an extra factor of y, adding to the power instead of using a coefficient. Writing (3y)² squares the whole of 3y, including the 3, which gives 9y² rather than 3y² — the square should apply to y alone. Writing 3 + y² adds the 3 instead of multiplying by it. The expression for 'y squared, multiplied by 3' is 3y².
- (c) 4 — x² + 12x + 40 = (x + 6)² − 6² + 40 = (x + 6)² + 4, so a = 6 and b = 4. Since (x + 6)² can never be negative, y = (x + 6)² + 4 is smallest when the bracket is zero, so the minimum value of y is 4. Giving 40 instead reads off the ORIGINAL constant term and ignores the completing-the-square step entirely — wrong, because 40 is the value of y when x = 0, not the minimum value. Giving −6 instead answers with the x-coordinate of the turning point (where the bracket is zero) rather than the minimum y-value itself — wrong, because the question asks for the minimum value of y, not the value of x that produces it. Giving 36 instead stops after squaring half the coefficient, 6² = 36, without combining it with the 40 already in the expression — wrong, because the minimum value is 40 minus 36, not 36 on its own.
- (d) The cost increases by about £10 per extra item — Gradient = change in cost ÷ change in items = (800 − 400) ÷ (70 − 30) = 400 ÷ 40 = 10. The units of the gradient are £ per item, so the cost is increasing by about £10 for every extra item produced, near x = 50. Subtracting in the wrong order, (400 − 800) ÷ (70 − 30) = −10, gives the right size but the wrong sign — check which point comes first each time. Leaving out the division by 40 gives £400 per item; dividing the wrong way round, 40 ÷ 400 = 0.1, gives £0.10 per item.
- (c) −0.5 — fg(x) = f(g(x)) = f(x²) = x² + 2. gf(x) = g(f(x)) = g(x + 2) = (x + 2)² = x² + 4x + 4. Setting fg(x) = gf(x): x² + 2 = x² + 4x + 4. Subtract x² from both sides: 2 = 4x + 4. Subtract 4 from both sides: −2 = 4x, so x = −0.5. Writing 1.5 comes from adding the 4 instead of subtracting it: 4x = 2 + 4 = 6, giving x = 1.5. Writing 'no solution' comes from expanding (x + 2)² as x² + 4 using (a + b)² = a² + b², losing the middle term — the equation then reads x² + 2 = x² + 4, which has no solution, but the expansion itself is wrong. Writing 0 comes from treating gf(x) as g(x) + f(x) instead of g(f(x)): x² + (x + 2) = x² + 2 gives x = 0, but that adds the two functions rather than composing them.
- (d) (4, 8) — The other endpoint is found from 2 × midpoint − known endpoint: x = 2 × (−1) − (−6) = −2 + 6 = 4, y = 2 × 5 − 2 = 10 − 2 = 8, giving (4, 8). (−3.5, 3.5) comes from averaging the given endpoint and the midpoint as if they were the two endpoints of a segment, instead of working backwards from the midpoint. (5, 3) comes from working out (−1 − (−6), 5 − 2) instead of doubling the midpoint before subtracting. (4, 5) comes from correctly finding the x-coordinate but copying the midpoint's y-coordinate of 5 instead of doubling it.
- (b) 14 m/s — Average speed for a whole journey is total distance divided by total time: 350 ÷ 25 = 14 m/s. Multiplying the distance and time instead of dividing gives 350 × 25 = 8750 m/s. Adding the distance and time instead of dividing gives 350 + 25 = 375 m/s. Inverting the division, working out time divided by distance, gives 25 ÷ 350, which rounds to 0.07 m/s.
- (a) x = 3/2 or x = −3/2 — Method: the equation has an x² term and a number but no x term, so make x² the subject and then take the square root of both sides, keeping the negative root as well as the positive one. Working: adding 9 to both sides of 4x² − 9 = 0 gives 4x² = 9, and dividing both sides by 4 gives x² = 9/4. Square-rooting the top and the bottom of 9/4 gives 3/2, so x = 3/2 or x = −3/2, and each value checks out because 4 × 9/4 − 9 = 0. Answer: x = 3/2 or x = −3/2. The distractors: x = 3 or x = −3 comes from square-rooting both sides of 4x² = 9 without first dividing by the 4, so the coefficient of x² is ignored; x = 9/4 or x = −9/4 comes from stopping at x² = 9/4 and writing that value down as x, leaving the square root undone; x = 3/2 only comes from taking the positive square root of 9/4 and losing the negative solution.
- (d) g is one-to-one: f(3) = f(−3), removed by x ≥ 0 — A function has an inverse only if it is one-to-one: every output must come from exactly one input. f(3) = 9 and f(−3) = 9, so two different inputs give the same output, and there is no way to send 9 back to a single input — f is not one-to-one over all real x. Restricting the domain to x ≥ 0 removes one of the two inputs behind every such pair, so g is one-to-one and does have an inverse. 'g's outputs are positive; f's could be negative' is wrong because f(x) = x² also only gives outputs of 0 or more — the outputs of f and g are identical sets; it is the INPUTS that differ, not the outputs. 'Restricting any domain always creates an inverse' is wrong because a restriction only helps if it actually removes the repeated outputs: restricting f(x) = x² to x ≥ −3 still leaves f(1) = f(−1) = 1, so that restricted function is still not one-to-one and still has no inverse. 'Squares can never be reversed, under any conditions' is wrong because √9 = 3 does reverse 3² = 9 once you know the input was non-negative — a square root just cannot tell you WHICH of two inputs you started from unless the domain has already ruled one of them out.
- (d) y = (1/4)x + 3 — The given line has gradient −4, so the perpendicular gradient is the negative reciprocal, 1/4. Since (0, 3) is the y-intercept, the perpendicular line is y = (1/4)x + 3. Distractor routes: y = −4x + 3 uses the original line's own gradient instead of the perpendicular gradient, only changing the intercept for the new point. y = (−1/4)x + 3 takes the reciprocal of −4 but forgets to change its sign, so it is not the true negative reciprocal. y = 4x + 3 negates the gradient −4 but does not take its reciprocal, giving 4 instead of 1/4.
- (d) 5 — Each term is found by multiplying the previous term by the common ratio, 0.5: 80, 40, 20, 10, and the next term is 10 × 0.5 = 5. A candidate who instead subtracts the same amount each time (repeating the last difference of 10) would reach 10 − 10 = 0. A candidate who divides by 4 instead of by 2 would reach 10 ÷ 4 = 2.5. A candidate who multiplies by 2 instead of dividing (reversing the direction of the sequence) would reach 10 × 2 = 20.
- (a) An identity, true for every value of x — Expanding the bracket on the left gives 3x + 12, which matches the right-hand side exactly, so the statement is true for every value of x — this makes it an identity. A candidate who reasons that any statement with an equals sign must be an equation picks that option, missing that an equation is only true for particular value(s) of x, not all of them. A candidate who confuses an identity with a formula, because both relate two expressions, picks the formula option — but a formula connects two different quantities, such as area and side length, not two equivalent forms of the same expression. A candidate who assumes it can be solved for a single value of x, as with a normal equation, picks that option, not realising there is no single solution here.
- (a) (4, 1) — y = −f(x) reflects the graph of y = f(x) in the x-axis: every point (x, y) maps to (x, −y). Applying this to (4, −1): the x-coordinate stays 4, and the y-coordinate −1 becomes its negative, 1. Leaving the y-coordinate unchanged skips the reflection entirely, giving (4, −1); reflecting the x-coordinate instead, or reflecting both, mixes this up with a reflection in the y-axis or a rotation, giving (−4, −1) or (−4, 1).
- (b) 319 — Substitute n = 10: 3 × 10² + 2 × 10 − 1 = 3 × 100 + 20 − 1 = 300 + 20 − 1 = 319. A sign error on the +2n term, treating it as −2n, gives 300 − 20 − 1 = 279. Working out 3 × 10² + 2 × 10 but forgetting to subtract the final 1 gives 300 + 20 = 320. Using n = 9 instead of n = 10 gives 3 × 81 + 18 − 1 = 243 + 18 − 1 = 260.
- (b) (−4, 3) — Method: in a rectangle whose sides are parallel to the axes only two different x-coordinates and two different y-coordinates appear, and each of them is shared by a pair of vertices, so the missing vertex takes the x-coordinate and the y-coordinate that so far appear only once. Working: the x-coordinates given are −4, 2 and 2, so 2 is already used twice and −4 is used once; the y-coordinates given are −1, −1 and 3, so −1 is already used twice and 3 is used once; the fourth vertex therefore has x = −4 and y = 3. Answer: (−4, 3). The distractors: (3, −4) comes from picking the two unpaired coordinates correctly and then writing them in the wrong order; (−4, −5) comes from matching the 4-unit vertical side but measuring it downwards from (−4, −1) instead of upwards; (8, 3) comes from carrying on round the shape with the horizontal step used earlier, adding 6 to the x-coordinate of (2, 3) instead of closing the rectangle.
Build your own mix at the worksheet builder.